Combined Municipal Solid Waste and biomass system optimization for district energy applications

Municipal Solid Waste (MSW) disposal has been a controversial issue in many countries over the past years, due to disagreement among the various stakeholders on the waste management policies and technologies to be adopted. One of the ways of treating/disposing MSW is energy recovery, as waste is considered to contain a considerable amount of bio-waste and therefore can lead to renewable energy production. The overall efficiency can be very high in the cases of co-generation or tri-generation. In this paper a model is presented, aiming to support decision makers in issues relating to Municipal Solid Waste energy recovery. The idea of using more fuel sources, including MSW and agricultural residue biomass that may exist in a rural area, is explored. The model aims at optimizing the system specifications, such as the capacity of the base-load Waste-to-Energy facility, the capacity of the peak-load biomass boiler and the location of the facility. Furthermore, it defines the quantity of each potential fuel source that should be used annually, in order to maximize the financial yield of the investment. The results of an energy tri-generation case study application at a rural area of Greece, using mixed MSW and biomass, indicate positive financial yield of investment. In addition, a sensitivity analysis is performed on the effect of the most important parameters of the model on the optimum solution, pinpointing the parameters of interest rate, investment cost and heating oil price, as those requiring the attention of the decision makers. Finally, the sensitivity analysis is enhanced by a stochastic analysis to determine the effect of the volatility of parameters on the robustness of the model and the solution obtained.     

Application of activated M/ZnO (M = Mn,Co, Ni,Cu, Ag) in photocatalytic degradation of diazo textile coloring dye

Activated ZnO powder has been prepared by procedures involving first its dissolution in nitric acid, then simultaneous treatment by adding NH₄OH and CO₂ bubbling leading to precipitation as Zn(OH)CO₃ (ZH) and further thermal decomposition of ZH at 400 °C. The gas evolution leads to formation of pores and increase in the specific surface area. Chemically activated M/ZnO powders doped with Mn, Co, Ni, Cu, and Ag have been obtained by the impregnation method. The samples have been characterized by ultraviolet-visible (UV-Vis) spectroscopy, diffuse reflectance (DR) UV-Vis, X-ray diffraction (XRD), single point Brunauer–Emmet–Teller (BET), scanning electron microscope (SEM), and X-ray photoelectron spectroscopy (XPS) methods. The experiments have shown that metal-doped activated ZnO powders possess higher photocatalytic activities in oxidative discoloration of model contaminant textile coloring dye Reactive Black 5 in slurry reactor compared to that of the pure ZnO. The XRD and XPS data have shown the presence of defects, nonstoichiometricity implying the formation of solid solutions. Copper-doped (1.5 wt%) activated ZnO (Cu²⁺ replaces Zn²⁺) is outstanding in its photocatalytic performance in discoloration of the dye due to the higher specific surface area and improved charge carrier separation.     

Rainwater toxicity and contamination study from São Paulo Metropolitan Region, Brazil

Wet deposition is an important process that removes pollutants from the atmosphere and transfers them to waters and soil. The goal of this study was to assess the biological effects of the atmospheric contamination of rainwater in the metropolitan area of São Paulo (MASP) using Daphnia similis, Ceriodaphnia dubia, and Vibrio fischeri. Experimental assays were carried out according to standard toxicity methodology. Twenty-three rainwater samples were collected from October 2007 to December 2008, at the Nuclear Research Institute (IPEN), in MASP. Major ions were determined by ionic chromatography, which showed NH₄ ⁺ and NO₃ ^? as prevalent ions. Ecotoxicological results confirmed toxic potential of rainwater, as all samples were toxic to D. similis and C. dubia. The V. fischeri luminescence reduction confirmed those negative effects of rainwater and percentage inhibition of relative luminescence ranged from 0.2 to 0.9 for 16 samples. Worse conditions were observed during the rainy season, suggesting convective rains are more effective in transferring contaminants and toxicity from atmosphere to surface.     

Vocal Activity as a Low Cost and Scalable Index of Seabird Colony Size

Although wildlife conservation actions have increased globally in number and complexity, the lack of scalable, cost‐effective monitoring methods limits adaptive management and the evaluation of conservation efficacy. Automated sensors and computer‐aided analyses provide a scalable and increasingly cost‐effective tool for conservation monitoring. A key assumption of automated acoustic monitoring of birds is that measures of acoustic activity at colony sites are correlated with the relative abundance of nesting birds. We tested this assumption for nesting Forster's terns (Sterna forsteri) in San Francisco Bay for 2 breeding seasons. Sensors recorded ambient sound at 7 colonies that had 15–111 nests in 2009 and 2010. Colonies were spaced at least 250 m apart and ranged from 36 to 2,571 m². We used spectrogram cross‐correlation to automate the detection of tern calls from recordings. We calculated mean seasonal call rate and compared it with mean active nest count at each colony. Acoustic activity explained 71% of the variation in nest abundance between breeding sites and 88% of the change in colony size between years. These results validate a primary assumption of acoustic indices; that is, for terns, acoustic activity is correlated to relative abundance, a fundamental step toward designing rigorous and scalable acoustic monitoring programs to measure the effectiveness of conservation actions for colonial birds and other acoustically active wildlife. La Actividad Vocal como un Índice Escalable y de Bajo Costo del Tamaño de Colonia de las Aves Marinas     

Implications of different population model structures for management of threatened plants

Population viability analysis (PVA) is a reliable tool for ranking management options for a range of species despite parameter uncertainty. No one has yet investigated whether this holds true for model uncertainty for species with complex life histories and for responses to multiple threats. We tested whether a range of model structures yielded similar rankings of management and threat scenarios for 2 plant species with complex postfire responses. We examined 2 contrasting species from different plant functional types: an obligate seeding shrub and a facultative resprouting shrub. We exposed each to altered fire regimes and an additional, species‐specific threat. Long‐term demographic data sets were used to construct an individual‐based model (IBM), a complex stage‐based model, and a simple matrix model that subsumes all life stages into 2 or 3 stages. Agreement across models was good under some scenarios and poor under others. Results from the simple and complex matrix models were more similar to each other than to the IBM. Results were robust across models when dominant threats are considered but were less so for smaller effects. Robustness also broke down as the scenarios deviated from baseline conditions, likely the result of a number of factors related to the complexity of the species’ life history and how it was represented in a model. Although PVA can be an invaluable tool for integrating data and understanding species’ responses to threats and management strategies, this is best achieved in the context of decision support for adaptive management alongside multiple lines of evidence and expert critique of model construction and output.     

Leaching behaviour of different scrap materials at recovery and recycling companies: Full-, pilot- and lab-scale investigation

Scrap material recovery and recycling companies are confronted with waste water that has a highly fluctuating flow rate and composition. Common pollutants, such as COD, nutrients and suspended solids, potentially toxic metals, polyaromatic hydrocarbons and poly chlorinated biphenyls can exceed the discharge limits. An analysis of the leaching behaviour of different scrap materials and scrap yard sweepings was performed at full-scale, pilot-scale and lab-scale in order to find possible preventive solutions for this waste water problem. The results of these leaching tests (with concentrations that frequently exceeded the Flemish discharge limits) showed the importance of regular sweeping campaigns at the company, leak proof or covered storage of specific scrap materials and oil/water separation on particular leachates. The particulate versus dissolved fraction was also studied for the pollutants. For example, up to 98% of the polyaromatic hydrocarbons, poly chlorinated biphenyls and some metals were in the particulate form. This confirms the (potential) applicability of sedimentation and filtration techniques for the treatment of the majority of the leachates, and as such the rainwater run-off as a whole.     

The city as a refuge for insect pollinators

Research on urban insect pollinators is changing views on the biological value and ecological importance of cities. The abundance and diversity of native bee species in urban landscapes that are absent in nearby rural lands evidence the biological value and ecological importance of cities and have implications for biodiversity conservation. Lagging behind this revised image of the city are urban conservation programs that historically have invested in education and outreach rather than programs designed to achieve high‐priority species conservation results. We synthesized research on urban bee species diversity and abundance to determine how urban conservation could be repositioned to better align with new views on the ecological importance of urban landscapes. Due to insect pollinators’ relatively small functional requirements—habitat range, life cycle, and nesting behavior—relative to larger mammals, we argue that pollinators put high‐priority and high‐impact urban conservation within reach. In a rapidly urbanizing world, transforming how environmental managers view the city can improve citizen engagement and contribute to the development of more sustainable urbanization.     

Geochemical fractionation of metals and metalloids in tailings and appraisal of environmental pollution in the abandoned Musina Copper Mine,South Africa

The economic benefits of mining industry have often overshadowed the serious challenges posed to the environments through huge volume of tailings generated and disposed in tailings dumps. Some of these challenges include the surface and groundwater contamination, dust, and inability to utilize the land for developmental purposes. The abandoned copper mine tailings in Musina (Limpopo province, South Africa) was investigated for particle size distribution, mineralogy, physicochemical properties using arrays of granulometric, X-ray diffraction, and X-ray fluorescence analyses. A modified Community Bureau of Reference (BCR) sequential chemical extraction method followed by inductively coupled plasma mass spectrometry/atomic emission spectrometry (ICP-MS/AES) technique was employed to assess bioavailability of metals. Principal component analysis was performed on the sequential extraction data to reveal different loadings and mobilities of metals in samples collected at various depths. The pH ranged between 7.5 and 8.5 (average?≈?8.0) indicating alkaline medium. Samples composed mostly of poorly grated sands (i.e. 50% fine sand) with an average permeability of about 387.6 m/s. Samples have SiO₂/Al₂O₃ and Na₂O/(Al₂O₃?+?SiO₂) ratios and low plastic index (i.e. PI?≈?2.79) suggesting non-plastic and very low dry strength. Major minerals were comprised of quartz, epidote, and chlorite while the order of relative abundance of minerals in minor quantities is plagioclase?>?muscovite?>?hornblende?>?calcite?>?haematite. The largest percentage of elements such as As, Cd and Cr was strongly bound to less extractable fractions. Results showed high concentration and easily extractable Cu in the Musina Copper Mine tailings, which indicates bioavailability and poses environmental risk and potential health risk of human exposure. Principal component analysis revealed Fe-oxide/hydroxides, carbonate and clay components, and copper ore process are controlling the elements distribution.     

Using empirical models of species colonization under multiple threatening processes to identify complementary threat‐mitigation strategies

Approaches to prioritize conservation actions are gaining popularity. However, limited empirical evidence exists on which species might benefit most from threat mitigation and on what combination of threats, if mitigated simultaneously, would result in the best outcomes for biodiversity. We devised a way to prioritize threat mitigation at a regional scale with empirical evidence based on predicted changes to population dynamics—information that is lacking in most threat‐management prioritization frameworks that rely on expert elicitation. We used dynamic occupancy models to investigate the effects of multiple threats (tree cover, grazing, and presence of an hyperaggressive competitor, the Noisy Miner (Manorina melanocephala) on bird‐population dynamics in an endangered woodland community in southeastern Australia. The 3 threatening processes had different effects on different species. We used predicted patch‐colonization probabilities to estimate the benefit to each species of removing one or more threats. We then determined the complementary set of threat‐mitigation strategies that maximized colonization of all species while ensuring that redundant actions with little benefit were avoided. The single action that resulted in the highest colonization was increasing tree cover, which increased patch colonization by 5% and 11% on average across all species and for declining species, respectively. Combining Noisy Miner control with increasing tree cover increased species colonization by 10% and 19% on average for all species and for declining species respectively, and was a higher priority than changing grazing regimes. Guidance for prioritizing threat mitigation is critical in the face of cumulative threatening processes. By incorporating population dynamics in prioritization of threat management, our approach helps ensure funding is not wasted on ineffective management programs that target the wrong threats or species.     

Bacterial toxicity testing and antibacterial activity of parabens

Parabens are used because of their antimicrobial effects, yet they have multiple adverse effects. The aim of this work was to evaluate the bactericidal activity and bacterial toxicity of the most common parabens: methylparaben, ethylparaben, propylparaben, isopropylparaben, butylparaben, isobutylparaben and phenylparaben. The bactericidal action was evaluated by means of the dilution-neutralization method against Escherichia coli and Staphylococcus aureus, and the biotest of inhibition of growth of E. coli was applied for the bacterial toxicity assay. Bactericidal concentrations were reached only for propylparaben, butylparaben and isobutylparaben. The toxicity study showed methylparaben to be the least toxic, whereas the most toxic one was phenylparaben. It can be concluded that the disinfectant activity of the parabens studied is insignificant against S. aureus and E. coli. Acute toxicity is very low, and the inhibitory effect is weak. Our results provide information about the risk–benefit balance of parabens use.