Comparison of different disinfection processes in the effective removal of antibiotic-resistant bacteria and genes

This study compared three different disinfection processes(chlorination, E-beam, and ozone) and the efficacy of three oxidants(H2O2, S2O-8, and peroxymonosulfate(MPS)) in removing antibiotic resistant bacteria(ARB) and antibiotic resistance genes(ARGs) in a synthetic wastewater. More than30 mg/L of chlorine was needed to remove over 90% of ARB and ARG. For the E-beam method, only1 dose(kGy) was needed to remove ARB and ARG, and ozone could reduce ARB and ARG by more than 90% even at 3 mg/L ozone concentration. In the ozone process, CT values(concentration × time)were compared for ozone alone and combined with different catalysts based on the 2-log removal of ARB and ARG. Ozone treatment yielded a value of 31 and 33(mg·min)/L for ARB and ARGs respectively. On the other hand, ozone with persulfate yielded 15.9 and 18.5(mg·min)/L while ozone with monopersulfate yielded a value of 12 and 14.5(mg·min)/L. This implies that the addition of these catalysts significantly reduces the contact time to achieve a 2-log removal, thus enhancing the process in terms of its kinetics.     

A study of polycyclic aromatic hydrocarbons concentrations and source identifications by methods of diagnostic ratio and principal component analysis at Taichung chemical Harbor near Taiwan Strait

Fine (PM(2.5)) and Coarse (PM(2.5-10)) particulates concentrations of ambient air particle-bound polycyclic aromatic hydrocarbons (PAHs) were measured simultaneously from February 2004 to January 2005 at the Taichung Harbor (TH) sampling site near Taiwan of central Taiwan. Particle-bound polycyclic aromatic hydrocarbons (PAHs) were collected on quartz filters, the collected sample used soxhlet analytical method extracted with a dichloromethane (DCM)/n-hexane mixture (50/50, v/v) for 24h, and then the extracts were subjected to gas chromatography-mass spectrometric (GC-MS) analysis. The results indicated that vehicle emissions, coal combustion, incomplete combustion and pyrolysis of fuel and oil burning were the main source of PAHs near Taiwan Strait of central Taiwan. Diagnostic ratio and principal component analysis (PCA) were also used to characterize and identify PAHs emission source in this study.     

Characteristics of Asian dust transport based on synoptic meteorological analysis over Korea

Classification of synoptic patterns and their correlation with dust events over East Asia were performed by means of cluster analysis. The average linkage and K-means clustering techniques were used to identify two major weather types during Asian dust events (ADEs; total 26 ADEs with 47 dusty days) of six spring seasons from 1996 to 2001. The first weather type mainly influenced neighboring Asian countries and frequently occurred with ADEs (approximately 23% of ADE cases). It mostly occurred under a surface high (low)-pressure system over the west (east) of the Korean peninsula coupled with an upper-level trough and cutoff low passage over the center of the Korean peninsula. It showed strong advection in the middle/ upper troposphere with both a high aerosol index and enhanced coarse particulate matter (PM) loading over Korea. In contrast, the second weather type was mostly associated with long distance or continental-scale transport and occurred less frequently with ADEs (approximately 15%). It appeared with an upper-level trough and a cutoff low vertically connected with a surface low system that was formed by a strong cyclonic vortex over the north of the Korean peninsula. There were weak advection, low aerosol index, and low coarse PM concentration over the Korean peninsula during the second weather type. In addition, it was found to be mostly associated with the trans-Pacific transport of Asian dust to the western coast of North America.     

Effects of Temperature and Relative Humidity on Polylactic Acid Plastic Degradation

Three high molecular weight (120,000 to 200,000 g mol^–1) polylactic acid (PLA) plastic films from Chronopol (Ch-I) and Cargill Dow Polymers (GII and Ca-I) were analyzed for their degradation under various temperature and relative humidity (RH) conditions. Two sets of plastic films, each containing 11 samples, were randomly hung in a temperature/humidity-controlled chamber by means of plastic-coated paper clips. The tested conditions were 28, 40, and 55°C at 50 and 100% RH, respectively, and 55°C at 10% RH. The three tested PLA films started to lose their tensile properties when their weight-average molecular weight (M _w) was in the range of 50,000 to 75,000 g mol^–1. The average degradation rate of Ch-I, GII, and Ca-I was 28,931, 27,361, and 63,025 M _w/week, respectively. Hence, GII had a faster degradation rate than Ch-I and Ca-I under all tested conditions. The degradation rate of PLA plastics was enhanced by the increase in temperature and relative humidity. This trend was observed in all three PLA plastics (Ca-I, GII, and Ch-I). Of the three tested films, Ch-I was the first to lose its mechanical properties, whereas Ca-I demonstrated the slowest loss, with mechanical properties under all tested conditions.     

Growth and macronutrient removal of water hyacinth in a small secondary sewage treatment plant

Studies have been made of the growth characteristics of water hyacinth, Eichhornia crassipes (Mart.) Solms, and its ability to remove N, P and K, in a secondary settling pond of a small secondary sewage treatment plant serving both the academic and residential blocks of the Swire Marine Laboratory, University of Hong Kong. The treatment plant consists of, in series, a primary settling tank, a trickling filter compartment and a secondary settling pond from which part of the treated wastewater is recycled to the primary settling tank while the remaining effluent (1 to 2 m³ daily) mixes with and hence is diluted by the outflowing seawater from the aquarium system of the Swire Marine Laboratory before discharge to the sea. Samples of wastewater have been taken regularly from the primary sedimentation pond, the outflow of the trickling filter, the secondary settling pond and the effluent of the treatment plant (before mixing with aquarium outflow) since January, 1992. Physical, chemical and biological characteristics of the samples have been determined and are typical of secondary effluents, with a mean pH of about 7.5, total solids 1200 mg L⁻¹, suspended solids 45 mg L⁻¹, conductivity 2000 μS cm⁻¹, salinity 1 ppt, dissolved oxygen 2 mg L⁻¹, BOD₅ 45 mg L⁻¹, Kjeldahl-N 30 mg L⁻¹, NH₄,-N 25 mg L⁻¹, NO₃-N 4 mg L⁻¹, total P 10 mg L⁻¹, K 35 mg L⁻¹ and total coliforms of less than 10⁵ colonies 100 ml⁻¹.Water hyacinth plants have been stocked in the secondary settling pond as an integral part of the treatment plant so as to improve the quality of, as well as to retrieving and recycling nutrient elements from, the wastewater. The plants are periodically harvested to maintain an active growing crop. The growth rate, standing crop biomass, tissue nutrient composition, nutrient storage and accumulation rate of two growth cycles, one from February 25 to March 18 (mean temperature 17.6°C) and the other from 22 April to 12 May (24.8°C) are reported. The water hyacinth assumed a relatively high standing crop biomass of 10 kg m⁻² (5 to 6 t DM ha⁻¹), and growth rates of 48 and 225 g m⁻² day⁻¹, respectively, for the first and second growth period. Nutrient storage capacities were relatively high, at about 20, 7.5 and 16.5 g m⁻² for N, P and K, respectively. The nutrient composition was very high, reaching 5.42% for N, 1.97 for P, and 4.57 for K. Both the stem and lamina accumulated high levels of N, while the petiole had the highest level of P and K. Apart from nutrient removal, the water hyacinth also helped to decrease the suspended solids, BOD₅ value and total coliforms of the wastewater.It is concluded that water hyacinth improves the quality of wastewater in such small-scale sewage treatment plants and it is recommended that frequent harvests of water hyacinth would increase the treatment efficiency, especially during the active growing season with high temperatures coupled with intense solar radiation.     

Heavy Metal Contents and Magnetic Properties of Playground Dust in Hong Kong

This study examined the levels of seven heavy metals (namelyzinc, copper, cadmium, chromium, lead, manganese and iron) andtheir associations with magnetic properties in playground dustof Hong Kong. Results showed that the playground dust containedhigh concentrations of Zn (mean = 1883 g g^-1), Cu(mean = 143 g g^-1) and Cr (mean = 263 g g^-1).Qualitative examination of dust samples under microscope indicated local traffic as one of the important pollutant sources. Magnetic measurements indicated that these anthropogenicpollutants mainly consisted of coarse-grained multidomain (MD) ferrimagnetic minerals. Superparamagnetic (SP), stable single domain (SSD) ferrimagnetic grains and non-ferrimagnetic mineralswere present in relatively small amounts. Significant correlations between heavy metals and various magnetic parametersindicated a strong affinity of heavy metals to magnetic minerals hence pointed out the potential of magnetic properties for simpleand rapid proxy indications of heavy metal pollution in playground dust.     

On a Temporal Investigation of Hurricane Strength and Frequency

Hurricanes originating in the West Atlantic often have devastating consequences on the cities in the US east coast, both monetary and otherwise, and hence pose a source of considerable concern to several authorities. The possibility of a connection between global warming in general and an increased frequency of these strong hurricanes is well researched, but is still actively debated. The present work tries to promote the use of a smoothing statistic termed empirical recurrence rates and to advocate the use of another, termed empirical recurrence rates ratio in a bid to better understand the rich history of these storms on one hand and to make appropriate inferences on the other, so that some light can be shed on the acceptability of conjectures held by renowned climate scientists. The methods introduced are intuitive and simple to implement and should find wide applications in diverse disciplines.