Environmental lead pollution threatens the children living in the Pearl River Delta region, China

Introduction and purpose

The objective of this study is to determine children??s blood lead levels and identify sources of lead exposure. Childhood lead exposure constitutes a major pediatric health problem today in China. A blood lead screening survey program for children in the age group of 2?C12?years residing in Pearl River Delta region, south of China, was carried out from Dec 2007 to Jan 2008.

Methods

Blood lead levels and lead isotope ratios of a total of 761 participants were assessed by inductively coupled plasma mass spectroscopy. Measurements of urban environmental samples for source identification of children lead exposure were also performed.

Results and conclusions

The geometric mean value of the children??s blood lead levels was 57.05???g/L, and 9.6% of them were higher than 100???g/L. The blood lead levels were still much higher than those in developed countries. Based on the data of environmental lead source inventories, lead isotopic tracing revealed that there is about 6.7% past used gasoline Pb embedded in Shenzhen residential dust and about 15.6% in Guangzhou dust, respectively.     

改性多壁碳纳米管对水中Cd~（2＋）的去除

为了增加多壁碳纳米管（multiwall carbon nanotubers,MWNTs）对水中Cd2＋的吸附量,使用混酸对多壁碳纳米管进行氧化处理,采用红外光谱进行结果表征,并探讨了吸附时间、pH值和MWNTs的使用量、Cd2＋的浓度及干扰离子对镉离子吸附的影响。结果表明,吸附时间为1.5 h、pH为5.3、吸附效果最佳,随MWNTs量的增加Cd2＋去除量增加,共存的阳离子会降低对Cd2＋的吸附效果,对Cd2＋的吸附符合Longmuir吸附定律。研究同时表明,pH小于2时Cd2＋能容易从碳纳米管上解吸。初步探讨了Cd2＋吸附机制。     

Determination of partition and diffusion coefficients of formaldehyde in selected building materials and impact of relative humidity

The partition and effective diffusion coefficients of formaldehyde were measured for three materials (conventional gypsum wallboard, "green" gypsum wallboard, and "green" carpet) under three relative humidity (RH) conditions (20%, 50%, and 70% RH). The "green" materials contained recycled materials and were friendly to environment. A dynamic dual-chamber test method was used. Results showed that a higher relative humidity led to a larger effective diffusion coefficient for two kinds of wallboards and carpet. The carpet was also found to be very permeable resulting in an effective diffusion coefficient at the same order of magnitude with the formaldehyde diffusion coefficient in air. The partition coefficient (K(ma)) of formaldehyde in conventional wallboard was 1.52 times larger at 50% RH than at 20% RH, whereas it decreased slightly from 50% to 70% RH, presumably due to the combined effects of water solubility of formaldehyde and micro-pore blocking by condensed moisture at the high RH level. The partition coefficient of formaldehyde increased slightly with the increase of relative humidity in "green" wallboard and "green" carpet. At the same relative humidity level, the "green" wallboard had larger partition coefficient and effective diffusion coefficient than the conventional wallboard, presumably due to the micro-pore structure differences between the two materials. The data generated could be used to assess the sorption effects of formaldehyde on building materials and to evaluate its impact on the formaldehyde concentration in buildings.     

Effects of nano-copper(II) oxide and nanomagnesium oxide particles on activated sludge

Effects of nano-copper(II) oxide (nano-CuO) and nanomagnesium oxide (nano-MgO) particles on activated sludge endogenous respiration (aerobic digestion), biochemical oxygen demand (BOD) biodegradation, and nitrification were investigated through respiration rate measurement. For comparison, the effects of Cu(II) and Mg(II) ions on activated sludge were also studied. Results indicated that soluble Cu(II) has half maximum inhibitory concentration (IC50) values of 19, 5.5, 53, and 117 mg Cu/L for endogenous respiration, BOD biodegradation, ammonium oxidation, and nitrite oxidation, respectively. However, nano-CuO only inhibited BOD biodegradation at 240 mg Cu/L or more, and its associated toxicity was primarily caused by soluble Cu(II). In contrast, soluble Mg(II) was not toxic to activated sludge in the experimental concentration range, but nano-MgO inhibited BOD biodegradation and nitrification with IC50 values of 70 and 143 mg Mg/L, respectively. Further study indicated that the toxicity of nano-MgO resulted primarily from increased pH following MgO hydrolysis.     

超声波促进城市生活污泥缺氧/好氧消化的研究

本研究将超声波预处理引入城市生活污泥缺氧/好氧消化工艺中,自主设计了容积为30 L的生活污泥超声波-缺氧/好氧消化中试系统并用以实验研究。超声波预处理的参数为超声频率28 kHz,声能密度0.15 W/mL,超声时间10 min,超声间隔12 h,污泥超声比例30%。结果表明,引入超声预处理后,缩短了污泥的稳定时间,提高了污泥的消化效率。污泥消化10 d就已经达到了稳定标准,比未引入超声预处理时缩短了12 d,而MLVSS最大去除率提高了11%,达到了55.10%。超声波的引入,对污泥缺氧/好氧消化系统中污泥上清液溶解性COD（SCOD）的变化趋势影响比较明显,而对上清液的pH、氨氮和TP的变化趋势没有明显影响。     

铁炭微电解工艺处理采油废水的研究

随着采油废水产生量的逐渐增大以及排放标准的日益严格,寻找一种经济、高效的处理方法显得十分必要。采用铁炭微电解技术对冀东油田采油废水进行了处理。考察了铁屑粒径、pH值、Fe/C质量比和反应时间对COD去除率的影响并设计了正交实验,结果表明,影响微电解工艺的因素主次关系为:pH>Fe/C质量比>反应时间,在最佳条件pH=5,Fe/C质量比为7∶1,反应时间50 min下,原水COD由170 mg/L降至95.6 mg/L,去除率达43.85%,出水满足国家二级排放标准。     

西安市城市主干道路面径流初期冲刷效应

以西安市城市主干道南二环太白路高架桥为路面径流采样区域,采用人工等时间间隔采样方法,在桥梁排水立管对2010年9—11月的3场径流事件进行全程采样,测试径流过程SS、COD、溶解性COD、NH3-N、Pb、溶解性Pb、Zn和溶解性Zn的浓度变化,研究路面径流的初期冲刷效应及其影响因素。结果表明,西安市城市主干道路面径流污染严重,降雨数小时后的末期径流仍具有较高的污染水平;径流过程污染物浓度变化规律与其赋存形态有关,SS、COD、Pb等以颗粒态为主的污染物的浓度随雨强变化剧烈波动,NH3-N、溶解态COD、溶解态Zn等以溶解态为主的污染物浓度变化受雨强影响较小,随径流过程呈逐渐减小趋势;路面径流初期冲刷现象并非普遍存在,与污染物的赋存状态和场次降雨特征密切相关,溶解态污染物易于出现初期冲刷现象,颗粒态污染物是否出现初期冲刷与场次降雨特征有关;测试的3场径流事件初期30%的径流携带的SS、COD、溶解性COD、NH3-N、Pb、Zn和溶解性Zn的负荷占场次径流总负荷的比例分别为21.8%～50.0%、25.5%～49.3%、36.3%～52.6%、52.6%～66.7%、26.8%～45.0%、27.2%～63.4%和36.2%～62.6%,表明仅对初期径流进行治理无法实现对西安市路面径流污染的有效控制。     

原位臭氧氧化污泥减量工艺的运行效能

采用ASBR/SBR原位臭氧污泥减量工艺,重点研究了原位臭氧氧化对SBR段污泥产率和出水水质的影响。两个相同的ASBR/SBR组合工艺同时运行,每隔3个周期向臭氧投加组SBR的曝气阶段原位间歇投加臭氧,臭氧投加量为0.027 g O3/g MLSS,连续运行40 d;对照组不投加臭氧作为对比。结果表明,原位臭氧氧化实现污泥减量约43.9%,臭氧投加组SBR段平均污泥产率系数为0.1447 g SS/g SCOD,而对照组为0.2580 g SS/g SCOD,投加组没有惰性污泥的累积,并且污泥沉淀性能得到改善。原位臭氧氧化对出水水质影响不大,投加组与对照组相比,臭氧投加3周期后的出水COD、NH4+-N、TN和TP平均值分别为47.8、0.76、14.1和6.4 mg/L,去除率分别下降了4%、2%、3%和7.7%,其中COD、NH4+-N和TN均能达到《城镇污水处理厂污染物排放标准》(GB18918-2002)一级A标准。     

沸石渗滤床在城市初期雨水径流污染控制的应用研究

根据城市初期雨水径流的污染负荷初始冲刷效应以及主要污染物COD和N/P与SS成线性相关性的污染特点,对初期雨水的主要污染物COD和N/P开展了控制技术研究。以示范工程为基础,研究城市初期雨水径流污染控制的强化处理技术即沸石渗滤床技术,运行结果表明,对NH3-N、TP、COD都有较好的去除效果,其中对NH3-N的去除效果较为明显,进水氨氮浓度在2～5 mg/L,出水都能达到地表IV类水标准(NH3-N≤0.5 mg/L)。     

阴极液及底物浓度对AFB-MFC同步废水处理及产电性能影响

为了提高厌氧流化床微生物燃料电池（AFB-MFC）的性能,并为双室MFC寻找价廉、易得、无污染的阴极液,在曝气量16～24 L/h、温度（35±2）℃、回流量10.2 L/h、阴极底边距阴极室内底部17.3 cm、外电阻250 Ω、水力停留时间（HRT）14.0～14.9 h以及进水pH 7.81～8.37下,研究了阴极液及底物浓度对系统产电及废水处理性能的影响。结果表明,使用缓冲溶液、阳极室出水和自来水作阴极液时,自来水的产电性能最佳,阴极液种类不影响系统有机基质的去除。以自来水为阴极液时,阴极液pH及电导率随运行时间增加而增加,COD去除率为80.11%～89.29%,输出电压及功率密度开始随运行时间增加而增加,之后稳定在440～452 mV和48.40～51.08 mW/m²之间。增加底物浓度对COD去除率影响不大,而输出电压及功率密度随底物浓度增加而下降;底物COD浓度由3 307.09 mg/L增至9 520 mg/L时,COD去除率在85.77%～94.44%之间,输出电压及功率密度则分别由449 mV和50.40 mW/m²下降至406 mV和41.21 mW/m²。自来水作阴极液可避免二次污染及阴极液对阳极室微生物的影响,并得到高的产电能力。