Differences and similarities of gas and dust explosions: A critical evaluation of the European ‘ATEX’ directives in relation to dusts

Explosive gas mixtures and explosive dust clouds, once existing, exhibit similar ignition and combustion features. However, there are two basic differences between dusts and gases which are of substantially greater significance in design of safety standards than these similarities. Firstly, the physics of generation and up-keeping of dust clouds and premixed gas/vapour clouds are substantially different. This means that in most situations where accidental explosive gas clouds may be produced quite readily, generation of explosive dust clouds would be highly unlikely. Secondly, contrary to premixed gas flame propagation, the propagation of flames in dust/air mixtures is not limited only to the flammable dust concentration range of dynamic clouds. The state of stagnant layers/deposits offers an additional discrete possibility of flame propagation.

The two European Directives 94/9/EC (1994) and 1999/92/EC (1999) primarily address gases/vapours, whereas the particular properties of dusts are not addressed adequately. Some recent IEC and European dust standards resulting from this deficiency are discussed, and the need for revising the two directives accordingly is emphasized.     

Off-site emergency scenario, a case study from a LPG Bottling Plant

After Bhopal disaster, emergency planning in an industrial area has become inevitable. The off-site emergency plan is an integral part of any major hazard control system. Boiling Liquid Expanding Vapour Explosion (BLEVE) leads to fatal consequences. This paper highlights some salient features of the emergency scenario, which ultimately leads to fireball with enormous pressure wave all around.     

The New Jersey Toxics Reduction Workplan for Ny-Nj Harbor: Distribution of Pcdd/Fs in Ambient Waters

As part of the NJ Toxics Reduction Workplan for NY-NJ Harbor, ambient water samples were collected at fifteen locations along the tidal portions of the Hackensack, Passaic, Raritan, Rahway and Elizabeth Rivers, and in Newark Bay, the Arthur Kill, and Kill van Kull. A Trace Organics Platform Sampler was used to collect a total of 75 suspended sediment phase samples between June 2000 and May 2002. These samples were analyzed for spatial and wet vs. dry weather trends in the 17 polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs; modified USEPA Method 1613b). Mean total PCDD/F (tPCDD/F) concentrations at the sampling locations ranged between 3.8 and 41.5 ng/g. On average, OCDD accounted for almost 80% of the tPCDD/F concentrations; mean total [PCDD/F – OCDD] concentrations ranged between 0.84 and 5.20 ng/g at the sampling locations. Mean 2,3,7,8-TCDD concentrations ranged between 0.003 and 0.28 ng/g, with the highest concentrations (> 0.10 ng/g) along the tidal Passaic and lower Hackensack Rivers, and in upper Newark Bay. Mean tPCDD/F Toxic Equivalency Quotients (TEQ) ranged between 45 and 344 TEQ pg/g, with the highest levels found in the lower Passaic River. Toxicity was primarily driven by 2,3,7,8-TCDD concentrations in the Passaic and Hackensack Rivers, and in Newark Bay. Examples of congener distribution patterns at some of the sampling locations are also presented.     

Application of tracer ratio and inverse dispersion methods with boat-based plume measurements to estimate ammonia emissions from seabird colonies

Ammonia emissions from two contrasting seabird colonies in Scotland were measured, based on the determination of atmospheric concentrations downwind of the colonies. Atmospheric concentrations of ammonia (NH₃) across the downwind plume were compared with the inverse application of a Gaussian dispersion model (ID) to calculate the modelled NH₃ emission that would generate the measured cross-wind-integrated plume concentration. In parallel, a tracer gas (sulphur hexafluoride, SF₆) was released from the colonies with air samples taken to allow determination of SF₆ concentrations. On the basis of the known emission rate of SF₆, the magnitude of ammonia emissions was estimated by the cross-wind-integrated tracer ratio (TR) of NH₃/SF₆ concentrations. Coupled with data on annual bird attendance, the measurements indicate annual emissions from the Isle of May and the Bass Rock of 18 and 132 tonnes NH₃-N year^–1, respectively. The measured NH₃ emissions were compared with estimates of seabird nitrogen excretion to estimate the proportion of excreted N that is volatilised as NH₃ (F_Nr). The emission estimates of the two methods compared favourably, giving 4 and 6 kg NH₃-N h^–1 (F_Nr = 15%) for the Isle of May for the ID and TR methods, respectively, and 21 and 25 kg NH₃-N h^–1 (F_Nr = 50%) for the Bass Rock for the ID and TR methods, respectively. The results provide the first measurement-based estimates to allow regional up scaling of ammonia emissions from seabirds.     

Rapid amino acid cycling in arctic and antarctic soils

Amino acids constitute one of the largest inputs of organic nitrogen (N) to most polar soils and have been hypothesized to be important in regulating vegetational succession and productivity in Arctic ecosystems. Our understanding of amino acid cycling in these soils, however, is poor. The aim of this study was to investigate the size and rate of turnover of the amino acid pool in a range of Arctic and Antarctic soils. Our results indicate that in polar soils with either high or low ornithogenic inputs the amino acid pool is small in comparison to the inorganic N pool (NO^–₃ and NH⁺₄). The free amino acid pool constituted only a small proportion of the total dissolved organic nitrogen (DON) pool in these soils. Here we show that these low concentrations may be due to rapid use by the soil microbial community in both Arctic and Antarctic soils. The turnover of the amino acid pool in soil was extremely rapid, with a half-life ranging from 2 to 24 h, indicating that this N pool can be turned over many hundred times each summer when polar soils are frequently unfrozen. The implications of amino acids in N cycling and plant and microbial nutrition are discussed.     

Lightweight Concrete Containing an Alkaline Resistant Starch-Based Aquagel

Starch aquagel-based lightweight concrete has properties similar to those of other lightweight concrete products. However, starch aquagels are unstable in the strongly alkaline conditions typical of Portland Cement-based concrete and may interfere with the setting process. The effect of alkali treatments on the physical, mechanical, and functional properties of starch aquagels and aquagels from starch/polymer blends was investigated. Starch was blended at 100–115°C in a twin-screw extruder with five different polymers to determine whether the blends improved alkaline resistance. Polymer blends containing 5%, 15%, and 30% of the polymer hydrated and formed aquagels when equilibrated in water for 24 h. However, equilibrium moisture content was lower for the blends compared to the starch control. Aquagels equilibrated in 0.15 N NaOH swelled, lost compressive strength and had greater than 90% moisture. The blend of starch and 30% PVOH absorbed less moisture and was more resistant to alkaline dissolution in 1 N NaOH than the other blends tested making it a more suitable material for aquagel-based concrete. The moisture content of starch-based aquagels and mixing time were critical factors in determining setting times. The size of aquagel blends had a minor effect on density and compressive strength.     

Assessing the Performance Level of a Water System

Water, Air, &; Soil Pollution: Focus - What should System Managers prefer? Systems that never fail or systems that remain safe during a failure? The present paper tries to give an answer to this...     

Towards a model of safety climate measurement.

In this study, a survey instrument was developed to measure safety climate. A review of the scientific literature as well as consultation with an expert panel was used to determine the survey's dimensions. Next, the survey was administered, first as a pilot study (n = 15) and then as a full scale study (n = 229), to employees of the City of Cincinnati Department of Public Works. The psychometric integrity of the survey was assessed according to validity, reliability and utility criteria. Results are presented and discussed.     

Rapid amino acid cycling in arctic and antarctic soils

Amino acids constitute one of the largest inputs of organic nitrogen (N) to most polar soils and have been hypothesized to be important in regulating vegetational succession and productivity in Arctic ecosystems. Our understanding of amino acid cycling in these soils, however, is poor. The aim of this study was to investigate the size and rate of turnover of the amino acid pool in a range of Arctic and Antarctic soils. Our results indicate that in polar soils with either high or low ornithogenic inputs the amino acid pool is small in comparison to the inorganic N pool (NO^? ₃ and NH⁺ ₄). The free amino acid pool constituted only a small proportion of the total dissolved organic nitrogen (DON) pool in these soils. Here we show that these low concentrations may be due to rapid use by the soil microbial community in both Arctic and Antarctic soils. The turnover of the amino acid pool in soil was extremely rapid, with a half-life ranging from 2 to 24 h, indicating that this N pool can be turned over many hundred times each summer when polar soils are frequently unfrozen. The implications of amino acids in N cycling and plant and microbial nutrition are discussed.