滑坡体三维构造及稳定性分析

采用体元技术建立滑坡体真三维模型,通过基本三棱柱体构建具有复杂曲面结构的空间组合体,每个单元都赋予不同的属性,为滑坡体三维稳定性分析提供基本的前、后处理功能.以此为基础,并结合三维极限平衡分析计算方法,开发了相关的滑坡三维模拟与稳定性分析软件,并成功应用于清江库岸大型滑坡的三维仿真计算.     

Impact of anions on the heavy metals release from marine sediments

Marine sediments from Lianshan Bay in Huludao, China, were studied in laboratory. A series of simulated experiments were carried out to investigate the influences of three kinds of anions CL^-, SO4^2- and HCO3^- on the release ofCd, Pb, Cu and Zn from the sediments. The results showed that the sequences about the impact of the three anions were Cl^-〉HCO3^-〉SO4^2＋. The release potential of heavy metals in the presence of each anions was in the following order： Cd≥Cu 〉Zn≈Pb. The correlations were positive between CI content and the quantity of Cd released from the marine sediment, whereas there was no significant relationship between CI content and amount of Cu and Zn released. For SO4^2- and HCO3^-, the release of the heavy metals from marine sediments was not obvious.     

Heavy metals associated with reduced sulfur in sediments from different deposition environments in the Pearl River estuary, China

Distribution of acid volatile sulfur (AVS) and the simultaneously extracted metals (SEM: Cu, Pb, Zn, Cd, Ni) in sediment profiles has been studied at five sites in Pearl River estuary, China. Of the five sampling locations, Nos.1 and 2 are in the middle shoal, Nos.3 and 4 in the west shoal and No. 5 locates to the south of the estuary. The AVS content in the sediments of the middle shoal varies in a small range (0.25–4.06 μmol g⁻¹), while that of west shoal increases with depth from 0 to ultimately 26.09 μmol g⁻¹. The SEM concentration in the sediment profiles at location Nos. 1, 2 and 5 is generally in the range of 0.95±0.2 μmol g⁻¹ with a slight upward increase, while that in the sediment of west shallows are much higher (1.43–2.42 μmol g⁻¹) with a significant upward increase, especially in the upper layer of ca. 15 cm. The observed upward increase of SEM content at all the sites implies that heavy metal contamination of sediment in the Pearl River estuary is increasing. Calculations of the excess heavy metal content which is defined by SEM-AVS molar difference suggests that the upper sediment in the Pearl River estuary, especially on the west shallows, could be a source of heavy metal contaminants and may cause toxicity to the benthos. The site-specific distribution patterns in the AVS and SEM profiles were interpreted according to the hydrogeochemistry of deposition environments.     

Role of surface functionality in the adsorption of anionic dyes on modified polymeric sorbents

While synthetic polymeric sorbents effectively treat dye wastewaters by adsorption, the underlying mechanisms remain to be understood. This work determined the adsorption of an anionic dye by three polymers differing significantly in surface functionality. Surface functional groups of polymers were indicated in FTIR spectra and quantified by the Boehm titration. In reference to the commercial sorbent XAD-4 with a low degree of functionality, the laboratory synthesized NG-8 had primarily acidic functional groups, whereas its aminated product MN-8 had mainly basic amino groups. Electrophoresis determined the points of zero charge of 4.18, 3.23, and 4.51 for XAD-4, NG-8, and MN-8, respectively. The adsorption of Reactive Black 5 dye (RB5) by all the sorbents on a unit surface area basis increased with decreasing pH. At the same low pH (4.40), the adsorption by NG-8 was similar to that by XAD-4, indicating little influence of protonated (neutral) surface functional groups. In contrast, the adsorption by NG-8 at pH 6.05 was 75% lower than that by XAD-4, resulting apparently from the strong electrostatic repulsion between RB5 and deprotonated (negative) groups. Amination substantially enhanced RB5 adsorption by eliminating acidic groups and creating a positive charge on the surface of MN-8. The adsorptive enhancement was also achieved in the presence of CaCl2, due presumably to the neutralization of negative surface charge by Ca2+ and the RB5-Ca2+ pairing. These results manifest the important role of surface functionality in the adsorption of dyes by synthetic polymers.     

耕作制度对川中丘陵区冬灌田CH4和N2O排放的影响

采用静态暗箱/气相色谱法连续2 a田间原位测定,研究川中丘陵区冬灌田CH₄和N₂O的排放特征和不同耕作制度对冬灌田CH₄和N₂O排放的影响.结果表明,1a只种1季中稻冬季灌水休闲的冬灌田(PF),在水稻生长期,CH₄平均排放通量为(21.44±1.77)mg·(m²·h)^-1,非水稻生长期为(3.77±0.99)mg·(m²·h)^-1,分别大大低于以前文献报道的在西南其它地方观测值;全年CH₄排放量以水稻生长期CH₄排放量为主,非水稻生长期CH₄排放量仅占全年总排放量的23.2%.冬灌田N₂O排放通量年均值为(0.051±0.008)mg·(m²·h)^-1,且主要集中在水稻生长季,非水稻生长期N₂O排放量仅占全年总排放量的8.1%.在采用水旱轮作制后,冬灌田CH₄排放量大大降低,稻-麦轮作(RW)和稻-油菜轮作(RR)全年CH₄排放量分别为PF的43.8%和40.6%.但冬灌田改为水旱轮作制后,N₂O排放量显著增大,RW和RR的N₂O年排放量分别是PF的3.7倍和4.5倍.综合考虑冬灌田在采用不同耕作制度后排放CH₄和N₂O的全球增温潜势(GWP),无论是短时间尺度还是长时间尺度,采用3种耕作制度全年所排放的CH₄和N₂O所产生的综合GWP都为:PF RW≈RR.在20a、100a和500a时间尺度上,PF分别约是RW和RR的2.6、2.1和1.7倍.冬灌田改为水旱轮作制度后能大大减少CH₄和N₂O所产生的综合GWP.     

A/DAT-IAT生物膜法处理高含盐废水

以含盐量为60 000mg/L(以NaCl计)的模拟工业废水为研究对象,利用A/DAT-IAT生物膜反应器,研究A/DAT-IAT工艺对投加悬浮填料后高含盐废水的处理,并以CODCr、NH4 -N、PO43--P等作为指标评价处理效果.试验结果表明,在总水力停留时间(HRT)为13 h、pH=7,5、25℃条件下,进水ρ(CODCr)、ρ(NH4 -N)和ρ(PO43--P)分别为907.4～1 210.0 mg/L、86.2～99.7 mg/L和3.6～5.1 mg/L.CODCr、NH4 -N和PO43--P的平均去除率分别为73.9%、38.6%和93.5%,平均出水SS为198 mg/L,其中CODCr和PO43--P的去除效果较好.研究表明,A/DAT-IAT生物膜法较其他活性污泥法有了较大的提高.     

二氯异氰脲酸钠和三氯异氰脲酸对棕囊藻细胞去除的研究

研究了二氯异氰脲酸钠和三氯异氰脲酸对球形棕囊藻的灭杀和控制作用,及其投药时间对除藻效果的影响,并比较2种药剂的除藻效果,初步探讨了除藻机理.结果表明,这2种除藻剂可以缓释次氯酸,提高其稳定性,有较长的药效期.当有效氯浓度达到4.5mg/L时,2种药剂均能有效地控制和灭杀球形棕囊藻,具有高效、低毒的优点.有效氯浓度为5.0mg/L,藻细胞去除率在24h可达到90%以上.在等于和大于5.0mg/L有效氯浓度时,三氯异氰脲酸的除藻效果优于二氯异氰脲酸钠,通过对2种药剂除藻率的t检验进一步证实了这一结论.     

中国碳排放的因素分解模型及实证分析:1995-2004

能源消费是碳排放的主要来源。随着中国经济的快速发展,能源消费的急剧增长以及以煤为主的能源结构在短期内很难改变,因此,碳排放不可避免地会出现一定幅度的增加。本文基于碳排放量的基本等式,采用对数平均权重Divisia分解法（Logarithmic mean weight Divisia method,LMD）,建立中国人均碳排放的因素分解模型,定量分析了1995-2004年间,能源结构、能源效率和经济发展等因素的变化对中国人均碳排放的影响,结果显示经济发展对拉动中国人均碳排放的贡献率呈指数增长,而能源效率和能源结构对抑制中国人均碳排放的贡献率都呈倒“U”。这说明能源效率对抑制中国碳排放的作用在减弱,以煤为主的能源结构未发生根本性变化,能源效率和能源结构的抑制作用难以抵销由经济发展拉动的中国碳排放量增长。     

基于FLACS的LNG船舶泄漏爆炸过程数值模拟研究*

为研究大尺寸、全场景下LNG船舶卸货作业过程中的泄漏爆炸风险,构建某LNG接收站及其周边20.5 km2的区域场景模型,采用FLACS软件数值模拟LNG泄漏扩散、气云爆炸的演化过程。结果表明:LNG从卸料臂处以满输速率持续泄漏5 min,最大液池面积17 047 m2,最大汽化速率350 kg/m3,遇点火源发生气云爆炸,爆炸持续时间12 s,产生最高爆炸火球340 m和最大爆炸超压0.25 MPa,形成半径380 m轻伤区、150 m重伤区和60 m死亡区。     

滤料的脉冲清灰效果评价指标的有效性分析

研究分析了袋式除尘器脉冲喷吹清灰效果的相关评价指标的有效性问题。结果表明:同一清灰装置,滤布的压差峰值、最大反向加速度和冲量密度与清灰效果是一致的;不同的清灰装置,冲量密度与清灰效果是一致的,而压差峰值和最大反向加速度与清灰效果则不再一致。因此,同一清灰系统,压差峰值、最大反向加速度及冲量密度均可用于评价其清灰效果,而不同的清灰系统,则只能用冲量密度来评价。