无机-有机复合絮凝剂PST处理印染废水效果研究

以模拟印染废水和实际印染废水为实验对象,检验了一种新合成有机-无机复合絮凝剂(PST)的絮凝效果。结果表明,PST具有良好的絮凝性能。在受试条件下,絮凝效果与絮凝剂投加量、染料浓度有较大相关性。废水的pH值应用范围较宽;搅拌时间对COD去除率和脱色率没有显著影响。采用PST处理广东省高明市某印染厂的印染废水后,COD去除率为75.16%,脱色率为76.18%,处理效果良好,处理成本明显低于目前市场上普遍使用的聚铝等絮凝剂。     

四川某中小城镇污水处理厂进水水质统计分析

生活污水水质对处理工艺的选择、设计参数的选取以及稳定运行十分重要。运用SPSS软件,对四川某中小城镇污水处理厂为期一年的进水指标(水量、COD、氨氮、总磷、pH、SS)进行方差和相关性分析。方差分析结果显示进水量、氨氮和SS在月份和季节之间存在显著性差异,而总磷和pH仅在月份之间存在显著差异,COD在季度和月份之间无显著性差异;指标相关性分析表明,进水量和氨氮之间呈负相关,氨氮和总磷、COD和总磷之间呈正相关,且相关性显著。在此分析的基础上对污水处理厂设计、工艺选择及运行管理提出了一些建议。     

Individual and combined toxic effects of cypermethrin and chlorpyrifos on earthworm

Toxicities were assessed for a pyrethroid (cypermethrin) and an organophosphate insecticide (chlorpyrifos) individually and in combination. A series of tests were conducted on di erent responses (acute, chronic, behavioral) of earthworms of species Eisenia fetida andrei in the ecological risk assessment of these pesticides. The results showed that the toxicity of the mixture of cypermethrin and chlorpyrifos was significantly higher than either of these pesticides individually, especially on the earthworm’s chronic responses. At a concentration of 5 mg/kg, the mixture caused significant reductions on the growth and reproduction rates of earthworms, but did not cause any significant e ect when the individual was tested. The increase in toxicity of the pesticide mixture means that the use of toxicity data obtained exclusively from single-pesticide experiments may underestimate the ecological risk of pesticides that actually present in the field.     

Mobilities and leachabilities of heavy metals in sludge with humus soil

Chemical forms of Zn, Ni, Cu, and Pb in municipal sewage sludge were investigated by adding humus soil to sludge and by performing sequential extraction procedures. In the final sludge mixtures, Zn and Ni were mainly found in Fe/Mn oxide-bound (F3) and organic matter/sulfide-bound (F4) forms. For Zn, exchangeable (F1), carbonate-bound (F2), and F3 forms were transformed to F4 and residual forms (F5). For Ni, F1 and F2 forms were transformed to F1, F2, and F3 forms. Both Cu and Pb were strongly associated with the stable forms F4 and F5. For Cu, F2 and F3 forms were major contributors, while for Pb, F3 and F4 forms were major contributors to F5. Humus soil dosage and pH conditions in the sludge were strongly correlated with the forms of heavy metals. Five forms were used to evaluate metal mobilities in the initial and final sludge mixtures. The mobilities of the four heavy metals studied decreased after 28 days. The metal mobilities in the final sludge mixtures were ranked in the following order: Ni > Zn > Cu = Pb. Leaching tests showed that the mobilities of Zn and Ni in lower pH conditions (pH 4) were higher than those in higher pH conditions (pH 8).     

Effects of Cu（Ⅱ） and humic acid on atrazine photodegradation

This work was designed to explore the characteristics of photodegradation of herbicides in the copper-polluted water body. The results showed that Cu(II) alone could induce a photo Fenton-like reaction to enhance the degradation of atrazine, in which hydroxyl radical ( OH) was a main active species. Humic acids restrained atrazine degradation, nevertheless, when introducing Cu(II), the photodegradation was accelerated, in which singlet oxygen (1O2) replaced OH acting as the prevailing species. A feasible mechanism for the photochemical process was also proposed, which is helpful for better understanding the environmental photochemistry of atrazine in the copper-polluted water.     

Potential particulate pollution derived from UV-induced degradation of odorous dimethyl sulfide

UV-induced degradation of odorous dimethyl sulfide (DMS) was carried out in a static White cell chamber with UV irradiation. The combination of in situ Fourier transform infrared (FT-IR) spectrometer, gas chromatograph-mass spectrometer (GC-MS), wide-range particle spectrometer (WPS) technique, filter sampling and ion chromatographic (IC) analysis was used to monitor the gaseous and potential particulate products. During 240 min of UV irradiation, the degradation e ciency of DMS attained 20.9%, and partially oxidized sulfur-containing gaseous products, such as sulfur dioxide (SO2), carbonyl sulfide (OCS), dimethyl sulfoxide (DMSO), dimethyl sulfone (DMSO2) and dimethyl disulfide (DMDS) were identified by in situ FT-IR and GC-MS analysis, respectively. Accompanying with the oxidation of DMS, suspended particles were directly detected to be formed by WPS techniques. These particles were measured mainly in the size range of accumulation mode, and increased their count median diameter throughout the whole removal process. IC analysis of the filter samples revealed that methanesulfonic acid (MSA), sulfuric acid (H2SO4) and other unidentified chemicals accounted for the major non-refractory compositions of these particles. Based on products analysis and possible intermediates formed, the degradation pathways of DMS were proposed as the combination of the O(1D)- and the OH- initiated oxidation mechanisms. A plausible formation mechanism of the suspended particles was also analyzed. It is concluded that UV-induced degradation of odorous DMS is potentially a source of particulate pollutants in the atmosphere.     

Preparation and coagulation efficiency of polyaluminium ferric silicate chloride composite coagulant from wastewater of high-purity graphite production

The aim of the present work was to produce a polyaluminium ferric silicate chloride (PAFSiC) coagulant from acidic and alkaline wastewater of purifying graphite by roasting, and subsequently to evaluate coagulation efficiency of the reagent by treating surface water from the Yellow River as well as municipal wastewater in comparison with the conventional coagulant polyaluminium chloride (PAC). The PAFSiC coagulant was prepared by co-polymerization. The effects of (Al+Fe)/Si molar ratio, OH/(Al+Fe) molar ratio (i.e., value), coagulant dosage and pH value of test suspension on the coagulation behavior of FAFSiC and the stability of the PAFSiC were also examined. Results showed that PAFSiC performed more efficiently than PAC in removing turbidity, chemical oxygen demand (COD), and total phosphate (TP). The PAFSiC with a value of 2.0 and (Al+Fe)/Si ratio of 5 (PAFSiC 2.0/5) showed excellent coagulation effect for both turbidity and COD, while PAFSiC 1.0/5 was the best for TP. The optimum coagulation pH range of PAFSiC 2.0/5 was 5.0–9.0, slightly wider than that of PAC (6.0–8.0). The process can be easily incorporated into high-purity graphite production plants, thereby reducing wastewater pollution and producing a valuable coagulant.     

Preliminary report on methane emissions from the Three Gorges Reservoir in the summer drainage period

Considerable variations may exist in CH4 emissions from the Three Gorges Reservoir.     

中心组合设计优化S-Cr-TiO2催化剂光降解工艺条件

在确定的温度和光照条件下,采用中心组合设计法研究了固相反应法合成的硫与铬共掺杂二氧化钛(S-Cr-TiO2)光催化剂与水溶苯胺蓝(ANB)可见光降解过程中的三个作用因子:催化剂的浓度、水溶苯胺蓝水溶液的pH值及其初始浓度之间的相互作用关系,得到了影响因子与降解速率之间的回归方程及因素之间相互作用的响应面图.结果表明,S...