用UDS试验检测黄浦江水质致遗传毒性

本文运用UDS试验来检测黄浦江水质致遗传毒性,结果表明,试验条件是可行的。UDS试验从DNA修复合成的角度来反映受试物的致遗传毒性作用,可作为水质评价的方法之一。     

珍贵油料植物诸葛菜的研究

四川大学植物遗传研究室经过几年的调查研究,发现诸葛菜的农艺性状较好,分枝多、角果多,每果子粒多,千粒重较重,含油量较高,特别是油分品质优异,其营养价值高的脂肪酸如油酸和亚油酸的含量较高,分别为20.32％,和53.17％,其营养价值低的脂肪酸如亚麻酸和芥酸的含量较低,分别为4.76％和0.94％,是油菜优质育种的优异新种源,可以作为油菜远缘杂交育种亲本,并可能选育出优质油料新作物。本文对诸葛菜的开花授粉习性作了观察,对核型特点作了分析,可供育种工作的参考,诸葛菜主产中国。四川大学在国内外首先推荐这种有希望的油料新种源。     

江南Z市农村饮水有机污染物健康风险评估

应用化学法及吹扫捕集、气相色谱-质谱联用仪(GC-MS),检测Z市农村不同类型饮用水与癌症相关的有机污染物,对污染物的剂量与癌症标化死亡率进行Spearman等级相关分析。该市河水、池塘水、浅井水中部分样品的COD_Mn、BOD₅和NH₃-N指标超过地表水环境质量Ⅲ类标准,微生物指标超过生活饮用水卫生标准,检出NH₃-N及NO₃-N、NO₂-N合成致癌物NAD的2类前体物及NDMA等直接致癌物。Z市农村河水、池塘水、浅井水主要受生活排污和农业生产污染,不宜作生活饮用水。不同类型饮用水有机污染物丰水期高于枯水期(P值均小于0.05)。癌症标化死亡率与不同类型饮用水有机污染浓度呈等级正相关(P值均小于0.05),与NO₂-N、NDMA、NDEA含量呈剂量-效应关系。直接饮用污染的地表水是造成该市农村癌症高发聚集分布的主要原因之一。     

工业类建设项目验收技术规范编制内容探讨

简述了我国建设项目环保验收技术规范颁布实施,以及国外对建设项目实行全过程监管方式现状,指出现行环保验收技术规范在行业性内容、验收监测频次、质量控制措施、总量核算方面存在的问题,提出,应出台总工业类环保验收技术规范,对出台行业类验收技术规范严格把关,并加大验收技术科研力度的建议.     

地铁换乘车站客流疏运模拟及风险分析（2）——单通道换乘车站

为了研究通道换乘地铁车站的客流疏运过程及风险点,文章针对某单通道换乘车站,通过对车站通道和客流分析,提出了优化的客流流线;并基于智能个体和矢量空间模拟技术,建立了地铁换乘车站的疏运模型,模拟了高峰时间段内的客流疏运过程。数值模拟结果显示了交叉客流、拥堵发生位置及原因,辨识了高风险位置,并提出了整改措施。文章提出的模拟方法和结论可为国内外类似车站制定客流组织方案及通道设计提供参考。     

Characteristic, composition, and sources of TSP investigated by HRTEM/EDS and ESEM/EDS

Total suspended particle (TSP) collected at the fifth floor of House Dust in Hunan University, China, was analyzed in terms of microscopic morphology and chemical composition. The fine particles (50?nm-2?μm) in the TSP were analyzed by a high-resolution transmission electron microscope equipped with an energy-dispersive X-ray analyzer (HRTEM/EDS). Results showed that the particles were in shapes of plate, irregular and agglomerate. Based on EDS results, these fine particulate matter was primarily composed of Fe-rich (35.82-61.29%), Ca-rich (30.18-36.77%) and Si-rich (18.95-32.28%) particles. Other elements mainly including Mg (0.47-4.97%), Al (0.45-14.57%), S (0.45-4.73%), K (1.13-2.13%) and Zn (0.67-3.85%) were also observed. The sources analysis indicated that the HRTEM particles mainly originated from coal combustion, traffic emission, vehicles exhaust emission and fugitive soil or cement particulate matter. The coarse particles (4-50?μm) were detected by environmental scanning electron microscopy coupled with energy-dispersive X-ray detector (ESEM/EDS). Based on a simple algorithm, ESEM particles were categorized into five groups: C-bearing (46.15%, 67% and 86.98%), Si + Ca-bearing (21.48?+?11.80%, 16.51?+?10.81% and 16.32?+?10.62%), Si + Al-bearing (20.06?+?12.40%, 20.16?+?11.22% and 15.31?+?11.25%), Si-bearing (34.40%, 26.92% and 27.15%) particles and aggregates, most of which exhibit obvious crystalline structure, and these ESEM particles mainly derived from vehicles exhaust emission, coal combustion, soil, and biomass burning, while the aggregates are indicative of atmospheric reaction progress. HRTEM/EDS and ESEM/EDS are mutual complementary in analyzing the characteristic and determining the sources of TSP.     

Characteristics and assessment of phthalate esters in urban dusts in Guangzhou city, China

Phthalate esters (PAEs) were examined in indoor and outdoor dust samples from the subtropical city of Guangzhou, China. The ∑(16)PAEs concentrations ranged from 121 to 3,223 μg g(-1) dust, with the median concentration of 840 μg g(-1) dust. Significantly higher concentrations of PAEs in dust samples were found in offices where electrical and electronic devices, carpet pads, and office furniture were widely used. Of the 16 PAEs, diisobutyl phthalate (DiBP), di-n-butyl phthalate (DnBP), and di(2-ethylhexyl) phthalate (DEHP) dominated the PAEs in indoor and outdoor dust samples, and accounted for >96.8% and >93.1% of the ∑(16)PAEs concentrations, respectively. The median daily inhalation exposure of ∑(16)PAEs were 3.53 and 0.247 μg kg(-1) body weight day(-1), and at the 95(th) percentile were 7.62 and 0.530 μg kg(-1) body weight day(-1), up on the measured concentrations and estimated dust ingestion rates, respectively, for toddles and adults. The ubiquitous distribution of PAEs as noted in this study suggests the need for detailed assessment of PAEs concentrations using more sites and to further investigate the factors influencing PAEs exposure in China.     

废旧冰箱拆解聚氨酯泡沫塑料制备PU/PP复合材料

利用废旧冰箱拆解的聚氨酯泡沫塑料(PU)和聚丙烯(PP)、聚丙烯接枝马来酸酐(PP-g-MAH)为原料,采用物理化学回收技术制备PU/PP复合材料。用正交实验法分析PU填充量、PU粒径和PP-g-MAH 3个因素对PU/PP复合材料力学性能影响的显著性。结果表明,PU填充量对PU/PP复合材料拉伸性能有显著影响,对冲击性能和弯曲性能没有显著影响;在本文的实验范围内,PU粒径对PU/PP复合材料的力学性能影响不大;而PP-g-MAH投加量对PU/PP复合材料具有一定的影响。确定的优化工艺配方为:PU 40%;PU粒径选择2.00 mm;PP-g-MAH投加量10%。采用优化工艺制备的PU/PP复合材料的密度为1 042.88 kg/m3;冲击强度为2.9 kJ/m2;拉伸强度为10.30 MPa;拉伸模量为1 100 MPa;弯曲强度为18.5 MPa;弯曲模量为733 MPa。     

铁碳微电解-Fenton法预处理苯胺基乙腈生产废水的动力学研究

通过采用铁碳微电解-Fenton法预处理苯胺基乙腈生产废水的实验研究,分析了处理过程的COD降解动力学;同时研究了单纯活性炭吸附和微电解过程中COD去除率的变化。结果表明,铁碳微电解的初期COD降解过程近似符合一级反应动力学,并且得到微电解与活性炭吸附对铁碳微电解降解COD的关系式;Fenton反应中通过研究有机物浓度和过氧化氢初始浓度与反应进程的关系,建立了反应动力学模型;单纯吸附实验COD去除率在24h内快速下降,而微电解在相应时间内COD去除率波动较小,为实际应用提供了数据经验和理论依据。     

MCM-41介孔分子筛的合成及其对铜离子的吸附性能简

以微硅粉为硅源,CTAB和PEG-6000为模板剂,合成MCM-41介孔分子筛。采用XRD、N₂吸附-脱附曲线、FTIR以及TEM表征了其结构、比表面积、孔径分布及晶体形貌,并且以该样品为吸附剂,对含Cu²⁺的溶液进行了静态吸附实验。结果表明,以微硅粉为硅源成功合成了具有典型六方排列孔道结构的MCM-41,其比表面积为869.5 m²/g,孔容为0.97 cm³/g,平均孔径为3.3 nm;溶液pH为5~6时,MCM-41对Cu²⁺的去除效果最好;MCM-41对Cu²⁺的最大吸附吸附容量36.3 mg/g;MCM-41对Cu²⁺的吸附性能符合Langmuir吸附方程的特征。动力学研究表明,该过程符合准二级动力学模型。