Impact of engine lubricant properties on regulated gaseous emissions of 2000-2001 model-year gasoline vehicles

The impact of the sulfur (S) content in lubricating oil was evaluated for four ultra-low-emission vehicles and two super-ultra-low-emission vehicles, all with low mileage. The S content in the lube oils ranged from 0.01 to 0.76%, while the S content of the gasoline was fixed at 0.2 ppmw. Vehicles were configured with aged catalysts and tested over the Federal Test Procedure, at idle and at 50-mph cruise conditions. In all testing modes, variations in the S level of the lubricant did not significantly affect the regulated gas-phase tailpipe emissions. In addition to the regulated gas-phase emissions, a key element of the research was measuring the engine-out sulfur dioxide (SO2) in near-real-time. This research used a new methodology based on a differential optical absorption spectrometer (DOAS) to measure SO2 from the lubricants used in this study. With the DOAS, the contribution of SO2 emissions for the highest-S lubricant was found to range from less than 1 to 6 ppm on a gasoline S equivalent basis over the range of vehicles and test cycles used. The development and operation of the DOAS is discussed in this paper.     

Shifted power-law relationship between NO2 concentration and the distance from a highway: A new dispersion model based on the wind profile model

In this paper, a shifted power-law model, based on the wind profile model, had been supposed to simulate concentration gradient of nitrogen dioxide (NO₂) with distance from a highway. Field experiments were performed for NO₂ gradients from a highway in Shanghai by using passive samplers. The shifted power-law model was fitted well with experimental results of field experiments both in this study and in the literature. The results not only verified the validity of shifted power-law relationship between NO₂ concentration and the distance from a highway, but also partially demonstrated that there were some significant similarities between wind profile and air pollutants concentration profile near highway. With known concentration of chosen reference point and appropriate value of the parameter k, the model could be practically applied for predicting the NO₂ distributions near a highway. The methods of determining the parameter k were also discussed for further detailed studies.     

含铬废水的治理研究

介绍了含铬废水的分离处理研究现状，讨论了各自的应用原理及优缺点。对工程设计和生产工艺提出了一些有益的建议。并对含铬废水处理的发展趋势作了分析和展望。     

Synchronous-scan fluorescence spectra of Chlorella vulgaris solution

The characterization of the Chlorella vulgaris solution was carried out using synchronous-scan spectroscopy. The range of concentration of algae and Fe(III) in aqueous solutions were 5 × 10⁸–8 × 10⁹ cells l⁻¹ and 10–60 μM, respectively. Effective characterization method used was synchronous-scan fluorescence spectroscopy. The wavelength difference (Δλ) of 90 nm was maintained between excitation and emission wavelengths; 90 nm was found to be the best Δλ for effective characterization of Chlorella vulgaris solution with or without quencher species (e.g., Fe(III), humic acid (HA)) for the first time. The peak was observed at about EX 236.6 nm/EM 326.6 nm for synchronous-scan fluorescence spectra. The fluorescence quenching of algae in system of algae–Fe(III)–HA was studied using synchronous-scan spectroscopy for the first time. Fe(III) was clearly the effective quencher. The relationship between I₀/I (quenching efficiency) and c (concentration of Fe(III) added) was a linear correlation for the algae solution with Fe(III). Also, Aldrich humic acid was found to be an effective quencher. pH effect on synchronous-scan fluorescence intensity of algal solution with Fe(III) and/or HA was evident.     

Uncertainty analysis of parameters for modeling the transfer and fate of benzo(a)pyrene in Tianjin wastewater irrigated areas

A Monte Carlo simulation for uncertainty analysis of three key parameters (local coal consumption rate Q(1L), dry deposition velocity of aerosol particulate Kp and biodegradation rate of benzo(a)pyrene in soil and sediment K(R3)) was conducted in this study. Results of the simulation indicate that the three parameters were influenced by uncertainty and that all equilibrium concentrations in the four bulk compartments and various sub-compartments were log-normally distributed. However, the results also indicated that among the six primary transfer fluxes, erosion associated with solids in soil and deposition associated with solids in water, along with output from sewers were also log-normally distributed, while deposition from air to soil and biodegradation in soil and sediment followed normal distributions. The effect of uncertainty on the model results of the three key parameters was derived using a comparison of upper and lower of confidence interval boundaries at the 95% level of confidence. The results reveal that uncertainty in the key parameters had a more significant influence on equilibrium concentrations of the chemical in the bulk compartments of soil and sediment than on concentrations in the other two bulk compartments, various sub-compartments and the six predominant transfer fluxes.     

System-level responses of lake ecosystems to chemical stresses using exergy and structural exergy as ecological indicators

This paper presents the system-level responses of experimental lake ecosystems to three chemical stresses (acidification, copper and pesticide contamination) using exergy and structural exergy as ecological indicators. The results indicate that the doses or toxicity of the three chemical stressors contributed to changes in both exergy and structural exergy. Remarkable changes in exergy and structural exergy occurred under acidic conditions and in the presence of Dursban, 24D-DMA, permethrin, bifenthrin, Carbaryl, TCP, PCP, trichlorethylene, benzene, and high doses of Cu, oil, and hexazinone. This seemed to indicate that the subject ecosystems were seriously contaminated by these chemical stressors. For low doses of Cu, oil, atrazine, HCBP, and hexazinone, exergy and structural exergy were either unchanged or only slightly changed, suggesting that the lake ecosystems were not significantly impacted by these chemical stressors. Discussion of the relationships between ecosystem-level changes and structural and functional changes in stressed lake ecosystems indicates that the above-mentioned ecosystem-level changes were in accordance with the changes in structure and function. The observed changes in exergy and structural exergy were also consistent with Odum's predictions of shortened food chains, reduced resource use efficiency, poor stability, low information, and high entropy in stressed aquatic ecosystems. The findings lead the authors to conclude that it is feasible for exergy and structural exergy to serve as ecological indicators when characterizing the system-level responses of experimental lake ecosystems to chemical stress. These results for experimental lake ecosystems would be extrapolated to actual lakes.     

双氰胺在四川3种主要土壤上的硝化抑制作用

采用室内培养试验方法,在不同浓度双氰胺(DCD)处理条件下,对四川3种主要土壤(紫色土、黄壤、灰潮土)的N2O释放量,NH4+-N及NO3--N含量动态变化进行了研究.结果表明,DCD对3种土壤N2O释放及土壤NO3--N含量有明显抑制作用,随DCD浓度增加,其抑制效果越显著.DCD同时能推迟NO3--N含量达到高峰,使土壤NH4+-N含量在较长时间保持相对较高水平,提高氮肥利用率,减少氮素流失.DCD在3种土壤上硝化抑制效果存在差异,表现为紫色土＞灰潮土＞黄壤.同时提出DCD在3种土壤上的适宜添加量,紫色土上为普通碳铵施入量的0.5%,黄壤和灰潮土上为0.3%.     

云南粳稻耐低磷特性的主基因加多基因遗传分析

磷高效水稻培育是提高土壤潜在磷利用效率的一种途径,通过对云南粳稻耐低磷特性的主基因加多基因遗传分析,可以明确耐低磷特性主基因的存在、对数及遗传效应的大小,为磷高效育种提供理论依据。本试验通过云南主栽粳稻品种合系35(Oryza sativa)与耐低磷极强早旱谷(Oryza sativa)配制P1、P2、F1、F2或F3世代,在云南省农科院进行低磷胁迫试验,对耐低磷鉴定和主基因加多基因联合遗传分析,结果表明:早旱谷的分蘖和株穗产量基因受两对主效基因 多基因相互配合遗传控制的,两对主基因间存在上位性效应,两主基因间效应差异较大。分蘖力F2主基因遗传率为58.82%~72.13%,F3主基因遗传率为45.88%~57.96%;株穗产量F2主基因遗传率60.94%~83.08%,F3主基因遗传率为62.20%~75.80%。因此育种中应当充分重视主基因的利用,利用主基因应以第一对主基因的加性效应为主,对后代耐低磷性状的选择宜从F2代开始,杂交的后期世代也要注意耐性的选择。     

同源四倍体水稻亲本材料的结实研究

研究了2份二倍体水稻和29份同源四倍体水稻(2n=4x=48)亲本(其中4份低代材料、25份高代材料)在2004年和2005年的结实情况.与二倍体对照相比,同源四倍体材料的花粉育性、结实率均不同程度下降,尤其低代材料的花粉育性(59.6%～65.3%)和结实率(26.8%～33.5%)大幅度降低;但经过选择改良,大多数材料的花粉育性和结实率均不同程度提高.F检验表明,同源四倍体不同品种间各性状均差异显著,说明同源四倍体材料具有很大的改良潜力.从1996年到2005年对部分同源四倍体水稻进行了连续选择改良,并对其结实率进行T检验,结果表明经过9a的选择改良,同源四倍体水稻结实率显著提高.本文还对同源四倍体水稻各性状间的相关性进行了分析,结果表明,结实率与花粉育性、穗着粒数、穗实粒数极显著相关,理论产量与花粉育性、有效穗数、穗着粒数、穗实粒数、结实率及千粒重极显著相关.表3图1参18     

广东省洪水资源化探讨

广东省多年平均人海水量4018亿m^2，并主要集中在汛期以洪水形式流人大海。文章根据广东省水资源与洪水特点，探讨了洪水资源化的途径及其安全保障措施：利用现有和新建水工程，采用科学合理的蓄、引、提、回灌与冲污等方式使洪水资源化；加强防洪调度与管理，以降低洪水资源化风险，确保安全利用洪水。该研究对解决广东省目前部分地区资源性和水质性缺水具有重要意义。