煤基腐殖酸对外源砷胁迫下玉米生长及生理性状的影响简

为了筛选用于砷污染土壤治理的煤基腐殖酸,采用盆栽实验研究了施用不同种类和浓度的煤基腐殖酸及EDTA对外源砷胁迫下玉米株高、株鲜重、株干重、根干重、砷积累量、叶片抗氧化酶（POD,SOD和CAT）活性和脯氨酸含量的影响。结果表明,11种供试煤基腐殖酸均促进了玉米生长,提高了叶片POD、SOD和CAT活性。其中6和10号腐殖酸可降低土壤砷活性和显著抑制玉米吸收和积累砷,而8和9号腐殖酸增加了土壤活性砷和显著促进了玉米对砷的吸收和累积,且不同程度地强于EDTA。除8和9号外,其余腐殖酸均可明显降低玉米叶片脯氨酸的含量。EDTA可显著促进玉米吸收和积累砷,且加剧了砷对玉米的危害。因此,8和9号供试煤基腐殖酸可以替代EDTA活化土壤砷,与植物配合以提高砷污染土壤的植物修复速度和效果,而6和10号供试煤基腐殖酸则可用于土壤砷钝化剂,以保证作物产品的安全。     

絮团粘性分维数的概念及其分析模型

水处理中的絮团具有复杂的形态结构,分维数是描述这种结构的有力工具。通过分析固液体系的粘度与絮团分维数之间的关系,提出了絮团粘性分维数的新概念及粘性分维数测定的数学物理模型,并进行了实验验证。与常用的质量分维数、边界分维数、面积分维数、体积分维数、表面积分维数等相比,絮团的粘性分维数及其测定模型具有易于测量、可同时表征不同类型絮团、可定量分析絮凝产品组成等特点,从而为絮团形态结构的定性及定量研究开辟了新的途径。     

煤粉炉掺烧干化污泥的污染物排放研究

结合某电厂420 t/h四角煤粉炉掺烧污泥项目的实验室分析测试,了解煤粉掺烧不同含水率不同比例的干化污泥条件下烟气中污染物和灰渣中重金属的排放特性。结果表明,在实验研究配比和燃烧的条件下,大部分重金属元素Pb、Cu、Cr和Ni残留在灰渣中,Zn、Cd部分残留在灰渣中,As、Hg和Se等易挥发元素释放到烟气中,在灰渣中的含量很小。掺烧污泥后,灰渣中的重金属含量较单烧单煤都有了一定幅度的升高,Zn的含量是单煤的2倍,其余重金属是单煤的1.1~1.2倍。3种不同的掺混比例之间的污染气体排放浓度基本相似。烟气中主要污染物及重金属浓度可以满足现行国家标准。与单烧单煤相比,CO、HCl以及其他有机气体排放浓度基本相同;NH3的排放浓度较单煤有所升高;SO2、NOx和CO2排放浓度略有降低;飞灰浓度有所升高。烟气中的重金属,Hg含量升高了30%,Pb含量约为单煤的4.3~4.8倍。以上研究结果可为环保达标和飞灰利用提供基础数据。     

江汉平原土地利用对钉螺分布的影响研究

分析了江汉平原2009年易于钉螺孳生的3种土地利用类型（滩地、河渠和水田）比例与钉螺密度的关系。首先,在ERDAS9.2和ENVI4.7软件中对江汉平原2009年的Landsat5TM遥感影像进行了预处理。在已有的多期土地利用数据的基础上,借助eCognition软件利用向量相似度指标来提取土地利用变化区域,结合目视解译经验并运用遥感指标通过建立规则集对变化区域进行分类,将变化区域的分类结果更新2000年数据,得到了该区域2009年的土地利用数据。接下来,整理了江汉平原2009年螺情资料并计算出村级钉螺平均密度,绘制了2009年钉螺分布图。将绘制的钉螺分布图与土地利用分类图叠置分析,并结合收集的螺情数据确定了钉螺易于孳生的3种土地利用类型,分别为滩地、河渠和水田。最后,将钉螺密度与这3种土地利用比例进行线性回归分析。研究结果表明,钉螺密度与这三种土地利用类型比例存在线性回归关系,模型精度为R2=0857。该结论对通过遥感影像来估算钉螺密度具有指导意义,另外也可以为湖北省提出合理用地和灭螺并重的土地利用模式提供一定的科学参考     

渗滤液耦合矿化垃圾制备甲烷氧化菌菌液

利用甲烷氧化菌菌液增加材料中甲烷氧化菌的数量,可以得到高甲烷氧化率的填埋场甲烷生物氧化覆盖材料。研究发现,渗滤液原水和渗滤液处理尾水均能促进甲烷氧化菌的生长,可利用渗滤液耦合矿化垃圾混合培养制备甲烷氧化菌菌液用于填埋场甲烷减排。填埋龄长的渗滤液原水有着较好的培养效果,得到的菌液在4 d内最高甲烷氧化速率达到2.68 mL/h,超过甲烷氧化菌培养液(nitrate minimal salt medium,NMS)的实验结果。渗滤液中总氮、无机碳、总有机碳和Ni元素的含量对甲烷氧化菌的培养过程影响较大,适用于甲烷氧化培养的渗滤液应满足:总氮1 400 mg/L,总有机碳55 mg/L,Ni元素0.4 mg/L,总磷含量较高。     

Investigation of pharmaceutical metabolites in environmental waters by LC-MS/MS

Pharmaceuticals, once ingested, are commonly metabolized in the body into more polar and soluble forms. These compounds might not be completely removed in the wastewater treatment plants and consequently being discharged into the aquatic ecosystem. In this work, a multi-class sensitive method for the analysis of 21 compounds, including 7 widely consumed pharmaceuticals and 14 relevant metabolites, has been developed based on the use of UHPLC-MS/MS in selected reaction monitoring (SRM) mode. The method was validated in six surface waters (SW) and six effluent wastewaters (EWW) at realistic concentration levels that can be found in waters. The optimized method was applied to the analysis of different types of water samples (rivers, lakes and effluent wastewater), detecting nearly all the parent compounds and metabolites investigated in this work. This fact illustrates that not only pharmaceuticals but also their metabolites are commonly present in these types of waters. Analytical research and monitoring programs should be directed not only towards parent pharmaceuticals but also towards relevant metabolites to have a realistic overview of the impact of pharmaceuticals in the aquatic environment.     

A comparison of statistical methods for deriving freshwater quality criteria for the protection of aquatic organisms

Species sensitivity distributions (SSDs) are increasingly used in both ecological risk assessment and derivation of water quality criteria. However, there has been debate about the choice of an appropriate approach for derivation of water quality criteria based on SSDs because the various methods can generate different values. The objective of this study was to compare the differences among various methods. Data sets of acute toxicities of 12 substances to aquatic organisms, representing a range of classes with different modes of action, were studied. Nine typical statistical approaches, including parametric and nonparametric methods, were used to construct SSDs for 12 chemicals. Water quality criteria, expressed as hazardous concentration for 5 % of species (HC₅), were derived by use of several approaches. All approaches produced comparable results, and the data generated by the different approaches were significantly correlated. Variability among estimates of HC₅ of all inclusive species decreased with increasing sample size, and variability was similar among the statistical methods applied. Of the statistical methods selected, the bootstrap method represented the best-fitting model for all chemicals, while log-triangle and Weibull were the best models among the parametric methods evaluated. The bootstrap method was the primary choice to derive water quality criteria when data points are sufficient (more than 20). If the available data are few, all other methods should be constructed, and that which best describes the distribution of the data was selected.     

纳米TiO2-石墨烯光催化剂的水热合成及其光催化性能

以钛酸四正丁酯和石墨为原料,通过水热法制备了锐钛矿型为主的纳米TiO2复合光催化剂（纳米TiO2-石墨烯）,并采用XRD,FTIR,FESEM,TEM技术对其进行了表征。通过紫外光照射降解溶液中的罗丹明B（RhB）研究了TiO2-石墨烯的光催化活性,分析了初始罗丹明B质量浓度、催化剂加入量、溶液pH和催化剂使用次数等影响降解效果的因素。实验结果表明：在初始RhB质量浓度为20 mg/L、溶液pH为7.10、催化剂加入量为1.000 g/L的条件下,紫外光照射30 min时,纳米TiO2-石墨烯对RhB的降解率高达98.69%,明显高于纳米TiO2的44.69%;纳米TiO2-石墨烯稳定性较强,可多次重复使用。     

A2O-MBR工艺处理城市污Z作农业灌溉用水中试研究

为开发一种污水再生利用于农田灌溉领域的新型技术,本实验以城市污水为研究对象,采用A2O—MBR工艺进行中试研究,并将系统出水水质与《农田灌溉水质标准（GB5084—2005）》的主要水质指标进行对比分析。结果表明,系统COD和BOD,出水浓度范围分别为3．2～59．6mg／L、1．0～7．6mg／L,系统出水pH为7．16～7．54,悬浮物浓度几乎为0,上述指标均符合标准;TP、TN和氨氮的出水范围分别为0．03～0．79mg／L、1．6～17．7mg／L和0．8～10．3mg／L。《农田灌溉水质标准》没有对上述3个指标提出具体要求,且少量的氮磷是植物生长的营养元素。该系统出水的主要水质指标符合标准兽求．     

Characterization of the interactions between tetracycline antibiotics and microbial extracellular polymeric substances with spectroscopic approaches

The antibiotics have attracted global attentions for their impact on aquatic ecosystem. The knowledge about the fate of antibiotics encountering extracellular polymeric substances (EPS) is, however, limited. In this study, we investigated the interacting mechanisms of tetracycline (TC) to EPS extracted from aerobic activated sludge. The contributions of the main components of EPS, extracellular proteins, and polysaccharides were evaluated using bovine serum albumin and alginate sodium, respectively. Fourier transform infrared spectroscopy, X-ray photoelectron spectroscopy, and nuclear magnetic resonance indicated that hydroxyl, carboxyl, and amino groups were the domain chemical groups involved in the interaction between TC and EPS, and the binding of TC onto EPS changed the structure of these chemical groups, thus causing shifts in their UV–visible absorption spectra. In addition, we found that extracellular proteins, rather than polysaccharides, were the major active contents involved in the interaction. Three-dimensional excitation–emission matrix fluorescence spectroscopy showed that the fluorophores in EPS were clearly quenched by TC and the static quenching process was observed, implying the complex formation of TC and EPS. Furthermore, thermodynamic analysis indicated that the binding of TC with EPS is spontaneous and dominated by electrostatic forces.