Identification of Driver Model Parameters

The paper presents a driver model, which can be used in a computer simulation of a curved ride of a car. The identification of the driver parameters consisted in a comparison of the results of computer calculations obtained for the driver-vehicle-environment model with different driver data sets with test results of the double lane-change manoeuvre (Standard No. ISO/TR 3888:1975, International Organization for Standardization [ISO], 1975) and the wind gust manoeuvre. The optimisation method allows to choose for each real driver a set of driver model parameters for which the differences between test and calculation results are smallest. The presented driver model can be used in investigating the driver-vehicle control system, which allows to adapt the car construction to the psychophysical characteristics of a driver.     

EU Directive,ICNIRP Guidelines and Polish Legislation on Electromagnetic Fields

This review describes the general provisions of and the philosophy behind European Directive 2004/40/EC and ICNIRP (International Commission on Non-Ionizing Radiation Protection) guidelines. As an example of national legislation on the protection of workers against excessive electromagnetic field exposure, regulations established in Poland are summarized. The problems of a practical implementation of the Directive’s provisions are discussed.     

The Influence of Anchor Devices on the Performance of Retractable Type Fall Arresters Protecting Against Falls From a Height

Retractable type fall arresters are part of the equipment used for protecting people against falls from a height. They are an intermediate part between full body harness worn by a man and the structural anchor at the worksite. The most important task of retractable type fall arresters is to arrest people’s falls and to reduce their harmful consequences. Information received from users as well as laboratories testing protective equipment indicates that the performance of such equipment is incorrect under specific conditions. The paper is concerned with an analysis of the conditions in which retractable type fall arresters demonstrate intermittent performance and with an explanation of that phenomenon. The results of tests investigating anchor devices and the performance of retractable type fall arresters are presented. External and internal factors contributing to intermittent performance have been determined and guidelines for safer use of these devices have been developed.     

Analysis of Conditions and Organization of Work of Notebook Computer Users

Abstract

Aim. The aim of this study was to evaluate working conditions with a notebook computer (notebook) as a potential cause of musculoskeletal disorders. Material and methods. The study had 2 stages. The first one was a questionnaire survey among 300 notebook users. The next stage was an expert analysis of 53 randomly selected workstations. The questionnaire survey included questions about the participants, their working conditions, work organization and also duration of work with a notebook. Results and conclusions. The results of the research showed that most examined operators used a notebook as a basic working tool. The most important irregularities included an unadjustable working surface, unadjustable height of the seat pan and backrest, unadjustable height and distance between the armrests and no additional ergonomic devices (external keyboard, docking station, notebook stand or footstool).     

Efficiency of Filtering Materials Used in Respiratory Protective Devices Against Nanoparticles

The basic aim of this research was to establish the efficiency of filtering materials widely used in respiratory protection devices with particular interest in their porosity, degree of electric and changeable process parameters, such as the flow rate of the test nanoaerosol and the size range of nanoparticles. Tests were carried out with an NaCl solid aerosol of 3.2 × 10⁵ particles/cm³ for the range of particle size of 7–270 nm, at aerosol flow rate of 1800, 2700, 3600, 4500 and 5400 L/h. The tests showed that electrospun nonwovens were the most effective filtering materials for nanoparticles over 20 nm. Melt-blown electret nonwovens with lower porosity than electrospun nonwovens had higher values of penetration of 1%–4%. Those materials provided very efficient protection against nanoparticles of certain sizes only.     

Bioaccumulation of trace elements in wild-growing edible mushrooms from Lubuskie voivodeship,Poland

Cu, Cr, Mn, Ni and Zn contents were quantified for three wild-growing edible species of macrofungi (Boletus edulis, Macrolepiota procera and Cantharellus cibarius) and underlying soil samples collected at forest sites in Lubuskie voivodeship, Poland. The total concentration of the analysed elements was determined using an ASA iCE 3000 series atomic absorption spectrometer. The analysis found significant differences in bioaccumulation between species and differing distributions of trace elements in the caps and stalks of fruiting bodies. Bioaccumulation factors revealed that Zn and Cu are the most bioaccumulated elements, whereas Cr and Mn are excluded from bioaccumulation. Macrolepiota procera showed the highest bioaccumulation of Cu, and Zn is accumulated to the greatest extent by Boletus edulis. A few significant differences (p≤0.05) between the examined species were observed.     

Catalytic wet-air oxidation of a chemical plant wastewater over platinum-based catalysts.

Catalytic wet-air oxidation (CWAO) of wastewater (chemical oxygen demand [COD] = 1800 mg O2/dm3) from a fine chemicals plant was investigated in a fixed-bed reactor at T = 393-473 K under total pressure of 5.0 or 8.0 MPa. Catalysts containing 0.3% wt. of platinum deposited on two supports, mixed silica-titania (SM1) and carbon black composites (CBC) were used. The CBC-supported catalyst appeared to be more active than the SM1-supported one. A slow decrease of activity of the platinum on SM1 (Pt-SM1) during the long-term operation is attributed to recrystallization of titania and leaching of a support component, while the Pt-CBC catalyst is deteriorated, owing to combustion of the support component. The power-law-kinetic equations were used to describe the rate of COD removal at CWAO over the catalysts. The kinetic parameters of COD reduction for the wastewater were determined and compared with the kinetic parameters describing phenol oxidation over the same catalysts. Rates of COD removal for the wastewater were found higher than those for phenol oxidation over the same catalysts and under identical operating conditions.     

Two-dimensional gap analysis: a tool for efficient conservation planning and biodiversity policy implementation

The maintenance of biodiversity by securing representative and well-connected habitat networks in managed landscapes requires a wise combination of protection, management, and restoration of habitats at several scales. We suggest that the integration of natural and social sciences in the form of "Two-dimensional gap analysis" is an efficient tool for the implementation of biodiversity policies. The tool links biologically relevant "horizontal" ecological issues with "vertical" issues related to institutions and other societal issues. Using forest biodiversity as an example, we illustrate how one can combine ecological and institutional aspects of biodiversity conservation, thus facilitating environmentally sustainable regional development. In particular, we use regional gap analysis for identification of focal forest types, habitat modelling for ascertaining the functional connectivity of "green infrastructures", as tools for the horizontal gap analysis. For the vertical dimension we suggest how the social sciences can be used for assessing the success in the implementation of biodiversity policies in real landscapes by identifying institutional obstacles while implementing policies. We argue that this interdisciplinary approach could be applied in a whole range of other environments including other terrestrial biota and aquatic ecosystems where functional habitat connectivity, nonlinear response to habitat loss and a multitude of economic and social interests co-occur in the same landscape.     

The impact of pesticides on oxidative stress level in human organism and their activity as an endocrine disruptor

Pesticides cause serious environmental and health problems both to humans and animals. The aim of this review is to discuss selected herbicides and fungicides regarding their mode of action and their influence on basic oxidative stress parameters and endocrine disruption properties tested in selected cell cultures in vitro. Because of numerous difficulties which animal studies are subject to, cell cultures are an excellent experimental model reflecting human exposure to different pesticides through all relevant routes. This experimental model can be used to monitor aggregate and cumulative pesticide exposures.