Achieving sustainable homes by 2016 in the UK: the current status

The code for sustainable homes (CSH), which came into existence in 2006, has not yet been investigated to determine whether its rate of adoption is on course to meet the UK government’s 2016 target for full implementation. Therefore, the aim of this investigation is to ascertain the level to which CSH has been implemented and the barriers preventing this. A questionnaire survey was sent to 71 of the Home Builders Federation (HBF) member organisations in the UK, to gauge and ascertain the following: the barriers to the implementation of CSH; the implications of implementation; and the general awareness of CSH amongst practitioners. The results from the analysis of the survey reveal that full implementation by 2016 appears a rather difficult target, as factors like economic downturn are hitting HBF and similar organisations quite hard. However, a government-driven injection of sustainable schemes is helping to bring back confidence to house builders, while also enhancing the way that barriers are handled within the industry. The key findings of the literature review identify barriers preventing the housing sector from achieving zero carbon homes by 2016. These include cost, and legislative, cultural and technical barriers, and are concordant with the results from the data obtained during the primary research. The analysis suggests that with the current trend, achieving full implementation will be difficult. However, comments made by some practitioners appear to suggest that the appointment of a CSH champion for implementation would accelerate the process of full implementation and that the target could be reached by 2016.     

Variations of arsenic species content in edible Boletus badius growing at polluted sites over four years

The content of arsenic (As) in mushrooms can vary depending on the concentration level of this metalloid in the soil/substrate. The present study evaluated the content of arsenic in Boletus badius fruiting bodies collected from polluted and non-polluted sites in relation to the content of this element in overgrown substrate. It was found that mushrooms from the arsenic-polluted sites contained mean concentrations from 49 to 450 mg As kg^?1 dry matter (d.m.), with the greatest content found for specimens growing in close proximity of sludge deposits (490±20 mg As kg^?1d.m.). The mean content of total arsenic in mushrooms from clean sites ranged from 0.03 to 0.37 mg kg^?1 It was found that B. badius could tolerate arsenic in soil substrate at concentrations of up to 2500 mg kg^?1, at least. In different years of investigation, shifts in particular arsenic forms, as well as a general increase in the accumulation of organic arsenic content, were observed. The results of this study clearly indicate that B. badius should not be collected for culinary purposes from any sites that may be affected by pollution.     

The variations of aluminium species in mountainous forest soils and its implications to soil acidification

Aluminium (Al) speciation is a characteristic that can be used as a tool for describing the soil acidification process. The question that was answered is how tree species (beech vs spruce) and type of soil horizon affect Al speciation. Our hypotesis is that spruce and beech forest vegetation are able to modify the chemical characteristics of organic horizon, hence the content of Al species. Moreover, these characteristics are seasonally dependent. To answer these questions, a detailed chromatographic speciation of Al in forest soils under contrasting tree species was performed. The Jizera Mountains area (Czech Republic) was chosen as a representative mountainous soil ecosystem. A basic forestry survey was performed on the investigated area. Soil and precipitation samples (throughfall, stemflow) were collected under both beech and spruce stands at monthly intervals from April to November during the years 2008–2011. Total aluminium content and Al speciation, pH, and dissolved organic carbon were determined in aqueous soil extracts and in precipitation samples. We found that the most important factors affecting the chemistry of soils, hence content of the Al species, are soil horizons and vegetation cover. pH strongly affects the amount of Al species under both forests. Fermentation (F) and humified (H) organic horizons contain a higher content of water extractable Al and Al³⁺ compared to organo-mineral (A) and mineral horizons (B). With increasing soil profile depth, the amount of water extractable Al, Al³⁺ and moisture decreases. The prevailing water-extractable species of Al in all studied soils and profiles under both spruce and beech forests were organically bound monovalent Al species. Distinct seasonal variations in organic and mineral soil horizons were found under both spruce and beech forests. Maximum concentrations of water-extractable Al and Al³⁺ were determined in the summer, and the lowest in spring.     

Overview of deaths associated with natural events, United States, 1979–2004

Analysis of the National Center for Health Statistics' Compressed Mortality File showed that between 1979 and 2004, natural events caused 21,491 deaths in the United States. During this 26-year period, there were 10,827 cold-related deaths and 5,279 heat-related deaths. Extreme cold or heat accounted for 75 per cent of the total number of deaths attributed to natural events— more than all of deaths resulting from lightning, storms and foods, and earth movements, such as earthquakes and landslides. Cold-related death rates were highest in the states of Alaska, Montana, New Mexico, and South Dakota, while heat-related deaths were highest in the states of Arizona, Missouri, and Arkansas. These deaths occurred more often among the elderly and black men. Other deaths were attributed to lightning (1,906), storms and foods (2,741), and earth movements (738). Most deaths associated with natural events are preventable and society can take action to decrease the morbidity and mortality connected with them.     

Impact of uranium mines closure and abandonment on groundwater quality

The aim of the study is to assess the evolving mine water quality of closed uranium mines (abandoned between 1958 and 1992) in the Czech Republic. This paper focuses on the changes in mine water quality over time and spatial variability. In 2010, systematic monitoring of mine water quality was performed at all available locations of previous uranium exploitation. Gravity flow discharges (mine adits, uncontrolled discharges) or shafts (in dynamic state or stagnating) were sampled. Since the quality of mine water results from multiple conditions—geology, type of sample, sampling depth, time since mine flooding, an assessment of mine water quality evolution was done taking into account all these conditions. Multivariate analyses were applied in order to identify the groups of samples based on their similarity. Evaluation of hydrogeochemical equilibrium and evolution of mine waters was done using the Geochemist’s Workbench and PHREEQC software. The sampling proved that uranium concentrations in mine waters did not predominantly exceed 0.45 mg/L. In case of discharges from old adits abandoned more than 40 years ago, uranium concentrations were below the MCL of US Environmental Protection Agency for uranium in drinking water (0.03 mg/L). Higher concentrations, up to 1.23 mg/L of U, were found only at active dewatered mines. Activity concentration of ²²⁶Ra varied from 0.03 up to 1.85 Bq/L except for two sites with increased background values due to rock formation (granites). Radium has a typically increasing trend after mine abandonment with a large variability. Concerning metals in mine water, Al, Co and Ni exceeded legislative limits on two sites with low pH waters. The mine water quality changes with a focus on uranium mobility were described from recently dewatered mines to shafts with water level maintained in order to prevent outflows to surface water and finally to stagnating shafts and discharges of mine water from old adits. The results were in good agreement with published experience on mine water stratification, its disturbance by pumping or natural water decant and the “first flush” phenomenon after mine flooding.     

Differences in Cu content in selected mushroom species growing in the same unpolluted areas in Poland

The aim of the study was to estimate copper (Cu) accumulation efficiency in whole-fruiting bodies of 18 edible and non-edible wild growing mushrooms collected from 27 places in the Wielkopolska Voivodeship. Mushrooms were collected each time from the same places to estimate the diversity in Cu accumulation between tested mushroom species within 3 consecutive years of study (2011–2013). The study results revealed various accumulation of Cu in the whole-tested mushroom fruiting bodies. The highest mean accumulation of Cu was observed in Macrolepiota procera (119.4 ± 20.0 mg kg^?1 dm), while the lowest was in Suillus luteus and Russula fellea fruiting bodies (16.1 ± 3.0 and 18.8 ± 4.6 mg kg^?1 dm, respectively). Significant differences in Cu accumulation between mushroom species collected in 2011 and in the two following years (2012 and 2013) were observed. The results indicated that sporadic consumption of these mushrooms was not related to excessive intake of Cu for the human body (no toxic influence on health).     

Prescribed Burns and Wildfires in Colorado: Impacts of Mitigation Measures on Indoor Air Particulate Matter

Abstract

Wildfires and prescribed burns are receiving increasing attention as sources of fine particulate matter (PM_2.5). The goal of this research project was to understand the impact of mitigation strategies for residences impacted by scheduled prescribed burns and wildfires. Pairs of residences were solicited to have PM_2.5 concentrations monitored inside and outside of their houses during four fires. The effect of using air cleaners on indoor PM_2.5 was investigated, as well as the effect of keeping windows closed. Appropriately sized air cleaners were provided to one of each pair of residences; occupants of all of the residences were asked to keep windows shut and minimize opening of exterior doors. Additionally, residents were asked to record all of the activities that may be a source of particulate matter, such as cooking and cleaning. Measurements were made during one prescribed burn and three wildfires during the 2002 fire season. Outdoor 24‐hr average PM_2.5 concentrations ranging from 6 to 38 µg/m³ were measured during the fires, compared with levels of 2–5 µg/m³ during background measurements when no fires were burning. During the fires, PM_2.5 was <3 µg/m³ inside all of the houses with air cleaners installed. This corresponds with a decrease of 63–88% in homes with the air cleaners operating when compared with homes without air cleaners. In the homes without the air cleaners, measured indoor concentrations were 58–100% of the concentrations measured outdoors.     

Abschätzung des umweltchemischen und ökotoxikologischen Verhaltens von Stoffen durch computergestützte Analyse von Struktur und Verhalten sowie von Struktur und Wirkung

Risk assessment of chemicals requires comprehensive data material, which often is not available. To provide substitutes for the lacking experimental ecotoxicological and physico-chemical data, a software-system (SAR-System) has been developed comprising more than 90 estimation models for relevant endpoints. The approach is based on quantitative structure-activity relationships (QSAR). Two major aspects characterize the SAR-System:

1. The implemented models were tested for their validity and application range.
2. The QSARs are accessible by a menu-driven programme package.

The following endpoints are included: Thysico-Chemical Data: 1-Octanol/water-partition-coefficient log P_ow, vapour pressure, water solubility, pK_a-value, boiling point Biological Data: Toxicity towards fish, daphnia, tetrahymenae, algae, bacteria and mammals, mutagenicity. Distribution: soil sorption, bioconcentration, Henry-Constant, Mackay (Level I). Degradation: photodegradation, biodegradability.     

Passive airborne dust sampling to assess mite antigen exposure in farming environments

The aim of this study was to estimate mite antigen exposure in farming environments by passive sampling of airborne dust. Antigen concentrations were measured with enzyme immunoassays specific for three storage mites (SM): Acarus siro, Lepidoglyphus destructor, Tyrophagus putrescentiae and the house dust mite (HDM) Dermatophagoides pteronyssinus. Dust samples were collected with electrostatic dust fall collectors (EDCs) in three different areas of cattle farms. EDCs were placed in cow stables (working area), in changing rooms (transit area) and in different rooms of farmer dwellings (living area). Mite concentrations in the living area of farm homes were compared to those of urban homes. In dust samples from stables, antigens of all four mite species could be detected. The highest exposure level was to L. destructor (median 56.7 μg/m(2)), the lowest to A. siro (median 14.4 μg/m(2)). Mite concentrations of different species showed no correlation within the cow stables. In comparison to stables, the median mite concentrations in farm homes were significantly lower, ranging from below the detection limit to 1.5 μg/m(2). Antigens of SM were predominantly found in changing rooms and kitchens, and HDM antigens were mainly detected in bedrooms. Antigens of all mites were measured the least often in living rooms. T. putrescentiae was the most prevalent mite in all room types, and the exposure levels correlated strongly between different rooms. The number of SM positive samples in farm homes was considerably higher than in urban homes, while the percentage of HDM positive samples did not differ significantly.     

Increased metal concentrations in exhaled breath condensate of industrial welders

It was the aim of this study to evaluate the effect of different devices on the metal concentration in exhaled breath condensate (EBC) and to prove whether working conditions in different welding companies result in diverse composition of metallic elements. The influence of two collection devices (ECoScreen, ECoScreen2) on detection of metallic elements in EBC was evaluated in 24 control subjects. Properties of ECoScreen and a frequent use can alter EBC metal content due to contamination from metallic components. ECoScreen2 turned out to be favourable for metal assessment. Concentrations of iron, nickel and chromium in EBC sampled with ECoScreen2 were compared between non-exposed controls and industrial welders. Metal concentrations in EBC were higher in 36 welders recruited from three companies. Exposure to welding fumes could be demonstrated predominantly for increased iron concentrations. Concentrations of iron and nickel differed by working conditions, but chromium could not be detected in EBC.