采用两级物化法去除黄磷废水中的氟化物

采用向含氟废水中加入适量石灰和聚合氯化铝，然后投加适量钙盐、磷酸和聚丙烯酰胺的二级处理工艺除氟，通过控制合适的pH、钙盐和磷酸的投加量、反应时间、反应温度、搅拌强度和絮凝剂的投加量，可使黄磷废水中氟的质量浓度降至5mg/L，氟的去除率达到99％以上，出水中氟的质量浓度达到GB8978－1996一级排放标准。     

多相催化湿式氧化法处理高浓度难降解有机废水的研究

在高压反应釜内，采用自制颗粒贵金属催化剂催化湿式氧化法处理高浓度饲料抗氧化剂合成废水，探讨了温度、压力、进水pH等反应条件对废水处理效果的影响。在温度为220℃、总压为8MPa条件下，COD，TOC，TN和色度的去除率分别达到77．0％，66．1％，70．2％，91％；处理后的废水pH很低，催化剂显示出较好的耐酸性；随进水pH的增加，COD的去除率逐渐降低，出水pH增加。     

再燃法烟气脱硝技术

综述了再燃法烟气脱硝技术及其主要影响因素。通过对几种脱硝技术的分析比较，认为再燃脱硝是一种很有前景的脱硝技术，其投资和运行费用界于低NO。燃烧器和选择性催化还原技术之间，有喷氨条件下的先进再燃脱硝效率接近于选择性催化还原技术。总结了国内外对先进再燃脱硝技术各种参数影响条件的研究结果，并论述了该技术的应用要点。     

竹炭对废水中Cu2+的吸附

探讨了竹炭粒径、加入量、溶液 pH、吸附时间、Cu2+初始质量浓度等因素对竹炭吸附 Cu2+效果的影响.实验结果表明:竹炭对废水中Cu2+有很好的吸附效果,当竹炭粒径小于0.15 mm、加入量为 16 g/L、溶液 pH 为 6.0、Cu2+初始质量浓度 25 mg/L、吸附时间为 1.5 h 时,竹炭对 Cu2+的去...     

NH3选择性还原NOx催化剂的制备及性能评价

以堇青石蜂窝陶瓷为载体,采用TiO2浆液涂覆载体,再负载活性组分V和W,制备了NH3选择性还原NOx催化剂,研究了TiO2涂层的制备工艺条件,并对催化剂的活性及稳定性进行了评价.实验结果表明,制备TiO2涂层的最佳工艺条件为:TiO2浆液中铝溶胶质量分数12％,浆液pH 1.91,浆液固含量(TiO2与铝溶胶中Al2O...     

The Relation Between Sandstorms and Strong Winds in Xinjiang,China

With observational data spanning 1961–1999 from 90 meteorological stations in Xinjiang, China, the spatial and temporal characteristics of sandstorms and strong winds, and the contribution of strong winds to the occurrence of sandstormsare analyzed. Moreover, the dominant wind direction and minimumwind speeds during sandstorm periods are discussed. The research shows that although possessing similar climatic trends, sandstorms and strong winds in Xinjiang have opposite geographical distributions, i.e. places with more sandstorms show fewer strong winds. The contribution of strongwinds to sandstorms in northern Xinjiang is larger than that insouthern Xinjiang. The dominant wind directions clearly indicatethe paths of the weather systems that introduced the sandstorms.The minimum wind speeds in the sandstorms were over 10 ms^-1in northern and eastern Xinjiang and in the Turpan and Yanqi Basins of southern Xinjiang. In Tarim Basin of southern Xinjiang,however, the minimum wind speed was about 6–8 ms^-1, and even 6 ms^-1 at its southern edge.     

混凝—催化氧化法处理丁苯橡胶生产废水

以聚合氯化铝（PAC）、阴离子聚丙烯酰胺（PAM）为混凝剂,以H2O2-O3为氧化剂,采用混凝-催化氧化法处理对丁苯橡胶生产废水。考察了混凝剂种类及其加入量、废水pH对混凝处理效果的影响,氧化剂及其加入量、反应时间和废水pH对COD去除率的影响。实验得出的最佳工艺条件：混凝实验,废水pH为7、PAC和PAM加入量为400mg／L和4mg／L;催化氧化实验,废水pH为7～8、H2O2加入量为200mg／L、H2O2与O3的质量比为0．5。处理后,废水COD从860mg／L降至145mg／L,COD去除率达83．1％,出水水质达到国家二级排放标准。     

Status and fuzzy comprehensive assessment of combined heavy metal and organo-chlorine pesticide pollution in the Taihu Lake region of China

The status of combined heavy metal and organo-chlorine pesticide (OCPs; i.e. HCH and DDT) pollution was investigated and the soil environmental quality of the Taihu Lake watershed, one of the most developed regions in China, was evaluated using a fuzzy comprehensive assessment. Statistical analyses showed the presence of combined pollution in the soil. At many sampling sites, heavy metal concentrations were above corresponding background values, indicating the effects of extraneous pollutants. It has been over 20 years since China banned the use of OCPs, but they can still be found in soil samples of this region. HCH levels at all investigated sites were below the Chinese Environmental Quality Standard for Soils. Fuzzy comprehensive assessment showed that the overall soil quality in this region could be categorized as class I. Nevertheless, the high coefficients of variation for levels of DDT, Cd and Hg indicated the existence of some point-source pollution. Continuous monitoring and further studies of the region are recommended to prevent pollution of farmland from these sources.     

室内空气中污染物的检测技术

室内环境空气污染对人体健康影响很大,文中指出了影响人体健康的致病因子,分析了单个微粒的光通量和粒径之间的关系。鉴于单下颗粒的散射光信号很弱,本文提出一种方法,把激光器的内腔作为颗粒注入区,利用激光器的内腔功率谱密度远大于腔外功率密度的特点,结合先进的激光散控制理论,对空气中的颗粒进行检测。     

OPTIMAL IDENTIFICATION OF MUSKINGUM ROUTING COEFFICIENTS1

Traditionally, identification of the Muskingum routing coefficients has been based on observations of the linearity of a loop formed by graphically plotting a forward and a reverse path. This graphical procedure is time-consuming and may not minimize the error of estimation. A procedure was developed to improve the drawbacks of the graphical method. This procedure calls for (a) the use of least square regression on the forward and reverse paths to determine their respective slopes, and (b) the use of statistical t-test to evaluate the hypothesis that these two slopes are equal. The computational procedure is repeated, using incremental values of the flow weighting coefficient, x. A graph of the computed t-value versus x can be constructed. The optimal value of x, as read from the graph, occurs at the minimum computed t-value. The procedure has been demonstrated superior to the graphical method for three illustrative examples, resulting in a reduction of the error squares by factors ranging from 5 to 6.