宝鸡市经济增长与环境空气综合污染指数关系研究

文章以空气综合污染指数法分析了宝鸡市2006年-2011年的环境空气质量状况,分析结果表明宝鸡市环境空气质量逐年变好。以人均GDP为经济指标,以空气综合污染指数为环境指标,建立经济增长与环境空气质量之间的计量模型,进行环境库兹涅茨曲线实证研究。研究结果表明,宝鸡市经济增长和环境空气质量的关系符合库兹涅茨曲线"拐点"后的下降部分。证明该市2006年-2011年的环境空气质量与人均GDP处于良性发展状态。     

用多道滤波接收函数法反演佛子岭台基的S波速度结构

以佛子岭地震台数字化仪器记录到的远震数据为基础,应用多道反褶积方法分组提取邻近地震事件的接收函数,并选择合适的地层厚度将台站下方介质结构简化成关于S波速度的水平分层模型。以此对Ps转换波的接收函数进行共转换点偏移叠加,反演计算得到每个水平层中的S波速度值,并给出了佛子岭台台基下方一维S波速度结构图。     

清水江流域环境保护污染治理经济效益分析

以《贵州省清水江流域环境保护规划(2013-2020年)》为例,分析清水江流域治理主要污染物的削减量和费用支出。从环境经济角度,通过费用-效益分析法以货币量化进行计算,流域治理能带来一定的经济效益、环境效益和社会效益。     

Fenton试剂氧化苯酚过程中Fe（Ⅱ）浓度的变化

考察了Fenton试剂氧化降解苯酚过程中Fe(Ⅱ)浓度的变化,并通过实验探讨了其变化的原因.实验结果表明,在Fenton反应发生的第1 rain内,Fe(Ⅱ)浓度可降低到初始浓度的60%左右,随着反应的继续Fe(Ⅱ)浓度在大约20min降低到最小值,然后开始增大,说明了Fe(Ⅲ)还原作用的存在;Fenton试剂氧化降解苯酚的中间产物包括对苯二酚、邻苯二酚、间苯二酚和苯醌等,其中前三者能对Fe(Ⅲ)有效还原,是Fenton试剂氧化降解苯酚过程中Fe(Ⅲ)还原的主要途径之一.     

Source apportionment of fine particles in Tennessee using a source-oriented model

Source apportionment of fine particles (PM2.5, particulate matter < 2 microm in aerodynamic diameter) is important to identify the source categories that are responsible for the concentrations observed at a particular receptor. Although receptor models have been used to do source apportionment, they do not fully take into account the chemical reactions (including photochemical reactions) involved in the formation of secondary fine particles. Secondary fine particles are formed from photochemical and other reactions involving precursor gases, such as sulfur dioxide, oxides of nitrogen, ammonia, and volatile organic compounds. This paper presents the results of modeling work aimed at developing a source apportionment of primary and secondary PM2.5. On-road mobile source and point source inventories for the state of Tennessee were estimated and compiled. The national emissions inventory for the year 1999 was used for the other states. U.S. Environmental Protection Agency Models3/Community Multi-Scale Air Quality modeling system was used for the photochemical/secondary particulate matter modeling. The modeling domain consisted of a nested 36-12-4-km domain. The 4-km domain covered the entire state of Tennessee. The episode chosen for the modeling runs was August 29 to September 9, 1999. This paper presents the approach used and the results from the modeling and attempts to quantify the contribution of major source categories, such as the on-road mobile sources (including the fugitive dust component) and coal-fired power plants, to observed PM2.5 concentrations in Tennessee. The results of this work will be helpful in policy issues targeted at designing control strategies to meet the PM2.5 National Ambient Air Quality Standards in Tennessee.     

Effective removal of coordinated copper from wastewater using a new dithiocarbamate-type supramolecular heavy metal precipitant

A new dithiocarbamate-type heavy metal precipitant, sodium 1,3,5-hexahydrotriazinedithiocarbamate (HTDC), was prepared and used to remove coordinated copper from wastewater. In the reported dithiocarbamate-type precipitants, HTDC possesses the highest percentage of the effective functional groups. It could effectively precipitate copper to less than 0.5 mg l⁻¹ from both synthetic and actual industrial wastewater containing CuEDTA in the range of pH 3–9. UV–vis spectral investigation and elemental analysis suggested that the precipitate was a kind of coordination supramolecular compound, [Cu₃(HTDC)₂]_n. The toxicity characteristic leaching procedure (TCLP) and semi-dynamic leaching test (SDLT) indicated that the supramolecular precipitate was non-hazardous and stable in weak acid and alkaline conditions. Tests of an anion exchange resin D231 provided a clue to simultaneously remove excess HTDC and residual CuEDTA in practical process of wastewater treatment.     

The concentrations and distribution of polycyclic musks in a typical cosmetic plant

Polycyclic musks [cashmeran (DPMI), celestolide (ADBI), phantolide (AHMI), traseolide (ATII), tonalide (AHTN) and galaxolide (HHCB)] in the air, wastewater, sludge samples of a typical cosmetic plant were analyzed. DPMI, ADBI, HHCB and AHTN were found in all samples, and ATII was not found in any sample. HHCB and AHTN were the major components in all samples. The polycyclic musk concentrations were very high in the air of the cosmetic plant, and polycyclic musks were mostly contained in the gas phase at the percentage of 86.35-97.70%. Average polycyclic musk concentrations in effluent were high, and ranged from 0.62 to 32.06 microgl-1. The removal efficiency during the active sludge wastewater treatment was also high, resulting from the adsorption of those compounds into the sludge. So the polycyclic musk concentrations were very high in the primary sludge and second sludge, and ranged from 1.78 to 92.45 mgkg-1 (dry), and from 2.87 to 65.67 mgkg-1 (dry), respectively. Results suggested that the sludge needed to be further treated to make polycyclic musks less influence to the environment.     

西庄河流域土地利用方式对土壤肥力影响的研究

采用野外调查、取样和实验分析相结合的方法对云南省保山市西庄河山地流域内4种主要土地利用方式（林地、耕地、茶园、灌丛）的土壤理化性质进行对比研究,讨论了不同土地利用方式对土壤肥力的影响,结果表明,不同的土地利用方式对土壤肥力具有比较明显的影响：土壤有机质和全氮质量分数变化从大到小依次为灌丛＞林地＞茶园＞耕地;磷、钾元素表现为耕地＞茶园＞林地＞灌丛;土壤阳离子交换量表现为耕地＞茶园＞灌丛＞林地;盐基饱和度表现为耕地＞灌丛＞林地＞茶园;农业耕作活动对表层土壤物理性质影响明显。     

天然气开采废水处理技术综述

针对天然气开采废水量大、矿化度高、杂质含量多、处理难度大的问题,从预处理技术、COD处理技术、氨氮处理技术、脱盐处理到深度处理技术等对各种处理技术进行分析和对比,说明了各种方法的特点和适用情况等。根据对各种方法的特点总结,结合不同废水的水质特点,提出适宜的组合处理方法,并探讨了综合处理技术在部分地区的工程化应用情况。     

Experimental investigation of a 250-kW turbine organic Rankine cycle system for low-grade waste heat recovery

An organic Rankine cycle (ORC) is generally used for converting low-grade heat into electricity. In this study, an extensive literature survey was conducted to identify current research gaps on experimental ORC systems. Specifically, there is limited experimental data and limited details on thermal and expander efficiencies of ORC systems. In order to address these gaps, the objective of this study included developing a turbine ORC with a power output exceeding 50 kW and thermal efficiency exceeding 8% for a heat source temperature < 120°C. The experimental results indicated that the system achieved a net power output of 242.5 kW and a thermal efficiency of 8.3% (the highest value for a turbine ORC system for the heat source temperature below 120°C). Thus, the study addressed the gaps identified in the research area of ORCs.