Removal of sulfamethoxazole and sulfapyridine by carbon nanotubes in fixed-bed columns

Sulfamethoxazole (SMX) and sulfapyridine (SPY), two representative sulfonamide antibiotics, have gained increasing attention because of the ecological risks these substances pose to plants, animals, and humans. This work systematically investigated the removal of SMX and SPY by carbon nanotubes (CNTs) in fixed-bed columns under a broad range of conditions including: CNT incorporation method, solution pH, bed depth, adsorbent dosage, adsorbate initial concentration, and flow rate. Fixed-bed experiments showed that pH is a key factor that affects the adsorption capacity of antibiotics to CNTs. The Bed Depth Service Time model describes well the relationship between service time and bed depth and can be used to design appropriate column parameters. During fixed-bed regeneration, small amounts of SMX (3%) and SPY (9%) were irreversibly bonded to the CNT/sand porous media, thus reducing the column capacity for subsequent reuse from 67.9 to 50.4 mg g^?1 for SMX and from 91.9 to 72.9 mg g^?1 for SPY. The reduced column capacity resulted from the decrease in available adsorption sites and resulting repulsion (i.e., blocking) of incoming antibiotics from those previously adsorbed. Findings from this study demonstrate that fixed-bed columns packed with CNTs can be efficiently used and regenerated to remove antibiotics from water.     

Measurement of Fine Particles in Diesel Emissions Using a Real-Time Aerosol Monitor

Abstract

A real-time monitoring methodology to determine diesel fine particles in diesel emissions has been evaluated. The range of particle size captured by the monitor was ～0.1 μm to 1 μm. DustTrak real-time monitors were connected to the dilution tunnel of the vehicle exhaust to measure the emissions during the vehicle tests under both dynamic and steady-state driving conditions, and concentration data were recorded every 5 sec. Test variation of the real-time monitoring among different test days was similar to that measured by traditional filter-based gravi-metric method, whereas the repeatability of the monitor data within the same-day tests was better than that of gravimetric method. Correlations between the two methods were established for different fuels tested on a single light duty vehicle. When the emissions from the reference fuel was used to convert the monitor’s response to diesel fuels, the levels determined by the real-time monitor were consistent with those measured by gravimetric method among different fuels tested. Use of the real-time monitor could provide information on the levels of fine particles that is more relevant to the public health than the total particles.     

羟基铝及复合改性蒙脱石对As(V)的去除性能

采用无机羟基铝及阳离子表面活性剂十六烷基三甲基溴化铵对天然蒙脱石进行无机及复合改性。在吸附过程中研究了反应时间、投加量和pH等变量对吸附性能的影响,同时进行吸附动力学及吸附等温线研究,吸附规律符合Langmuir等温方程式。采用X射线衍射、X射线荧光、傅里叶红外光谱等表征手段对未改性及改性蒙脱石进行性能表征。研究结果表明,羟基铝及复合改性蒙脱石对As(V)具有良好的吸附性能,在pH为4～10,初始砷浓度为2 mg/L,改性蒙脱石对As(V)的去除率接近99%。吸附机理主要为羟基铝表面络合吸附和静电吸附。     

混凝剂品种对混凝-超滤联合工艺膜污染的影响

本实验以工业化学合成聚合硫酸铁混凝剂和自制生物聚合硫酸铁为例,考察了铁系混凝剂品种对地表水浊度、TOC和UV254的去除效果,混凝剂品种对混凝-超滤联合工艺处理地表水过程中超滤膜污染的影响。混凝实验结果表明,在10 mg/L(以Fe3+计)最佳投加量下,两类混凝剂对浊度、TOC和UV254的去除率基本相同。超滤膜污染实验结果表明,生物聚合铁预处理水样通量衰减速度略大于化学聚合铁预处理水样;膜污染阻力分析结果显示,随着循环次数的增加,工业化学合成聚合铁预处理水样造成的不可逆污染阻力逐渐增加,而生物聚合铁预处理水样造成的不可逆污染阻力却略有下降;膜污染机理分析表明,2组过滤过程的膜污染类型基本相似,由最初的膜孔堵塞过渡到最终的滤饼层污染。SEM分析表明,生物聚合铁预处理水样的膜污染较为严重。     

添加氮损失抑制剂对蓝藻泥堆肥质量的影响

对脱水蓝藻进行大型生产性堆肥实验。研究堆肥过程中,氮损失抑制剂过磷酸钙的添加对堆肥物料各类理化性质的影响。研究结果表明,过磷酸钙加入的处理组与未加过磷酸钙的对照组堆制37 d后堆肥物料均可腐熟,且堆肥肥效均符合NY525-2002的相关要求。添加过磷酸钙处理组有机质含量为490 g/kg,全N、全P和全K含量分别为20.75、10.02和11.32 g/kg,总养分含量达到9.77%,堆肥品质明显优于对照处理。同时,在微生物的作用下,对照组中微囊藻毒素MC-RR与微囊藻毒素MC-LR去除率分别达到89.8%与78.3%。值得一提的是,添加过磷酸钙后,MC-RR和MC-LR的去除率得到进一步提高,分别达到了92.96%和100%,较好地保证了蓝藻堆肥农用的安全性,为脱水蓝藻好氧堆肥化提供了可行性依据。     

壳牌公司的环境评价技术方法和应用研究

文章从信息收集、环境危害评价、环境影响控制、应急恢复、HSE例卷管理等方面,分析了壳牌公司环境评价的概念和应用领域,总结了壳牌公司环境管理的经验,并据此提出了改进我国石油石化企业环境管理的若干建议。     

光催化氧化处理低浓度含醇废水实验

室内实验了TiO2紫外光催化氧化处理废水中的低浓度甲醇。通过对TiO2催化剂活性及添加方式、溶液pH、紫外光强与催化剂加量等参数优化,在TiO2加入浓度为300mg/L和120 W紫外灯照射条件下,对6.8L甲醇浓度为2.77%的低浓度含醇废水持续处理70min后,废水中的甲醇去除率可达98.31%。该实验为进一步处理低浓度含醇废水提供了方法依据。     

The OH-induced degradation mechanism of 4-chloro-2-methylphenoxyacetic acid (MCPA) with two forms in the water: a DFT comparison

The initial degradation mechanisms of OH and 4-chloro-2-methylphenoxyacetic acid (MCPA) including molecular form and anionic form are studied at the MPWB1K/6-311+G(3df, 2p)//MPWB1K/6-31+G(d, p) level. Possible reaction pathways of H-atom abstraction and OH addition are considered in detail. By result comparison analysis, it is found that the reaction mechanisms for OH and two forms of MCPA are different, and most reactions for anionic MCPA are easier than those for molecular MCPA. For H-atom abstraction reactions, the calculated energies show that OH abstracting H-atom from -CH₃ group of molecular MCPA is the most kinetically favorable process; the potential energy surface for anionic MCPA indicates that H-atom in -CH₂ group is slightly easier to be abstracted than that in -CH₃ group. For OH addition reactions, the addition of OH to the C1 site is the initial step for molecular MCPA and the predominant product is 4-chloro-2-methylphenol (denoted P3), while the C4 site is the most reactive site for anionic MCPA and the primary product results from the hydroxylation of the aromatic ring, which is in good agreement with the experimental observation. In additional, results from PCM calculations show that most reactions in water phase are more kinetically favorable than those in gas phase, though the mechanisms discussed above will not be changed.     

Identification of priority pharmaceuticals in the water environment of China

In recent years, increasing attention has been paid to the trace-level contamination of pharmaceuticals in the water environment all over the world. Considering a large number of pharmaceuticals used, it is crucial to establish a priority list of pharmaceuticals that should be monitored and/or treated first. In the present study, we developed a ranking system based on the pharmaceutical consumption, removal performance in the wastewater treatment plants (WWTPs) and potential ecological effects, and applied to the situation of China. 39 pharmaceuticals, which had available consumption data and also been reported previously in the WWTPs of China, were selected as candidate pharmaceuticals. Among them, seventeen pharmaceuticals were considered as priority pharmaceuticals, out of which, erythromycin, diclofenac acid and ibuprofen, had the high priority. Compared with other literatures, we found that some pharmaceuticals given concerns to globally should also be included in the priority list in China; while some pharmaceuticals, not mentioned in other literatures, such as cefalexin, ketoconazole, should be also given prior consideration in China. Among all the therapeutic classes, antibiotics, which were grossly abused in China, contributed the most to the priority pharmaceuticals. However, priority antibiotics accounted for only 32% of candidate antibiotics, while 71% and 100% of the candidate anti-inflammatory and antilipidemic respectively were identified as the priority pharmaceuticals, indicating that antibiotics might be overanxiously considered in the previous studies on their behaviors in the WWTPs of China.     

Identification of cadmium-excluding welsh onion (Allium fistulosum L.) cultivars and their mechanisms of low cadmium accumulation

Purpose

Screening out cadmium (Cd) excluding cultivars of a crop in agricultural production is an effective way to prohibit Cd entering into food chain.

Methods

A judging criterion for Cd-excluding cultivars based on food safety was suggested and used in the identification of Cd-excluding welsh onion (Allium fistulosum L.) cultivars. A pot culture experiment was carried out to screen out Cd-excluding cultivars, of which the results were confirmed by plot experiments. The relevant factors of Cd accumulation in the pseudostem were analyzed and used in the correlation analysis aiming to study the low Cd accumulation mechanisms.

Results

The concentration of Cd in the pseudostem of welsh onions was 0.08?C0.20, 0.18?C0.41, and 0.26?C0.61?mg/kg fresh weight (FW) under three treatments (1.0, 2.5, and 5.0?mg/kg), respectively. The significant (p? ₃ ^? ?CN, and eight other elements in the tested welsh onion cultivars. Two cultivars were identified as Cd-excluding cultivars, mainly because the accumulation of Cd in their pseudostem was only 0.041?±?0.003 and 0.046?±?0.002?mg/kg FW, and 0.054?±?0.001 and 0.066?±?0.011?mg/kg FW, when growing in plots with Cd concentration of 0.49 and 0.99?mg/kg, respectively.

Conclusions

Ribentiegancongwang and Wuyeqi could be identified as Cd-excluding cultivars. Low bioaccumulation factor of the roots was the main mechanism of Cd-excluding welsh onion cultivars.