Measurement of real time black carbon for investigating spot loading effects of Aethalometer data

Measurements of real-time continuous PM_2.5 black carbon (BC) concentrations were made using a single-wavelength Aethalometer (@880 nm) in three different environments, i.e., an indoor office, a residential indoor living room and an urban site, to evaluate the difference in temporal behaviors of BC particles and investigate the optical shadowing effect in the Aethalometer BC data. An empirical method was used for correcting the optical saturation effect on the original BC data obtained from the measurements at the three sites. Also, the elemental carbon (EC) concentrations from 24-h filter-based measurements of PM_2.5 particles were determined using a thermal optical transmittance (TOT) method at the same urban site for comparison with the Aethalometer BC results. Transient events of BC were often observed for period of a few hours at all sites, reaching a maximum level of 27.3 μg m^?3 at the urban site. The diurnal cycles of the BC concentrations observed at the two indoor environments were found to be considerably affected by the air exchange rate, occupants' behavior patterns and nearby traffic emissions. The time-series plots of the Aethalometer data showed obvious discontinuities at the filter spot change, and a rise in the apparent BC concentrations after filter tape advances. Also, the relationship between the attenuation and BC concentration was found to be non-linear at all sites. The empirical approach presented here demonstrated a definite improvement in the continuity of the BC data across the time gaps of each tape advance. The compensated BC concentration was 1.10–1.23 times greater than the raw BC data, depending on the observation sites, with the highest difference observed between the raw and compensated BC data at an indoor office near a small traffic road. The 24-h integrated EC concentration was approximately 12% higher than the original 24-h average BC concentration and 6% lower than the loading compensated BC concentration, showing that the loading compensation process accounted for the saturation effect of the filter tape.     

Determinants of exposure to fine particulate matter (PM2.5) for waiting passengers at bus stops

This research evaluates commuter exposure to particulate matter during pre-journey commute segments for passengers waiting at bus stops by investigating 840 min of simultaneous exposure levels, both inside and outside seven bus shelters in Buffalo, New York. A multivariate regression model is used to estimate the relation between exposure to particulate matter (PM_2.5 measured in μg m^?3) and three vectors of determinants: time and location, physical setting and placement, and environmental factors. Four determinants have a statistically significant effect on particulate matter: time of day, passengers’ waiting location, land use near the bus shelter, and the presence of cigarette smoking at the bus shelter. Model results suggest that exposure to PM_2.5 inside a bus shelter is 2.63 μg m^?3 (or 18 percent) higher than exposure outside a bus shelter, perhaps due in part to the presence of cigarette smoking. Morning exposure levels are 6.51 μg m^?3 (or 52 percent) higher than afternoon levels. Placement of bus stops can affect exposure to particulate matter for those waiting inside and outside of shelters: air samples at bus shelters located in building canyons have higher particulate matter than bus shelters located near open space.     

Estimating bulk optical properties of aerosols over the western North Pacific by using MODIS and CERES measurements

Over the western North Pacific, a large amount of land aerosols from Asian-Pacific countries is transported by the prevailing westerlies. This transport makes the radiative characteristics of these aerosols diverse, particularly when one compares those characteristics over the coastal sea with those over the open sea. In this paper we discuss a method that uses satellite data to obtain the single-scattering albedo (ω) and asymmetry factor (g) of atmospheric aerosols for two large-scale subdivisions—the coastal sea (within 250 km from the coast) and the open sea (the remaining area)—over the western North Pacific (110°E–180°, 20°N–50°N). Our estimation method uses satellite measurements, obtained over a six-year period (2000–2005), of aerosol optical depth (AOD) and shortwave fluxes at both the surface and the top of the atmosphere (TOA); the measurements are obtained using the Moderate Resolution Imaging Spectroradiometer (MODIS) and the Clouds and the Earth's Radiant Energy System (CERES). For the two subdivisions, the estimated annual means of (ω,g) at 630 nm are significantly different: (0.94, 0.65) over the coastal sea and (0.97, 0.70) over the open sea. From a quantitative viewpoint, this result indicates that in comparison with aerosols over the open sea, those over the coastal sea show greater absorption and lesser forward scattering of solar radiation. The estimated optical properties are responsible for the aerosol surface cooling observed by MODIS and CERES, which is approximately 138 and 108 W m⁻² per AOD over the coastal sea and open sea, respectively.     

Comparison of two estimation methods for surface area concentration using number concentration and mass concentration of combustion-related ultrafine particles

Recent research has suggested that the adverse health effects caused by nanoparticles are associated with their surface area (SA) concentrations. In this study, SA was estimated in two ways using number and mass concentrations and compared with SA (SA_meas) measured using a diffusion charger (DC). Aerosol measurements were made twice: once starting in October 2002 and again starting in December 2002 in Mysore, India in residences that used kerosene or liquefied petroleum gas (LPG) for cooking. Mass, number, and SA concentrations and size distributions by number were measured in each residence. The first estimation method (SA_PSD) used the size distribution by number to estimate SA. The second method (SA_INV) used a simple inversion scheme that incorporated number and mass concentrations while assuming a lognormal size distribution with a known geometrical standard deviation. SA_PSD was, on average, 2.4 times greater (range = 1.6–3.4) than SA_meas while SA_INV was, on average, 6.0 times greater (range = 4.6–7.7) than SA_meas. The logarithms of SA_PSD and SA_INV were found to be statistically significant predictors of the logarithm of SA_meas. The study showed that particle number and mass concentration measurements can be used to estimate SA with a correction factor that ranges between 2 and 6.     

Rural southeast Texas air quality measurements during the 2006 Texas Air Quality Study

The authors conducted air quality measurements of the criteria pollutants carbon monoxide, nitrogen oxides, and ozone together with meteorological measurements at a park site southeast of College Station, TX, during the 2006 Texas Air Quality Study II (TexAQS). Ozone, a primary focus of the measurements, was above 80 ppb during 3 days and above 75 ppb during additional 8 days in summer 2006, suggestive of possible violations of the ozone National Ambient Air Quality Standard (NAAQS) in this area. In concordance with other air quality measurements during the TexAQS II, elevated ozone mixing ratios coincided with northerly flows during days after cold front passages. Ozone background during these days was as high as 80 ppb, whereas southerly air flows generally provided for an ozone background lower than 40 ppb. Back trajectory analysis shows that local ozone mixing ratios can also be strongly affected by the Houston urban pollution plume, leading to late afternoon ozone increases of as high as 50 ppb above background under favorable transport conditions. The trajectory analysis also shows that ozone background increases steadily the longer a southern air mass resides over Texas after entering from the Gulf of Mexico. In light of these and other TexAQS findings, it appears that ozone air quality is affected throughout east Texas by both long-range and regional ozone transport, and that improvements therefore will require at least a regionally oriented instead of the current locally oriented ozone precursor reduction policies.     

Occurrence of perfluorooctanoate and perfluorooctanesulfonate in the Korean water system: implication to water intake exposure

Perfluorinated compounds (PFCs) measured in surface running waters indicated the existence of different emission sources in eight main city basins. The tap water reflected the contamination pattern and levels in their corresponding source water basins. The daily intakes through tap water consumption ranged from <0.01 to 0.73 ng kg⁻¹ d⁻¹ for perfluorooctanoate (PFOA) and <0.01 to 0.08 ng kg⁻¹ d⁻¹ for perfluorooctanesulfonate (PFOS). Tap water intake-derived exposure accounted for 8.6%-101% (for PFOA) and while <10% (for PFOS) of total daily exposure, which was estimated from Korean serum concentrations using a pharmacokinetic model. Our findings indicate that tap water intake could be an important contributor to PFOA exposure in Korean populations; accordingly, additional efforts are necessary to improve the removal efficiency of perfluorinated compounds (PFCs) in the water purification process. However, more fundamentally the aim would be to reduce the discharge of PFCs from potential sources within the basin.     

Comparison of endotoxin levels and gram-negative bacteria under different conditions in microbial laboratories and a biowaste site

In this study, we assessed airborne endotoxin levels in university laboratories, hospital diagnostic laboratories, and a biowaste site. We also investigated indoor and outdoor sampling, sampling site, type of ventilation system, presence of open biowaste boxes, weather, and detection of Gram-negative bacteria (GNB). A total of 69 air samples were collected from 11 facilities in three institutions. Average total airborne endotoxin levels ranged from <0.01 to 10.02 EU m⁻³, with an overall mean of 1.03 EU m⁻³. Endotoxin levels were high in window-ventilated facilities, in facilities in which GNB were detected; levels were also high when it was rainy (all ps < 0.05). Endotoxin levels were significantly correlated with humidity (r = 0.70, p < 0.01). The presence of HVAC; humidity; and the presence of open biowaste boxes affect endotoxin levels in laboratories.     

Comparative effectiveness of mixed organic substrates to mushroom compost for treatment of mine drainage in passive bioreactors

Bioreactors are one possible best sustainable technology to address the mine-impacted water problems. Several prospective substrates (mushroom compost, cow manure, sawdust, wood chips, and cut rice straw) were characterized for their ability to serve as a source of food and energy for sulfate-reducing bacteria. Twenty bench-scale batch bioreactors were then designed and set up to investigate relative effectiveness of various mixtures of substrates to that of mushroom compost, the most commonly used substrate in field bioreactors, for treating mine drainage with acidic (pH 3) and moderate pH (pH 6). Overall, reactive mixtures showed satisfactory performances in generating alkalinity, reducing sulfate and removing metals (Al>Fe>Mn) (up to 100%) at both pH conditions, for all substrates. The mixture of sawdust and cow manure was found as the most effective whereas the mixture containing 40% cut rice straw gave limited efficiency, suggesting organic carbon released from this substrate is not readily available for biodegradation under anaerobic conditions. The mushroom compost-based bioreactors released significant amount of sulfate, which may raise a more concern upon the start-up of field-scale bioreactors. The correlation between the extent of sulfate reduction and dissolved organic carbon/SO(4)(2-) ratio was weak and this indicates that the type of dissolved organic carbon plays a more important role in sulfate reduction than the absolute concentration and that the ratio is not sensitive enough to properly describe the relative effectiveness of substrate mixtures.     

Applicability of a sharp-interface model for estimating steady-state salinity at pumping wells--validation against sand tank experiments

A numerical sharp-interface model of saltwater and freshwater behavior was validated against experiments conducted in two small scale sand tanks. A simple algorithm was proposed to determine saltwater and freshwater withdrawal rates at a pumping well at which a total pumping rate was specified. Model estimates were compared with transient salinity breakthroughs and steady-state salinities of water extracted from pumping wells in the sand tanks. Experimental scenarios included various combinations of freshwater pumping and injection and saltwater pumping. The corresponding Nash-Sutcliffe model efficiency was 0.95, which showed that the agreement between observations and computed results was satisfactory.     

Placental transfer of polychlorinated biphenyls, their hydroxylated metabolites and pentachlorophenol in pregnant women from eastern Slovakia

The aim of the present study was to understand the placental transfer of polychlorinated biphenyls (PCBs), specific hydroxylated PCB metabolites (OH-PCBs), and pentachlorophenol (PCP) in blood serum, in a birth cohort from eastern Slovakia. During the period 2002-2004, cord blood specimens were collected in parallel with maternal specimens from women delivering in the two eastern Slovak districts of Michalovce and Svidnik/Stropkov. A total of 92 pairs of mother-cord specimens at delivery were selected for this study. 4-OH-CB107, 3-OH-CB153, 4-OH-CB146, 3'-OH-CB138, 4-OH-CB187, and 4'-OH-CB172 were quantified. The median concentrations of Sigma(17)PCBs, Sigma(6)OH-PCBs, and PCP in cord serum were 0.92, 0.33, and 0.69 ng/g wet wt., respectively and highly correlated with the corresponding maternal serum levels (correlations were R(2)=0.61, 0.78, and 0.82, respectively). The median cord to mother ratios of the Sigma(17)PCBs, Sigma(6)OH-PCBs, and PCP were 0.18, 0.75, and 1.10, respectively. The median ratio of the Sigma(6)OH-PCBs to the Sigma(17) PCBs in the cord serum was 0.38 from wet weight based concentrations, which was about four times higher than the ratio of these compounds in maternal serum (0.09). PCP was more abundant than any PCB or OH-PCB congener measured in cord serum. The higher cord to maternal ratios of OH-PCB metabolites as compared with the parent compounds suggests either a higher placental transfer rate or greater metabolism in the fetus as compared with the maternal compartment. These findings are consistent with their preferential binding to TTR that can cross the placenta. The cord to maternal ratio varies by congener (e.g., 4-OH-CB107=0.58, 4-OH-CB146=0.74, 3'-OH-CB138=1.01).