Quantification of differentially expressed genes in Daphnia magna exposed to rubber wastewater

In this study, differentially expressed genes (DEGs) were investigated in Daphnia magna exposed to rubber wastewater using an annealing control primer (ACP)-based polymerase chain reaction (PCR) and real-time PCR. Among three identified DEGs, two genes (DEG1 and DEG2) were up-regulated, and DEG1 expression was well-correlated to a logarithm of rubber wastewater concentration (r(2)=0.971, p<0.0001). In addition, DEG1 expression in D. magna exposed to rubber wastewater was strongly correlated with that of D. magna exposed to Zn (r(2)=0.9513, p<0.05), suggesting that the induction of DEG1 was caused by Zn, which is the dominant toxicant in rubber wastewater. In addition, DEG1 expression was more sensitive to toxicants than immobility, which is the conventional endpoint in toxicity tests using D. magna. The lowest observed effect concentrations (LOEC) determined using immobility tests were 2.5% for rubber wastewater and 1.6mgl(-1) for Zn. In contrast, a significant increase in DEG1 expression was observed at exposure concentrations of as low as 0.6% rubber wastewater and 0.2mgl(-1) Zn. These results indicate that DEG1 is a sensitive and quantitative biomarker of water and wastewater containing Zn.     

Dechlorination of trichloroethylene formed from 1,1,2,2-tetrachloroethane by dehydrochlorination in Portland cement slurry including Fe(II)

Transformation of 1,1,2,2-tetrachloroethane (1,1,2,2-TeCA) by Fe(II) in 10% cement slurries was characterized using a batch reactor system. 1,1,2,2-TeCA was completely converted to trichloroethylene (TCE) within 1h in all experiments, even in controls with cement that did not include Fe(II). Therefore, complete degradation of 1,1,2,2-TeCA depends on the behavior of TCE. The half-life of TCE was observed to be 15d when concentrations of Fe(II) and 1,1,2,2-TeCA were 98mM and 0.245mM, respectively. The kinetics of TCE removal was observed to be dependent on Fe(II) dose, pH and initial substrate concentration. Pseudo-first-order rate constants linearly increased with Fe(II) dose up to 198mM when initial target concentration was 0.245mM. Pseudo-first-order kinetics generally described the degradation reactions of TCE at a specific initial concentration, but a modified Langmuir-Hinshelwood model was necessary to describe the degradation kinetics of TCE over a wide range of initial concentrations. A surface reaction of TCE on active solids, which were formed from Fe(II) and products of cement hydration appears to control observed TCE degradation kinetics.     

Impacts of climate change on surface water quality in relation to drinking water production

Besides climate change impacts on water availability and hydrological risks, the consequences on water quality is just beginning to be studied. This review aims at proposing a synthesis of the most recent existing interdisciplinary literature on the topic. After a short presentation about the role of the main factors (warming and consequences of extreme events) explaining climate change effects on water quality, the focus will be on two main points. First, the impacts on water quality of resources (rivers and lakes) modifying parameters values (physico-chemical parameters, micropollutants and biological parameters) are considered. Then, the expected impacts on drinking water production and quality of supplied water are discussed. The main conclusion which can be drawn is that a degradation trend of drinking water quality in the context of climate change leads to an increase of at risk situations related to potential health impact.     

Aryl hydrocarbon receptor-mediated activity of atmospheric particulate matter from an urban and a rural site in Switzerland

Atmospheric particulate matter (PM) is an air-suspended mixture of solid and liquid particles that vary in size, shape, and chemical composition. Long-term exposure to elevated concentrations of fine atmospheric particles is considered to pose a health threat to humans and animals. In this context, it has been hypothesized that toxic chemicals such as polycyclic aromatic hydrocarbons (PAHs) play an important role. Some PAHs are known to be carcinogenic and it has been shown that carcinogenic effects of PAHs are mediated by the aryl hydrocarbon receptor (AhR). In this study, PM1 was collected at a rural and an urban traffic site during an intense winter smog period, in which concentration of PM1 often exceeded 50 μg m^?3. We applied an in vitro reporter gene assay (DR-CALUX) to detect and quantify PM1-associated chemicals that induce AhR-mediated gene expression. This activity was expressed as CALUX equivalents of 2,3,7,8-tetrachlorodibenzodioxin (PM-TCDD-CEQs). In addition, concentrations of PAHs in the PM1 extracts were determined using gas chromatography/high-resolution mass spectrometry. Concentrations of PM-TCDD-CEQs ranged from 10 to 85 pg m^?3 and from 19 to 87 pg m^?3 at the urban and rural site, respectively. By the use of known relative potency factors, the measured concentration of a PAH was converted into a PAH-TCDD-CEQ concentration. ΣPAH-TCDD-CEQ and PM-TCDD-CEQ were highly correlated at both sites (r² = 0.90 and 0.69). The calculated ΣPAH-TCDD-CEQs explain between 2% and 20% of the measured PM-TCDD-CEQs. Benzo[k]fluoranthene was the most important PAH causing approximately 60% of the total ΣPAH-TCDD-CEQ activity. In contrast to NO, CO, PM10, and PM1, the concentration of PM-TCDD-CEQs showed no significant difference between the two sites. No indications were found that road traffic emissions caused elevated concentrations of PM-TCDD-CEQs at the urban traffic site.     

Removal characteristics of CO2 using aqueous MEA/AMP solutions in the absorption and regeneration process

The carbon dioxide (CO2) removal efficiency, reaction rate, and CO2 loading into aqueous blended monoethanolamine (MEA) + 2-amino-2-methyl-1-propanol (AMP) solutions to enhance absorption characteristics of MEA and AMP were carried out by the absorption/regeneration process. As a result, compared to aqueous MEA and AMP solutions, aqueous blended MEA+AMP solutions have a higher CO2 loading than MEA and a higher reaction rate than AMP. The CO2 loading of rich amine of aqueous 18 wt.% MEA+12 wt.% AMP solution was 0.62 mol CO2/mol amine, which is 51.2% more than 30 wt.% MEA (0.41 mol CO2/mol amine). Consequently, blending MEA and AMP could be an effective way to design cousidering economical efficiency and used to operate absorber for a long time.     

Development of combined plant of biogas and bio solid-refuse-fuel from swine manure slurry

Journal of Material Cycles and Waste Management - An environment-friendly treatment of organic waste like swine manure and food waste is considered to be big challenge, because the residue of...     

Prüfanforderungen des Umweltbundesamtes zur Bewertung der Auswirkungen von Pflanzenschutzmitteln auf terrestrische Pflanzen

The fundamental data requirements for the authorization of plant protection products and the inclusion of active ingredients in Annex I of Council Directive 91/414/EEC are described in the Annexes II and III of this Directive. Definite instructions with regard to preconditions and for implementation and methodology (guidelines) concerning investigations with terrestrial plants are deficient. In the following, the scientific data requirements are explained for assessing the effects of plant protection products on terrestrial plants.     

Water extraction with CO2 bubbling as pretreatment of melting-furnace fly ash for metal recovery

In Japan, melting-furnace fly ash (MFA) generated from ash melting and gasification/melting plants is considered an “urban mine” due to its high metal content. This study aimed to develop a novel approach to pretreating MFA for metal recovery. Water extraction with CO₂ bubbling was investigated because MFA mainly consists of water-soluble salts containing elements such as Cl, Ca, Na, and K. Instead of acid addition, CO₂ bubbling was applied to maintain the optimal pH for minimizing the release of target metal elements and maximizing the removal of undesirable elements during water extraction. The results revealed that CO₂ bubbling effectively decreased the release of Pb, Zn, and Cd into the treatment water. This was mainly due to coprecipitation with CaCO₃, which was primarily formed by the reaction of Ca²⁺ from the MFA with CO₃ ²⁻ from the CO₂ gas. The bubbling process also helped accelerate the removal of Cl from MFA. Furthermore, the study showed that it is possible to lower the water-to-solid ratio to 5 with only a slight reduction in water extraction effect. Finally, approximately four times the concentration of target metals (rare metals and Cu, Pb, and Zn) was achieved by removing 90% of Cl, 70%–90% of Na and K, and 30%–40% of Ca through water extraction with CO₂ bubbling, resulting in a concentration of target metals that was nearly equal to that of ore.     

Observed chemical characteristics of long-range transported particles at a marine background site in Korea

Deokjeok Island is located off the west coast of the Korean Peninsula and is a suitable place to monitor the long-range transport of air pollutants from the Asian continent. In addition to pollutants, Asian dust particles are also transported to the island during long-range transport events. Episodic transport of dust and secondary particles was observed during intensive measurements in the spring (March 31-April 11) and fall (October 13-26) of 2009. In this study, the chemical characteristics of long-range-transported particles were investigated based on highly time-resolved ionic measurements with a particle-into-liquid system coupled with an online ion chromatograph (PILS-IC) that simultaneously measures concentrations of cations (Li+, Na , NH4+, K+, Ca2+, Mg2+) and anions (F-, C1-, NO3-, SO42-). The aerosol optical thickness (AOT) distribution retrieved by the modified Bremen Aerosol Retrieval (M-BAER) algorithm from moderate resolution imaging spectroradiometer (MODIS) satellite data confirmed the presence of a thick aerosol plume coming from the Asian continent towards the Korean peninsula. Seven distinctive events involving the long-range transport (LRT) of aerosols were identified and studied, the chemical components of which were strongly related to sector sources. Enrichment of acidic secondary aerosols on mineral dust particles, and even of sea-salt components, during transport was observed in this study. Backward trajectory, chemical analyses, and satellite aerosol retrievals identified two distinct events: a distinctively high [Ca2++Mg2]/[Na+] ratio (>2.0), which was indicative of a preprocessed mineral dust transport event, and a low [Ca2++Mg2+]/[Na+] ratio (<2.0), which was indicative of severe aging of sea-salt components on the processed dust particles. Particulate C1- was depleted by up to 85% in spring and 50% in the fall. A consistent fraction of carbonate replacement (FCR) averaged 0.53 in spring and 0.55 in the fall. Supporting evidences of C1- enrichment on the marine boundary layer prior to a dust front were also found. Supplemental materials are available for this article. Go to the publisher's online edition of the Journal of the Air & Waste Management Association for sector and air mass classifications of clean and LRT cases.