油箱明火烤燃下燃爆危险性分析与安全对策

为预防交通事故中油箱燃爆危险的发生,利用摄像机、高速照相机和红外热成像仪观测油箱在烤燃过程中的燃爆特性,得到爆炸火球参数和油箱内部温度变化,并针对油箱烤燃的危险性,利用爆炸火球辐射总能量和热剂量来评判热效应严重程度。结果表明:明火烤燃状态17min左右,油箱发生爆炸;爆炸火球的体积、表面最高温度和辐射总能量分别为150.46m~3、1 490.4℃和2.10×10~4kJ,距爆炸火球中心1m、5m和10m处的热剂量分别为1 978.8kJ/m~2、99.4kJ/m~2和25.1kJ/m~2。最后,从油箱本质安全设计和点火源控制方面提出了相应的安全对策与措施。     

军绿有机涂层破损腐蚀行为研究

目的研究不同破损程度下军绿有机涂层的腐蚀行为,确定破损率对其防护性能变化的影响。方法通过人工制作不同的破损率,并利用电化学阻抗谱技术,研究不同破损程度下军绿有机涂层的电化学特征。结果根据不同破损程度下的军绿有机涂层的电化学特征,确定了涂层从完好到失效的四个阶段,初始完好阶段(破损率K≤0.0004%)、破损增大阶段(0.0016%K≤0.04%)、破损过大阶段(0.16%K≤1%)和失效阶段(4%K≤16%)。结论破损率K为0.04%的点是该涂层防护性能急转直下的转折点,因此破损率K大于0.04%时,应及时对车辆表面涂层进行修补和防护。     

基于预应力杆的空间桁架天线固有频率调节技术

目的研究预应力杆对大型空间桁架天线固有频率影响,提出采用作动器实时对在轨空间天线低阶固有频率进行调整,主动避免共振现象发生。方法针对大型空间桁架天线结构有限元模型,采用降温法对桁架杆施加预应力,重点分析预应力大小、预应力杆位置、预应力杆数量对整体结构固有频率的影响。结果增加预应力大小、合理布置预应力杆位置、增加预应力杆数量能够增加空间桁架天线固有频率的改变率。结论合理优化空间桁架天线上预应力杆,可实现对在轨运行的空间桁架天线低阶固有频率实时调整,可为空间桁架天线避振设计提供参考。     

基于能源-环境情景模拟的北京市大气污染对居民健康风险评价研究

保护居民健康是北京市能源系统优化管理和大气污染治理的重要目标.本研究基于北京市的社会经济发展目标并结合相关节能减排和环保要求,针对全市2010-2020年间的能源消费分别设计了高、中、低3种约束情景,通过LEAP模型预测了全市至2020年的能源消费量与S02、NOx、PM10和PM2.5等4种主要大气污染物的排放强度,并采用泊松回归模型对3种情景下主城区居民受环境空气中这4种大气污染物的暴露危害所导致的健康风险进行了评估.结果显示:相对低约束情景,高约束情景至2020年可避免与S02、NOx、PM10和PM2.5污染相关的死亡危害分别为2663、6359、4720和4104人·a-1,而且在高约束情景下煤炭消费比重每下降1％,可相应地避免约1400人·a-1的污染急性死亡.由此建议北京市实施更加严格的节能和减排措施,严控煤炭消费总量,进一步优化能源结构,最大程度地降低能源消费导致的大气污染所产生的居民健康风险.     

链霉菌FX645对偶氮染料红AR30的降解机制研究

从印染厂污泥中筛选到1株对偶氮染料红30(AR30)具有较强脱色降解作用的菌株Streptomyces sp.FX645.通过降解产物的紫外-可见吸收光谱、LC-MS分析及各降解产物在发酵体系中浓度随时间变化的规律,探讨了菌株FX645对AR30的可能降解途径,首先在偶氮还原酶的作用下AR30发生偶氮键的裂解,生成4-硝基-2,6-二氯苯胺与2-[(4-胺苯基)-(2-氰乙基)-氨基]乙酸乙酯,然后分别发生硝基还原、氨基酰化、氰基水解作用,生成一系列的苯胺类化合物.     

Pollination syndromes ignored: importance of non-ornithophilous flowers to Neotropical savanna hummingbirds

Generalization prevails in flower–animal interactions, and although animal visitors are not equally effective pollinators, most interactions likely represent an important energy intake for the animal visitor. Hummingbirds are nectar-feeding specialists, and many tropical plants are specialized toward hummingbird-pollination. In spite of this, especially in dry and seasonal tropical habitats, hummingbirds may often rely on non-ornithophilous plants to meet their energy requirements. However, quantitative studies evaluating the relative importance of ornithophilous vs. non-ornithophilous plants for hummingbirds in these areas are scarce. We here studied the availability and use of floral resources by hummingbirds in two different areas of the Cerrado, the seasonal savannas in Central Brazil. Roughly half the hummingbird visited plant species were non-ornithophilous, and these contributed greatly to increase the overall nectar availability. We showed that mean nectar offer, at the transect scale, was the only parameter related to hummingbird visitation frequency, more so than nectar offer at single flowers and at the plant scale, or pollination syndrome. Centrality indices, calculated using hummingbird–plant networks, showed that ornithophilous and non-ornithophilous plants have similar importance for network cohesion. How this foraging behaviour affects reproduction of non-ornithophilous plants remains largely unexplored and is probably case specific, however, we suggest that the additional energy provided by non-ornithophilous plants may facilitate reproduction of truly ornithophilous flowers by attracting and maintaining hummingbirds in the area. This may promote asymmetric hummingbird–plant associations, i.e., pollination depends on floral traits adapted to hummingbird morphology, but hummingbird visitation is determined more by the energetic "reward" than by pollination syndromes.     

单光子/光电子在线质谱实时分析聚氯乙烯热分解/燃烧产物

实验室研制了低能光电子磁场增强电离(MEPEI)和单光子电离(SPI)复合电离源,该电离源具有电离化合物范围宽、碎片离子少、质谱图简单等优点,结合飞行时间质谱(TOF-MS)实现了聚氯乙烯(PVC)热分解/燃烧产物的在线分析.针对不同的目标化合物,MEPEI/SPI复合电离源通过调节电离区电场强度,可以快速在SPI和SPI-MEPEI之间切换.PVC热分解/燃烧产物中电离能大于光子能量(10.60 eV)的HCl和CO2(12.74 eV、13.77 eV)利用MEPEI模式电离;而烯烃、二氯乙烯、苯系物、氯苯、苯乙烯、茚满及萘系物等可通过SPI-MEPEI复合模式电离.通过实时监测PVC主要燃烧产物的信号强度随温度的变化趋势可推断出,PVC燃烧产物主要是通过两种机制生成:①250～370℃时,PVC发生脱氯及分子内环化反应,产生大量的HCl、苯和萘;②380～510℃时,PVC发生分子间交联反应,生成烷基芳烃,如甲苯和二甲苯/乙苯等.实验结果表明,SPI/SPI-MEPEI复合离子源TOF-MS分析速度快,应用范围广,在在线分析中具有广泛的应用前景.     

Cost-performance analysis of nutrient removal in a full-scale oxidation ditch process based on kinetic modeling

A full-scale oxidation ditch process for treating sewage was simulated with the ASM2d model and optimized for minimal cost with acceptable performance in terms of ammonium and phosphorus removal. A unified index was introduced by integrating operational costs (aeration energy and sludge production) with effluent violations for performance evaluation. Scenario analysis showed that,in comparison with the baseline (all of the 9 aerators activated), the strategy of activating 5 aerators could save aeration energy significantly with an ammonium violation below 10%. Sludge discharge scenario analysis showed that a sludge discharge flow of 250–300 m3/day (solid retention time (SRT), 13–15 days) was appropriate for the enhancement of phosphorus removal without excessive sludge production. The proposed optimal control strategy was: activating 5 rotating disks operated with a mode of "111100100" ( "1"represents activation and "0" represents inactivation) for aeration and sludge discharge flow of 200 m3/day (SRT, 19 days). Compared with the baseline, this strategy could achieve ammonium violation below 10% and TP violation below 30% with substantial reduction of aeration energy cost (46%) and minimal increment of sludge production (< 2%). This study provides a useful approach for the optimization of process operation and control.     

Preparation of MgO/B2O3 coatings by plasma spraying on SUS304 surface and effects of heat-resistant

This study mainly deals with the preparation of MgO/B₂O₃ coatings by plasma spraying on the SUS304 surface and the effects of heatresistant. The power materials of low thermal conductivity were selected to control the heat divergent performance of high temperature parts. The reticular micro-structure between the cover thermal layer and the substrate was prepared by using the plasma spraying method. The powder mixture of MgO and B₂O₃ were selected as spraying materials and the SUS304 was used as the substrate material. The MgO/B₂O₃ coating was prepared on the surface of the SUS304 to provide better cover thermal performance. The properties of the microstructures and the morphologies were studied by Optical Microscope, Scanning Electron Microscope, Electron Probe Microanalyzer, and X-ray Diffraction. The results showed that the cover thermal performance has been improved.     

日本沼虾与秀丽白虾的营养生态位

为科学评估虾类的营养关系及资源的保护,利用稳定同位素技术研究了2种淡水虾类在大型通江湖泊——洞庭湖和鄱阳湖中的营养生态位和生态宽幅大小.结果表明,日本沼虾与秀丽白虾的δ13C值呈显著差异,而δ15N值无明显差异.同时,由于营养状况及水文的差异,虾类同位素值的差异在2个湖泊中表现不同.日本沼虾的δ13C值范围比秀丽白虾大,频率分布相对集中在-25.0‰～-23.0‰区间,表明其摄食的食物来源更广,对某些饵料生物有所偏好.另外,日本沼虾与秀丽白虾的营养生态位重叠程度较大,表明二者的主要食物来源相同,在食物网中占据的营养级相近,存在着激烈的种间竞争.在鄱阳湖中,日本沼虾占有的营养生态位和生态宽幅大于秀丽白虾;而在洞庭湖的研究结果则相反,主要是由于采样区域生境的差异及人类活动干扰的程度不同所致.