Use of inert C&D materials for seawall foundation: quality control measures

The technical viability of using inert construction and demolition (C&D) materials for the construction of seawall and breakwater foundations has been established by laboratory testing of the materials, numerical analysis of foundation stability, and a pilot field-scale engineering performance evaluation. However, quality control measures are still required so that only suitable materials are used for seawall and breakwater foundation construction. The development of different quality control measures for different site conditions is presented in this paper. The rationale, practicality, and implementation of these quality control measures are also discussed.     

嘉华电厂不设GGH湿法脱硫烟囱防腐改造探讨

对嘉华电厂不设GGH的湿法脱硫烟囱防腐技术方案进行了探讨.从嘉华电厂的烟囱及其运行特征入手,根据防腐要求提出各种可选方案;通过对方案特性的对比分析,得到最优方案.     

Characteristic, composition, and sources of TSP investigated by HRTEM/EDS and ESEM/EDS

Total suspended particle (TSP) collected at the fifth floor of House Dust in Hunan University, China, was analyzed in terms of microscopic morphology and chemical composition. The fine particles (50?nm-2?μm) in the TSP were analyzed by a high-resolution transmission electron microscope equipped with an energy-dispersive X-ray analyzer (HRTEM/EDS). Results showed that the particles were in shapes of plate, irregular and agglomerate. Based on EDS results, these fine particulate matter was primarily composed of Fe-rich (35.82-61.29%), Ca-rich (30.18-36.77%) and Si-rich (18.95-32.28%) particles. Other elements mainly including Mg (0.47-4.97%), Al (0.45-14.57%), S (0.45-4.73%), K (1.13-2.13%) and Zn (0.67-3.85%) were also observed. The sources analysis indicated that the HRTEM particles mainly originated from coal combustion, traffic emission, vehicles exhaust emission and fugitive soil or cement particulate matter. The coarse particles (4-50?μm) were detected by environmental scanning electron microscopy coupled with energy-dispersive X-ray detector (ESEM/EDS). Based on a simple algorithm, ESEM particles were categorized into five groups: C-bearing (46.15%, 67% and 86.98%), Si + Ca-bearing (21.48?+?11.80%, 16.51?+?10.81% and 16.32?+?10.62%), Si + Al-bearing (20.06?+?12.40%, 20.16?+?11.22% and 15.31?+?11.25%), Si-bearing (34.40%, 26.92% and 27.15%) particles and aggregates, most of which exhibit obvious crystalline structure, and these ESEM particles mainly derived from vehicles exhaust emission, coal combustion, soil, and biomass burning, while the aggregates are indicative of atmospheric reaction progress. HRTEM/EDS and ESEM/EDS are mutual complementary in analyzing the characteristic and determining the sources of TSP.     

农药厂周边有机磷农药在生物体中残留的检测方法研究

对中美两国固定源测试技术体系进行总结并按照辅助类参数、烟气类污染物、烟尘类污染物、有机类污染物、元素及卤化物、在线监测规范进行分类并比较,指出两国测试体系的异同。结合目前形势指出中国烟尘、烟气及VOCs类污染物监测体系面临问题并提出建议。     

Distribution and source analysis of aluminum in rivers near Xi’an City, China

To study the status and source of aluminum (Al) contamination, a total of 21 sampling sites along six rivers near Xi’an City (Shaanxi province, China) were investigated during 2008–2010. The results indicated that the average concentration of total Al (Al_t) in the six rivers increased by 1.6 times from 2008 to 2010. The spatial distribution of Al_t concentrations in the rivers near Xi’an City was significantly different, ranged from 367 μg/L (Bahe River) to 1,978 μg/L (Taiping River). The Al_t concentration was highest near an industrial area for pulp and paper-making (2,773 μg/L), where the Al level greatly exceeded the water quality criteria of both the USA (Criterion Continuous Concentration, 87 μg/L) and Canada (100 μg/L). The average concentration of inorganic monometric aluminum (Al_im) was 72 μg/L which would pose threats to fishes and other aquatic lives in the rivers. The concentrations of exchangeable Al (Al_ex) in the sediment of the Taiping River sampled were relatively high, making it to be an alternative explanation of increasing Al concentrations in the rivers near Xi’an City. Furthermore, an increasing Al level has been detected in the upstream watershed near Xi’an City in recent years, which might indicate another notable pollution source of Al.     

Green synthesis of gold nanoparticles using fungus <Emphasis Type="Italic">Mariannaea</Emphasis> sp. HJ and their catalysis in reduction of 4-nitrophenol

In the present study, biosynthesis of gold nanoparticles (AuNPs) by the cells (cells-AuNPs) and cell-free extracts (extracts-AuNPs) of a new fungus Mariannaea sp. HJ was reported. The as-synthesized particles were characterized by UV-vis spectroscopy, transmission electron microscopy (TEM), X-ray diffraction (XRD), and Fourier transform infrared spectroscopy (FTIR). The effects of different parameters on AuNP biosynthesis were investigated, and initial gold ion concentration of 2 mM, pH 7, was demonstrated to be suitable for both cells-AuNP and extracts-AuNP syntheses. The cells-AuNPs were of various shapes, including sphere, hexagon, and irregular shapes, with an average size of 37.4 nm, while the extracts-AuNPs were almost spherical and pseudo-spherical with an average size of 11.7 nm. XRD pattern suggested that the crystal structure of both AuNPs was face-centered cubic. FTIR spectra implied that some biomolecules from the fungal cell walls or cell-free extracts were involved in the formation of AuNPs. The as-synthesized AuNPs were demonstrated to have excellent catalytic activities for the reduction of 4-nitrophenol with the catalytic rate constants of 5.7 × 10^?3/s for cells-AuNPs and 24.7 × 10^?3/s for extracts-AuNPs. To the best of our knowledge, this is the first report on AuNP biosynthesis by Mariannaea sp.     

Manganese concentrations in maternal–infant blood and birth weight

Manganese (Mn) is an essential mineral nutrient in mammals. The physiological role of Mn in animal models is well documented, but little is known about the adverse effects of Mn deficiency or overexposure in humans, including pregnancy outcomes such as birth weight. We examined the relationship of the maternal and cord blood Mn levels with birth weight in a cohort of 172 mother–infant pairs born in Shanghai, China. Non-linear spline and quadratic regression models were used to test the hypothesis of an inverted U-shaped association between the Mn levels and birth weight. The median (range) levels of Mn in the maternal and cord blood were 5.38 (2.34–30.37) μg/dL and 7.66 (2.57–34.23) μg/dL, respectively. An inverted U-shaped relationship was observed between maternal Mn and birth weight after adjusting for potential confounders. The birth weight increased with Mn levels up to 4.18 μg/dL, and a slight reduction in weight was observed at higher levels. The cord blood Mn levels were not found to be associated with birth weight. Both lower and higher Mn exposures are associated with lower birth weight, which may influence important developmental parameters; the association of higher Mn levels with lower weight was weak and imprecise.     

Medium optimization for the production of anti-cyanobacterial substances by Streptomyces sp. HJC-D1 using response surface methodology

Bioremediation using isolated anti-cyanobacterial microorganism has been widely applied in harmful algal blooms (HABs) control. In order to improve the secretion of activated anti-cyanobacterial substances, and lower the cost, a sequential optimization of the culture medium based on statistical design was employed for enhancing the anti-cyanobacterial substances production and chlorophyll a (Chl a) removal by Streptomyces sp. HJC-D1 in the paper. Sucrose and KNO₃ were selected as the most suitable carbon and nitrogen sources based on the one-at-a-time strategy method, and sucrose, KNO₃ and initial pH were found as major factors that affected the anti-cyanobacterial ability of the isolated stain via the Plackett–Burman design. Based on the response surface and canonical analysis, the optimum condition of culture medium was obtained at 22.73 g l^-1 of sucrose, 0.96 g l^-1 of KNO₃, and initial pH 8.82, and the Chl a removal efficiency by strain HJC-D1 increased from 63?±?2 % to 78?±?2 % on the optimum conditions.     

Causes of decreased reference evapotranspiration and pan evaporation in the Jinghe River catchment, northern China

This study focused on the changes of reference evapotranspiration (ET₀) and pan evaporation (ET_pan) to study the impacts of climate change on the hydrological cycle in the Jinghe River catchment. Based on the Penman–Monteith equation, the ET₀ was calculated. The temporal trend and spatial distribution of ET₀ and E_pan measured with a 20-cm pan were examined at the 14 stations during 1957–2005. The effects of meteorological factors on the variation of ET₀ were determined by analyzing the trends in themselves with comparison between original climate and detrended climate scenarios and then their sensitivity to ET₀. Both the ET₀ and E_pan showed remarkable decreasing trends from 1957 to 2005 and their decreasing rate was 40.9 and 17.7 mm per 10 years, respectively. Trend analysis of meteorological factors exhibited that the reduction in ET₀ and ET_pan was principally caused by both significant decreases in wind speed and sunshine hours. Furthermore, the decreasing trend of ET₀ was mainly dominated by the significant decrease in wind speed with high sensitivity, to a less extent, by the decrease in net radiation. Although relative humidity is one of the most sensitive variables, its effect on ET₀ was negligible because of its temporal constancy. The contribution of wind speed reduction to decreased ET₀ has increased from 50 to 76.1%, but net radiation, by contrast, decreased from 50 to 23.9%.     

Heterogeneous photocatalytic degradation of methyl orange in schwertmannite/oxalate suspension under UV irradiation

Introduction

Schwertmannite was synthesized through an oxidation of FeSO₄ by Acidithiobacillus ferrooxidans LX5 cell suspension at an initial pH?2.5 and 28°C for 3?days and characterized using X-ray diffraction spectroscopy and scanning electron microscope. The schwertmannite photocatalytic degradation of methyl orange (MO) by oxalate was investigated at different initial pH values, concentrations of schwertmannite, oxalate, and MO.

Results

The results demonstrated that photodegradation of MO in the presence of schwertmannite or oxalate alone was very weak. However, the removal of MO was significantly enhanced when schwertmannite and oxalate coexisted in the reaction system. Low pH (4 or less) was beneficial to the degradation of MO. The optimal doses of schwertmannite and oxalate were 0.2?g?L^?1 and 2?mM, respectively. Hydroxyl radicals (·OH) and Fe(II), the intermediate products, were also examined during the reaction to explore their correlation with the degradation of MO.

Conclusion

A possible mechanism for the photocatalytic decomposition of MO in the study was proposed. The formation of Fe(III)-oxalate complexes on the surface of schwertmannite was a precursor of H₂O₂ and Fe(II) production, further leading to the yield of ·OH responsible for the decomposition of MO.