有机污染胁迫对人工湿地中浮萍抗氧化系统的影响

湿地植物在处理高负荷有机废水时会受到不同程度的氧化胁迫。本研究基于对浮萍的有机污染胁迫模拟系统,通过对浮萍脂质过氧化和抗氧化防御系统的监测与分析,研究了浮萍对有机污染胁迫的耐受能力及胁迫去除后浮萍的恢复规律。结果表明,浮萍对有机污染胁迫具有较高的耐受性,在胁迫去除后,具有一定的恢复能力。在COD小于400mg/L时,浮萍并未受到氧化胁迫;当COD达到800 mg/L时,浮萍体内ROS含量上升,细胞膜脂过氧化加剧,但抗氧化酶活性升高,抗氧化物质含量增加,浮萍可保持生长,胁迫去除后,抗氧化防御系统可恢复到对照水平;当COD过高（≥1 000mg/L）,ROS急剧上升,抗氧化防御系统遭受破坏,造成不可逆伤害,胁迫去除后不能恢复正常生长。     

天然黄铁矿的除磷性能

除磷是控制水体富营养化的重要手段。为了考察黄铁矿的除磷特征,采用序批实验,分别研究了反应时间、初始磷浓度和干扰离子（NH4＋、NO3- 和SO24-）对黄铁矿除磷的影响。动力学表明,黄铁矿的除磷过程符合伪二级动力学模型。pH=6．5时,磷的平衡去除量为6．82mg／kg。Langmuir方程能较好描述黄铁矿除磷的吸附等温过程,其磷的饱和吸附量为11．01mg／kg。NH4＋、NO3-和SO24- 对黄铁矿除磷基本没有影响。磷的去除主要是通过铁磷沉淀和铁氧化物及氢氧化物的吸附,去除的磷主要以可被生物利用的Fe、Al-P形态存在。黄铁矿的这些除磷性能和机制对选取黄铁矿作为人工湿地填料实现同步脱氮除磷具有重要指导作用。     

胶合竹材GluBam甲醛释放影响因素的气候箱实验与分析

胶合竹材GluBam的甲醛释放情况是现代竹结构住宅环保性的一个重要方面,也是竹结构住宅推广中最受关注的指标之一。采用1 m3气候箱对温度、相对湿度和封边情况与GluBam的甲醛释放量和释放速率的相关关系进行了测试,并以一阶单衰减模型为基础提出了GluBam的甲醛释放分析模型。测试和分析结果表明:GluBam板材在各模拟条件下甲醛浓度峰值均小于规范要求;初始甲醛释放量E0和衰减率常数k可以用来评价GluBam的甲醛释放特征;GluBam的醛释放量和释放速率随环境温度和湿度增加而显著增大,且温度因素的影响更大;封边处理可以有效降低GluBam板材的甲醛释放量。     

漆酶对活性黑KN-B和直接大红染料的脱色性能

利用白腐真菌漆酶对活性黑KN-B和直接大红2种偶氮染料进行脱色实验。考察反应时间、加酶量、pH值、染料浓度、温度对脱色率的影响,研究了ABTS介体以及金属离子存在下的脱色效果,并分析了漆酶脱色的动力学性能以及其对偶氮染料的降解规律。结果表明,活性黑KN-B和直接大红脱色适宜条件为：反应时间为30 min,加酶量8 U/mL,pH=7,染料浓度分别为50 mg/L和80 mg/L,温度40~45℃。ABTS介体对酶促偶氮染料脱色没有明显促进作用。Fe²⁺对漆酶脱色有较强的抑制作用;Cu²⁺对漆酶催化活性黑KN-B促进作用较大,对直接大红影响较小。漆酶对2种染料的脱色反应符合米氏方程,其催化活性黑KN-B和直接大红染料的K_m值分别为114.81 mg/L,317.5 mg/L,v_max值分别为6.57 mg/（L·min）和26.0 mg/（L·min）。     

Probability of intellectual disability is associated with soil concentrations of arsenic and lead

Background

The association between metals in water and soil and adverse child neurologic outcomes has focused on the singular effect of lead (Pb), mercury (Hg), and arsenic (As). This study describes the complex association between soil concentrations of As combined with Pb and the probability of intellectual disability (ID) in children.

Methods

We used a retrospective cohort design with 3988 mother child pairs who were insured by Medicaid and lived during pregnancy and early childhood in South Carolina between 1/1/97 and 12/31/02. The children were followed until 6/1/08, using computerized service files, to identify the diagnosis of ID in medical records and verified by either school placement or disability service records. The soil was sampled using a uniform grid and analyzed for eight metals. The metal concentrations were interpolated using Bayesian Kriging to estimate concentration at individual residences.

Results

The probability of ID increased for increasing concentrations of As and Pb in the soil. The Odds Ratio for ID, for one unit change in As was 1.130 (95% confidence interval 1.048-1.218) for Pb was 1.002 (95% confidence interval 1.000-1.004). We identified effect modification for the infants based on their birth weight for gestational age status and only infants who were normal size for their gestational age had increased probability of ID based on the As and Pb soil concentrations (OR for As at normal weight for gestational age = 1.151 (95% CI: 1.061-1.249) and OR for Pb at normal for gestational age = 1.002 (95% CI: 1.002-1.004)). For normal weight for gestational age children when As = 22 mg kg⁻¹ and Pb = 200 mg kg⁻¹ the risk for ID was 11% and when As = 22 mg kg⁻¹and Pb = 400 mg kg⁻¹ the probability of ID was 65%.

Conclusion

The probability of ID is significantly associated with the interaction between Pb and As for normal weight for gestational age infants.     

Analysis of pesticide residues using the Quick Easy Cheap Effective Rugged and Safe (QuEChERS) pesticide multiresidue method in traditional Chinese medicine by gas chromatography with electron capture detection

The Quick Easy Cheap Effective Rugged and Safe multiresidue method (QuEChERS) has been validated for the extraction of 15 organochlorine pesticides (OCPs) in completely different matrices of traditional Chinese medicine (TCM). The method employed a rapid, simple and cost-effective procedure. The spiking levels for the recovery experiments were 0.1, 0.5 and 2.0 mg kg⁻¹. Mean recoveries mostly ranged between 76.0% and 114.0% (96.0% on average), and relative standard deviations (RSD) were generally below 10% (4.72% on average). Based on these results, the methodology has been proven to be highly efficient and robust and thus suitable for monitoring the MRL compliance of a wide range of commodity. The contamination status of 15 OCPs on 80 different TCMs marketed in China, and a total of 400 samples were also performed using a previously validated method. 15 OCPs were benzene hexachloride (BHC, including α-BHC, β-BHC, γ-BHC, δ-BHC), hexachlorobenzene, heptachlor, heptachlor epoxide, aldrin, p, p′-DDE, p, p′-DDD, o, p′-DDT, p, p′-DDT, mirex, endrin, dieldrin. This study indicates that the proposed method is useful for analyzing OCPs in TCM.     

西安市城市主干道路面径流污染及沉淀特性研究

在西安市城市主干道南二环路建立路面径流采样站,利用自制流量等比例采样装置,采集2009年3-11月的34场降雨径流,测试研究径流SS、COD事件平均浓度(EMC)、有机污染物赋存状态,并就降雨特征对径流污染的影响进行相关分析,还采用累积曲线法对16场径流水样进行沉淀实验,研究沉淀对径流中污染物的去除效果.结果表明,城市...     

pH、盐度对微生物还原硫酸盐的影响研究

采用厌氧生物处理工艺,研究了在不同盐度下pH连续降低对硫酸盐还原和有机物去除率的影响。实验结果表明,硫酸盐还原菌有很强的适应pH变化的能力,在pH值达到4以下仍有60％的硫酸盐去除率。NaCl浓度由4g／L增加到50g／L抑制了各厌氧菌的活性,导致硫酸盐和有机物去除率的下降,但硫酸盐还原菌耐受性高于产甲烷菌等其他厌氧菌,在NaCl浓度为50g／L下,硫酸盐去除率能达到50％,而有机物去除率则低于30％。qRT—PCR表明了系统菌落中SRB随着环境的变化情况与化学指标结果相一致,该反应器体系中SRB在整个厌氧菌群落中只占了很小部分。     

Effects of Preparation Parameters on Properties of Soy Protein-Based Fiberboard

The effects of manufacturing parameters on mechanical properties of medium density fibreboard (MDF) bonded with modified soy protein-based glue were studied to find an appropriate manufacture technology. Physical properties of MDF made with different amount of wax emulsion were measured. Results indicated that water repellent had no obvious influence on physical properties of soy protein-based MDF boards. The fiberboards bonded with soy protein-based glue showed stronger water resistance properties than those bonded with urea–formaldehyde (UF) resins. Furthermore, the soy protein-based MDF boards had good quality [25.2% 24 h soak thickness swell (TS), 29.9 MPa modulus of rupture (MOR), 3130 MPa modulus of elasticity (MOE)], which met requirements of Chinese national standard. Practical processing parameters were obtained by orthogonal experiment, i.e., glue content 8.0%, hot-press temperature 200 °C, and hot-press time 150 s.