Effects of suburban land use on phosphorus fractions and speciation in the Upper Peruque Creek, Eastern Missouri

This field study was conducted to explore the spatial and seasonal changes in total phosphorus and fraction distribution in relation to land uses. Water samples were collected biweekly at four sampling locations, which represented different potential phosphorus sources along the Upper Peruque Creek in Eastern Missouri. Total phosphorus concentrations of > 0.8 mg/L appeared sporadically at site 2, downstream of a small community, with an average of 0.82 +/- 0.14 mg/L in fall. Particulate phosphorus accounted for approximately 80% of total phosphorus at all sampling sites, except for site 2, where approximately 50 to 75% of dissolved phosphorus was often observed. Approximately 71 and 85% of total phosphorus in the sediment was in the form of iron (III) phosphate at the headwaters and downstream sites, respectively; 29 and 15% was in the form of phytic acid at the two sites. Land uses affect the total phosphorus concentration and alternate phosphorus fraction and speciation in the creek.     

Contributions of Acid Deposition and Natural Processes to Cation Leaching from Forest Soils: A Review

Methods of quantifying the roles of atmospheric acid inputs and internal acid generation by carbonic, organic, and nitric acids are illustrated by reviewing data sets from several intensively studied sites in North America. Some of the sites (tropical, temperate deciduous, and temperate coniferous) received acid precipitation whereas others (northern and subalpine) did not. Natural leaching by carbonic acid dominated soil leaching in the tropical and temperate coniferous sites, nitric acid (caused by nitrification) dominated leaching In an N-fixing temperate deciduous site, and organic acids dominated surface soil leaching in the subalpine site and contributed to leaching of surface soils in several other sites. Only at the temperate deciduous sites did atmospheric acid input play a major role in soil leaching. In no case, however, are the annual net losses of cations regarded as alarming as compared to soil exchangeable cation capital.

These results were used to illustrate the methods of quantifying the effects of atmospheric inputs and internal processes on soil leaching rates, not to draw broad generalizations as to acid rain effects on soils. However, there are predictable patterns in natural soil leaching processes which relate to climate, soil properties, and vegetation that may help in predicting the relative importances of natural vs. atmospheric acid inputs to soil leaching.     

How seasonality affects the flow of estrogens and their conjugates in one of Japan's most populous catchments

A detailed study of the free and conjugated estrogen load discharged by the eight major sewage treatment plants into the Yodo River basin, Japan was carried out. Sampling campaigns were focused on the winter and autumn seasons from 2005 to 2008 and the free estrogens estrone(E1), 17β-estradiol(E2), estriol(E3), 17α-ethynylestradiol(EE2) as well as their conjugated (sulfate and glucuronide) forms. For both sewage effluent and river water E2 and E1 concentrations were greatest during the winter period (December-March). This coincides with the period of lowest rainfall and lowest temperatures in Japan. E1 was the dominant estrogenic component in effluent (means of 10-50 ng/L) followed by E2 (means of 0.5-3 ng/L). The estrogen sulfate conjugates were found intermittently in the 0.5-1.7 ng/L concentration range in the sewage effluents. The greatest estrogen exposure was found to be in the Katsura River tributary which exceeded 1 ng/L E2-equivalents during the winter period.     

1992 Environmental Software Survey

By some accounts, there are up to 1,000 different software packages on the market today. These range from specialized products that calculate releases from fixed roof storage tanks to comprehensive chemical inventory tracking and reporting systems. One of the positive benefits to this proliferation of software is that there is a wide selection of products available. The down side is that many times the hardest part of purchasing an environmental software product is figuring out which product to buy, and where to find it. The 1992 Environmental Software Survey is intended to fill this gap for those who rely upon computers as a tool to perform their job functions. This paper summarizes information on more than 600 environmental software products produced by over 200 vendors. Information includes environmental media addressed by the software, program functions and vendor information.     

Translating science into policy: using ecosystem thresholds to protect resources in Rocky Mountain National Park

Concern over impacts of atmospheric nitrogen deposition to ecosystems in Rocky Mountain National Park, Colorado, has prompted the National Park Service, the State of Colorado Department of Public Health and Environment, the Environmental Protection Agency, and interested stakeholders to collaborate in the Rocky Mountain National Park Initiative, a process to address these impacts. The development of a nitrogen critical load for park aquatic resources has provided the basis for a deposition goal to achieve resource protection, and parties to the Initiative are now discussing strategies to meet that goal by reducing air pollutant emissions that contribute to nitrogen deposition in the Park. Issues being considered include the types and locations of emissions to be reduced, the timeline for emission reductions, and the impact of emission reductions from programs already in place. These strategies may serve as templates for addressing ecosystem impacts from deposition in other national parks.     

Measuring the flux at the interface of coal-tar impacted sediment and river water near a former MGP site

Determining water movement through contaminated sediment is critical for characterizing transport of chemicals from the sediment to the overlying water. Field studies to characterize the water flow across the sediment-water interface within a river adjacent to a former manufactured gas plant site were conducted. For this purpose, a new design of an interfacial flow meter was developed and tested. The in situ components of the system consisted of: a cylinder with an interfacial area of 2342 cm2; a dome attached to the cylinder; and a flow tube that allows water to flow from inside the dome to the river at the rate equal to the specific discharge across the sediment-water boundary. A 'heat-pulse' method was used to measure flow by heating the center of the flow tube for a brief time period and measuring the temperature profile within the tube over time. The system was calibrated to measure volumetric flux in the range 1.5-4.0 cm d(-1), however using a flow-addition method, the measurement of lower velocities also was accomplished, and calibration at higher fluxes is possible. From the groundwater flow at the interface of the coal-tar impacted sediment and information on the sediment pore water concentrations of several PAHs (poly-cyclic aromatic hydrocarbons), the mass flux of these PAHs to the river were estimated. Information on PAH mass flux at the sediment-water interface is useful for site assessment, including the evaluation of remediation alternatives and longer term site characterization.     

A contaminated site investigation: comparison of information gained from geophysical measurements and hydrogeological modeling

The investigation of contaminated sites is usually a long and expensive process. It is therefore desirable to use a combination of methodologies in an integrative approach that can reduce redundant information gathering. The objective of this study was to examine the usefulness of 2 non-intrusive exploration techniques in a contaminated site investigation. Borehole positioning based on geophysical measurements was compared to positioning based on the Bayesian expert system for flow-field modeling. The goal set at the field site was the assessment of the type and load of contaminants transported from the landfill site to the adjacent aquifer and the extent of leachate plumes within the groundwater. The two methods made different demands on information gathering and were found to be complementary. The geophysical approach focused attention on the waste compartments at the site and on mixing plumes in the adjacent aquifer but could not, without prior information, provided information on the flow field. The Bayesian approach to flow-field modeling determined areas of greatest model uncertainty at the model boundaries. The model highlighted areas of greatest uncertainty that might otherwise have been overlooked and provided information on the most likely mean direction of the leachate plumes. It was concluded that both methods contribute to a site investigation and should be used before additional drilling is carried out.     

Forecasting Peak Daily Ozone Levels: Part 2—A Regression with Time Series Errors Model Having a Principal Component Trigger to Forecast 1999 and 2002 Ozone Levels

Abstract

A modified time series approach, a Box-Jenkins regression with time series errors (RTSE) model plus a principal component (PC) trigger, has been developed to forecast peak daily 1-hr ozone (O₃) in real time at the University of Wisconsin-Milwaukee North (UWM-N) during 1999 and 2002. The PC trigger acts as a predictor variable in the RTSE model. It tries to answer the question: will the next day be a possible high O₃ day? To answer this question, three PC trigger rules were developed: (1) Hi-Low Checklist, (2) Discriminant Function Approach I, and (3) Discriminant Function Approach II. Also, a pure RTSE model without including the PC trigger and a persistence approach were tested for comparison. The RTSE model with DFA I successfully forecast the only two 1-hr federal exceedances (124 ppb), one in 1999 and one in 2002. In terms of the O₃ 100-ppb exceedances, 60–80% of the incorrect forecasts occurred with incorrect PC decisions. A few others may have been caused by unexpected O_3- weather relations. When the three approaches used UWM-N data to forecast a 100-ppb exceedance somewhere in the Milwaukee, WI, metropolitan area, their performance was dramatically improved: the false alarm rate was reduced from 0.89 to 0.44, and the probability of detection was increased from 0.71 to 0.88.     

Soil- and surfactant-enhanced reductive dechlorination of carbon tetrachloride in the presence of Shewanella putrefaciens 200

Sorption of organic contaminants to soils has been shown to limit bioavailability and biodegradation in some systems. Use of surfactants has been proposed to reverse this effect. In this study, the effects of a high organic carbon content soil and a nonionic surfactant (Triton X-100) on the reductive dechlorination of carbon tetrachloride (CCl₄) were examined in anaerobic systems containing Shewanella putrefaciens. Although more than 70% of the added CCl₄ was sorbed to the soil phase in these systems, the reductive dechlorination of CCl₄ was not diminished. Rather, rates of CCl₄ dechlorination in systems containing soil were enhanced relative to systems containing non-sorptive sand slurries. This enhancement was also observed in sterile soil slurries to which a chemical reductant, dithiothreitol was added. It appears that the organic soil used in these experiments contains some catalytic factor capable of transforming CCl₄ in the presence of an appropriate chemical or microbial reductant. The addition of Triton X-100 to sand and soil slurries containing S. putrefaciens resulted in increased CCl₄ degradation in both systems. The effect of Triton could not be explained by: (i) surfactant induced changes in the distribution of CCl₄, (i.e. decreased sorption) or the rate of CCl₄ desorption; (ii) a direct reaction between Triton and CCl₄; or (iii) increased cell numbers resulting from use of the surfactant as a substrate. Rather, it appears that Triton X-100 addition resulted in lysis of bacterial cells, a release of biochemical reductant, and enhanced reductive transformation of CCl₄. These results provide insights to guide the development of more effective direct or indirect bioremediation strategies.