Using Multiple Antibiotic Resistance and land use characteristics to determine sources of fecal coliform bacterial pollution

Multiple Antibiotic Resistance (MAR) analysis and regression modeling techniques were used to identify surface water areas impacted by fecal pollution from human sources, and to determine the effects of land use on fecal pollution in Murrells Inlet, a small, urbanized, high-salinity estuary located between Myrtle Beach and Georgetown, South Carolina. MAR analysis was performed to identify areas in the estuary that are impacted by human-source fecal pollution. Additionally, regression analysis was performed to determine if an association exists between land use and fecal coliform densities over the ten-year period from 1989 to 1998. Land-use variables were derived using Geographic Information System (GIS) techniques and were used in the regression analysis.MAR analyses were conducted by comparing the frequency and patterns of antibiotic resistance found in Escherichia coli isolates derived from surface water samples and from sewage sources in the Murrells Inlet sewage collection system. The MAR results suggest that the majority of the fecal pollution detected in the Murrells Inlet estuary may be from non-human sources, including fecal coliforms isolated from areas in close proximity to high densities of active septic tanks.A MAR Index, which measures the frequency of antibiotic resistance, was calculated for each of twenty-three water samples and nine sewage samples. The antibiotic resistance pattern comparisons were performed using cluster analysis. Although the MAR indices indicated that several surface water sites had potential human-source contamination, the cluster analysis suggests that only one sampling site had MAR patterns that were similar to those found in the sewage samples. This site was in close proximity to several large pleasure boats as well as a sewage collection system lift station, but was not near areas with active septic tanks. The results of the regression analysis also suggest that sewage sources and rainfall runoff from urbanized areas may contribute to fecal pollution in the estuary.     

Incorporating natural capital into economy-wide impact analysis: a case study from Alberta

Traditionally, decision-makers have relied on economic impactestimates derived from conventional economy-wide models. Conventional models lack the environmental linkages necessary for examining environmental stewardship and economic sustainability, and in particular the ability to assess the impact of policies on natural capital. This study investigatesenvironmentally extended economic impact estimation on a regionalscale using a case study region in the province of Alberta knownas the Foothills Model Forest (FMF). Conventional economic impactmodels are environmentally extended in pursuit of enhancingpolicy analysis and local decision-making. It is found that theflexibility of the computable general equilibrium (CGE) modelingapproach offers potential for environmental extension, with a solid grounding in economic theory. The CGE approach may be the tool of the future for more complete integrated environment andeconomic impact assessment.     

State of the marine environment at Little Bay Arm,Newfoundland and Labrador,Canada, 10 years after a "do nothing" response to a mine tailings spill

In 1989, the tailings pond dam at the site of a former copper mine near Little Bay, Newfoundland and Labrador, Canada, ruptured and tailings spilled into Little Bay Arm. At the time, no action was taken to arrest the flow of tailings or to mitigate the effects of the spill. To date, no action has been taken to repair the dam and tailings continue to flow into Little Bay Arm. As a result, the marine environment around Little Bay Arm has become contaminated with heavy metals from the tailings. However, the tailings are not the only source of heavy metals to the ecosystem. An old slag heap and what is presumably concentrated copper ore spilled during the loading of ore freighters, are also contributing to the ecosystem's metal load. Marine sediment throughout the Arm contained elevated concentrations of Cu, Ni, Zn, As, V, Co, and Mn. Beach material also contained elevated concentrations of metals with material near the slag heap being the most contaminated. At this site, Cu concentrations were in excess of 5000 mg kg(-1) dry weight, Zn greater than 3000 mg kg(-1) and Co concentrations exceeded 700 mg kg(-1). The highest concentrations of metals in biota were found near the slag heap, near the tailings dam breach, and at the site of the former concentrate loading dock. Despite elevated metal concentrations, the tailings and nearby sediment were not devoid of life. Bivalves and seaweed were abundant in the area and there were no obvious signs of tissue damage or disease in soft shell clams (Mya arenaria) living in the tailings. These clams may be suffering from chronic exposure to the tailings, however, evidence of lipid peroxidation in the clams was inconclusive.     

The distribution of octachlorostyrene (OCS) in environmental samples from Europe

Although octachlorostyrene (OCS) was never used as a commercial product, it may be produced during incineration and combustion processes involving chlorinated compounds. Its environmental spreading was evaluated through the analysis of several representative samples. OCS could not be measured in soil samples collected from urban and rural areas or sediments, but was present (up to 5.41 ng/g dry weight) in industrial soil collected near chemically polluted areas. For aquatic biota samples, the OCS concentrations in freshwater mussels ranged from <0.01 ng/g wet weight (ww) to 0.18 ng/g ww (mean 0.06 ng/g ww) and similar levels could be measured in 11 freshwater fish species from Belgium and Romania. A higher OCS contamination level was found in shrimps (mean 0.08 ng/g ww) compared to marine fish (mean 0.02 ng/g ww for bib and 0.01 ng/g ww for sole and whiting, respectively). OCS could also be measured in 19 harbour porpoise (Phocoena phocoena) liver samples with a mean value of 1.90 ng/g ww. According to these data, it could be computed that the biomagnification factor for OCS was one order of magnitude lower than that of HCB in the fish-porpoise food chain. The mean OCS concentrations in blue tits (Parus caeruleus) eggs and great tits (Parus major) adipose tissue were 1.24 ng/g ww and 3.24 ng/g ww, respectively. OCS could be measured in different tissues of hedgehog (Erinaceus europaeus), with the highest concentrations found in adipose tissue (mean 0.34 ng/g ww) and liver (mean 0.39 ng/g ww). In contrast, only low concentrations of OCS could be measured in human adipose tissue (up to 0.38 ng/g ww) and liver (up to 0.05 ng/g ww), while it could not be detected in human brain or lung. The relationship between the concentrations of OCS and HCB was also discussed for each species.     

Metal microchannel lamination using surface mount adhesives for low-temperature heat exchangers

This paper reports the feasibility of using surface mount adhesives to produce low temperature microchannel arrays in a wide variety of metals. Sheet metal embossing and chemical etching processes have been used to produce sealing bosses that eliminate channel laminae, resulting in approximately 50% material savings over traditional methods. An assembly process using adhesive dispense and cure is outlined to produce leak-free devices. Optimal fill ratios were determined to be between 1.1 and 1.25. Bond strength investigation reveals robustness to surface conditions and a bond strength of 5.5–8.5 MPa using a 3X safety factor. Dimensional characterization reveals a two sigma (95%) post-bonded channel height tolerance under 10% after bonding. Patterning tolerance and surface roughness of the laminae faying surfaces were found to have a significant influence on the final post-bonded channel height. Leakage and burst pressure testing on several samples has established confidence that adhesive bonding can produce leak-free joints. Operating pressures up to 413 kPa have been satisfied, equating to tensile pressure on bond joints of 1.9 MPa. Higher operating pressures can be accommodated by increasing the bond area of devices.     

The influence of source and timing of nitrogen fertilizers on yield and nitrogen use efficiency of four sweet potato cultivars

Nitrogen (N) availability is a very important determinant of crop yield. It is also one of the most expensive inputs in crop production. Thus, the efficient management of N by farmers with limited resource is a very important part of successful soil and crop management system. A field study was conducted on a Norfolk sandy loam soil at the George Washington Carver Agricultural Experiment Station, Tuskegee, AL, to evaluate the influence of fertilizer source and timing on the yield of four sweet potato [Ipomoea batatas (L.)] cultivars. Two N sources (urea, CO(NH₂)₂ and ammonium nitrate, NH₄NO₃), four sweet potato cultivars (‘Georgia Jet’, GA-Jet; ‘TU-82-155’, TU-155; ‘TU-1892’; and ‘Rojo Blanco’, Rojo-Bl) and three times (zero, single, and split applications) were used in a factorial designed experiment. Plants were harvested after 80 and 120 days and total and marketable yields determined. Nitrogen recovery efficiency, yield efficiency and physiological efficiency were also determined. Total and marketable yields of early maturing cultivars were significantly higher than of late maturing cultivars (P<0.05). The single application of N resulted in significantly higher yield in storage roots than split application (P<0.05). Physiological efficiency values were highly correlated with total marketable yields. Recovery rates increased with time. Late maturing cultivars tended to have higher N recovery and physiological efficiency than early maturing cultivars. These results suggest that cultivar maturity group should play an important part in N fertilization recommendations for sweet potato.     

Differential N uptake by maize cultivars and soil nitrate dynamics under N fertilization in West Africa

Nitrate is prone to leaching in the sandy soils of the West African moist savannas. Better management of nitrogen (N) resources and maize cultivars with enhanced genetic capacity to capture and utilize soil and fertilizer N are strategies that could improve N-use efficiency. In two field experiments conducted at Zaria, northern Nigeria, five maize (Zea mays L.) cultivars planted early in the season were assessed under various N levels for differences in N uptake, soil N dynamics, and related N losses. Cultivar TZB-SR accumulated more N in the aboveground plant parts in both years than the other cultivars. All, except the semi-prolific late (SPL) variety, met about 50–60% of their N demand by the time of silking (64–69 DAP). In both years, SPL had the greatest capacity to take up N during the grain filling period, and it had the highest grain-N concentration and the least apparent N loss through leaching in the second year. There were no significant differences in soil N dynamics among cultivars in both years. At harvest, the residual N in the upper 90 cm of the profile under all the cultivars ranged from 56 to 72 kg ha⁻¹ in the first year and from 73 to 83 kg ha⁻¹ in the second year. Apparent N loss from 0 to 90 cm soil profile through leaching ranged from 35 to 122 kg ha⁻¹ in both years. N application significantly increased N uptake by more than 30% at all sampling dates in the second year of the experiment, but had no effect on apparent N loss. Results indicate that the use of maize cultivars with high N uptake capacity during the grain filling period when maximum leaching losses occur could enhance N recovery and may be effective in reducing leaching losses of mineral N in the moist savanna soils.     

Sustainable resource management coupled to resilient germplasm to provide new intensive cereal–grain–legume–livestock systems in the dry savanna

Sustainable resource management is the critical agricultural research and development challenge in sub-Saharan Africa. The accumulated knowledge on soil management gathered over the last 10 years, combined with solid crop improvement and plant health research at farmers’ level, has brought us to a stage where we can now address with confidence the intensification of cereal–grain–legume-based cropping systems in the dry savanna of West Africa in a sustainable and environmentally positive manner.Two sustainable farming systems that greatly enhance the productivity and sustainability of integrated livestock systems have been developed and implemented in the dry savanna of Nigeria. These are: (i) maize (Zea mays L.)–promiscuous soybean [Glycine max (L.) Merr.] rotations that combine high nitrogen fixation and the ability to kill large numbers of Striga hermonthica seeds in the soil; and (ii) miflet [Eleusine coracana (L.) Gaerth] and dual-purpose cowpea [Vigna unguiculata (L.) Walp.]. Improvement of the cropping systems in the dry savanna has been driven by the adoption of promiscuously nodulating soybean varieties (in particular TGx 1448-2E) and dual-purpose cowpea. The rate of adoption is very high, even in the absence of an efficient seed distribution system. The number of farmers cultivating the improved varieties increased by 228% during the last 3 years. Increased production of promiscuous soybean has been stimulated by increased demand from industries and home utilization. Production in Nigeria was estimated at 405,000 t in 1999 compared to less than 60,000 t in 1984. Economic analysis of these systems shows already an increase of 50–70% in the gross incomes of adopting farmers compared to those still following the current practices, mainly continuous maize cultivation. Furthermore, increases in legume areas of 10% in Nigeria (about 30,000 ha in the northern Guinea savanna) and increases of 20% in yield have translated into additional fixed nitrogen valued annually at US$ 44 million. This reflects, at the same time, an equivalent increase in land-use productivity, and with further spread of the improved crops, there are excellent prospects for additional economic and environmental benefits from a very large recommendation domain across West Africa.