Analysis of arable land loss and its impact on rural sustainability in Southern Jiangsu Province of China

Rapid urbanization and industrialization in southern Jiangsu Province have consumed a huge amount of arable land. Through comparative analysis of land cover maps derived from TM images in 1990, 2000 and 2006, we identified the trend of arable land loss. It is found that most arable land is lost to urbanization and rural settlements development. Urban settlements, rural settlements, and industrial park-mine-transport land increased, respectively, by 87 997 ha (174.65%), 81 041 ha (104.52%), and 12 692 ha (397.99%) from 1990 to 2006. Most of the source (e.g., change from) land covers are rice paddy fields and dryland. These two covers contributed to newly urbanized areas by 37.12% and 73.52% during 1990–2000, and 46.39% and 38.86% during 2000–2006. However, the loss of arable land is weakly correlated with ecological service value, per capita net income of farmers, but positively with grain yield for some counties. Most areas in the study site have a low arable land depletion rate and a high potential for sustainable development. More attention should be directed at those counties that have a high depletion rate but a low potential for sustainable development. Rural settlements should be controlled and rationalized through legislative measures to achieve harmonious development between urban and rural areas, and sustainable development for rural areas with a minimal impact on the ecoenvironment.     

Chilled ammonia process for CO2 capture

The chilled ammonia process absorbs the CO₂ at low temperature (2–10 °C). The heat of absorption of carbon dioxide by ammonia is significantly lower than for amines. In addition, degradation problems can be avoided and a high carbon dioxide capacity is achieved. Hence, this process shows good perspectives for decreasing the heat requirement. However, a scientific understanding of the processes is required. The thermodynamic properties of the NH₃–CO₂–H₂O system were described using the extended UNIQUAC electrolyte model developed by Thomsen and Rasmussen in a temperature range from 0 to 110 °C and pressure up to 100 bars. The results show that solid phases consisting of ammonium carbonate and bicarbonate are formed in the absorber. The heat requirements in the absorber and in the desorber have been studied. The enthalpy calculations show that a heat requirement for the desorber lower than 2 GJ/ton CO₂ can be reached.     

Block Copolymers Containing (R)-3-Hydroxybutyrate and Isosorbide Succinate or (S)-Lactic Acid Mers

A new aliphatic block copolyester was synthesized in bulk from transesterification techniques between poly((R)-3-hydroxybutyrate) (PHB) and poly(isosorbide succinate) (PIS). Additionally, other two block copolyesters were synthesized in bulk either from transesterification reactions involving PHB and poly(l-lactide) (PLLA) or from ring-opening copolymerization of l-lactide and hydroxyl-terminated PHB, as result of a previous transesterification reactions with isosorbide. Two-component blends of PHB and PIS or PLLA were also prepared as comparative systems. SEC, MALDI-TOF mass spectrometry (MALDI-TOFMS), ¹H and ¹³C NMR spectroscopy, WAXD, solubility tests, and TG thermal analysis were used for characterization. The block copolymer structures of the products were evidenced by MALDI-TOFMS, ¹³C NMR, and WAXD data. The block copolymers and the corresponding binary blends presented different solubility properties, as revealed by solubility tests. Although the incorporation of PIS sequences into PHB main backbone did not enhance the thermal stability of the product, it reduced its crystallinity, which could be advantageous for faster biodegradation rate. These products, composed of PHB and PIS or PLLA sequences, are an interesting alternative in biomedical applications.     

Sisal/Carbon Fibre Reinforced Hybrid Composites: Tensile, Flexural and Chemical Resistance Properties

The variation of mechanical properties such as tensile and flexural properties of randomly oriented unsaturated polyester based sisal/carbon fibre reinforced hybrid composites with different fibre weight ratios have been studied. The chemical resistance test of these hybrid composites to various solvents, acids and alkalies were studied. The effect of NaOH treatment of sisal fibres on the tensile, flexural and chemical resistance properties of these sisal/carbon hybrid composites has also been studied. The hybrid composites showed an increase in tensile and flexural properties with increase in the carbon fibre loading. The tensile properties and flexural properties of these hybrid composites have been found to be higher than that of the matrix. Significant improvement in tensile properties and flexural properties of the sisal/carbon hybrid composites has been observed by alkali treatment. The chemical resistance test results showed that these untreated and alkali treated hybrid composites are résistance to all chemicals except carbon tetra chloride. Hand lay-up technique was used for making the composites and tests are carried out by using ASTM methods.     

Reclaimed Mineland Curve Number Response to Temporal Distribution of Rainfall1

Warner, Richard C., Carmen T. Agouridis, Page T. Vingralek, and Alex W. Fogle, 2010. Reclaimed Mineland Curve Number Response to Temporal Distribution of Rainfall. Journal of the American Water Resources Association (JAWRA) 46(4): 724-732. DOI: 10.1111/j.1752-1688.2010.00444.x Abstract: The curve number (CN) method is a common technique to estimate runoff volume, and it is widely used in coal mining operations such as those in the Appalachian region of Kentucky. However, very little CN data are available for watersheds disturbed by surface mining and then reclaimed using traditional techniques. Furthermore, as the CN method does not readily account for variations in infiltration rates due to varying rainfall distributions, the selection of a single CN value to encompass all temporal rainfall distributions could lead engineers to substantially under- or over-size water detention structures used in mining operations or other land uses such as development. Using rainfall and runoff data from a surface coal mine located in the Cumberland Plateau of eastern Kentucky, CNs were computed for conventionally reclaimed lands. The effects of temporal rainfall distributions on CNs was also examined by classifying storms as intense, steady, multi-interval intense, or multi-interval steady. Results indicate that CNs for such reclaimed lands ranged from 62 to 94 with a mean value of 85. Temporal rainfall distributions were also shown to significantly affect CN values with intense storms having significantly higher CNs than multi-interval storms. These results indicate that a period of recovery is present between rainfall bursts of a multi-interval storm that allows depressional storage and infiltration rates to rebound.     

Variation in biogenic volatile organic compound emission pattern of Fagus sylvatica L. due to aphid infection

Volatile organic compounds (VOCs) have been the focus of interest to understand atmospheric processes and their consequences in formation of ozone or aerosol particles; therefore, VOCs contribute to climate change. In this study, biogenic VOCs (BVOCs) emitted from Fagus sylvatica L. trees were measured in a dynamic enclosure system. In total 18 compounds were identified: 11 monoterpenes (MT), an oxygenated MT, a homoterpene (C₁₄H₁₈), 3 sesquiterpenes (SQT), isoprene and methyl salicylate. The frequency distribution of the compounds was tested to determine a relation with the presence of the aphid Phyllaphis fagi L. It was found that linalool, (E)-β-ocimene, α-farnesene and a homoterpene identified as (E)-4,8-dimethyl-1,3,7-nonatriene (DMNT), were present in significantly more samples when infection was present on the trees. The observed emission spectrum from F. sylvatica L. shifted from MT to linalool, α-farnesene, (E)-β-ocimene and DMNT due to the aphid infection. Sabinene was quantitatively the most prevalent compound in both, non-infected and infected samples. In the presence of aphids α-farnesene and linalool became the second and third most important BVOC emitted. According to our investigation, the emission fingerprint is expected to be more complex than commonly presumed.     

Characteristics of springtime profiles and sources of ozone in the low troposphere over northern Taiwan

To quantify the possible sources of the high ambient ozone concentration in the low troposphere over Taiwan, ozone sounding data from a two-year intensive field measurement program conducted in April and early May of 2004 and 2005 in northern Taiwan has been examined. We found that the vertical ozone distributions and occurrence of enhanced ozone in the lower troposphere (below 6 km) mainly resulted from (1)Type NE: the long-range transport of ozone controlled by the prevailing northeasterly winds below 2 km, (2)Type LO: the local photochemical ozone production process, and (3)Type SW: the strong southwest/westerly winds aloft (2–6 km). In the boundary layer (BL), where Asian continental outflow prevails, the average profile for type NE is characterized by a peak ozone concentration of nearly 65 ppb at about 1500 m altitude. For type LO, high ozone concentration with an average ozone concentration greater than 80 ppb was also found in the BL in the case of stagnant atmospheric and sunny weather conditions dominated. For type SW, significant ozone enhancement with average ozone concentration of 70–85 ppb was found at around 4 km altitude. It is about 10 ppb greater than that of the types NE and LO at the same troposphere layer owing to the contribution of the biomass burning over Indochina. Due to Taiwan's unique geographic location, the complex interaction of these ozone features in the BL and aloft, especially features associated with northeasterly and south/southwesterly winds, have resulted in complex characteristics of ozone distributions in the lower troposphere over northern Taiwan.     

Use of CALPUFF for exposure assessment in a near-field,complex terrain setting

CALPUFF is an atmospheric source-receptor model recommended by the U.S. Environmental Protection Agency for use on a case-by-case basis in complex terrain and wind conditions. The ability of the model to provide useful information for exposure assessments in areas with those topographical and meteorological conditions has received little attention. This is an important knowledge gap for use of CALPUFF outside of regulatory applications, such as exposure analyses conducted in support of risk assessments and health studies. We compared deposition of cadmium (Cd), lead (Pb), and zinc (Zn) calculated with CALPUFF as a result of emissions from a zinc smelter with corresponding concentrations of the metals measured in attic dust and soil samples obtained from the surrounding area. On a point-by-point analysis, predictions from CALPUFF explained 11% (lead) to 53% (zinc) of the variability in concentrations measured in attic dust. Levels of heavy metals in soil interpolated to 100 residential addresses from the distribution of concentrations measured in soil samples also agreed well with deposition predicted with CALPUFF: R² of 0.46, 0.76, and 079 for Pb, Cd, and Zn, respectively. Community-average concentrations of Cd, Pb, and Zn measured in soil were significantly (p < 0.0001) and strongly correlated (R² ranged from 0.77 to 0.98) with predicted deposition rates. These findings demonstrate that CALPUFF can provide reasonably accurate predictions of the patterns of long-term air pollutant deposition in the near-field associated with emissions from a discrete source in complex terrain. Because deposition estimates are calculated as a linear function of air concentrations, CALPUFF is expected to be reliable model for prediction of long-term average, near-field ambient air concentrations in complex terrain as well.     

Ambient TSP concentration and dustfall in major cities of China: Spatial distribution and temporal variability

Based on environmental monitoring data in 93 major cities and meteorological records at 398 weather stations in China from 1981 to 2007, total suspended particle (TSP) concentration, the intensity of dustfall, and sand and dust storm frequency (F_d) were analysed. During the past 27 years, the annual average TSP concentration (C_TSP) in 93 cities was 402 μg m^?3. Annual average C_TSP decreased from the north to the south and from inland to the coast areas with a peak value of 628.8 μg m^?3 in Lanzhou. In the 1980s, 1990s and 2000s, annual average C_TSP was 628.7, 319.2, and 250.1 μg m^?3, respectively. Annual average intensity of dustfall (I_d) was 240.5 t km^?2 a^?1, decreased from northern to southern China and from inland to the coast areas with the maximum value of 717.2 t km^?2 a^?1 in Baotou. In the 1980s, 1990s and 2000s, annual average I_d was 334.8, 220.9, 146 t km^?2 a^?1 respectively. Annual average I_d in the Loess Plateau region was commonly higher than 200 t km^?2 a^?1. The annual average F_d decreased from arid regions in northwestern China to humid areas in southeastern China with two sand and sand storm centers existing in Xinjiang Taklamakan Desert and western Inner Mongolia. The annual average F_d in the 1980s, 1990s, 2000s was 16, 8, 6 days respectively, decreased steadily from 18 days in 1981–5 days in 2007. Annual average I_d had a positive linear relation to annual average C_TSP (R² = 0.96). Annual average F_d had a positive relation with annual average C_TSP (R² = 0.97) as well as annual average I_d (R² = 0.94). TSP was the chief pollutant influencing Air Pollution Index (API) in northern China in spring and winter seasons. Sand and dust storm might be a major factor affecting the temporal variability and spatial distribution of TSP and dustfall in China.