A PCE groundwater plume discharging to a river: influence of the streambed and near-river zone on contaminant distributions

An investigation of a tetrachloroethene (PCE) groundwater plume originating at a dry cleaning facility on a sand aquifer and discharging to a river showed that the near-river zone strongly modified the distribution, concentration, and composition of the plume prior to discharging into the surface water. The plume, streambed concentration, and hydrogeology were extensively characterized using the Waterloo profiler, mini-profiler, conventional and driveable multilevel samplers (MLS), Ground Penetrating Radar (GPR) surveys, streambed temperature mapping (to identify discharge zones), drivepoint piezometers, and soil coring and testing. The plume observed in the shallow streambed deposits was significantly different from what would have been predicted based on the characteristics of the upgradient plume. Spatial and temporal variations in the plume entering the near-river zone contributed to the complex contaminant distribution observed in the streambed where concentrations varied by factors of 100 to 5000 over lateral distances of less than 1 to 3.5 m. Low hydraulic conductivity semi-confining deposits and geological heterogeneities at depth below the streambed controlled the pattern of groundwater discharge through the streambed and influenced where the plume discharged into the river (even causing the plume to spread out over the full width of the streambed at some locations). The most important effect of the near-river zone on the plume was the extensive anaerobic biodegradation that occurred in the top 2.5 m of the streambed, even though essentially no biodegradation of the PCE plume was observed in the upgradient aquifer. Approximately 54% of the area of the plume in the streambed consisted solely of PCE transformation products, primarily cis-1,2-dichloroethene (cDCE) and vinyl chloride (VC). High concentrations in the interstitial water of the streambed did not correspond to high groundwater-discharge zones, but instead occurred in low discharge zones and are likely sorbed or retarded remnants of past high-concentration plume discharges. The high-concentration areas (up to 5529 microg/l of total volatile organics) in the streambed are of ecological concern and represent potential adverse exposure locations for benthic and hyporheic zone aquatic life, but the effect of these exposures on the overall health of the river has yet to be determined. Even if the upgradient source of PCE is remediated and additional PCE is prevented from reaching the streambed, the high-concentration deposits in the streambed will likely take decades to hundreds of years to flush completely clean under natural conditions because these areas have low vertical groundwater flow velocities and high retardation factors. Despite high concentrations of contaminants in the streambed, PCE was detected in the surface water only rarely due to rapid dilution in the river and no cDCE or VC was detected. Neither the sampling of surface water nor the sampling of the groundwater from the aquifer immediately adjacent to the river gave an accurate indication of the high concentrations of PCE biodegradation products present in the streambed. Sampling of the interstitial water of the shallow streambed deposits is necessary to accurately characterize the nature of plumes discharging to rivers.     

Airborne Particulate Emissions from a Chromic Acid Anodizing Process Tank

Particulate mass concentration, particle size distribution, and particle chemical composition measurements have been conducted on the gases exhausting from a chromic acid anodizing process tank. Particle mass concentrations in the 200 to 20,000 μg/m³ range were measured using open-faced filters (47 mm diameter) adjacent to the process tank liquid and with closed filters (90 mm diameter) in the exhaust duct. Particle size distributions, measured using University of Washington Mark 3 and Mark 20 Cascade Impactors, showed the particle aerodynamic mass median diameter was about 3 microns. Chemical analysis of the particle samples obtained by the Modified EPA Method 5 sampling train, the Mark 20 UW Cascade Impactors, and by the 47 mm and 90 mm diameter filters showed Cr⁺⁶ concentrations in the 20 to 1,500 μg/m³ range with over 99 percent of the chromium in particles larger than 1.0 microns diameter. An integrating nephelometer was used to measure the light scattering coefficient of the exhaust gases upstream of the wet scrubber. The light scattering coefficient increased by a factor of about 2–3 over the background level during the 40 minute time period while a part was being anodized. The bscat values ranged from 3 × 10^?5 to 3 × 10^?4 meters^?1 for the aerosol particles less than about 6 microns aerodynamic diameter.     

A Policy of Options

As many of you know, I previously served as Deputy Administrator of the Environmental Protection Agency at a time when the problem of air pollution control was reaching a peak of public awareness. The work of the Air Pollution Control Association in investigating facts and accelerating the development of solutions earned my high respect then and my continued admiration now.     

Economics and Alternatives for Sulfur Removal from Coke Oven Gas

Two processes are currently being employed in North America for the desulfurization of coke oven gas, the Vacuum Carbonate System, and the Stretford System. A third, the Sulfi-ban Process, which was recently announced, now has several plants scheduled for construction. Overall operating requirements for each of these processes are considered in detail. Emphasis is placed on an identification of power and steam requirements, the types and amounts of solid and/or liquid waste streams produced together with methods for their treatment, and the net desulfurization efficiencies achieved by each process. Detailed estimates of capital and operating costs for desulfurization are considered, and equipment needs for environmental control requirements are discussed.     

Work and non-work correlates of illness and behaviour in male and female Swedish white collar workers

Four broad classes of dependent variables (psychological strain, physical illness symptoms, health-related behaviour and social participation) were associated with eleven categories of stressors and stress moderators from work and family life, using multiple logistic regression analysis for a random sample of 8700 full-time male and female members of T.C.O., a major Swedish white-collar labour federation (covering 25 per cent of the Swedish labour force). Our goal was to find broad patterns of associations by comparing relative magnitudes of effects for (a) stressors and stress moderators; (b) work and family activities, and (c) males and females. Fifty per cent of the associations between environmental factors and dependent variables were significant in the predicted direction at the 5 per cent level. However, only 5 per cent of the associations are as strong, for example, as average smoking/heart disease associations. Our primary conclusion is that job factors are the next strongest set of predictors of health and behaviour after age. Job factors are stronger than family factors for both men and women; proportionally increasing the explained variance by over 60 per cent versus roughly 20 per cent for family factors (over the 25 per cent of explanation due to demographic factors). The overall pattern of stressor/outcome associations is quite similar for men and women, although both job/outcome and family burden/outcome associations are stronger for women than for men. We failed to find a clear linkage between particular stressors and particular physical illnesses. Among the job factors, control and work load have the strongest associations; with the former predicting behaviour patterns and job satisfaction (along with social support), and the latter predicting mental strain symptoms. Family problems are associated with increased health risks (stronger for men) and family responsibilities and constraints affect health behaviour (stronger for women). Job satisfaction is the most successfully predicted outcome in the study, and is similarly affected for men and women.     

Development and Adoption of a Simple Nonpoint Source Pollution Model for Port Phillip Bay,Australia

New computing tools and approaches allow tailored development of software to meet the needs of environmental managers. The processes required for such tailoring fit well with adaptive management concepts where, as knowledge and system understanding develop among managers, the software can be developed or replaced to match. This paper reports on development and adoption of a simple nonpoint source pollution modeling tool, including technical aspects of data support for modeling and social aspects of software design. The software, named FILTER, used a unit load model to generate expected pollutant loads from subcatchments of Port Phillip Bay, Australia. Monitoring data were used for calibration to modify the delivery of generated pollutants to receiving waters. Spatial, tabular, and charting software components were used to provide alternative forms of output visualization. FILTER was developed using a process that resulted in manager-stakeholders taking responsibility for setting of model parameter values and operation of the user interface, thereby encouraging uptake. The inclusive development process, tailoring of the software to manager needs and styles of usage, and matching of model complexity to data and knowledge, resulted in a successful application that has become the current agreed system representation among disparate stakeholder organizations.     

Transforming open mining pits into fish farms: Moving towards sustainability

The legacy of mining activities has typically been land ‘returned to wildlife’, or, at some sites, degraded to such an extent that it is unsuitable for any alternate use. Progress towards sustainability is made when value is added in terms of the ecological, social and economic well‐being of the community. In keeping with the principles of sustainable development, the innovative use of flooded open pits and tailings impoundments as commercial, recreational or ornamental fish farms should be considered in some locations, as it could make a significant contribution to the social equity, economic vitality and environmental integrity of mining communities. This article highlights the growing significance of aquaculture and explores the benefits and barriers to transforming flooded pits and impoundments into aquaculture operations. Among other benefits, aquaculture may provide a much‐needed source of revenue, employment and, in some cases, food to communities impacted by mine closure. Further, aquaculture in a controlled closed environment may be more acceptable to critics of fish farming who are concerned about fish escapes and viral transmissions to wild populations. Despite the potential benefits, aquaculture in flooded pits and impoundments is not without its complications — it requires a site‐specific design approach that must consider issues ranging from metals uptake by fish, to the long‐term viability of the aquatic system as fish habitat, to the overall contribution of aquaculture to sustainability.     

Modeling Parent and Metabolite Fate and Transport in Subsurface Drained Fields With Directly Connected Macropores1

Abstract: Few studies exist that evaluate or apply pesticide transport models based on measured parent and metabolite concentrations in fields with subsurface drainage. Furthermore, recent research suggests pesticide transport through exceedingly efficient direct connections, which occur when macropores are hydrologically connected to subsurface drains, but this connectivity has been simulated at only one field site in Allen County, Indiana. This research evaluates the Root Zone Water Quality Model (RZWQM) in simulating the transport of a parent compound and its metabolite at two subsurface drained field sites. Previous research used one of the field sites to test the original modification of the RZWQM to simulate directly connected macropores for bromide and the parent compound, but not for the metabolite. This research will evaluate RZWQM for parent/metabolite transformation and transport at this first field site, along with evaluating the model at an additional field site to evaluate whether the parameters for direct connectivity are transferable and whether model performance is consistent for the two field sites with unique soil, hydrologic, and environmental conditions. Isoxaflutole, the active ingredient in BALANCE^® herbicide, was applied to both fields. Isoxaflutole rapidly degrades into a metabolite (RPA 202248). This research used calibrated RZWQM models for each field based on observed subsurface drain flow and/or edge of field conservative tracer concentrations in subsurface flow. The calibrated models for both field sites required a portion (approximately 2% but this fraction may require calibration) of the available water and chemical in macropore flow to be routed directly into the subsurface drains to simulate peak concentrations in edge of field subsurface drain flow shortly after chemical applications. Confirming the results from the first field site, the existing modification for directly connected macropores continually failed to predict pesticide concentrations on the recession limbs of drainage hydrographs, suggesting that the current strategy only partially accounts for direct connectivity. Thirty‐year distributions of annual mass (drainage) loss of parent and metabolite in terms of percent of isoxaflutole applied suggested annual simulated percent losses of parent and metabolite (3.04 and 1.31%) no greater in drainage than losses in runoff on nondrained fields as reported in the literature.     

SUSPENDED SEDIMENT AND METALS REMOVAL FROM URBAN RUNOFF BY A SMALL LAKE1

ABSTRACT: A small lake in the Chicago Metropolitan Area was from 91 to 95 percent efficient in removing suspended sediment and from 76 to 94 percent efficient in removing copper, iron, lead, and zinc from urban runoff. Sediments accumulated in the lake in the form of an organic-rich mud at an average rate of 20 millimeters per year; this reduced lake storage and covered potential habitat for aquatic organisms. Copper, lead, and zinc concentrations were closely associated with suspended-sediment concentrations and with silt- and clay-sized fractions of lake sediment. Although concentrations of mercury and cadmium were near detection limits in runoff, measurable concentrations of these metals accumulated in the lake sediments.