鼠李糖脂洗脱氯丹和灭蚁灵污染场地土壤的工艺参数

优化了鼠李糖脂洗脱氯丹、灭蚁灵污染土壤的工艺条件,为开展有机氯农药污染场地土壤洗脱修复工程实践提供科学依据和技术参数。实验结果表明,随着洗脱剂———鼠李糖脂浓度的增加,氯丹和灭蚁灵的洗脱量呈现先增加后降低的趋势;洗脱时间和液固比对洗脱效果的影响趋势与浓度相同;在0~120 r/min范围内,氯丹和灭蚁灵洗脱量随着搅拌速度的增加而增大,80、120和200 r/min的洗脱量间差异不显著;单次洗脱量随洗脱次数的增加而降低,累计洗脱量则逐渐增大。综上所述,氯丹、灭蚁灵污染场地土壤鼠李糖脂洗脱的适宜工艺参数为鼠李糖浓度10 mmol/L,搅拌速度80 r/min,固液比1∶10,洗脱时间20 min,洗脱3次。     

Fenton法处理垃圾渗滤液的参数优化及反应动力学模型

采用Fenton法处理垃圾渗滤液,研究反应时间、初始浓度、pH、Fenton试剂用量对垃圾渗滤液TOC去除率的影响。研究结果表明,最优反应条件是反应时间30 min,初始pH为3.0,初始[H2O2]0=7 310 mg/L,最佳[H2O2]/[Fe2+]摩尔比为5,反应温度为室温,此时渗滤液的TOC去除率达到70.3%。渗滤液矿化过程符合一级反应动力学,并建立了符合该渗滤液的反应动力学模型。     

重庆主城区秋冬季逆温对空气质量影响的观测分析

2013年9—11月利用RPG-HATPRO地基多通道微波辐射计对重庆主城区大气进行连续探测,统计了大气逆温情况,并对典型重污染天气下大气逆温与空气质量状况进行综合分析。结果表明,逆温出现的频率为63.3%,基本为接地逆温类型,逆温层厚度为953 m,逆温强度为0.3℃/hm;逆温的存在为气溶胶的积聚和凝聚创造了有利条件。     

基于CA-MAS的水域总有机碳扩散模拟研究

当前水环境污染扩散研究一般基于普通数值模型模拟,忽略了水污染扩散微观驱动力的影响。为能更真实地反映其动态扩散过程,针对水域总有机碳(TOC)扩散机理,基于CA和MAS技术,将影响TOC扩散的自然和社会经济因素抽象为微观的水流Agent、风速Agent、径流量Agent、污水排放口Agent、人工管理Agent以及农业生产地Agent,将研究水域抽象为CA元胞空间,建立了CA-MAS水域总有机碳扩散模型,对水域总有机碳的动态演化过程进行模拟,并以武汉理工大学鉴湖水域作为实验区域,借助NetLogo仿真平台完成了模型的实现与验证。模拟结果表明,该模型基本能够反映水体总有机碳的扩散规律,可以为水环境污染控制提供参考。     

不同运行模式对同步脱氮除磷CAST工艺快速启动及其稳定维持的影响

以实际生活污水为处理对象,考察了传统进水/曝气和改良型分段进水的交替缺氧-好氧(A/O)2种运行模式对CAST工艺的快速启动及脱氮除磷性能稳定维持的影响。结果表明,传统进水/曝气运行模式下,系统达到最佳营养物去除性能所需启动时间30 d,稳定运行阶段TN平均去除80.66%,磷的去除率维持在66.30%左右;采用改良型交替运行模式,反应器达到稳定运行状态仅需18 d,系统稳定运行时TN平均去除81.36%,磷去除率稳定维持在90%以上,出水磷浓度在0.3 mg/L以下,出水水质达到国家污水综合排放标准一级A(GB8978-2002)。研究还发现,传统运行模式下,由低温引起的污泥沉降性能变差导致系统污泥严重流失,反应器几乎丧失污染物去除性能;而低温对交替运行模式下的反应器除磷性能几乎没有影响,总氮去除则因氨氮不完全硝化而大大降低。     

Fenton法处理垃圾渗滤液MBR-NF浓缩液

采用Fenton法处理MBR-NF浓缩液,考察了FeSO4·7H2O投加量、n(H2O2)/n(Fe2+)投加比、初始pH对渗滤液MBR-NF浓缩液处理效果的影响,并在最佳实验条件下,探讨浓缩液富里酸(FA)、亲水性有机物(HyI)组分在Fenton氧化前后组成的变化。研究结果表明,在FeSO4·7H2O投加量为0.055 mol/L、n(H2O2)/n(Fe2+)投加比为4、初始pH为7.58时,对COD、腐植酸(UV254)、色度(CN)的去除率分别为79.6%、93.7%和97.8%。Fenton氧化后,浓缩液中有机物组分含量发生了较大变化,腐植酸含量下降,HyI成为渗滤液溶解性有机物主要成分。紫外-可见光谱表明,Fenton法对FA去除效果较好,而对HyI氧化效果较差;傅立叶红外光谱显示,经Fenton氧化后,FA的结构发生了明显变化,而HyI则变化不明显。     

温度对正渗透工艺性能的影响

正渗透技术是一种以渗透压差为驱动力的新型膜分离工艺。温度是影响正渗透过程的关键因素。为考察温度在工艺运行中的重要作用,研究了温度对正渗透膜特性及工艺性能的影响,探讨通量衰减机制。结果表明,温度影响汲取液动态稀释、浓差极化和膜污染等的效应程度,进而影响正渗透性能。高温能够明显增加水通量和回收率,且汲取液温度影响比原料液显著。因此,合理优化温度条件是降低能耗提高正渗透性能的有效途径。     

The Relationship between the Quantity of Heavy Metal and PAHs in Fly Ash

ABSTRACT

Heavy metal and polycyclic aromatic hydrocarbons (PAHs) in flue gas have received considerable attention in recent years due to their mutagenic or carcinogenic properties. The present study is carried out to investigate the influence of the quantity of heavy metals on PAHs formation in fly ash.

A fluidized bed incinerator was used in this experiment to obtain fly ash of chemical similarity by incinerating various compositions of waste. The obtained fly ash, both with and without heavy metal, were used to adsorb the PAHs in the flue gas and to investigate the formation of PAHs in fly ash. The results indicate that carbon and heavy metals most greatly influence the formation of PAHs in the fly ash. Carbon is absorptive; heavy metals encourage not only absorption of PAHs but also catalyze PAHs formation.     

The Wind-Frequency Allocation Method on Discharge Loading of Function Zones

Abstract

This paper introduces a new allocation method on discharge loading of each function zone in a total emission control region. The wind frequency, the position of each district, and the pollutant’s influence area were taken into account in this new method. The concept of “average downwind distance” was brought forward in this paper. The method here is more reasonable than the original method of area distribution, which was proposed by the “A-value” method in regulation of total emissions in China, by means of the simulation of annual average concentration in the total emission control region.     

Comparison of the purification performance and microbial community functional diversity in flow-directional-switching and unidirectional-flow biotrickling filters

Because of the characteristics of low operating cost and convenient operation, the biotrickling filter is extensively researched and used to treat low concentration waste gas contaminated by volatile organic compounds (VOCs) and other odors. In this paper, two laboratory-scale biotrickling filters were constructed and toluene was selected as the sole carbon source, and the effects of different waste-gas flow configuration patterns on the purification capacity and the microbial community functional diversity of biotrickling filters were evaluated. The results indicated that the flow-directional-switching (FDS) biotrickling filter had better purification performance, and the maximum elimination capacity reached 480 g·m^?3·hr^?1, which was 17.1% higher than conventional unidirectional-flow (UF) biotrickling filter. Comparing the purification capacities of different sections in two biotrickling filters, the maximum toluene elimination capacity of section III in FDS system could reach 542 g·m^?3·hr^?1, which was 2.8 times as great as that in UF system, which resulted from the difference of elimination capacity in two systems. By analyzing the metabolic activity of two systems by community-level physiological profiling (CLPP) with Biolog (Biolog Inc., Hayward, CA) ECO-plate technique, metabolic activity in three sections of FDS system was higher than that of UF system. The metabolic activity was the highest in section III of FDS system and 46.8% higher than that of UF system. Shannon index and McIntosh index of section III in FDS system were 6.2% and 31.5% higher, respectively, than those of UF system.

Implications: The flow-directional-switching (FDS) biotrickling filter had a better purification performance than unidirectional-flow (UF) biotrickling filter at high inlet loadings, because FDS produced a more uniform distribution of biomass and microbial metabolic capacity along the length of the packed bed without diminishing activity and removal capacity in the inlet section.