金属离子对δ-MnO2 去除对叔辛基酚抑制作用的研究

研究了pH 4.0的水溶液中各种金属离子对合成的δ-MnO2去除对叔辛基酚(4-t-OP)的影响.实验表明反应150 min时,δ-MnO2对4-t-OP的去除率达到100%,但当反应体系中含有金属离子时,去除效果受到抑制.抑制效果随金属离子浓度的增加而增大,并随金属离子的不同表现出较大的差异.在pH 4.0条件下,Pb2+和Mn2+的抑制效果最强,其次为过渡金属离子,再次是碱土金属离子,而碱金属离子基本上不产生抑制作用.还比较了δ-MnO2对多种金属离子的吸附能力,其对Pb2+的吸附作用最强,在其余的金属离子中,对过渡金属离子的吸附量稍大于碱土金属离子.结果表明,金属离子所产生抑制作用的源于其占据了δ-MnO2表面反应位点并与4-t-OP形成竞争,而抑制作用大小的差异主要来源于δ-MnO2与金属离子间吸附作用强弱的差别,MnO2表面结构的变化,以及溶液中自由态金属离子的分布比例及其离子半径的不同.     

三峡库区大宁河枯水期藻细胞的时空分布

本研究旨在为三峡库区大宁河藻华预警提供基础数据,于2011年4～9月期间在大宁河流域选择4个取样点开展藻细胞时空变化研究.藻细胞在时间序列表现为:4～9月,藻种主要以蓝藻、绿藻和硅藻为主,藻密度呈逐步递增趋势;在此期间4个取样点的蓝藻比重均逐步增大,硅藻比重逐步降低,绿藻比重变化不显著.藻细胞在空间分布上表现为:藻密度与水温和叶绿素呈极显著相关,相关系数分别为0.97和0.95,与光照、溶解氧、pH值和可溶性磷盐呈显著相关,相关系数分别为0.87、0.83、0.82、0.82;菜子坝在整个试验期间0 m处藻密度比其他水层的藻密度高,白水河在6月和7月的2.0 m处藻密度最高,双龙在7、8和9月的0 m和2.0 m处藻密度较高,大昌在整个试验期间,藻密度变化不大;不同藻细胞在垂向水层中的比重也随时间的变化而改变,可能是不同藻细胞适合不同生态环境所致.     

pH过程控制对铁炭微电解-Fenton影响中试研究

采用铁炭微电解-Fenton联合工艺处理制药废水生化出水,探讨了初始pH对微电解过程COD降解速率、出水中Fe2+和Fe3+变化规律以及后续Fenton氧化效果的影响,为优化联合工艺提出了微电解反应pH过程控制的理论。采用pH过程控制时,微电解对COD降解速率大大提高,降解过程基本符合零级反应动力学,同时可大大提高Fe2+和Fe3+浓度及总铁析出量。试验结果表明:当初始pH=2.5,以3.0L/h连续性投加稀硫酸100 min,曝气微电解反应2 h,出水再投加1.0mL/L的H2O2进行Fenton氧化2 h,出水COD总去除率可达85.6%;采用pH过程控制可将微电解出水ρ(Fe2+)浓度从48.6 mg/L提高至149 mg/L,COD降解速率从10.9 mg/(L·h)提高至23.8 mg/(L·h)。     

不同Fe(Ⅲ)对活性污泥异化铁还原及除磷影响研究

以SBBR反应器活性污泥作为铁还原菌菌种来源,采用兼性厌氧/严格厌氧恒温培养试验,投加不同Fe(Ⅲ)考察各条件下的异化铁还原能力同时比较对磷的去除效果.结果表明:2种条件下Fe(Ⅲ)还原能力具有较好的一致性,依次为:Fe(OH)3＞氧化铁皮＞青矿＞红矿,其中严格厌氧条件下较好.同时,除磷效果与其呈正相关,富集培养至7d,Fe(OH)3及氧化铁皮体系出水磷浓度均达到2mg/L以下,之后继续降低,最终达到0.5mg/L以下.结合异化铁还原除磷机理,可以证明,不同Fe(Ⅲ)表面吸附作用对TP的去除贡献较小,其主要作用为铁还原菌驱动下的化学沉淀去除.     

天津近岸表层沉积物重金属和放射性核素分布特征

对渤海湾天津海域14个表层沉积物样品进行粒度、重金属和核素放射性活度测量,结果显示,沉积物组成以粉砂为主,其粒径在研究区横纵向上分别呈由南至北、由东至西逐渐变粗的分布特征.重金属元素含量为Cu:25.6~35.1mg/kg、Pb:44.1~67.7mg/kg、Zn:60~73.5mg/kg;210Pb活度为13.2~35.3Bq/kg,137Cs活度为0.05~1.28Bq/kg,重金属含量和放射性活度随粒径减小而增大,总体上呈由北至南逐渐增大的分布特征,在中部和南部分别呈由西北至东南和由西至东逐渐增大的分布特征.这主要是因为细颗粒组分对Cu、Pb、Zn、210Pb和137Cs的吸附作用大于粗颗粒组分,因此,其分布受渤海湾水流及其所导致的粒径变化所影响.     

Iron and lead ion adsorption by microbial flocculants in synthetic wastewater and their related carbonate formation

Although microbial treatments of heavy metal ions in wastewater have been studied, the removal of these metals through incorporation into carbonate minerals has rarely been reported. To investigate the removal of Fe^3＋ and Pb^2＋, two representative metals in wastewater, through the precipitation of carbonate minerals by a microbial flocculant （MBF） produced by Bacillus mucilaginosus. MBF was added to synthetic wastewater containing different Fe^3＋ and Pb^2＋ concentrations, and the extent of flocculation was analyzed. CO2 was bubbled into the mixture of MBF and Fe^3＋/Pb^2＋ to initiate the reaction. The solid substrates were analyzed via X-ray diffraction, transmission electron microscopy and energy dispersive spectroscopy. The results showed that the removal efficiency decreased and the MBF adsorption capacity for metals increased with increasing heavy metal concentration. In the system containing MBF, metals （Fe^3＋ and Pb^2＋）, and CO2, the concentrated metals adsorbed onto the MBF combined with the dissolved CO2, resulting in oversaturation of metal carbonate minerals to form iron carbonate and lead carbonates. These results may be used in designing a method in which microbes can be utilized to combine CO2 with wastewater heavy metals to form carbonates, with the aim of mitigating environmental problems.     

Interface-mediated synthesis of monodisperse ZnS nanoparticles with sulfate-reducing bacterium culture

We have created a new method of ZnS nanospheres synthesis. By interface-mediated precipitation method (IMPM), monodisperse ZnS nanoparticles was synthesized on the particle surface of sulfate-reducing bacterium nutritious agar culture. Sulfate-reducing bacterium (SRB) was used as a sulfide producer because of its dissimilatory sulfate reduction capability, meanwhile produced a variety of amino acids acting as templates for nanomaterials synthesis. Then zinc acetate was dispersed into nutritious agar plate. Subsequently agar plate was broken into particles bearing much external surface, which successfully mediated the synthesis of monodisperse ZnS nanoparticles. The morphology of monodisperse ZnS nanospheres and SRB were examined by scanning electron microscopy (SEM), and the microstructure was investigated by X-ray diffraction (XRD). The thermostability of ZnS nanoparticles was determined by thermo gravimetric-differential thermo gravimetric (TG-DTG). The maximum absorption wavelengh was analysed with an ultraviolet-visible spectrophotometer within a range of 199–700 nm. As a result, monodisperse ZnS nanoparticles were successfully synthesized, with an average diameter of 80 nm. Maximum absorption wavelengh was 228 nm, and heat decomposed temperature of monodisperse ZnS nanoparticles was 596°C.     

Interface-mediated synthesis of monodisperse ZnS nanoparticles with sulfate-reducing bacterium culture

We have created a new method of ZnS nanospheres synthesis. By interface-mediated precipitation method (IMPM), monodisperse ZnS nanoparticles was synthesized on the particle surface of sulfate-reducing bacterium nutritious agar culture. Sulfate-reducing bacterium (SRB) was used as a sulfide producer because of its dissimilatory sulfate reduction capability, meanwhile produced a variety of amino acids acting as templates for nanomaterials synthesis. Then zinc acetate was dispersed into nutritious agar plate. Subsequently agar plate was broken into particles bearing much external surface, which successfully mediated the synthesis of monodisperse ZnS nanoparticles. The morphology of monodisperse ZnS nanospheres and SRB were examined by scanning electron microscopy (SEM), and the microstructure was investigated by X-ray diffraction (XRD). The thermostability of ZnS nanoparticles was determined by thermo gravimetric-differential thermo gravimetric (TG-DTG). The maximum absorption wavelengh was analysed with an ultravioletvisible spectrophotometer within a range of 199-700 nm. As a result, monodisperse ZnS nanoparticles were successfully synthesized, with an average diameter of 80 nm. Maximum absorption wavelengh was 228 nm, and heat decomposed temperature of monodisperse ZnS nanoparticles was 596℃.     

基于阳离子树脂的Fenton非均相催化剂制备及性能测试

采用阳离子交换树脂颗粒为催化剂载体采用浸渍法负载二价铁离子,制备出非均相Fenton反应催化剂,并用该非均相Fenton催化剂氧化脱色亚甲基蓝溶液,考察其催化性能。实验结果表明:制备催化剂时最佳FeSO4浓度为16.67 mmol/L,pH=3.0,H2O2初始浓度为46.6 mmol/L,反应时间为30 min的条件下,亚甲基蓝溶液初始浓度为0.028 mmol/L时,亚甲基蓝溶液在非均相Fenton催化氧化过程中,其脱色率可达92.9%。采用序批形式反应使用5次后,该非均相催化剂仍有良好的催化效果,反应30 min后亚甲基蓝溶液脱色率仍可达85.2%,拓宽了Fenton技术的使用范围。     

SPE-UFLC-MS/MS法测定制药废水中四环素类抗生素

文章建立了利用固相萃取-超快速液相色谱-串联质谱(SPE-UFLC-MS/MS)测定制药废水中四环素类抗生素(土霉素、四环素和金霉素)残留的方法。水样经(30%硫酸锌+20%亚铁氰化钾)溶液作为沉淀剂沉淀蛋白质后,上清液采用Oasis HLB固相萃取柱富集和净化,以(0.1%甲酸溶液+乙腈)为流动相进行梯度洗脱,经Agilent ZORBAX SB C18柱分离后,在串联质谱ES(I+)模式下进行MRM检测。该方法四环素类抗生素检出限(S/N=3时)0.02μg/L,3种目标物在0.010¹.0 mg/L范围内线性关系良好,线性相关系数在0.998 21.0 mg/L范围内线性关系良好,线性相关系数在0.998 2⁰.999 8之间。在0.20、0.40和0.60μg/L添加水平,各组分的回收率在80.8%0.999 8之间。在0.20、0.40和0.60μg/L添加水平,各组分的回收率在80.8%⁹7.2%之间,相对标准偏差在5.31%97.2%之间,相对标准偏差在5.31%⁹.92%之间。该方法可满足制药废水中四环素类抗生素残留检测的要求。