Critical loads for Finnish lakes: comparison of three steady-state models

Three simple steady-state water-chemistry models are used to calculate critical loads of sulfur for lakes in Finland. Because of the high concentrations of organic matter in Finnish lakes, the influence of organic anions on the calculation of critical loads has been given special attention. The first two methods are well known ion-balance methods which have been used in many previous lake-acidification studies. The third method, developed for this study, includes the numerical solution of equilibrium equations for organic anions, inorganic carbon species and inorganic monomeric aluminum. The original pH and aluminum concentration of the lakes are estimated with this model, and a method to estimate the original acid neutralizing capacity (ANC) by simulating a Gran-titration is also tested on the lake data. Uncertainty in the predictions is estimated by varying the most critical model parameters.     

Deposition of atmospheric ammonia to moorlands

Micrometeorological methods were applied to measure fluxes of atmospheric ammonia (NH3) to moorlands. Measurements were made in a wide variety of surface conditions and included both Calluna vulgaris (L.) Hull and Eriophorum vaginatum L. dominated sites. NH3 was found to deposit rapidly to all the sites investigated, providing large deposition velocities (Vd, typically 10-40 mm s(-1)) and usually minimal surface resistances (rc). A small number of measurements were made in frozen conditions and suggest a possible exception to this pattern with mean rc of 50-200 s m(-1). The effect of vegetation drying was also investigated and a possible increase in rc observed, though this was small (< 10 s m(-1)). The results are interpreted in terms of the processes controlling exchange; it is shown that NH3 deposition is predominantly to the leaf surfaces and that the net NH3 compensation point approaches zero. Annual estimates show that dry deposition of NH3 is a major source of atmospheric nitrogen to moorland ecosystems. For two typical UK sites subject to background air concentrations, NH3 dry deposition is of similar magnitude to equivalent NH4+ inputs in wet deposition. In the vicinity of emission sources, NH3 dry deposition is expected to dominate inputs of atmospheric nitrogen.     

Cadmium availability to the cyanobacterium Synechocystis aquatilis in solutions containing chloride

Availability of cadmium to Synechocystis aquatilis (estimated by 109Cd sorption and cadmium toxicity-14C method) in solutions containing cadmium and complexing (KCl) or non-complexing (KNO3) salts, in the range of 0-0.5 m was investigated. Both cadmium surface adsorption and transport into the cells were lower in solutions containing cadmium chloride complexes (CdCl+, CdCl2, CdCl3-) than in those containing cadmium in the form of Cd2+. Also, cadmium toxicity in solutions of higher KCl concentrations, in which CdCl+ and CdCl2 forms predominated, was significantly limited.     

Seasonal trend of fog water chemical composition in the Po Valley

Fog frequency in the Po Valley, Northern Italy, can be as high as 30% of the time in the fall-winter season. High pollutant concentrations have been measured in fog water samples collected in this area over the past few years. The combined effects of high fog occurrence and high pollutant loading of the fog droplets can determine, in this area, appreciable chemical deposition rates. An automated station for fog water collection was developed, and deployed at the field station of S. Pietro Capofiume, in the eastern part of the Po Valley for an extended period: from the beginning of November 1989 to the end of April 1990. Time-resolved sampling of fog droplets was carried out during all fog events occurring in this period, and chemical analyses were performed on the collected samples. Statistical information on fog occurrence and fog water chemical composition is reported in this paper, and a tentative seasonal deposition budget is calculated for H+, NH4+, NO3- and SO4(2-) ions. The problems connected with fog droplet sampling in sub-freezing conditions are also addressed in the paper.     

Trace metals in interstitial waters from sandstones: acidic inputs to shallow groundwaters

There is some evidence from southern Britain that shallow groundwaters in non-carbonate lithologies may be affected by acidic deposition. To investigate this, interstitial water profiles down to 12 m have been obtained from unsaturated sands or semi-consolidated sandstones from the Folkestone Beds (Lower Greensand) of Surrey and the Sherwood Sandstone of the West Midlands. The pH of the interstitial waters generally increased with depth and reflected an increase in the base saturation of the exchange complex. Beneath the highly acidic surface soil horizons (pH 3.0-3.5), interstitial waters with a pH of 4.0-4.5 were found down to depths of several metres. The pH progressively increased to around pH 5.5 because of base cation desorption and the weathering of silicate minerals. High concentrations of aluminium (10-20 mg litre(-1)) and other metals (Fe, Mn, Cu, Ni, Co, Zn, Be) were found in the interstitial water in the upper unsaturated zone. Most metal concentrations were strongly pH-dependent but also reflected the geochemical characteristics of the parent sands or sandstones. H+ and trace element concentrations were slightly higher beneath areas of afforestation than beneath heathland. The downward fluxes of solutes have been estimated using rainfall-derived chloride as a non-reactive solute. The profiles retain a record of 10-20 years input allowing the past inputs from SO4 and other species to be estimated using solute/chloride ratios. Cation exchange sites are probably depleted over a period of decades and there can be a significant decrease in the unsaturated zone pH as a result of increased or sustained acidic deposition. The shallow groundwater environment (0-15 m) in non-carbonate terrains is therefore a sensitive environment where high metal concentrations may be generated and may ultimately lead to water quality problems in shallow water supplies.     

Effects of atmospheric ammonia and ammonium sulphate on Douglas fir (Pseudotsuga menziesii)

Three-year-old Douglas firs (Pseudotsuga menziesii) were fumigated with 180 microg m(-3) NH3 or clean (charcoal-filtered) air. During these fumigations the plants received 15 mm artificial rain weekly, supplemented with 20, 500 or 2500 micromol litre(-1) (NH4)2SO4. Exposure to NH3 and NH4+ for 14 weeks resulted in a change of the nutrient status of the needles. The most remarkable effect was the increase in the N/K ratio, due to both uptake of N and leaching of K. The action of NH3 was stronger than that of NH4+. Both NH3 and (NH4)2SO4 affected the epicuticular wax layer and decreased mycorhiza frequency. Following fumigation and artificial rain treatments, needles were incubated for 8 h in a medium containing 0, 50, 250, 500 and 2500 micromol litre(-1) (NH4)2SO4. Almost no exchange of Ca, Mg and K for NH4+ was found. Therefore this ion exchange probably explains only a minor part of the changes in nutrient status of the whole trees.     

Effects of thiobencarb herbicide to an alga (Nannochloris oculata) and the cladoceran (Daphnia magna)

Chronic toxicity studies were conducted with an algae (Nannochloris oculata) and the cladoceran (Daphnia magna) to determine their relative sensitivities to the thiocarbamate herbicide thiobencarb (S-4-chlorobenzyl diethylthiocarbamate). Most of the algal populations were initially affected by exposure to the herbicide. Thiobencarb concentrations higher than 0.5 mg/L significantly reduced algal densities after 24-h exposure. The 24-h static EC50 in D. magna was 3.01 mg/L. The sublethal effects of 0.3, 0.37, 0.5, 0.75, and 1.5 mg/L of thiobencarb concentrations on the survival, reproduction, and growth of D. magna were monitored for 21 days. The parameters used to determined the effect of the herbicide on D. magna were mean total young per female; mean brood size; days to first brood; intrinsic rate of natural increase (r); growth; and survival. Reproduction was significantly reduced at thiobencarb concentrations of 0.30 mg/L and higher while survival was affected after exposure to 0.75 and 1.5 mg/L of the pesticide. The r value decreased with increasing concentrations of thiobencarb. Growth, as measured by body length, was depressed significantly after exposure to all herbicide concentrations tested.     

Adsorption of methabenzthiazuron on six allophanic and nonallophanic soils: effect of organic matter amendment

This article reports on methabenzthiazuron [1-(1,3-benzothiazol-2-yl)-1,3-dimethylurea] (MBT) adsorption process on six agricultural allophanic and nonallophanic soils. The effect of amendment with exogenous organic matter was also studied. Adsorption kinetic fits an hyperbolic model. MBT adsorption reached an apparent equilibrium within 2 h and followed a second-order reaction. The maximum adsorbed amounts for natural soils ranged from 32 to 145 microg g(-1). Rate constants were considered relatively low (0.27-1.5 x 10(-4) [microg g(-1)](1-n) s-1); the slow process was attributed to a combined effect of difussion and adsorption. MBT adsorption fits the Freundlich model with r values > or =0.998 at P < or = 0.001 significance levels. Kf and Freundlich exponents (l/n) ranged from 5.3 to 82.1 cm3 g(-1) and from 0.66 to 0.73, respectively. Kf values for soils with a low organic matter content were lower than that obtained from the only typical allophanic soil derived from volcanic ash under study. Lineal regression analysis between Kf and organic matter content of nonallophanic soils gave a correlation coefficient of 0.980 (P = 0.02). Dispersion of Kd values together with close values of K(OM) indicate that organic matter (OM) was the principal component responsible for MBT adsorption in unamended soils. Addition of peat decreased soil pH and increased adsorption capacity for allophanic and nonallophanic soils. Kinetic experiments showed enhancements of Xmax values and lower rate constants.     

On the behavior of approaches to simulate reactive transport

Two families of approaches exist to simulate reactive transport in groundwater: The Direct Substitution Approach (DSA), based on Newton-Raphson and the Picard or Sequential Iteration Approach (SIA). We applied basic versions of both methods to several test cases and compared both computational demands and quality of the solution for varying grid size. Results showed that the behavior of the two approaches is sensitive to both grid size and chemistry. As a general rule, the DSA is more robust than the SIA, in the sense that its convergence is less sensitive to time step size (any approach will converge given a sufficiently small time step). Moreover, the DSA leads to a better simulation of sharp fronts, which can only be reproduced with fine grids after many iterations when the SIA is used. As a consequence, the DSA runs faster than SIA in chemically difficult cases (i.e., highly non-linear and/or very retarded), because the SIA may require very small time steps to converge. On the other hand, the size of the system of equations is much larger for the DSA than for the SIA, so that its CPU time and memory requirements tend to be less favorable with increasing grid size. As a result, the SIA may become faster than the DSA for very large, chemically simple problems. The use of an iterative linear solver for the DSA makes its CPU time less sensitive to grid size.     

Surfactant enhanced recovery of tetrachloroethylene from a porous medium containing low permeability lenses. 1. Experimental studies

A matrix of batch, column and two-dimensional (2-D) box experiments was conducted to investigate the coupled effects of rate-limited solubilization and layering on the entrapment and subsequent recovery of a representative dense NAPL, tetrachloroethylene (PCE), during surfactant flushing. Batch experiments were performed to determine the equilibrium solubilization capacity of the surfactant, polyoxyethylene (20) sorbitan monooleate (Tween 80), and to measure fluid viscosity, density and interfacial tension. Results of one-dimensional column studies indicated that micellar solubilization of residual PCE was rate-limited at Darcy velocities ranging from 0.8 to 8.2 cm/h and during periods of flow interruption. Effluent concentration data were used to develop effective mass transfer coefficient (Ke) expressions that were dependent upon the Darcy velocity and duration of flow interruption. To simulate subsurface heterogeneity, 2-D boxes were packed with layers of F-70 Ottawa sand and Wurtsmith aquifer material within 20-30 mesh Ottawa sand. A 4% Tween 80 solution was then flushed through PCE-contaminated boxes at several flow velocities, with periods of flow interruption. Effluent concentration data and visual observations indicated that both rate-limited solubilization and pooling of PCE above the fine layers reduced PCE recovery to levels below those anticipated from batch and column measurements. These experimental results demonstrate the potential impact of both mass transfer limitations and subsurface layering on the recovery of PCE during surfactant enhanced aquifer remediation.