Characteristics and potential human health hazards of charged aerosols generated by high-voltage power lines

We investigated the characteristics of charged aerosols produced by high-voltage power lines (HVPLs) to explore the effects on respiratory disease incidence among those who handle HVPLs. Charged aerosol currents and charged aerosol concentrations were measured over 24?h at 12 sites. Aerosol current effective levels were 2.7 times higher compared to exposed and control sites. This pattern of relative enhancement at exposed sites was seen consistently in all measurements and the difference was 1.7 higher at exposed sites. Correlation analysis among all important variables revealed strong positive correlations between currents and concentration, currents and magnetic field, humidity and concentration, and humidity and particles of 10?µm or less (PM₁₀), while negative correlations were observed between charged aerosol concentrations and wind velocity and between wind velocity and humidity. Estimated production of charged aerosols from HVPLs found that people who work with HVPLs are highly likely to be exposed to charged aerosols.     

Ozone air pollution and foliar injury development on native plants of Switzerland

The objectives of this study were to examine the foliar sensitivity to ozone exposure of 12 tree, shrub, and herbaceous species native to southern Switzerland and determine the seasonal cumulative ozone exposures required to induce visible foliar injury. The study was conducted from the beginning of May through the end of August during 2000 and 2001 using an open-top chamber research facility located within the Lattecaldo Cantonal Forest Nursery in Canton Ticino, southern Switzerland (600 m asl). Plants were examined daily and dates of initial foliar injury were recorded in order to determine the cumulative AOT40 ppb h ozone exposure required to cause visible foliar injury. Plant responses to ozone varied significantly among species; 11 species exhibited visible symptoms typical of exposures to ambient ozone. The symptomatic species (from most to least sensitive) were Populus nigra, Viburnum lantana, Salix alba, Crataegus monogyna, Viburnum opulus, Tilia platyphyllos, Cornus alba, Prunus avium, Fraxinus excelsior, Ribes alpinum, and Tilia cordata; Clematis spp. did not show foliar symptoms. Of the 11 symptomatic species, five showed initial injury below the critical level AOT40 10 ppmh O3 in the 2001 season.     

Effects of trichloroacetic acid on the nitrogen metabolism of Pinus sylvestris--a 13C/15N tracer study

Trichloroacetic acid (TCA) can be found in various environmental compartments like air, rain and plants all over the world. It is assumed that TCA is an atmospheric degradation product of volatile chloroorganic hydrocarbons. The herbicide effect of TCA in higher concentrations is well known, but not much is known about the phytotoxic effects in environmentally relevant concentrations. It can be shown in this study by using the 13C/15N stable isotope tracer technique that [13C]TCA is taken up by roots of two-year-old seedlings of Pinus sylvestris L. and transported into the needles. At the same time the effect of the substance on nitrogen metabolism can be analyzed by measuring the incorporation of 15NO3- into different nitrogen fractions of the plant. The more [13C]TCA incorporation, the higher the synthesis of 15N labelled amino acids and proteins is. These effects on the nitrogen metabolism are probably based on the activation of stress- and detoxification metabolism. It has to be assumed that there is an influence on N metabolism of Pinus sylvestris caused by the deposition of environmentally relevant TCA concentrations.     

Effect of dissolved metal ions on PCE decomposition by gamma-rays

This study investigates the effect of initial tetrachloroethylene (PCE) concentration, irradiation dose and dissolved metal ions such as Cr3+, Mn2+, Fe3+, Co2+, Ni2+, Cu2+ and Zn2+ on removal of PCE by gamma irradiation. The amount of removed PCE decreased with increase in initial PCE concentration and increased with increase in irradiation dose. PCE removal reached a maximum in the presence of Fe3+, while Cu2+ strongly hindered PCE decomposition. Except for Cu2+, the amount of removed PCE in the presence of metal ions was linearly dependent on the standard reduction potential of the metal ions. The extraordinary inhibition of Cu2+ in PCE removal was caused by the action of Cu2+ as a strong *OH scavenger, that was directly confirmed by electron paramagnetic resonance spectroscopy.     

Remediation of arsenic-contaminated soils and washing effluents

Laboratory experiments were conducted to determine the distribution of various arsenic species in tailings and soils. Other specific goal of the tests were to evaluate the extraction efficiency of arsenic using alkaline or acid washing, to determine optimum operational parameters of alkaline washing, and to evaluate the arsenic precipitation of washing effluents by pH adjustment or ferric chloride addition. Alkaline washing using sodium hydroxide was found to be favorable in removing arsenic from tailings or soils having a higher portion of arsenic in the operationally defined crystalline mineral fraction of crystalline oxide and amorphous aluminosilicates. This is due to the ligand displacement reaction of hydroxyl ions with arsenic species and high pH conditions that can prevent readsorption of arsenic because predominant negatively charged crystalline oxides do not attract the negatively charged oxyanions. For tailings, sodium hydroxide had 10-20 times higher extraction efficiencies than hydrochloric- or citric acid. The optimum concentration of sodium hydroxide for soil washing was determined to be 200 mM for all samples, while the optimum ratios were 10:1 and 5:1 for tailings and field/river sedimentary soils, respectively. The washing effluent of river soil was effectively treated by adjusting pH to 5-6 with hydrochloric acid, resulting in arsenic concentrations of <50 microgl(-1). In the case of field soil effluent, an addition of ferric chloride with a minimum mass ratio of 11 (Fe/As) was needed to reduce the arsenic below 50 microgl(-1).     

Model development for nutrient loading estimates from paddy rice fields in Korea

A field experiment was performed to evaluate water and nutrient balances in paddy rice culture operations during 2001-2002. The water balance analysis indicated that about half (50-60%) of the total outflow was lost by surface drainage, with the remainder occurring by evapotranspiration (490-530 mm). The surface drainage from paddy fields was mainly caused by rainfall and forced-drainage, and in particular, the runoff during early rice culture periods depends more on the forced-drainage due to fertilization practices. Most of the total phosphorus (T-P) inflow was supplied by fertilization at transplanting, while the total nitrogen (T-N) inflow was supplied by the three fertilizations, precipitation. and from the upper paddy field, which comprised 13-33% of the total inflow. Although most of the nutrient outflow was attributed to plant uptake. nutrient loss by surface drainage was substantial, comprising 20% for T-N and 10% for T-P. Water and nutrient balances indicate that reduction of surface drainage from paddy rice fields is imperative for nonpoint source pollution control. The simplified computer model, PADDIMOD, was developed to simulate water and nutrient (T-N and T-P) behavior in the paddy rice field. The model predicts daily ponded water depth, surface drainage, and nutrient concentrations. It was formulated with a few equations and simplified assumptions, but its application and a model fitness test indicated that the simulation results reasonably matched the observed data. It is a simple and convenient planning model that could be used to evaluate BMPs of paddy rice fields alone or in combination with other complex watershed models. Application of the PADDIMOD to other paddy rice fields with different agricultural environments might require further calibration and validation.     

Quantification of bacterial lipopolysaccharides (endotoxin) by GC-MS determination of 3-hydroxy fatty acids

A GC-MS method for the quantification of bacterial lipopolysaccharides (LPS, endotoxin) is presented. After hydrolytic cleavage of 3-hydroxy fatty acids (3-OH FAs) from the lipid A region of LPS, derivatisation of both the hydroxyl and the carboxyl group was performed in one step with a mixture of methyl-bis(trifluoracetamide)(MBTFA) and N-methyl-N-(tert-butyldimethylsilyl)trifluoracetamide (MTBSTFA). Using GC-MS in the EI mode with selected ion monitoring (SIM) for analysis, baseline separation of 3-OH FAs (and of possibly interfering 2-OH FAs) was achieved. The sensitivity of the method (LOD 7-50 pg/injection for the different 3-OH FAs investigated) allows for the efficient quantification of LPS in occupational and environmental samples. Degradation of 3-OH FAs as well as of their derivatives during sample preparation and GC-MS separation as a possible source of errors in analytical methods based on 3-OH FA determination is reported for the first time. Thermal elimination of water from the underivatised 3-OH FAs and of trifluoroacetic acid from the derivatives was identified as the cause of degradation. The resulting alpha,beta-unsaturated compounds showing the same mass spectra as the 3-OH FA derivatives were detected as more or less prominent satellite peaks. By using alkaline instead of acidic hydrolysis and cool on-column instead of split/splitless injection, elimination was reduced to an acceptable level.