Individual and combined inhibition of phenol and thiocyanate on microbial activity of partial nitritation

This study evaluated the individual and interactive effect of phenol and thiocyanate (SCN⁻) on partial nitritation (PN) activity using batch test and response surface methodology. The IC₅₀ of phenol and SCN⁻ on PN sludge were 5.6 and 351 mg L⁻¹, respectively. The PN sludge was insensitive to phenol and SCN⁻ at levels lower than 1.77 and 43.3 mg L⁻¹, respectively. A regression model equation was developed and validated to predict the relative specific respiration rate (RSRR) of PN sludge exposed to different phenol and SCN⁻ concentrations. In the range of independent variables, the most severe inhibition was observed with a valley value (17%) for RSRR, when the phenol and SCN⁻ concentrations were 4.08 and 198 mg L⁻¹, respectively. An isobole plot was used to judge the combined toxicity of phenol and SCN⁻, and the joint inhibitory effect was variable depending on the composition and concentration of the toxic components. Furthermore, the toxic compounds showed independent effects, which is the most common type of combined toxicity.

     

Multiple copper adsorption and regeneration by zeolite 4A synthesized from bauxite tailings

Copper ions were first adsorbed by zeolite 4A synthesized from bauxite tailings, the desorption of Cu(II) using Na₂EDTA solutions was performed, and the recycling of zeolite 4A in adsorption and desorption was systematically investigated. It was observed that the Cu(II) removal efficiency was directly dependent on the initial pH value. The maximum removal efficiency of Cu(II) was 96.2% with zeolite 4A when the initial pH value was 5.0. Cu(II) was completely absorbed in the first 30 min. It was also observed that the desorption efficiency and zeolite recovery were highly dependent on the initial pH and concentration of Na₂EDTA in the solution. The desorption efficiency and percent of zeolite recovered were 73.6 and 85.9%, respectively, when the Na₂EDTA solution concentration was 0.05 mol L^?1 and the pH value was 8. The recovered zeolites were pure single phase and highly crystalline. After 3 cycles, the removal efficiency of Cu(II) was as high as 78.9%, and the zeolite recovery was 46.9%, indicating that the recovered zeolites have good adsorption capacity and can repeatedly absorb Cu(II).

     

Distribution and controls of heavy metals and organic matter in the surface sediments of the Southern Yellow Sea,China

Environmental Science and Pollution Research - Accurate and effective determination of the source of heavy metals is essential for the treatment of marine ecological environments. This article...     

Optimum ridge-to-furrow ratio in ridge-furrow mulching systems for improving water conservation in maize (Zea may L.) production

Environmental Science and Pollution Research - Water-saving cultivation techniques have been attracting increased attention worldwide. Ridge-furrow mulching system (RFMS), as a prospective...     

Are we planning for sustainable disaster recovery? Evaluating recovery plans after the Wenchuan earthquake

This article examines local recovery plans that were created in response to the Wenchuan earthquake and then suggests ways that planners can better apply the concept of sustainability to the recovery process. We utilize a plan evaluation protocol to analyze 16 recovery plans in counties and towns that were severely affected by the earthquake. We also conducted semi-structured interviews with public officials and planners, with the qualitative data gleaned from these interviews being used to supplement the plan quality assessment. The results reveal that local recovery plans do not appear to have incorporated sufficiently the concepts of sustainability. We conclude the paper with the following recommendations: emphasizing sustainability as a policy priority during vision and goal development; developing solid databases and planning techniques; designing a diversified set of regulatory- and incentive-based policy tools suitable for local governments; enhancing social and institutional learning; and further integrating multi-level and interagency governmental units.     

Mass transfer coefficients for volatilization of polychlorinated biphenyls from the Hudson River,New York measured using micrometeorological approaches

Air–water exchange is an important process controlling the fate of many organic chemicals in the environment. Modeling this process is hampered by the lack of direct observations. Thus, the purpose of this work was to derive direct measurements of the mass transfer coefficients for air–water exchange (v_aw) of polychlorinated biphenyls (PCBs) that may be used to check the validity of values derived from tracer gas experiments. v_aw values for PCBs were determined using previously published turbulent fluxes divided by the corresponding dissolved phase concentrations. The median v_aw values for each homolog decreased with increasing molecular weight and ranged from 0.29 for hexachlorobiphenyls to 2.2 m d^?1 for monochlorobiphenyls with a propagated uncertainty of about 70%, lower than in previous studies. Due to relatively low wind speeds and possible sorption of PCBs to colloids, these numbers may be biased low. These field measurements of v_aw differ by as much as a factor of 23 from predictions based on the widely-used Whitman two-film model. Therefore a new formulation for the calculation of v_aw based on field measurements is needed. This study demonstrates that micrometeorological approaches are a viable option for the measurement of v_aw for hydrophobic organics such as PCBs and should be used to generate enough field data on the air–water exchange of hydrophobic organics to allow the development of new predictive models.     

Partitioning and bioaccumulation of metals from oil sands process affected water in indigenous Parachlorella kessleri

This paper studies the partitioning and bioaccumulation of ten target metals (⁵³Cr, Mn, Co, ⁶⁰Ni, ⁶⁵Cu, ⁶⁶Zn, As, ⁸⁸Sr, ⁹⁵Mo and Ba) from oil sands tailings pond water (TPW) by indigenous Parachlorella kessleri. To determine the role of extracellular and intracellular bioaccumulation in metal removal by P. kessleri, TPW samples taken from two oil sands operators (Syncrude Canada Ltd. and Albian Sands Energy Inc.) were enriched with nutrient supplements.Results indicate that intracellular bioaccumulation played the main role in metal removal from TPW; whereas extracellular bioaccumulation was only observed to some extent for Mn, Co, ⁶⁰Ni, ⁶⁵Cu, ⁸⁸Sr, ⁹⁵Mo and Ba. The FTIR scan and titration of functional groups on the cell surface indicated low metal binding capacity by indigenous P. kessleri. However, it is believed that the dissolved cations and organic ligand content in TPW (such as naphthenic acids) may interfere with metal binding on the cell surface and lower extracellular bioaccumulation. In addition, the total bioaccumulation and bioconcentration factor (BCF) varied during the cultivation period in different growth regimes.     

Biofiltration Control of Hydrogen Sulfide 1. Design and Operational Parameters

Laboratory scale biological filter systems for control of hydrogen sulfide (H₂S) in waste gas have been studied and the optimum design and operating parameters determined. Extensive tests have been conducted to evaluate the effect of various filter bed operating parameters such as temperature, retention time, H₂S concentration, and H₂S loading rate. Variable properties of new and used composts such as sulfate content, acidity, and water content have been studied for their influence on H₂S removal efficiency. The effects of compost particle size distribution on system pressure drop and the maximum H₂S elimination capacity were examined. Biofiltration systems containing various types of yard waste compost as the filter material have been observed to remove hydrogen sulfide with efficiencies greater than 99.9 percent for H₂S inlet concentrations in the range from 5 to 2650 ppmv.     

微电解预处理靛蓝牛仔布印染废水

靛蓝牛仔布印染废水组分复杂,浓度高、水量大,属于难处理的工业废水,为了有效降低后续生物处理单元的负荷,采用铁炭微电解工艺对该废水进行预处理;通过正交实验考察pH、反应时间及铁炭比处理效果的影响规律及COD去除反应动力学,并对各因素作了单因素影响实验,确定了最佳工艺条件.结果表明,铁炭微电解法是预处理靛蓝牛仔布印染废水的一种有效方法,在Fe/C为2:1、pH为3的条件下反应90 min,铁炭微电解出水COD的去除率在49.2％,色度去除率达到80％,该印染废水经微电解处理后,BOD5/COD比值可从原来的0.248上升至0.436,可生化性明显提高.此外,微电解预处理靛蓝牛仔布印染废水中COD的去除反应符合二级反应动力学规律.