Occupational Exposure to Polycyclic Aromatic Hydrocarbons During Diesel Combustion

Identification and determination of polycyclic aromatic hydrocarbons (PAHs) in Diesel exhaust in the working environment and assessment of workers’ occupational exposure to these suspected human carcinogens were the aim of this experimental investigation.

The range of exposure factors calculated on the basis of 9 individual PAH concentrations determined in personal air samples shows that time-averaged concentration of these compounds did not exceed the Polish Maximum Admissible Concentration (MAC) value for PAHs, that is, 2 μg·m^–3. The highest concentrations of PAHs were determined in the breathing zone of forklift operators. The maximum exposure factor was 0.427 μg·m^–3 (about 1/4 of MAC).     

PAH mass concentrations measured in PM10 particle fraction

This paper presents daily, monthly and yearly variations of PAH mass concentrations measured in PM(10) particle fraction, collected at one measuring site in Zagreb air between 2001 and 2004, and seasonal differences in PAH mass concentrations in PM(10) samples collected from 21 March 2003 to 20 March 2004. Twenty-four hour samples were taken in the northern residential part of Zagreb using a low-volume (50 m(3)) sampler and glass or quartz filters. The analysis was performed using a high-performance liquid chromatograph (HPLC) and fluorescence detector with changeable excitation and emission wavelength. The annual average mass concentrations over the four-year measuring period for BaP ranged from 1.17 ng/m(3) in 2004 to 1.87 ng/m(3) in 2003 and were below the limit value (2 ng/m(3)) set by the Ordinance on Recommended and Limit Air Quality Values in Croatia. The highest concentrations of all PAHs measured in PM(10) samples collected from 21 March 2003 to 20 March 2004 were found in the winter and the lowest in the summer. Winter average of BaP was 2.94 ng/m(3) and summer average 0.12 ng/m(3). Autumn average was 2.76 ng/m(3) and was very similar to winter concentrations. Spring average of 0.58 ng/m(3) was higher than the summer average (0.12 ng/m(3)). Mass concentrations of all measured PAHs were much higher in the autumn than in the spring. Although annual averages for BaP did not exceed the limit value, autumn and winter BaP mass concentrations did, which calls for measures for reducing PAH emissions in the autumn and winter.     

垃圾渗沥液中氨氮的电化学氧化

针对目前国内外垃圾渗沥液处理中存在的问题,采用电化学氧化与上流式厌氧污泥床（UASB）相结合,研究建立了对香港垃圾渗沥液的二步法处理工艺．本文着重探讨了电化学间接氧化去除渗沥液中氨氮的反应机制及主要影响因素,并通过实验找出了最佳的操作条件：入水初始 pH值为9.0;流速为0.01－0.10cm/s;CI加入量2000mg/L;电流密度 32.3mA/cm²．在此条件下,经过 6h电解后,UASB反应器出水中NH_－N和COD的去除率分别达到100％和87％．对该电化学氧化过程的运行成本进行了评估．     

Global burned-land estimation in Latin America using MODIS composite data.

This paper presents results of the AQL2004 project, which has been develope within the GOFC-GOLD Latin American network of remote sensing and forest fires (RedLatif). The project intended to obtain monthly burned-land maps of the entire region, from Mexico to Patagonia, using MODIS (moderate-resolution imaging spectroradiometer) reflectance data. The project has been organized in three different phases: acquisition and preprocessing of satellite data; discrimination of burned pixels; and validation of results. In the first phase, input data consisting of 32-day composites of MODIS 500-m reflectance data generated by the Global Land Cover Facility (GLCF) of the University of Maryland (College Park, Maryland, U.S.A.) were collected and processed. The discrimination of burned areas was addressed in two steps: searching for "burned core" pixels using postfire spectral indices and multitemporal change detection and mapping of burned scars using contextual techniques. The validation phase was based on visual analysis of Landsat and CBERS (China-Brazil Earth Resources Satellite) images. Validation of the burned-land category showed an agreement ranging from 30% to 60%, depending on the ecosystem and vegetation species present. The total burned area for the entire year was estimated to be 153 215 km2. The most affected countries in relation to their territory were Cuba, Colombia, Bolivia, and Venezuela. Burned areas were found in most land covers; herbaceous vegetation (savannas and grasslands) presented the highest proportions of burned area, while perennial forest had the lowest proportions. The importance of croplands in the total burned area should be taken with reserve, since this cover presented the highest commission errors. The importance of generating systematic products of burned land areas for different ecological processes is emphasized.     

Using Ion-Exchange Resins to Study Soil Response to Experimental Watershed Acidification

Ion-exchange resins (IER) offer alternative approaches to measuring ionic movement in soils that may have advantages over traditional approaches in some settings, but more information is needed to understand how IER compare with traditional methods of measurement in forested ecosystems. At the Bear Brook Watershed in Maine (BBWM), one of two paired, forested watersheds is treated bi-monthly with S and N (28.8 and 25.2kgha⁻¹yr⁻¹ of S and N, respectively). Both IER and ceramic cup tension lysimeters were used to study soil solution responses after ∼11 years of treatment. Results from both methods showed treatments resulted in the mobilization of base cations and Al, and higher SO₄—S and inorganic N in the treated watershed. Both methods indicated similar differences in results associated with forest type (hardwoods versus softwoods), a result of differences in litter quality and atmospheric aerosol interception capacity. The correlation between lysimeter and IER data for individual analytes varied greatly. Significant correlations were evident for Na (r=0.75), Al (r=0.65), Mn (r=0.61), Fe (r=0.57), Ca (r=0.49), K (r=0.41) and NO₃—N (r=0.59). No correlation was evident between IER and soil solution data for NH₄—N and Pb. Both IER and soil solution techniques suggested similar interpretations of biogeochemical behavior in the watershed.     

Influence of community-based natural resource management strategies in the resilience of social-ecological systems

Different social-ecological systems around the world are managed under community-based natural resource management (CBNRM) strategies. This paper analyses how CBNRM strategies influence the resilience of social-ecological systems to the disturbances they face, drawing upon the experience of three Latin American cases (two in Mexico and one in Colombia). The cases differ in their CBNRM approach and in the time these governance systems have been in place. By using a mixed-method approach, we review the socio-ecological history and describe each CBNRM characteristics. We then assess their resilience to socioeconomic and environmental disturbances through a set of indicators. We found that CBNRM strategies influence positively and negatively resilience and that internal decisions might address important threats. On the positive side, the social-ecological systems with longer tradition of CBNRM and more local buy-in of commonly agreed objectives appear to be more resilient to environmental challenges. But, internal governance factors such as power imbalances, poor income distribution, and gender inequities linked to CBNRM undermine resilience and foster out migration. Finally, communities appear to have limited capacities to cope with external disturbances such as global drivers of change or national policies that negatively affect their social-ecological resilience.

     

Correction to: Influence of community-based natural resource management strategies in the resilience of social-ecological systems

Regional Environmental Change - The published online version contains mistake. Author name was incorrectly captured. Instead of Maria del Mar Delgado-Serrano was incorrectly captured as Ma del Mar...     

Illicit drugs in wastewater of the city of Zagreb (Croatia) - Estimation of drug abuse in a transition country

A comprehensive study of various psychoactive substances and their metabolites was performed in the wastewater treatment plant of the city of Zagreb (780 000 inhabitants) using liquid chromatography/tandem mass spectrometry (LC-MS-MS). The estimation of drug abuse for five different illicit drugs, including heroin, cocaine, marijuana, amphetamine and ecstasy, was made on the basis of their representative excretion rates, which were determined over a period of 8 months. Marijuana (1000 kg/year), heroin (75 kg/year) and cocaine (47 kg/year) were found to be the most frequently consumed illicit drugs, while the consumption of amphetamine-type drugs was much lower (1-3 kg/year). A comparison with other reports indicated that drug abuse profiles in transition countries might be different from those reported for Western Europe, in particular with respect to the comparatively increased consumption of heroin. Enhanced consumption of stimulating drugs (cocaine and ectasy) was systematically detected during weekends.     

The Properties of Poly(<Emphasis Type="SmallCaps">l</Emphasis>-Lactide) Prepared by Different Synthesis Procedure

Different synthesis methods were applied to determine optimal conditions for polymerization of (3S)-cis-3,6-dimethyl-1,4-dioxane-2,5-dione (l-lactide), in order to obtain poly(l-lactide) (PLLA). Bulk polymerizations (in vacuum sealed vessel, high pressure reactor and in microwave field) were performed with tin(II) 2-ethylhexanoate as the initiator. Synthesis in the vacuum sealed vessel was carried out at the temperature of 150 °C. To reduce the reaction time second polymerization process was carried out in the high pressure reactor at 100 °C and at the pressure of 138 kPa. The third type of rapid synthesis was done in the microwave reactor at 100 °C, using frequency of 2.45 GHz and power of 150 W at the temperature of 100 °C. The temperature in this method was controlled via infrared system for in-bulk measuring. The solution polymerization (with trifluoromethanesulfonic acid as initiator) was possible even at the temperature of 40 °C, yielding PLLA with narrow molecular weight distribution in a very short period of time (less than 6 h). The obtained polymers had the number-average molecular weights ranging from 43,000 to 178,000 g mol⁻¹ (polydispersity index ranging from 1 to 3) according to the gel permeation chromatography measurements. The polymer structure was characterized by Fourier transform infrared and NMR spectroscopy. Thermal properties of the obtained polymers were investigated using thermogravimetry and differential scanning calorimetry.