Reactivity-Based Hydrocarbon Controls: Scientific Issues and Potential Regulatory Applications

The California Air Resources Board and the South Coast Air Quality Management District hosted a conference on April 8-9, 1991 to examine the scientific issues associated with reactivity-based hydrocarbon controls, and to identify the obstacles to potential regulatory applications. Owing to residual uncertainties in the underlying science, and the complex emission measurement capabilities required for enforcement, a general consensus emerged on the need for further research before application of reactivity-based controls. A number of recommendations were made for research on the remaining scientific, enforcement, and policy issues, many of which have led to cooperative efforts initiated since the conference.     

Controlled Exposures of Volunteers to Respirable Carbon and Sulf uric Acid Aerosols

Respirable carbon or fly ash particles are suspected to increase the respiratory toxicity of coexisting acidic air pollutants, by concentrating acid on their surfaces and so delivering it efficiently to the lower respiratory tract. To investigate this issue, we exposed 15 healthy and 15 asthmatic volunteers in a controlled- environment chamber (21°C, 50 percent relative humidity) to four test atmospheres: (i) clean air; (ii) 0.5-μm H2SO4 aerosol at =100 μg/m³, generated from water solution; (iii) 0,5-μm carbon aerosol at =250 μg/m³, generated from highly pure carbon black with specific surface area comparable to ambient pollution particles; and (iv) carbon as in (iii) plus =100 μg/m³ of ultrafine H2SO4 aerosol generated from fuming sulfuric acid. Electron microscopy showed that nearly all acid in (iv) became attached to carbon particle surfaces, and that most particles remained in the sub-μm size range. Exposures were performed double-blind, 1 week apart. They lasted 1 hr each, with alternate 10-min periods of heavy exercise (ventilation =50 L/min) and rest. Subjects gargled citrus juice before exposure to suppress airway ammonia. Lung function and symptoms were measured pre-exposure, after initial exercise, and at endexposure. Bronchial reactivity to methacholine was measured after exposure. Statistical analyses tested for effects of H₂SO₄ or carbon, separate or interactive, on health measures. Group data showed no more than small equivocal effects of any exposure on any health measure. One individual's responses were consistent with a clinically significant excess airway constriction from H₂SO₄ plus carbon, and 2-3 others showed slight excess responses to the combined pollutants, but all these observations might have reflected chance variations. We conclude that coexisting carbon aerosol did not increase respiratory irritancy of H₂SO₄, in most healthy and asthmatic subjects exposed for 1 hr under simulated "worst-case" ambient conditions.     

The Cost Estimation of Thermal and Catalytic Incinerators for the Control of VOCs

In an earlier paper, major commercially available incinerator technologies designed to treat dilute waste gas streams containing volatile organic compounds (VOCs) were described in a qualitative comparison. In addition, a simplified procedure was outlined through which important sizing parameters could be calculated given certain information about the waste gas. This paper describes the use of these parameters in developing a study (±30percent) cost estimate for the total capital investment and the total annual costs incurred in treating a waste stream of volatile organic compounds (VOCs). An illustrative problem used in the former paper is completed here in order to contrast some of the economic differences between thermal and catalytic incinerator systems.     

Mathematical Modeling of SO2 Absorption in a Venturi Scrubber

Abstract

A three-dimensional mathematical model was used to predict the removal efficiency of a venturi scrubber for SO₂ absorption into a water and alkaline solution. In order to obtain better results, nonuniform droplet concentration distribution was considered. The results of the model with nonuniform droplet concentration distribution are compared with several sets of experimental data, as well as with prediction data of a mathematical model with uniform droplet concentration distribution. Without exception, all comparisons indicated that including nonuniformity of droplet concentration distribution in the model will significantly improve the agreement between the experimental data and predicted values.     

Contribution of Nitrate and Carbonaceous Species to PM2.5 Observed in Canadian Cities

ABSTRACT

At a variety of Canadian monitoring sites, carbonaceous compounds were estimated to account for an average of 50% of fine particle mass. These estimates were determined by subtracting the total fine particle mass associated with inorganic compounds from the total fine mass determined gravimetrically. This approach, which yields an upper limit estimate of the total amount of carbon-related mass was necessary since particulate carbon was not measured in the Canadian National Air Pollution Surveillance (NAPS) network. In this paper, total carbon estimates are evaluated against organic and elemental carbon measurements at locations in the Greater Vancouver area and Toronto. In addition, particle nitrate measurements at seven Canadian locations are used to determine the importance of nitrate relative to total mass and to examine the sampling artifacts due to the loss of particle nitrate from Teflon filters used in the NAPS di-chotomous samplers.

Measurements of organic and elemental carbon indicated that the total carbon estimation approach provides representative estimates of the average contribution by carbonaceous material to the total fine and coarse mass. The average total carbon among all Vancouver area measurements (N = 225) was 4.28 μg m^-3, while the estimated value was 4.34 μg m^-3. There was a larger discrepancy between Toronto total carbon measurements (12.1 μg m^-3) and estimates (8.8 μg m^-3), which is attributed in part to sampling of particles above 10 mm in diameter. However, the R² relating the measurements and estimates was about 0.71 for both areas. Linear regression slopes of 0.98 for Vancouver and 0.78 for Toronto (nonsignificant intercepts) indicate little bias in the Vancouver estimates, but a tendency for underestimation as the observed total carbon concentration increased in Toronto.

Annually, nitrate was responsible for 17% and 12% of the fine mass in the Vancouver area and Ontario, respectively. In contrast, at two rural locations in southern Quebec and Nova Scotia, only 6% of fine mass was associated with nitrate. Due to filter losses, nitrate concentrations determined through the NAPS dichot sampling were much lower than actual concentrations (0.44 μg m^-3 vs. 2.63 μg m^-3). As a result of these losses (attributed mostly to loss during laboratory storage), previous total carbon estimates for the Canadian NAPS sites were likely to have been overestimated on average by about 10%.     

Comparison of Computer Simulations of Total Lung Deposition to Human Subject Data in Healthy Test Subjects

ABSTRACT

A mathematical model was used to predict the deposition fractions (DF) of PM within human lungs. Simulations using this computer model were previously validated with human subject data and were used as a control case. Human intersubject variation was accounted for by scaling the base lung morphology dimensions based on measured functional residual capacity (FRC) values. Simulations were performed for both controlled breathing (tidal volumes [V_T] of 500 and 1000 mL, respiratory times [T] from 2 to 8 sec) and spontaneous breathing conditions. Particle sizes ranged from 1 to 5 um. The deposition predicted from the computer model compared favorably with the experimental data. For example, when V_T = 1000 mL and T = 2 sec, the error was 1.5%. The errors were slightly higher for smaller tidal volumes. Because the computer model is deterministic (i.e., derived from first principles of physics), the model can be used to predict deposition fractions for a range of situations (i.e., for different ventilatory parameters and particle sizes) for which data are not available. Now that the model has been validated, it may be applied to risk assessment efforts to estimate the inhalation hazards of airborne pollutants.     

Analysis of a Summertime PM2.5 and Haze Episode in the Mid-Atlantic Region

Abstract

Observations of the mass and chemical composition of particles less than 2.5 μm in aerodynamic diameter (PM_2.5), light extinction, and meteorology in the urban Baltimore-Washington corridor during July 1999 and July 2000 are presented and analyzed to study summertime haze formation in the mid-Atlantic region. The mass fraction of ammoniated sulfate (SO₄ ^2-) and carbonaceous material in PM_2.5 were each ～50% for cleaner air (PM_2.5 < 10 μg/m³) but changed to ～60% and ～20%, respectively, for more polluted air (PM_2.5 > 30 μg/m³). This signifies the role of SO₄ ^2- in haze formation. Comparisons of data from this study with the Interagency Monitoring of Protected Visual Environments network suggest that SO₄ ^2? is more regional than carbonaceous material and originates in part from upwind source regions. The light extinction coefficient is well correlated to PM_2.5 mass plus water associated with inorganic salt, leading to a mass extinction efficiency of 7.6 ± 1.7 m²/g for hydrated aerosol. The most serious haze episode occurring between July 15 and 19, 1999, was characterized by westerly transport and recirculation slowing removal of pollutants. At the peak of this episode, 1-hr PM_2.5 concentration reached ～45 μg/m³, visual range dropped to ～5 km, and aerosol water likely contributed to ～40% of the light extinction coefficient.     

Biofiltration of Trichloroethylene-Contaminated Air: A Pilot Study

Abstract

This project demonstrated the biofiltration of a trichloroethylene (TCE)-contaminated airstream generated by air stripping groundwater obtained from several wells located at the Anniston Army Depot, Anniston, AL. The effects of several critical process variables were investigated to evaluate technical and economic feasibility, define operating limits and preferred operating conditions, and develop design information for a full-scale biofilter system. Long-term operation of the demonstration biofilter system was conducted to evaluate the performance and reliability of the system under variable weather conditions. Propane was used as the primary substrate necessary to induce the production of a nonspecific oxygenase. Results indicated that the process scheme used to introduce propane into the biofiltration system had a significant impact on the observed TCE removal efficiency. TCE degradation rates were dependent on the inlet contaminant concentration as well as on the loading rate. No microbial inhibition was observed at inlet TCE concentrations as high as 87 parts per million on a volume basis.