Influence of regional development policies and clean technology adoption on future air pollution exposure

Future air pollution emissions in the year 2030 were estimated for the San Joaquin Valley (SJV) in central California using a combined system of land use, mobile, off-road, stationary, area, and biogenic emissions models. Four scenarios were developed that use different assumptions about the density of development and level of investment in transportation infrastructure to accommodate the expected doubling of the SJV population in the next 20 years. Scenario 1 reflects current land-use patterns and infrastructure while scenario 2 encouraged compact urban footprints including redevelopment of existing urban centers and investments in transit. Scenario 3 allowed sprawling development in the SJV with reduced population density in existing urban centers and construction of all planned freeways. Scenario 4 followed currently adopted land use and transportation plans for the SJV. The air quality resulting from these urban development scenarios was evaluated using meteorology from a winter stagnation event that occurred on December 15th, 2000 to January 7th 2001. Predicted base-case PM2.5 mass concentrations within the region exceeded 35 μg m^?3 over the 22-day episode. Compact growth reduced the PM2.5 concentrations by ～1 μg m^?3 relative to the base-case over most of the SJV with the exception of increases (～1 μg m^?3) in urban centers driven by increased concentrations of elemental carbon (EC) and organic carbon (OC). Low-density development increased the PM2.5 concentrations by 1–4 μg m^?3 over most of the region, with decreases (0.5–2 μg m^?3) around urban areas. Population-weighted average PM2.5 concentrations were very similar for all development scenarios ranging between 16 and 17.4 μg m^?3. Exposure to primary PM components such as EC and OC increased 10–15% for high density development scenarios and decreased by 11–19% for low-density scenarios. Patterns for secondary PM components such as nitrate and ammonium ion were almost exactly reversed, with a 10% increase under low-density development and a 5% decrease under high density development. The increased human exposure to primary pollutants such as EC and OC could be predicted using a simplified analysis of population-weighted primary emissions. Regional planning agencies should develop thresholds of population-weighted primary emissions exposure to guide the development of growth plans. This metric will allow them to actively reduce the potential negative impacts of compact growth while preserving the benefits.     

湘江株洲段表层水重金属含量及存在形态分布研究

以国家Ⅲ类水质限值为标准,总体来讲,湘江株洲段河水中Cu、Pb、Zn和Cd的总量均不超标,Cd的污染较重。霞湾断面的污染最重,清水塘工业区铅锌冶炼和化工企业是其污染的主要来源。采用化学分析的方法,对湘江株洲段水体中的Cu、Pb、Zn和Cd进行了形态分析,Cu、Zn溶解态在各断面均大于50%;Pb、Cd的形态在不同的断面其所占比例不一样。监测了各水质参数,pH大都在7.5左右,Eh在200~300mv之间,为氧化的环境,COD大部分断面均在15~20mg/L以下。     

Medium optimization for the production of anti-cyanobacterial substances by Streptomyces sp. HJC-D1 using response surface methodology

Bioremediation using isolated anti-cyanobacterial microorganism has been widely applied in harmful algal blooms (HABs) control. In order to improve the secretion of activated anti-cyanobacterial substances, and lower the cost, a sequential optimization of the culture medium based on statistical design was employed for enhancing the anti-cyanobacterial substances production and chlorophyll a (Chl a) removal by Streptomyces sp. HJC-D1 in the paper. Sucrose and KNO₃ were selected as the most suitable carbon and nitrogen sources based on the one-at-a-time strategy method, and sucrose, KNO₃ and initial pH were found as major factors that affected the anti-cyanobacterial ability of the isolated stain via the Plackett–Burman design. Based on the response surface and canonical analysis, the optimum condition of culture medium was obtained at 22.73 g l^-1 of sucrose, 0.96 g l^-1 of KNO₃, and initial pH 8.82, and the Chl a removal efficiency by strain HJC-D1 increased from 63?±?2 % to 78?±?2 % on the optimum conditions.     

臭氧氧化6-APA制药厂生化处理出水的特性及动力学简

通过现场实验研究了6-APA制药厂生化处理出水的臭氧氧化特性及其动力学规律。结果表明,当臭氧浓度为27.5 mg/L,气水接触时间为80 min时,COD、UV₂₅₄、NH₃-N和色度的去除率分别可达72.95%、73.28%、72%和96.25%,达到《发酵类制药废水工业水污染物排放标准》（GB 21903-2008）排放控制要求。拟合结果表明,在0~10、10~30和30~90 min时段内,臭氧氧化过程遵循拟一级反应,但反应速率逐渐降低。当气水接触时间为30 min时,废水可生化性可由0.1提高至0.35,采用臭氧/生物处理的联合工艺也有望使出水达到相同的排放控制要求。     

碳酸根对磷酸钙沉淀反应回收磷的影响简

以模拟的厌氧消化液为处理对象,通过小试实验,考察不同初始磷浓度C_P、Ca/P物质的量比、pH和温度下,碳酸根（CO₃^2-）对磷酸钙沉淀反应回收磷的影响;利用扫描电镜（SEM）、X射线衍射仪（XRD）和傅里叶变换红外光谱（FTIR）对沉淀产物进行表征。结果表明,高浓度的CO₃^2-对以磷酸钙沉淀反应去除和回收磷的效率影响较大;C_P相同时,CO₃^2-浓度（C_CO3^2-）越大,P的去除率越低,低C_P（20 mg/L）时尤为显著;当C_CO3^2-相同时,随着C_P的增大,反应速率加快,P的去除率逐渐升高,但升高幅度越来越小;增大Ca/P比和pH能提高P的去除率,降低CO₃^2-对磷酸钙沉淀反应的抑制作用,综合考虑实际效果,应选择Ca/P比为3.33,pH为9.0作为适宜的反应条件;升高温度对降低CO₃^2-对磷酸钙沉淀反应的抑制作用贡献不大。在C_P为60 mg/L,Ca/P比为1.67,pH为9.0,温度为20℃的条件下,当C _CO3^2-为0时,得到的沉淀产物主要为羟基磷灰石HAP;当C _CO3^2-为30 mmol/L时,得到的沉淀产物为磷酸钙和碳酸合磷灰石的混合物。     

水平潜流人工湿地在不同水力负荷下的水力效率及可视化分析

构建水平潜流人工湿地装置,通过NaCl示踪脉冲实验,得到不同水力负荷条件下的水力停留时间分布密度曲线,根据不同停留时间的关系计算相对水力效率,并利用染料,进行不同水力负荷下的可视化示踪实验,通过MATLAB处理得到高对比度的流态图像。观察"死区"分布,计算"死区"相对面积用以表征其水力效率。结果表明,湿地装置进水水力负荷较高或较低时,水力效率均较低,且水力负荷较大时更明显;水力分布散度(σ2θ)的大小会对水平潜流人工湿地水力效率造成较大影响;在不同水力负荷下,采用水力学效能(λ)所得到的排序结果相比短路值(s)和有效体积比(e)更能代表实际水平潜流人工湿地的水力效率。     

络合萃取技术分离制药废水中的金刚烷胺

以P204为络合剂萃取水溶液中的金刚烷胺,研究了正辛醇和煤油2种稀释剂对萃取效果的影响,分析了萃取过程的络合机理和热力学过程,并考察了该萃取体系对实际制药废水中金刚烷胺的萃取效果。结果表明,采用P204/正辛醇=3∶2的复配萃取剂,在初始pH为8.0,在油/水相比为1∶1的条件下,金刚烷胺的萃取效率可以达到99.8%以上;以2.0mol/L的HCl溶液为反萃取剂,可以将51.1%的负载金刚烷胺反萃回收;红外光谱分析表明,P204对金刚烷胺的萃取遵循离子交换和离子缔合成盐机制;萃取过程为放热过程,低温条件下有利于萃取反应的进行;P204/正辛醇复配萃取剂对实际制药废水中的金刚烷胺也具有很高的萃取效率。     

Green and compatible industrial development in Western China

Western China has lagged a lot in terms of industrial structure and economic development,compared with the national average.And China announced its target of CO_2 emission reduction,i.e.by 2020,CO_2 emission per GDP will drop by40-45%compared with 2005.The target will be incorporated into China's long-term industrial planning.Against this background,this paper will make a comprehensive examination of the industrial development of Western China,aiming to discover a green and compatible way.First,we analyze the spatiotemporal evolution of regional industrial structure for the period 2000-2010.Second,we try to discover the industrial structure optimization path for Western China by employing the Vector Auto Regression model.Lastly,we try to provide some advice and suggestions for further industrial development in Western China.Our examination shows that further industrial development in Western China should pay full attention to resource conservation and recycling,and develop on a green and compatible path.     

Mn/γ-Al2O3催化剂的制备及头孢合成废水的催化臭氧氧化法深度处理

对Mn/γ-Al₂O₃催化剂的制备条件及头孢合成废水的催化臭氧氧化法深度处理工艺条件进行了优化。实验结果表明：以Mn（NO₃）₂溶液为浸渍液,Mn/γ-Al₂O₃催化剂的最优制备条件为浸渍液浓度0.10 mol/L、浸渍时间9 h、焙烧温度400 ℃、焙烧时间2 h;在反应时间为30 min、废水pH为9.0、臭氧通量为4.6 mg/min、催化剂加入量为5 g/L的条件下,当进水COD、BOD₅、ρ（氨氮）和色度分别为220~250 mg/L,8~10 mg/L,10~12 mg/L和60~70倍时,出水COD、BOD₅、ρ（氨氮）和色度的平均去除率分别为53%,30%,33%和93%,出水水质满足GB 21904—2008《化学合成类制药工业水污染物排放标准》的要求。     

利用白云石石灰去除与回收污泥厌氧消化液中氮和磷

以白云石石灰为实验材料去除与回收污泥厌氧消化液中的氮磷,通过小试实验研究不同投药固液比S/L、初始pH值、反应温度、搅拌速度及反应时间对去除与回收氮磷效果的影响。实验结果表明,在最佳投药固液比S/L为300mg/L,最佳初始pH值范围为8.5~9.5,反应温度为25.0℃,搅拌速度为150 r/min,反应时间为24 h条件下,氨氮(NH+4-N)和磷(PO3-4-P)的去除率分别为37.26%和89.60%。利用X射线衍射仪(XRD)、扫描电镜(SEM)对沉淀产物进行了表征,通过分析可知沉淀产物中含有磷酸铵镁(MAP),可实现废水中氮磷经济有效的回收。