Ex‐situ efficacy analysis of brine remediation products in clay loam soil

This study evaluated the effectiveness of gypsum and three proprietary products to remediate brine‐contaminated soil. The research objective was to determine if additives could increase plant cover germination in soils without costly prior soil‐washing or dilution techniques. The soil was shredded using a soil shredder equipped with a spray bar to apply the individual treatments of DeSalt Plus, SoilTech, Chlor*rid, and calcium sulfate (gypsum). Treatments were placed in 40‐mm high‐density polyethylene cells and small drainage systems were installed to allow removal of excess water. An initial 10‐point soil composite was taken from bulk untreated soils at a depth of more than 2.5 cm. Five‐point composite samples were collected from the same depth at weekly intervals and analyzed for: electrical conductivity, sodium adsorption ratio, cation exchange capacity, sodium, calcium, magnesium, potassium, chlorides, and pH. The Gapon selectivity coefficient was calculated and utilized to quantify the affinity for binding between ionic alkali salt constituent groups Na⁺, Ca ⁺⁺, and Mg ^++. Soil analysis indicated product‐related improvements in and bioavailability of salts. The nature of the products requires some prior treatment such as soil washing or dilution using clean soil to lower electroconductivity levels and allow the site to vegetate.     

The effects of hand force variation on shoulder muscle activation during submaximal exertions

Upper limb injuries are highly prevalent in the workplace and new tools are needed to proactively design workstations to reduce injury risk. The objective was to characterize spatial, load and direction dependency of muscle activity for hand exertions in the upper limb workspace. Electromyographic signals were collected from 14 upper limb muscles during exertions for all combinations of 4 submaximal hand forces (20/30/50/60?N) in 6 cardinal (up/down/left/right/forward/backward) directions at 5 hand locations. Linear muscle activity increases accompanied increased hand forces. Total muscle activity increases between 20 and 60?N hand forces ranged by direction from 92% (downward) to 189% (right). Prediction equations for all muscles depended on hand force, and linear, quadratic and interaction permutations of hand location. Muscle activity associated with manual tasks is load, direction and spatially dependent. Equations developed to describe these complex relationships can be used to better design future and evaluate current occupational activities.     

Comparison of Escherichia coli and Campylobacter jejuni transport in saturated porous media

Due to the difficulties in testing for specific pathogens, water samples are tested for the presence of nonpathogenic indicator organisms to determine whether a water supply has been contaminated by fecal material. An implicit assumption in this approach is that where pathogenic microorganisms are present fecal indicator organisms are present as well; yet surprisingly few studies have been conducted that directly compare the transport of indicator organisms with pathogenic organisms in ground water environments. In this study we compared the cell properties and transport of Escherichia coli, a commonly used indicator organism, and Campylobacter jejuni, an important enteropathogen commonly found in agricultural wastes, through saturated porous media. Differences in cell properties were determined by measuring cell geometry, hydrophobicity, and electrophoretic mobility. Transport differences were determined by conducting miscible displacement experiments in laboratory columns. Under the experimental conditions tested, C. jejuni was much more negatively charged and more hydrophobic than E. coli. In addition, C. jejuni cells were slightly longer, narrower, and less spherical than E. coli. The variations in cell properties, primarily surface charge, resulted in significant differences in transport between these two microorganisms, with the transport of C. jejuni exceeding that of E. coli when conditions favored low attachment rates, thus calling into question the usefulness of using E. coli as an indicator organism for this important pathogen.     

Polymodal foraging in adult female loggerheads (Caretta caretta)

To determine whether loggerhead turtles (Caretta caretta) nesting in southeastern USA exhibit polymorphic foraging strategies, we evaluated skin samples for stable isotopes of carbon (δ¹³C) and nitrogen (δ¹⁵N) from 310 loggerheads from four locations on the east coast of Florida and epibionts from 48 loggerheads. We found a dichotomy between a depleted δ¹³C cluster and an enriched δ¹³C cluster. Epibionts from oceanic/pelagic or neritic/benthic habitats were largely consistent with this dichotomy. The bimodal distribution of δ¹³C could reflect a bimodal foraging strategy or—because of the potential for confounding among four gradients of δ¹³C in marine environments—a polymodal foraging strategy. We integrate our results with results from other stable isotope studies, satellite telemetry, and flipper tags to evaluate potential foraging strategies. Understanding foraging strategies is essential for development of management plans for this endangered species that has suffered a 43% population decline over the last decade.     

Low-wind/high particulate matter episodes in the Calexico/Mexicali region

The U.S. Environmental Protection Agency (EPA) currently classifies Imperial County, CA, as a nonattainment area for PM10 (particulate matter [PM] < or = 10 microm in diameter), and this region suffers from high rates of chronic bronchitis and childhood asthma. Although high annual and daily average PM levels can have negative health and economic effects, recent studies have identified an association between adverse health effects and short-term PM spikes of tens of micrograms per cubic meter. This study identified PM episodes in Calexico/Mexicali that involve PM concentration spikes with concentrations up to 10 times greater than those reported to cause adverse health effects. These episodes appear to be relatively common during the winter months, are associated with wind speeds below 2 m/sec and stable boundary level heights below 500 m, and can comprise a large portion of the 24-hr PM levels. The organic composition of the PM10 samples collected during the low-wind/ high-PM episodes differed from that collected at other times. However, a preliminary source attribution identified only one significant difference between the source classes: agricultural burning accounted for 6.7% of organic-fraction PM10 for low-wind/high-PM episodes versus 0.25% at other times. This preliminary source attribution also revealed that motor vehicles were the most important relative contributor to organic PM10.     

Current shifts and kin aggregation explain genetic patchiness in fish recruits

The scales of population structure in marine species depend on the degree to which larvae from different populations are mixed in the plankton. There is an intriguing trend in marine population genetic studies of significant genetic structure for larvae, recruits, or populations at fine scales that is unpatterned across space and changes through time. This "chaotic genetic patchiness" suggests that larval pools are not well mixed in the plankton. However, few studies have been able to distinguish among potential causes of spatial and temporal genetic heterogeneity: changes in larval migration patterns, changes in environmental selection, or stochasticity caused by "sweepstakes" reproductive success of spawners creating detectable family structure. Here we use microsatellite markers to show that significant allele frequency shifts occurred sporadically in space and time for cohorts of recruits of Paralabrax clathratus (kelp bass) collected once every two weeks over two years from five sites in the Santa Barbara Channel, California, USA. We found that the pattern of genetic differentiation among cohorts was explained by a combination of (1) family structure in some cohorts, evidenced by half and full siblings, and (2) an indication of changes in larval delivery. It is unlikely but possible that environmental selection also plays a role. Although sampling of potential source populations was incomplete, cohorts arriving during western current flows show most genetic similarity with a population sample collected in the west, and cohorts arriving during current flows from the southeast show similarity with population samples collected in the south and east. Despite the family structure apparent in some cohorts, these "sweepstakes" events occur on too fine a scale to create lasting year class genetic structure. The results corroborate oceanographic models of larval dispersal, which suggest that larval mixing in the plankton is less extensive than previously believed.     

Black carbon and polycyclic aromatic hydrocarbon emissions from vehicles in the United States-Mexico border region: pilot study

The investigators developed a system to measure black carbon (BC) and particle-bound polycyclic aromatic hydrocarbon (PAH) emission factors during roadside sampling in four cities along the United States-Mexico border, Calexico/Mexicali and El Paso/Juarez. The measurement system included a photoacoustic analyzer for BC, a photoelectric aerosol sensor for particle-bound PAHs, and a carbon dioxide (CO2) analyzer. When a vehicle with measurable emissions passed the system probe, corresponding BC, PAH, and CO2 peaks were evident, and a fuel-based emission factor was estimated. A picture of each vehicle was also recorded with a digital camera. The advantage of this system, compared with other roadside methods, is the direct measurement of particulate matter components and limited interference from roadside dust. The study revealed some interesting trends: Mexican buses and all medium-duty trucks were more frequently identified as high emitters of BC and PAH than heavy-duty trucks or passenger vehicles. In addition, because of the high daily mileage of buses, they are good candidates for additional study. Mexican trucks and buses had higher average emission factors compared with U.S. trucks and buses, but the differences were not statistically significant. Few passenger vehicles had measurable BC and PAH emissions, although the highest emission factor came from an older model passenger vehicle licensed in Baja California.     

Characterization of contaminants in snapping turtles (Chelydra serpentina) from Canadian Lake Erie Areas of Concern: St. Clair River, Detroit River, and Wheatley Harbour

PCBs, organochlorine pesticides and dioxins/furans in snapping turtle eggs and plasma (Chelydra serpentina) were evaluated at three Areas of Concern (AOCs) on Lake Erie and its connecting channels (St. Clair River, Detroit River, and Wheatley Harbour), as well as two inland reference sites (Algonquin Provincial Park and Tiny Marsh) in 2001-2002. Eggs from the Detroit River and Wheatley Harbour AOCs had the highest levels of p,p'-DDE (24.4 and 57.9 ng/g) and sum PCBs (928.6 and 491.0 ng/g) wet weight, respectively. Contaminant levels in eggs from St. Clair River AOC were generally higher than those from Algonquin Park, but similar to those from Tiny Marsh. Dioxins appeared highest from the Detroit River. The PCB congener pattern in eggs suggested that turtles from the Detroit River and Wheatley Harbour AOCs were exposed to Aroclor 1260. TEQs of sum PCBs in eggs from all AOCs and p,p'-DDE levels in eggs from the Wheatley Harbour and the Detroit River AOCs exceeded the Canadian Environmental Quality Guidelines. Furthermore, sum PCBs in eggs from Detroit River and Wheatley Harbour exceeded partial restriction guidelines for consumption. Although estimated PCB body burdens in muscle tissue of females were well below consumption guidelines, estimated residues in liver and adipose were above guidelines for most sites.     

The perceived compatibility of safety and production expectations in hazardous occupations

INTRODUCTION: Safety hazards are unavoidable in many work environments. Employees must be both productive and safe, however, conflicting safety and production demands can negatively affect safety, production, or both. The employee's perception of the compatibility of management's safety and production expectations is a possible predictor of such consequences. This paper defines "safety-production compatibility" and describes how measures of safety-production compatibility, as well as safety pressure and production pressure, were developed. METHOD: We used LISREL structural equation modeling to test the influences of safety-production compatibility, safety pressure, and production pressure on safe work behavior and interference with performing other work tasks. The 239 study participants were workers employed in diverse but hazardous occupations. RESULTS: Pressure to work safely was positively associated with safe work behavior. The perceived compatibility of safety and production demands positively influenced safe work behavior and reduced the interference of safety hazards performing other tasks. Safety-production compatibility was also found to mediate the relationship between trust in management and safe work behavior. CONCLUSIONS: The results of this field study suggest increased compatibility, and thus less conflict, between safety and production demands influences safe work behavior and the interference of safety hazards with performing other work tasks. More broadly, the worker's reaction to multiple work demands is a safety and performance influence. IMPACT ON INDUSTRY: Safety management efforts that focus only on the hazards fail to eliminate many accidents because accidents arise from many factors including technology, safety climate, social influences, production, and safety demands. This study suggests that workers differ in their perception of the compatibility of safety and production demands. These differences will show up in safe work behavior, influencing the effectiveness of safety management efforts and the trust workers have in management's concern for safety.