Correction to: Design considerations of constructed wetlands to reduce landfill leachate contamination in tropical regions

Journal of Material Cycles and Waste Management - In the original publication of the article, Eq. 5 was published incorrectly. The correct equation is given below.     

Heterogeneous Sulfate Formation on Dust Surface and Its Dependence on Mineralogy: Balloon-Borne Observations from Balloon-Borne Measurements in The Surface Atmosphere of Beijing, China

This study focuses on providing a direct insight into the process by which sulfate is formed on mineral dust surface in the actual atmosphere. Six sets of aerosol measurements were conducted in the outskirts of Beijing, China, in 2002–2003 using a tethered balloon. The mineralogy of individual dust particles, as well as its influence on the S (sulfur) loadings was investigated by SEM-EDX analysis of the directly collected particles. The mixed layer in the urban atmosphere was found to be quite low (500–600m), often appearing as a particle dense stagnant layer above the surface. It is suggested that mineral dust is a common and important fraction of the coarse particles in Beijing (35–68%), and that it is relatively enriched with Calcite (>28%). An exceptional amount of S was detected in the mineral particles, which can be explained neither by their original composition, nor by coagulation processes between the submicron sulfates and the dust. Heterogeneous uptake of gaseous SO₂, and its subsequent oxidation on dust was suggested as the main pathway that has actually taken place in the ambient environment. The mineral class found with the largest number of particles containing S was Calcite, followed by Dolomite, Clay, Amphibole etc., Feldspar, and Quartz. Among them, Calcite and Dolomite showed distinctly higher efficiency in collecting sulfate than the other types. A positive correlation was found with the number of S containing particles and the relative humidity. Calcite in particular, since almost all of its particles was found to contain S above 60% r.h. On the other hand, the active uptake of SO₂ by the carbonates was not suggested in the free troposphere downwind, and all the mineral classes exhibited similar S content. Relative humidity in the free troposphere was suggested as the key factor controlling the SO₂ uptake among the mineral types. In terms of sulfate loadings, the relationship was not linear, but rather increased exponentially as a function of relative humidity. The humidity-dependent uptake capacity of mineral types altogether showed an intermediate value of 0.07 gSO₄ ²⁻ g⁻¹ mineral at 30% r.h. and 0.40 gSO₄ ²⁻ g⁻¹ mineral at 80%, which is fairly consistent with laboratory experiments.     

239+240Pu作为湖泊沉积物计年时标:以云南程海为例

在近代沉积作用领域137Cs时标与210Pb计年结合,获得了广泛而有效的应用.然而,137Cs经过两个半衰期的衰变已难于辩识.环境中的Pu核素具有相对较长的半衰期,也随全球大气扩散而散落于地球表面,可望作为沉积计年的时间标志.通过程海沉积物柱芯中239+240Pu比活度、240Pu/239Pu原子比率及校正到沉积年代的...     

Abundance, growth and life cycle of the mesopelagic amphipod Primno abyssalis (Hyperiidea: Phrosinidae) in the Oyashio region, western subarctic Pacific

Abundance and life-cycle features of the mesopelagic hyperiid amphipod Primno abyssalis (formerly P. macropa) in the Oyashio region, western subarctic Pacific, were investigated using samples collected between July 1996 and July 1998. P. abyssalis was collected throughout the entire survey period, with abundance peaks occurring in spring to autumn. While all maturity stages of males and females were observed throughout the study period, the peak reproduction season was in summer. Instar analysis based on the segment number of the pleopod rami indicated that hatched juveniles molted 10 times before becoming adult males and 13 times before becoming adult females. Judging from the dry and ash-free dry weights of each instar, males and females continued to feed throughout the final instar stage. Based on cohort analysis of seasonal samples and laboratory observations on molting frequencies, growth in body length of P. abyssalis was linear with time, and estimated generation lengths were 2.3-3.8 years for females and 1.4-1.9 years for males. Brood size of females ranged from 66 to 337 and increased with increasing female body length. Lifetime fecundity, calculated as the sum of six successive broods, was 1,004. Compared with P. abyssalis in the southern Sea of Japan, those in the Oyashio region have a larger number of adult instars (six versus five for females, three 3 vs one for males), a lower growth rate (0.014 mm day^-1 vs 0.021 mm day^-1), and mature earlier (instar 13 vs instar 15 for females; instar 10 vs instar 11 for males). These characteristics are considered to be advantageous life-history traits to counteract higher niche competition within the mesopelagic community and higher predation pressure by mesopelagic fishes in the Oyashio region than in the Sea of Japan.     

The influence of lower extremity postures on kinematics and injuries of cyclists in vehicle side collisions

Objective: A cyclist assumes various cyclic postures of the lower extremities while pushing the pedals in a rotary motion while pedaling. In order to protect cyclists in collisions, it is necessary to understand what influence these postures have on the global kinematics and injuries of the cyclist.

Method: Finite element (FE) analyses using models of a cyclist, bicycle, and car were conducted. In the simulations, the Total Human Model of Safety (THUMS) occupant model was employed as a cyclist, and the simulation was set up such that the cyclist was hit from its side by a car. Three representative postures of the lower extremities of the cyclist were examined, and the kinematics and injury risk of the cyclist were compared to those obtained by a pedestrian FE model. The risk of a lower extremity injury was assessed based on the knee shear displacement and the tibia bending moment.

Results: When the knee position of the cyclist was higher than the hood leading edge, the hood leading edge contacted the leg of the cyclist, and the pelvis slid over the hood top and the wrap-around distance (WAD) of the cyclist's head was large. The knee was shear loaded by the hood leading edge, and the anterior cruciate ligament (ACL) ruptured. The tibia bending moment was less than the injury threshold. When the cyclist's knee position was lower than the hood leading edge, the hood leading edge contacted the thigh of the cyclist, and the cyclist rotated with the femur as the pivot point about the hood leading edge. In this case, the head impact location of the cyclist against the car was comparable to that of the pedestrian collision. The knee shear displacement and the tibia bending moment were less than the injury thresholds.

Conclusion: The knee height of the cyclist relative to the hood leading edge affected the global kinematics and the head impact location against the car. The loading mode of the lower extremities was also dependent on the initial positions of the lower extremities relative to the car structures. In the foot up and front posture, the knee was loaded in a lateral shear direction by the hood leading edge and as a result the ACL ruptured. The bicycle frame and the struck-side lower extremity interacted and could influence the loadings on lower extremities.     

Proximate composition of household waste and applicability of waste management technologies by source separation in Hanoi,Vietnam

The organic fraction of municipal solid wastes in Southeast Asia, which has a high moisture content, accounts for a large proportion of total waste. Local governments need to pay adequate attention to the composition of wastes to determine alternative waste management technologies. This study proposed the use of a triangle diagram to describe changes in proximate composition and rates of successful source separation of municipal solid waste and to identify technical challenges about alternative waste management technologies such as incineration, composting, and refuse-derived fuel production based on physical and proximate composition analysis of household waste sampled in Hanoi, Vietnam, as a case study. The analysis indicated the effectiveness of different types of source separation as well as different levels of successful achievement of source separation as an adjustment mechanism for the proximate composition of waste. Proper categorization of wastes for source separation is necessary for the appropriate use of alternative waste management technologies. The results showed that, at a source separation rate of just greater than 0.52 in a three-way separation scheme, the waste separated as combustible waste would be suitable for incineration with energy recovery. Based on well-designed schemes of source separation, alternative waste management technologies can be applied.     

Characterization of Pu concentration and its isotopic composition in soils of Gansu in northwestern China

The total ^239+240Pu activities and ²⁴⁰Pu/²³⁹Pu atom ratios in surface soil samples (0–5 cm) in the Kumtag Desert in western Gansu Province, and in a soil core sample in Lanzhou were investigated using a sector-field ICP-MS. In the surface soil samples, ^239+240Pu activities in fine particles (<150 μm) were 1.3–2.1 times of those in coarse particles (150 μm–1 mm) which ranged from 0.005 to 0.157 mBq/g. Atom ratios of ²⁴⁰Pu/²³⁹Pu in the surface soils ranged from 0.168 to 0.192 with a mean of 0.182 ± 0.008. The mean ratio was similar to the typical global fallout value although the Kumtag Desert was believed to have received close-in fallout derived from Chinese nuclear weapons tests mainly conducted in the 1970s. Furthermore, the mean ²⁴⁰Pu/²³⁹Pu atom ratio observed in the soil core sample in Lanzhou was similar to the typical global fallout value. In the soil core sample, ^239+240Pu activities in the various layers ranged from 0.012 to 0.23 mBq/g, and the inventory of ^239+240Pu (32.4 Bq/m², 0–23 cm) was slightly lower than that expected from global fallout (42 Bq/m²) at the same latitude. Rapid downward migration of Pu isotopes was observed in Lanzhou soil core sample layers. The contribution of the 10-cm deep top layers of surface soils to total inventory was only 17%, while the contribution of deeper layers (10–23 cm) was as high as 83%. The ^239+240Pu activity levels and ²⁴⁰Pu/²³⁹Pu atom ratios in soils in Gansu Province, China are similar to those in atmospheric deposition samples collected in the spring in recent years in Japan.     

Photodechlorination of octachlorodibenzothiophene and octachlorodibenzofuran: comparison of experimental degradation pathways with degradation pathways predicted by DFT

Polychlorodibenzothiophenes (PCDTs) are sulfur analogues of polychlorodibenzofurans (PCDFs) and have been detected in environmental samples. We used density functional theory calculations (Gaussian 98W) to predict the photodechlorination pathways of octachlorodibenzothiophene (OCDT) and octachlorodibenzofuran (OCDF) in hexane, and we compared the predicted pathways with those observed during UV irradiation experiments. OCDT and OCDF were observed to degrade through first-order dechlorination processes, and the rate constant for OCDT was less than one-third that for OCDF. The main experimental photodechlorination pathways of OCDT and OCDF led to hexachlorinated and tetrachlorinated congeners, respectively; that is, the photodechlorination pathway of OCDT differed from that of OCDF. On the assumption that the dechlorination mechanisms involved radical reactions, we used DFT calculations to estimate bond-dissociation energies and single-point energies of OCDT and OCDF and their dechlorinated congeners, and we used the resulting information, along with hypotheses regarding the rate-controlling step of the degradations, to predict theoretical degradation pathways. We propose that reaction of dechlorinated radicals with a hydrogen donor was the rate-controlling step for OCDT and that C-Cl bond dissociation by UV light was the rate-controlling step for OCDF.     

Design considerations of constructed wetlands to reduce landfill leachate contamination in tropical regions

In tropical regions, landfill leachate contamination at municipal solid waste disposal sites is a critical issue because of the large volume of highly contaminated leachate formed during the rainy season. We evaluated the efficacy of constructed wetlands (CWs) with the ability to reduce the water volume and pollutant levels to reduce leachate contamination compared to the most commonly used treatment system, stabilization ponds, based on parameters obtained in a field experiment in Thailand. The simulation indicated that CWs had a higher potential to reduce the water volume than stabilization ponds over the course of a year. Scenario evaluations under varying initial water depths, system depths, and area sizes indicated that the CWs could reduce the treatment area to prevent overflow and leachate pollution. In addition, the CWs were estimated to reduce the leachate amount and pollution by 83–100% and 92–99%, respectively. When there is limited land available, deeper CWs can be used to sustainably prevent contamination from leachate overflow. Effectively designed CW systems may be valuable for both reducing the required area and the contamination; therefore, CWs are a promising option for sustainable landfill leachate treatment systems in developing tropical regions.