突变灰盖鬼伞过氧化物酶降解刚果红的响应面法优化分析简

酶法降解偶氮染料刚果红是一个复杂的过程,受温度、pH、酶量、刚果红浓度和双氧水浓度显著影响。为研究各因素及因素间交互作用对刚果红降解影响,提高刚果红的降解率,分别使用单因素法和响应面分析法对刚果红降解条件进行了优化。单因素实验结果显示灰盖鬼伞过氧化物酶降解刚果红的最适条件为：pH 5.0、32℃、酶量4.98 U、双氧水0.1 mmol/L、刚果红20 mg/L,此时刚果红最高降解率为34.84%。然后选双氧水浓度、刚果红浓度和灰盖鬼伞过氧化物酶量作为3个因素,通过中心组合设计实验,用响应面法对刚果红降解进行优化分析,最后得到一个拟合度良好的二次多项方程模型（R²=0.9900）。方差分析结果显示,刚果红浓度和酶量是影响最显著的因素,双氧水与酶以及染料与酶之间的交互作用极显著。响应面分析优化后的反应体系为：双氧水浓度0.15 mmol/L,刚果红浓度为27.21 mg/L,酶为2.0 7 U,在此条件下,刚果红降解率达58.13%。     

共代谢膜生物反应器法处理二甲基亚砜废水

采用蔗糖作为共代谢基质与一体式好氧膜生物反应器（MBR）工艺相结合处理二甲基亚砜（DMSO）废水。考察了装置的污泥驯化效果、DMSO去除率、污泥的性能、HRT和冲击负荷对DMSO去除率的影响。试验结果表明：驯化第29天,DMSO去除率达98.5%,表明MBR内的污泥已驯化成功;在MBR运行的正式期,当DMSO处于高负荷状态时,DMSO去除率较低;随蔗糖加入量的增加,DMSO去除率逐渐提高,最终恢复到DMSO高负荷冲击前的DMSO去除效果;正常运行时,装置进水ρ（DMSO）=257~1 448 mg/L（平均值为718 mg/L）、出水ρ（DMSO）=6~22 mg/L（平均值为7 mg/L）,DMSO去除率为96.4%~99.6%（平均值为98.9%）;在MBR运行的正式期,污泥体积指数小于100 mL/g,表明污泥的沉降性能较好,MLVSS/MLSS较高,表明污泥的活性高,MBR内MLSS的平均值为5.52 g/L,MLVSS的平均值为4.78 g/L;MBR适宜的HRT为12 h。     

两级EGSB反应器处理焦化废水的实验研究

采用两级膨胀颗粒污泥床(EGSB)反应器在微氧条件下处理焦化废水,分别考察了一级和二级EGSB反应器(EGSBⅠ和EGSBⅡ)对污染物的去除效果。结果表明,系统能够高效去除COD和NH3-N,EGSBⅠ主要用于去除COD,EGSBⅡ主要用于去除NH3-N。总水力停留时间(HRT)为24 h(EGSBⅠ12 h+EGSBⅡ12 h),系统对952 mg/L的COD、41.3 mg/L的NH3-N、34.55 mg/L的挥发酚、295.8 mg/L的硫氰化物和0.89 mg/L的氰化物的平均去除率分别为78.1%、81.3%、100%、98.1%和89.9%。出水COD、NH3-N、挥发酚、硫氰化物和氰化物的平均浓度分别为208、7.7、0、5.7和0.09 mg/L。出水NH3-N、挥发酚和氰化物浓度均低于《炼焦化学工业污染物排放标准》(GB 16171-2012)的直接排放限值。     

Effects of Preparation Parameters on Properties of Soy Protein-Based Fiberboard

The effects of manufacturing parameters on mechanical properties of medium density fibreboard (MDF) bonded with modified soy protein-based glue were studied to find an appropriate manufacture technology. Physical properties of MDF made with different amount of wax emulsion were measured. Results indicated that water repellent had no obvious influence on physical properties of soy protein-based MDF boards. The fiberboards bonded with soy protein-based glue showed stronger water resistance properties than those bonded with urea–formaldehyde (UF) resins. Furthermore, the soy protein-based MDF boards had good quality [25.2% 24 h soak thickness swell (TS), 29.9 MPa modulus of rupture (MOR), 3130 MPa modulus of elasticity (MOE)], which met requirements of Chinese national standard. Practical processing parameters were obtained by orthogonal experiment, i.e., glue content 8.0%, hot-press temperature 200 °C, and hot-press time 150 s.     

Life cycle assessment of biodiesel fuel production from waste cooking oil in Okayama City

A life cycle assessment (LCA) is performed to make clear of the actual environment impacts from conversation of waste cooking oil (WCO) to biodiesel fuel (BDF) in Okayama. A scenario analysis is carried out based on different participation rate of residents who separate WCO from general waste, corresponding to different BDF utilisation rate in transportation system. Sub scenarios complying with different gas emission standards regarding vehicles are designed as well. Afterwards, life cycle impact assessment is conducted to focus on global warming, acidification, and urban air pollution. Overall improvement of almost all kinds of life cycle inventories is significant when diesel is replaced with BDF, demonstrating that a shift from WCO-to-incineration to WCO-to-BDF is more beneficial. Under carbon neutral, compared to base scenario (S0), about 746.05 ton CO₂ emission will be reduced annually in the scenario with 100 % BDF utilisation in vehicles (S4). Meanwhile, total external cost in three environmental impacts (EI) sharply reduces by 51.90 %, showing much economic sustainability in S4. Moreover, the manufacturing cost for producing one litter WCO-to-BDF is 97.32 Yen. Sensitivity analysis shows that the gas emission standard regarding vehicles had much bigger effect on EI than BDF manufacturing process in this research.     

Industrial and urban symbiosis in Japan: Analysis of the Eco-Town program 1997–2006

Japan's Eco-Town Program spearheaded in Japan the integration of Industrial Symbiosis and Urban Symbiosis, seeking to maximise the economic and environmental benefit from close geographic proximity of industrial and urban areas, through the use of previously discarded commercial, municipal and industrial waste materials in industrial applications. The program established 26 Eco-Towns around Japan. Approximately 1.65 billion USD was invested in 61 innovative recycling projects, with an average government subsidy of 36%. In addition at least 107 other recycling facilities have been constructed without government subsidy. 14 Eco-Towns primarily contributed to improving industry's productivity, whilst 10 Eco-Towns primarily contributed to improving environmental amenity. In 16 Eco-Towns the private sector was the most important actor supporting local government in the realisation of the Eco-Town, whilst in 9 Eco-Towns this was civil society. The availability of investment subsidies, the coming into force of ambitious recycling legislation with quantified, product-specific targets, access to the significant technological resources of the private sector, and widespread recognition of the urgency to act on environmental issues, all contributed to the success of the Eco-Town Program.     

构建现代产业体系的环保思考

在对当前国际国内环境保护大背景分析的基础上,阐述了构建现代产业体系与环境保护的关系,以及生态文明、科学发展观、可持续发展战略、循环经济、清洁生产等与环境保护相关的关键词,提出构建现代产业体系,必须与环境保护体系建设同步进行,将最新的环保理念和思想纳入到现代产业体系的构建之中,并从环保政策上给与支持。     

铁炭微电解工艺处理采油废水的研究

随着采油废水产生量的逐渐增大以及排放标准的日益严格,寻找一种经济、高效的处理方法显得十分必要。采用铁炭微电解技术对冀东油田采油废水进行了处理。考察了铁屑粒径、pH值、Fe/C质量比和反应时间对COD去除率的影响并设计了正交实验,结果表明,影响微电解工艺的因素主次关系为:pH>Fe/C质量比>反应时间,在最佳条件pH=5,Fe/C质量比为7∶1,反应时间50 min下,原水COD由170 mg/L降至95.6 mg/L,去除率达43.85%,出水满足国家二级排放标准。     

干旱定义述评

本文列举了干旱的几种定义,分析了它们之间的联系。认为干旱的各种定义各有侧重,相互补充,都有其存在的必要,试图统—干旱定义是不现实的。各学科在干旱研究上应加强相互协作与交流。     

我国环境管理模式的转变

本文通过对我国的环境管理发展历程分析后认为,我国的环境管理模式已由过去单一的管理模式转变为强化执法监督、加大投入、注重技术相互结合的综合型管理模式,在继续强化执法监督的同时,不断提高环保投入的比例和不断增加科技含量,是环境管理发展的趋势。