无银催化-分光光度法测定COD的研究

以XS-LP为催化剂,探讨了改进的无银催化HACH法测定污水中COD的系列条件实验。结果表明:在药剂A,B的投配比为1∶2,投加总量为12 g/L的条件下,其准确度、精密度与国标法有较好的可比性,分别小于10%和3%;对实际废水的测量结果与国标回流法的相关系数分别高达0.9951和0.9874,可满足一般环境检测技术规范要求。     

表面活性剂清洗处理重度石油污染土壤

为了优化表面活性剂清洗处理重度石油污染土壤的方法和具体洗脱条件参数,采集山东省东营市胜利油田污染土壤,研究了阴离子-非离子混合表面活性剂对该土壤中石油类污染物的去除效果。应用化学热洗原理,主要考查了表面活性剂配比、投加量、清洗温度及清洗助剂对去除效果的影响。实验得到的清洗处理最佳条件为：使用LAS与TX-100质量比为8∶2的组合表面活性剂,总表面活性剂浓度为3 g/L,助剂硅酸钠浓度为5 g/L,75℃条件下搅拌1 h。清洗后土壤含油量从20%下降到4.6%,去除率达到76.9%。废水回用实验表明,清洗处理的废水对土壤中石油烃类物质仍有一定的去除效果。废水回用比从30%到100%时,对土壤中石油烃的去除率都可达到55%以上。对废水进行二次回用时仍能去除18.8%的污染物。     

高锰酸钾降解地下水中PCE的研究

以氯代有机污染物中常见的PCE为目标污染物,以自制高锰酸钾溶液为氧化剂,采用批实验方法,探讨了高锰酸钾降解PCE的反应动力学、影响因素以及反应机理。反应结果表明,高锰酸钾降解PCE的反应符合一级动力学方程,反应活化能E为57.119 kJ/mol,在30℃条件下,反应速率常数为0.0076 min^-1,半衰期为91.20 min。在pH在3～10,离子强度在0～0.1030 mol/L之间变化时,反应速率不受明显影响。     

含中间层的DSA电极电催化氧化硝基苯废水的研究

为了提高难降解有机废水的可生化性,以及更高效地去除废水中的特征污染物,同时避免二次污染,利用自制的含锡锑中间层的钌钯氧化物涂层电极对有机废水中的硝基苯进行处理,并利用SEM、XRD等方法对电极中间层、表层进行微观表征。微观测试表明,基体、中间层、表层之间结合力较强,有利于增强电极寿命;水处理实验表明,电催化氧化反应体系适合高浓度有机废水的处理,由于该反应体系需要外加电解质加强传质,这在实际运用中为废水中盐度的处理提供了一种新的途径,当电流密度为20 mA/cm²、电解质浓度为10 g/L、pH=5、极板间距=2 cm时,电催化氧化体系对硝基苯具有较高的去除效率。     

The quest for environmental justice in China: citizen participation and the rural–urban network against Panguanying’s waste incinerator

Environmental distribution conflicts (EDCs) related to the construction and operation of waste incinerators have become commonplace in China. This article presents a detailed case study of citizen opposition to an incinerator in the village of Panguanying, Hebei Province. Drawing on in-depth fieldwork, we show how this case was notable, because it transcended the local arena to raise bigger questions about environmental justice, particularly in relation to public participation in siting decisions, after villagers exposed fraudulent public consultation in the environmental impact assessment. An informal network between villagers and urban environmental activists formed, enabling the Panguanying case to exert influence far beyond the village locality. This network was critical in creating wider public debate about uneven power and substandard public participation in siting disputes, a central feature in many Chinese EDCs. By transcending local specificities and exposing broader, systemic inadequacies, this case became instrumental in supporting “strong sustainability”.     

De novo formation of dioxins from milled model fly ash

Environmental Science and Pollution Research - Municipal solid waste incineration (MSWI) fly ash has been classified as hazardous waste and needs treatment in an environmentally safe manner....     

Distribution and controls of heavy metals and organic matter in the surface sediments of the Southern Yellow Sea,China

Environmental Science and Pollution Research - Accurate and effective determination of the source of heavy metals is essential for the treatment of marine ecological environments. This article...     

Treatment of 1,3-Butadiene in an Air Stream by a Biotrickling Filter and a Biofilter

ABSTRACT

This paper presents results obtained from a performance study on the biotreatment of 1,3-butadiene in an air stream using a reactor that consisted of a two-stage, in-series biotrickling filter connected with a three-stage, in-series biofilter. Slags and pig manure-based media were used as packing materials for the biotrickling filter and the biofilter, respectively. Experimental results indicated that, for the biotrickling filter portion, the butadiene elimination capacities were below 5 g/m³/hr for loadings of less than 25 g/m³/hr, and the butadiene removal efficiency was only around 17%. For the biofilter portion, the elimination capacities ranged from 10 to 107 g/m³/hr for loadings of less than 148 g/m³/hr. The average butadiene removal efficiency was 75–84% for superficial gas velocities of 53–142 m/hr and a loading range of 10–120 g/m³/hr. The elimination capacity approached a maximum of 108 g/m³/hr for a loading of 150 g/m³/hr. The elimination rates of butadiene in both the biotrickling filter and biofilter were mass-transfer controlled for influent butadiene concentrations below about 600 ppm for superficial gas velocities of 29–142 m/hr. The elimination capacity was significantly higher in the biofilter than in the biotrickling filter. This discrepancy may be attributed to the higher mass-transfer coefficient and gas-solid interfacial area offered for transferring the gaseous butadiene in the biofilter.     

甲基氯硅烷生产废液制备氯化氢和有机硅树脂

研究了将高、低沸点甲基氯硅烷生产废液分别通过醇解和水解反应制备HCl和有机硅树脂的工艺方法,考察了醇解时间、醇解温度和m(废液)∶m(甲醇)等因素对产物收率的影响.实验得到最佳反应条件为:m(废液)∶m(甲醇)=1∶0.5,醇解温度65℃,醇解时间2h.在该条件下由高、低沸点废液制得的有机硅树脂收率分别为43.2％和40.6％.将制得的有机硅树脂经500℃干燥处理后,可作为填料,制备有机硅树脂-聚氯乙烯复合材料.该材料的力学性能与SiO2 -聚氯乙烯复合材料接近.     

Pyrolysis behavior of tire-derived fuels at different temperatures and heating rates

Pyrolytic product distribution rates and pyrolysis behavior of tire-derived fuels (TDF) were investigated using thermogravimetric analyzer (TGA) techniques. A TGA was designed and built to investigate the behavior and products of pyrolysis of typical TDF specimens. The fundamental knowledge of TGA analysis and principal fuel analysis are applied in this study. Thermogravimetry of the degradation temperature of the TDF confirms the overall decomposition rate of the volatile products during the depolymerization reaction. The principal fuel analysis (proximate and ultimate analysis) of the pyrolytic char products show the correlation of volatilization into the gas and liquid phases and the existence of fixed carbon and other compounds that remain as a solid char. The kinetic parameters were calculated using least square with minimizing sum of error square technique. The results show that the average kinetic parameters of TDF are the activation energy, E = 1322 +/- 244 kJ/mol, a pre-exponential constant of A = 2.06 +/- 3.47 x 10(10) min(-1), and a reaction order n = 1.62 +/- 0.31. The model-predicted rate equations agree with the experimental data. The overall TDF weight conversion represents the carbon weight conversion in the sample.