影响水中COD测定值关键因素的探讨

随着国家节能减排工作的大力推进,COD作为减排中四个重要约束性指标之一,其分析的准确性极大地影响着COD减排工作的顺利实施。本文根据《水质化学需氧量的测定重铬酸盐法》（GB11914—89）,结合《水质采样技术指导》（HJ494-2009）要求及笔者多年COD分析测试工作经验,着重探讨重铬酸盐法中水样中悬浮物及氯离子对测定结果的影响,以求在实际工作中能更准确、更方便地完成水样中COD的分析工作。     

基于功率法的结构⁃TMD减震控制分析∗

建立了结构-TMD振动方程,推导了无控结构和带TMD受控结构基于功率表达的运动方程,分别解释并给出了各种功率表达参数的物理意义,推导了随机激励下结构耗能功率流均值的随机表达式,对比分析了基于功率法的结构-TMD优化方法与其他优化方法的优化分析结果,并对其减震控制效果进行了对比分析。结果表明,结构-TMD系统的参数可以通过耗能功率流随机分析方法所得均值进行优化,且通过功率法优化后,结构在减震效果上优于其他传统方法得到的结果,从耗能功率均值的随机分析和时程功率分析角度证明了TMD控制的有效性;TMD做功功率为负时对结构有控制效果,起吸收转移能量的作用,且功率幅值越大控制效果越好,做功功率为正时则相反。     

Unregulated emissions from diesel engine with particulate filter using Fe-based fuel borne catalyst

The alteration and formation of toxic compounds and potential changes in the toxicity of emissions when using after-treatment technologies have gained wide attention. Volatile organic compound（VOC）, carbonyl compound and particle-phase polycyclic aromatic hydrocarbon（PAH） emissions were tested at European Steady State Cycle（ESC） to study unregulated emissions from a diesel engine with a fuel-borne catalyst and diesel particulate filter（FBC–DPF）. An Fe-based fuel-borne catalyst was used for this study. According to the results, brake specific emissions of total VOCs without and with DPF were 4.7 and4.9 mg/kWh, respectively, showing a 4.3% increase. Benzene and n-undecane emissions increased and toluene emission decreased, while other individual VOC emissions basically had no change. When retrofitted with the FBC–DPF, total carbonyl compound emission decreased 15.7%, from 25.8 to 21.8 mg/kWh. The two highest carbonyls, formaldehyde and acetaldehyde, were reduced from 20.0 and 3.7 to 16.5 and 3.3 mg/kWh respectively. The specific reactivity（SR） with DPF was reduced from 6.68 to 6.64 mg/kWh. Total particle-phase PAH emissions decreased 66.4% with DPF compared to that without DPF. However, the Benzo[a]pyrene equivalent（BaPeq） with DPF had increased from 0.016 to 0.030 mg/kWh.Fluoranthene and Pyrene had the greatest decrease, 91.1% and 88.4% respectively. The increase of two- and three-ring PAHs with DPF indicates that the fuel-borne catalyst caused some gas-phase PAHs to adsorb on particles. The results of this study expand the knowledge of the effects of using a particulate filter and a Fe-based fuel-borne catalyst on diesel engine unregulated emissions.     

Effect of a high strength chemical industry wastewater on microbial community dynamics and mesophilic methane generation

A high strength chemical industry wastewater was assessed for its impact on anaerobic microbial com- munity dynamics and consequently mesophilic methane generation. Cumulative methane production was 251 mL/g total chemical oxygen demand removed at standard temperature and pressure at the end of 30 days experimental period with a highest recorded methane percentage of 80.6% of total biogas volume. Volatile fatty acids （VFAs） analysis revealed that acetic acid was the major intermediate VFAs produced with propionic acid accumulating over the experimental period. Quantitative analysis of microbial communities in the test and control groups with quantitative real time polymerase chain reaction highlighted that in the test group, Eubacteria （96.3%） was dominant in comparison with methanogens （3.7%）. The latter were dominated by Methanomicrobiales and Methanobacteriales while in test groups increased over the experimental period, reaching a maximum on day 30. Denaturing gradient gel electrophoresis profile was performed, targeting the 16S rRNA gene of Eubacteria and Archaea, with the DNA samples extracted at 3 different time points from the test groups. A phylogenetic tree was constructed for the sequences using the neighborhood joining method. The analysis revealed that the presence of organisms resembling Syntrophomonadaceae could have contributed to increased production of acetic and propionic acid intermediates while decrease of organisms resembling Pelotomaculum sp. could have most likely contributed to accumulation of propionic acid. This study suggested that the degradation of organic components within the high strength industrial wastewater is closely linked with the activity of certain niche microbial communities within eubacteria and methanogens.     

固相萃取-高效液相色谱法测定水中丙烯酰胺研究

采用固相萃取-高效液相色谱法对水中的丙烯酰胺定性、定量分析。结果显示:丙烯酰胺含量在20μg/L~400μg/L之间呈良好线性关系,回归方程Y=0.476 8X+0.845 4,相关系数R为0.997 72,检出限0.1μg/L,样品回收率在71.85%~92.28%之间,相对标准偏差为3.4%~10.9%。该方法减少了有机溶剂用量,缩短了有机溶剂暴露时间,降低污染,且能满足地表水环境质量标准(GB 3838-2002)限值要求,是水中丙烯酰胺含量准确稳定的检测方法。用该方法测定了呼和浩特市引黄入呼左岸、右岸、中浅和中深4个断面水样,均未检出丙烯酰胺。     

宜昌市三级监测站标准化建设现状分析及对策研究

标准化站建设是提升环境监测站能力水平的重要途径和抓手,为促进宜昌市三级站的整体达标验收,该研究分析了辖区三级监测站标准化建设存在的主要共性问题为：在岗人员数量少和人才流失严重、经费保障和监测用房面积不足、监测项目偏少、管理体系不健全,并结合实际提出了加强人才队伍建设、拓宽监测经费来源、提高监测分析能力和强化质量管理等对策建议.     

呼和浩特城区冬季近地面挥发性有机物污染特征初步研究

挥发性有机物(VOCs)是环境空气监测的主要目标污染物。本文运用罐采样-三级冷阱预浓缩-中心切割-气相色谱(FID)/气质联用法对人群主要活动的近地面不同高度、不同时间段及不同区域的呼和浩特冬季大气环境中挥发性有机物进行定性定量分析。发现典型天气情况下,呼和浩特城区冬季近地面挥发性有机物组分中烷烃和芳香烃占比较高,城区西侧所监测点位挥发性有机物总量(TVOCs)浓度高于其他区域,且其浓度在高度和时段上存在明显差异。     

Diffusive gradients in thin films using molecularly imprinted polymer binding gels for in situ measurements of antibiotics in urban wastewaters

• Selective molecularly imprinted polymer (MIP) binding gel was prepared. • MIP-DGT showed excellent uptake performance for antibiotics. • In situ measurement of antibiotics in wastewaters via MIP-DGT was developed. • The MIP-DGT method was robust, reliable, and highly sensitive. Urban wastewater is one of main sources for the introduction of antibiotics into the environment. Monitoring the concentrations of antibiotics in wastewater is necessary for estimating the amount of antibiotics discharged into the environment through urban wastewater treatment systems. In this study, we report a novel diffusive gradient in thin films (DGT) method based on molecularly imprinted polymers (MIPs) for in situ measurement of two typical antibiotics, fluoroquinolones (FQs) and sulfonamides (SAs) in urban wastewater. MIPs show specific adsorption toward their templates and their structural analogs, resulting in the selective uptake of the two target antibiotics during MIP-DGT deployment. The uptake performance of the MIP-DGTs was evaluated in the laboratory and was relatively independent of solution pH (4.0–9.0), ionic strength (1–750 mmol/L), and dissolved organic matter (DOM, 0–20 mg/L). MIP-DGT samplers were tested in the effluent of an urban wastewater treatment plant for field trials, where three SA (sulfamethoxazole, sulfapyridine, and trimethoprim) and one FQ (ofloxacin) antibiotics were detected, with concentrations ranging from 25.50 to 117.58 ng/L, which are consistent with the results measured by grab sampling. The total removal efficiency of the antibiotics was 80.1% by the treatment plant. This study demonstrates that MIP-DGT is an effective tool for in situ monitoring of trace antibiotics in complex urban wastewaters.     

Magnetic nanoparticles incorporation into different substrates for dyes and heavy metals removal—A Review

Environmental Science and Pollution Research - Substantial discharge of hazardous substances, especially dyes and heavy metal ions to the environment, has become a global concern due to...