利用CRT屏玻璃制备板状泡沫玻璃

以废旧阴极射线管(CRT屏)为主要原料,混合碳粉作为发泡剂,硼砂为助熔剂、稳泡剂,利用烧结法制备出的板状泡沫玻璃是一种高性能无机建筑保温材料。利用TG-DSC-MS研究分析了CRT屏玻璃的热性能与发泡剂协同作用的关系。配合料被预先压制成板块状,然后在发泡温度下进行烧成。研究了发泡剂碳粉的含量、发泡温度和发泡时间与其结构、性能的关系。研究分析表明,以废CRT屏玻璃为主要原料、碳粉为发泡剂,将混合料压制成块,烧制出板状泡沫玻璃。其较佳的发泡温度为850℃、碳粉的最佳用量范围为0.3%～0.5%,较好的发泡时间为30 min。烧制的板状泡沫玻璃的密度为0.292 g/cm3。在相同的制备条件下,随着发泡温度的升高,气泡孔径也呈现增大趋势,孔壁也逐渐变薄。随着发泡时间逐渐增加,气孔的直径迅速增大,并有形成连通孔。     

超滤膜深度处理染整废水的膜污染机理

实验采用不同规格和材料的超滤膜进行染整二级尾水分离实验,对超滤膜污染机理及影响因素进行了分析。实验采用红外光谱分析了聚醚(PES)膜、聚砜(PSF)膜和聚醚酰亚胺(PEI)膜3种超滤膜材料,对比了污染前后膜面的接触角以及不同切割分子量对膜通量及出水水质的影响,并利用线性化的Herman堵塞模型拟合了不同分子量超滤膜的堵塞模型,初步探讨了超滤膜的污染机理。实验结果表明,膜材料表面亲水性基团的多少与初始膜通量大小成正比,出水COD值随超滤膜切割分子量减小而减小。切割分子量同为2 000 Da的3种超滤膜中,PES膜的处理效果最佳,出水COD平均值为47.81 mg/L;PEI膜通量最高,平衡通量可达50 L/(m2.h);切割分子量为1 000、10 000的超滤膜堵塞机理符合滤饼过滤模型,100 000的超滤膜堵塞机理更接近于完全堵塞模型;1 000的聚醚砜材质膜(PES)更适合此类废水的深度处理。     

氧化物催化剂对非热等离子体催化降解甲苯的影响

考察了在干燥气氛下不同氧化物催化剂对非热等离子体催化降解甲苯的影响。从甲苯降解率、碳平衡、CO2选择性和O3去除4个方面,对比了氧化物催化剂的介电性能、表面供氧能力和比表面积与多孔结构对反应产生影响的强弱。结果表明,催化剂的介电性能有利于甲苯降解率、碳平衡和O3产量的提高,但对CO2选择性和O3去除的影响极小;一定能量密度下,催化剂比表面积与多孔结构对CO2选择性和O3去除所产生的影响要强于介电性能;催化剂表面供氧能力可明显促进反应的进行,其对反应所产生的影响要强于比表面积与多孔结构。     

Subcellular distribution and toxicity of cadmium in Potamogeton crispus L

The submerged macrophyte Potamogeton crispus L. was subjected to varying doses of cadmium (0, 20, 40, 60 and 80 μM) for 7 d, and the plants were analyzed for subcellular distribution of Cd, accumulation of mineral nutrients, photosynthesis, oxidative stress, protein content, and ultrastructural distribution of calcium (Ca). Leaf fractionation by differential centrifugation indicated that 48-69% of Cd was accumulated in the cell wall. At all doses of Cd, the levels of Ca and B rose and the level of Mn fell; the levels of Fe, Mg, Zn, Cu, Mo, and P rose initially only to decline later. Exposure to Cd caused oxidative stress as evident by increased content of malondialdehyde and decreased contents of chlorophyll and protein. Photosynthetic efficiency, as indicated by the quenching of chlorophyll a fluorescence (Fv/Fm, Fo and Fm), decreased significantly, the extent of decrease being directly proportional to the concentration of Cd. Increased amounts of precipitates of calcium were noticed in the treated plants, located either outside the cell membrane or in chloroplasts, mitochondria, the nucleus, and the cytoplasm whereas control plants showed small deposits of the precipitates around surface of the vacuole membrane and in the intercellular space but rarely in the cytoplasm. Photosynthetic efficiency and oxidative stress could be used as indicators of physiological end-points in determining the extent of Cd phytotoxicity.     

Comparison of homologous and heterologous formats in nanocolloidal gold-based immunoassays for parathion residue determination

The effectiveness of homologous and heterologous formats in a nanocolloidal gold-based immunoassay for pesticide residue determination was investigated. Parathion, one of the most toxic organophosphorus pesticides, was used as the target analyte. One-step homologous and heterologous test strips based on a nanocolloidal gold-labeled monoclonal antibody were developed for the rapid detection of parathion residues. The results showed that the heterologous format was more effective than the homologous format, being more sensitive, more specific to parathion and more tolerant of matrix interferences. The best competitive hapten was found to have a moderate heterology and the opposite electronic distribution to the immunizing hapten. The detection limits for parathion using the preferred heterologous strip were 1 μg/L in water samples and 5 μg/kg in soil and food samples.     

Speciation distribution and mass balance of copper and zinc in urban rain, sediments, and road runoff

Heavy metal pollution in road runoff had caused widespread concern since the last century. However, there are little references on metal speciation in multiple environmental media (e.g., rain, road sediments, and road runoff). Our research targeted the investigation of metal speciation in rain, road sediments, and runoff; the analysis of speciation variation and mass balance of metals among rain, road sediments, and runoff; the selection of main factors by principal component analysis (PCA); and the establishment of equation to evaluate the impact of rain and road sediments to metals in road runoff. Sequential extraction procedure contains five steps for the chemical fractionation of metals. Flame atomic absorption spectrometry (Shimadzu, AA-6800) was used to determine metal speciation concentration, as well as the total and dissolved fractions. The dissolved fractions for both Cu and Zn were dominant in rain. The speciation distribution of Zn was different from that of Cu in road sediments, while speciation distribution of Zn is similar to that of Cu in runoff. The bound to carbonates for both Cu and Zn in road sediments were prone to be dissolved by rain. The levels of Cu and Zn in runoff were not obviously influenced by rain, but significantly influenced by road sediments. The masses for both Cu and Zn among rain, road sediments, and road runoff approximately meet the mass balance equation for all rainfall patterns. Five principal factors were selected for metal regression equation based on PCA, including rainfall, average rainfall intensity, antecedent dry periods, total suspended particles, and temperature. The established regression equations could be used to predict the effect of road runoff on receiving environments.     

Characterization of carbonic anhydrase II from Chlorella vulgaris in bio-CO2 capture

Carbonic anhydrase II (CA II) can catalyze the reversible hydration reaction of CO₂ at a maximum of 1.4?×?10⁶ molecules of CO₂ per second. The crude intracellular enzyme extract containing CA II was derived from Chlorella vulgaris. A successful CO₂ capture experiment with the presence of calcium had been conducted on the premise that the temperature was conditioned at a scope of 30?C40?°C, that the biocatalyst-nurtured algal growth period lasted 3?days, and that pH ranged from7.5 to 8.5. Ions of K⁺, Na⁺, Ca²⁺, Co²⁺, Cu²⁺, Fe³⁺, Mg²⁺, Mn²⁺, and Zn²⁺ at 0.01, 0.1, and 0.5?M were found to exhibit no more than 30?% inhibition on the residual activity of the biocatalyst. It is reasonable to expect that calcification catalyzed by microalgae presents an alternative to geological carbon capture and sequestration through a chain of fundamental researches carried on under the guidance of sequestration technology.     

厌氧滤池处理纺织印染废水的中试研究

对厌氧滤池反应器处理难降解印染废水进行中试研究。结果表明,厌氧滤池反应器水力停留时间(HRT)在8.1～14.6 h之间,进水COD浓度波动较大(500～1 000 mg/L)时,对COD平均去除率为20%。印染废水的BOD5/COD由0.23提高到0.35,废水可生化性明显改善。印染废水中硫酸根浓度略有下降,去除浓度为70 mg/L左右。厌氧滤池进出水颜色明显变化,由紫红色变为蓝黑色,紫外可见光谱分析表明废水中的有机物结构发生变化。     

无硫膨胀石墨的制备及吸油性能

通过单因子实验考察了无硫膨胀石墨制备过程中氧化剂及插层剂用量、氧化反应及插层反应时间、氧化反应及插层反应温度对无硫膨胀石墨膨胀体积的影响。通过正交实验确定了制备无硫膨胀石墨的最优条件是:石墨(g)∶浓硝酸(mL)∶30%H2O2(mL)∶乙酸酐(mL)=1∶2.25∶0.25∶0.6,在30℃条件下氧化反应60 min,加入插层剂后在60℃条件下插层反应90 min,此条件无硫膨胀石墨的膨胀体积达317 mL/g使用XPS、FT-IR、XRD和SEM对无硫膨胀石墨进行了表征并对其吸油性能和再生性能进行了研究。结果表明,所制备无硫膨胀石墨对原油和柴油的最大吸附量分别为66.3 g/g和62.7 g/g。吸附原油后的无硫膨胀石墨抽滤再生后首次再生率为49.1%,原油的回收率为64.5%。     

基于GCM_CB模型的土壤重金属污染评价

灰色聚类法已经运用于土壤重金属污染评价中,然而此法在确定聚类权重时仅考虑重金属浓度,忽略了衡量重金属毒性强弱的重要指标生物毒性指数。为了更客观和准确地反映土壤重金属的污染程度,将生物毒性指数引入到聚类指标权重中,构建GCM_CB(grey clustering method_concentration and biotoxicity)土壤重金属污染评价模型。通过对华东某地区的10个区域土壤重金属污染进行分析评价,并与常用评价方法对比研究,表明:其多数样点的评价结果基本一致,但针对样品4和样品9中的元素Hg,因其强毒性,使得评价等级由I级定为II级,从而提高了评价方法的灵敏度,更加符合该区域的实际土壤污染情况。