Relationships between Aerosol Extinction Coefficients Derived from Airport Visual Range Observations and Alternative Measures of Airborne Particle Mass

Epidemiological assessments of population exposures to airborne particles are often hampered by the scarcity of available fine particle mass measurements. In an attempt to overcome this serious problem, we analyze In this paper methods for predicting fine particle (M ₁) and Inhalable particle (IP) mass concentrations using relative humidity corrected light extinction coefficient (b _ext) estimated from airport visual range (V _r) observations. The analyses presented are based on theoretical determinations as well as statistical investigations utilizing EPA's NASN and Inhalable Particle Monitoring Network (IPMN) data bases and routine airport visual range observations In twelve large U.S. cities. Our results Indicate that, after controlling for certain limitations of airport visual range data, most of the regression models developed in this paper can be applied satisfactorily to predict M _t and IP. Furthermore, our findings Indicate that a more representative formula than the commonly used meteorological range formula to predict atmospheric b _ext values in urban areas may be b _ext = (1.8 ± 0.04)/V _r. Because of known local or regional influences, however, we do suggest calibration of any predictive model which utilizes airport visibility data against site-specific aerometric data on particle mass concentrations or scattering coefficient measurements.     

Industrial Pollution Prevention

The 1992 A&WMA Critical Review was authored by Harry Freeman and members of his staff at the Pollution Prevention Research Branch, Risk Reduction Engineering Laboratory, U.S. Environmental Protection Agency in Cincinnati, Ohio. Mr. Freeman presented the paper "Industrial Pollution Prevention," at the Critical Review session held during the 85th Air & Waste Management Association Annual Meeting in Kansas City, Missouri. Prepared discussions and invited comments presented during the session are published here, as well as closing remarks by Mr. Freeman.     

Effects of Fuel Type,Driving Cycle,and Emission Status on In-Use Vehicle Exhaust Reactivity

ABSTRACT

The introduction of reformulated gasolines significantly reduced exhaust hydrocarbon (HC) mass emissions, but few data are available concerning how these new fuels affect exhaust reactivity. Similarly, while it is well established that high-emitting vehicles contribute a significant portion of total mobile source HC mass emissions, it is also important to evaluate the exhaust reactivity from these vehicles. The objective of this study was to evaluate the relative influence on in-use vehicle exhaust reactivity of three critical factors: fuel, driving cycle, and vehicle emission status. Nineteen in-use vehicles were tested with seven randomly assigned fuel types and two driving cycles: the Federal Test Procedure (FTP) and the Unified Cycle (UC). Total exhaust reactivity was not statistically different between the FTP and UC cycles but was significantly affected by fuel type. On average, the exhaust reactivity for California Phase 2 fuel was the lowest (16 % below the highest fuel type) among the seven fuels tested for cold start emissions. The average exhaust reactivity for high-emitting vehicles was significantly higher for hot stabilized (11%) and hot start (15%) emissions than for low-emitting vehicles. The exhaust reactivities for the FTP and UC cycles for light-end HCs and carbonyls were significantly different for the hot stabilized mode. There was a significant fuel effect on the mean specific reactivity (SR) for the mid-range HCs, but not for light-end HCs or carbonyls, while vehicle emission status affected the mean SR for all three HC compound classes.     

Impact of Dredging on Phosphorus Transport in Agricultural Drainage Ditches of the Atlantic Coastal Plain1

Abstract: Drainage ditches can be a key conduit of phosphorus (P) between agricultural soils of the Atlantic Coastal Plain and local surface waters, including the Chesapeake Bay. This study sought to quantify the effect of a common ditch management practice, sediment dredging, on fate of P in drainage ditches. Sediments from two drainage ditches that had been monitored for seven years and had similar characteristics (flow, P loadings, sediment properties) were sampled (0‐5 cm) after one of the ditches had been dredged, which removed fine textured sediments (clay = 41%) with high organic matter content (85 g/kg) and exposed coarse textured sediments (clay = 15%) with low organic matter content (2.2 g/kg). Sediments were subjected to a three‐phase experiment (equilibrium, uptake, and release) in recirculating 10‐m‐long, 0.2‐m‐wide, and 5‐cm‐deep flumes to evaluate their role as sources and sinks of P. Under conditions of low initial P concentrations in flume water, sediments from the dredged ditch released 13 times less P to the water than did sediments from the ditch that had not been dredged, equivalent to 24 mg dissolved P. However, the sediments from the dredged ditch removed 19% less P (76 mg) from the flume water when it was spiked with dissolved P to approximate long‐term runoff concentrations. Irradiation of sediments to destroy microorganisms revealed that biological processes accounted for up to 30% of P uptake in the coarse textured sediments of the dredged ditch and 18% in the fine textured sediments of the undredged ditch. Results indicate that dredging of coastal plain drainage ditches can potentially impact the P buffering capacity of ditches draining agricultural soils with a high potential for P runoff.     

Defining the Features of Sustainable Development for a Developing Country: The Zimbabwe Case

For the past two decades, planners and researchers have struggled to define concepts of sustainable development, but most definitions are too general. Goals need to be more specific and will vary to reflect the different conditions and national development policies across countries. A national Delphi survey, using two sequential questionnaires, was conducted in Zimbabwe during late 1992 with a broad cross-section of stakeholders. The survey identified, clarified and ranked 34 national objectives for environmentally sustainable development in Zimbabwe. Survey respondents weighted environmental objectives in development planning higher than both economic and social objectives. The ranked objectives will help guide the country's efforts to implement environmentally sustainable development and associated policy measures.     

MODELING UPLAND EROSION1

ABSTRACT: We have developed a computer model of soil loss on an upland watershed from the continuity considerations for sediment transport and from equations describing rill and interrill erosion. The model is based on dividing the upland area into a grid containing rill and interill zones, on the Universal Soil Loss Equation (USLE), and on equations describing detachment and transport capacity of rill flow. The USLE estimates the sediment load from the contributing areas. The location and amount of total erosion and deposition are determined by comparing the transport and detachment capacity of rill flow for specific storms. The model considers the mechanics of erosion process and can serve as basis for reservoir and channel design and land use planning.     

MISSISSIPPI EMBAYMENT AQUIFER SYSTEM IN MISSISSIPPI: GEOHYDROLOGIC DATA COMPILATION FOR FLOW MODEL SIMULATION1

ABSTRACT: As part of the Gulf Coast Regional Aquifer System Analysis (GC RASA) study, data from 184 geophysical well logs were used to define the geohydrologic framework of the Mississippi embayment aquifer system in Mississippi for flow model simulation. Five major aquifers of Eocene and Paleocene age were defined within this aquifer system in Mississippi. A computer data storage system was established to assimilate the information obtained from the geophysical logs. Computer programs were developed to manipulate the data to construct geologic sections and structure maps. Data from the storage system will be input to a five-layer, three-dimensional, finite-difference digital computer model that is used to simulate the flow dynamics in the five major aquifers of the Mississippi embayment aquifer system.     

Applications

Summary Economic incentives have spurred numerous applications of genetically engineered organisms in manufacture of pharmaceuticals and industrial chemicals. These successes, involving a variety of methods of genetic manipulation, have dispelled early fears that genetic engineering could not be handled safely, even in the laboratory. Consequently, the potential for applications in the wider environment without physical containment is being considered for agriculture, mining, pollution control, and pest control. These proposed applications range from modest extensions of current plant breeding techniques for new disease-resistant species to radical combinations of organisms (for example, nitrogen-fixing corn plants). These applications raise concerns about potential ecological impacts (see chapter 5), largely because of adverse experiences with both deliberate and inadvertent introductions of nonindigenous species.     

Regulatory aspects

Summary At this time, there is no US legislation that is specifically aimed at regulating the environmental release of genetically engineered organisms or their modified components, either during the research and development stage or during application. There are some statutes, administered by several federal agencies, whose language is broad enough to allow the extension of intended coverage to include certain aspects of biotechnology. The one possible exception is FIFRA, which has already brought about the registration of several natural microbial pesticides but which also has provision for requiring the registration of strain improved microbial pesticides. Nevertheless, there may be gaps in coverage even if all pertinent statutes were to be actively applied to the control of environmental release of genetically modified substances. The decision to regulate biotechnology under TSCA was justified, in part, on the basis of its intended role as a gap-filling piece of environmental legislation. The advantage of regulating biotechnology under TSCA is that this statute, unlike others, is concerned with all media of exposure (air, water, soil, sediment, biota) that may pose health and environmental hazards. Experience may show that extending existing legislation to regulate biotechnology is a poor compromise compared to the promulgation of new legislation specifically designed for this purpose. It appears that many other countries are ultimately going to take the latter course to regulate biotechnology.