城市在用CNG汽车排放研究

通过车载实验,怠速法检测、简易工况法检测数据评价分析等方法,研究了重庆市在用CNG车辆排放情况,比较了CNG车与同类型汽油、柴油车尾气污染物排放情况。研究发现,目前CNG在用车并非绝对的环保汽车,其中在NOx的排放上,CNG车排放高于同类型汽油、柴油车0．03—14倍;在CO、THC的排放上,不同测试工况下CNG汽车表...     

长柄石杉居群遗传多样性和遗传结构的AFLP分析

石杉科植物因所含石杉碱甲(Huperzine A)对中老年痴呆等具有良好疗效,近年来倍受关注.利用AFLP分子标记对武夷山脉广布种长柄石杉[Huperzia serrata(Thunb.ex Murray)Trev.var.longipetiolata(Spring)H.M.Chang]7个居群112株个体进行遗传多样性和居群遗传结构分析.选用多态性高、分辨力强的8对选择性扩增引物组合共获得675个位点,其中多态位点比例为69.38%.居群内观测等位基因数(Na)为1.633,有效等位基因数(Ne)1.493;Nei’s基因多样性指数(He)与Shannon多态性信息指数(I)的平均值分别为0.272和0.392,多样性最高为地处武夷山脉中段的泰宁居群和建宁居群,最低为山脉北段的光泽居群.居群总基因多样性(Ht)为0.327 3,居群内基因多样性(Hs)为0.272 2,居群间的遗传分化系数(Gst)为0.168 1,表明居群内变异是长柄石杉遗传多样性的主要来源.由Gst估计,武夷山脉长柄石杉自然居群的基因流(Nm)为2.474 0.邻接树分析表明居群间遗传亲缘关系与地理位置相关.武夷山脉长柄石杉较高的遗传多样性和基因流水平表明其仍然具有相当的适应(生存)能力和进化潜力,这可能与其生物学(异交水平)、生态学特性及武夷山脉相对良好的生境条件有关.     

二氯喹啉酸在水稻、土壤和田水中消解动态及残留

为评价二氯喹啉酸在水稻及其土壤中的安全性,建立其在水稻上的使用规范,于2008、2009年在杭州、济南和铁力三地进行田间试验,研究了二氯喹啉酸在水稻、土壤和田水中消解动态及最终残留量。建立了二氯喹啉酸在水稻、土壤和田水中残留量的超高效液相色谱串联质谱测定方法。在添加水平5～100μg.kg-1范围内,二氯喹啉酸的平均回收率在81.6%～105.7%之间,相对标准偏差均低于17.9%。残留试验结果表明,二氯喹啉酸在植株、土壤和田水中消解均符合一级动力学方程,消解半衰期分别为16.4～18.6、16.6～21.9和15.4～16.9 d;二氯喹啉酸在植株、土壤、糙米和稻壳中最终残留量均未检出（〈5μg.kg-1）。若二氯喹啉酸在水稻中的最高残留限量推荐值为0.5 mg.kg-1,建议每年以有效成分25 g.mu-1的剂量,于水稻移栽后10 d喷施1次,用于防治水稻田中稗草。     

类二噁英多氯联苯生殖毒性的研究进展

类二噁英多氯联苯(DlPCBs)作为典型的环境内分泌干扰物,会干扰接触个体或其后代的内分泌功能,破坏机体的神经系统、免疫系统,尤其对生殖系统的影响最为明显,比如对生殖器官的形态与功能、生殖内分泌、原始生殖细胞及其受精和早期胚胎发育等产生严重影响,最终导致各种生殖系统疾病的发生。DlPCBs的蓄积性及半挥发性使其在环境中分布广泛,半衰期长的特点使其将对动物及人类的生存和健康造成难以想象的影响。本文综述了DlPCBs的分类与构成、一般性质、生殖毒性以及其可能的致病机理,并对DlPCBs生殖毒性机理研究的重点方向进行了展望。     

Quantification of energy related industrial eco-efficiency of China

Improving eco-efficiency is propitious for saving resources and reducing emissions, and has become a popular route to sustainable development. We define two energy-related eco-efficiencies: energy efficiency (ENE) and greenhouse gas (GHG) emission-related eco-efficiency (GEE) using energy consumption and the associated GHG emissions as the environmental impacts. Using statistical data, we analyze China??s energy consumption and GHG emissions by industrial subsystem and sector, and estimate the ENE and GEE values for China in 2007 as 4.871×10⁷ US$/PJ and 4.26×10⁸ US$/TgCO₂eq, respectively. Industry is the primary contributing subsystem of China??s economy, contributing 45.2% to the total economic production, using 79.6% of the energy consumed, and generating 91.4% of the total GHG emissions. We distinguish the individual contributions of the 39 industrial sectors to the national economy, overall energy consumption, and GHG emissions, and estimate their energyrelated eco-efficiencies. The results show that although ferrous metal production contributes only 3.5% to the national industrial economy, it consumes the most industrial energy (20% of total), contributes 16% to the total industrial global warming potential (GWP), and ranks third in GHG emissions. The power and heat sector ranks first in GHG emissions and contributes one-third of the total industrial GWP, although it only consumes about 8% of total industrial energy and, like ferrous metal production, contributes 3.5% to the national economy. The ENE of the ferrous metal and power and heat sectors are only 8 and 2.1×10⁷ US$/PJ, while the GEE for these two sectors are 9 and 4×10⁴ US$/GgCO₂eq, respectively; these are nearly the lowest ENE and GEE values among all 39 industry sectors. Finally, we discuss the possibility of ecoefficiency improvement through a comparison with other countries.     

Characteristics of CO2 release from forest soil in the mountains near Beijing

CO₂ release from forest soil is a key driver of carbon cycling between the soil and atmosphere ecosystem. The rate of CO₂ released from soil was measured in three forest stands (in the mountainous region near Beijing, China) by the alkaline absorption method from 2004 to 2006. The rate of CO₂ released did not differ among the three stands. The CO₂ release rate ranged from ??341 to 1,193 mg m^???2 h^???1, and the mean value over all three forests and sampling times was 286 mg m^???2 h^???1. CO₂ release was positively correlated with soil water content and the soil temperature. Diurnally, CO₂ release was higher in the day than at night. Seasonally, CO₂ release was highest in early autumn and lowest in winter; in winter, negative values of CO₂ release suggested that CO₂ was absorbed by soil.     

硝基苯气相氟代脱硝反应热安全性的理论研究

为研究硝基苯气相氟代脱硝反应的热安全性,采用Gaussian98软件,运用密度泛函理论(DFT)B3LYP,在6-31G(D)基组水平上,全优化计算气相条件下氟离子对硝基苯进攻的氟代脱硝反应的微观机理,得到反应路径并通过IRC验证,并对反应过程中反应物,各中间体、过渡态、产物进行分子几何构型优化,标准热力学函数计算。理论计算研究表明:该反应属于SN2亲核取代反应;反应能垒较低,反应所需能量可以从过程R→IM1和TS3→P所释放的能量(279.06 kJ/mol,143.34 kJ/mol)中获得;与席曼反应相比较,该反应速率下降3个数量级,热安全性更高,符合化工工程设计的本质安全化要求,具有广阔的应用前景。     

不同扰动方式对底泥/水系统中生物有效磷的影响

为了解底泥扰动对水体磷迁移转化的影响,通过模拟试验研究了底泥不同扰动方式(间歇扰动、持续扰动)下上覆水中生物有效磷(BAP)及其组成的变化规律.结果表明,间歇扰动作用下,在24～216h和216～624 h之间,BAP分别稳定在0.09mg·L-1和0.052 mg·L-1.显著低于初始状态(0.679 mg·L-1);持续扰动作用下,BAP在第6 h达到最大值(2.437mg·L-1),随后下降,24h后稳定在0.759mg·L-1.但其组成以颗粒态生物有效磷(BAPP)为主(超过93%).间歇扰动作用下,溶解性总磷(TDP)占BAP的百分比下降了约10%,而无扰动试验中,该值有所增加.说明扰动促进了TDP向BAPP的转化,降低了水体富营养化的直接风险.     

Numerical and experimental study of the explosions caused by residual pressure in quick actuating vessels

The explosion accident caused by residual pressure is one of the most common kinds of accidents in quick actuating pressure vessels. And it is important to provide some reliable methods, which can give reasonable analysis of the explosion. In this study, experiments of the explosion are preformed by using two quick actuating pressure vessels with residual pressure, and a new mathematical model is presented. The model is based on the combination of the Spalart-Allmaras turbulence fluid model and Newton’s second Law for the solid motion. And the model is solved with local remeshing method. By performing the simulation with the same parameters of experiments, the results of the simulation confirm the accuracy of the model. And the results shows the crucial factor of vessel structure, which the maximum ejected speed of the lid highly depends on. Based on that, the optimal design of the structure is presented, which can provide better security.     

射流曝气MBR处理啤酒废水的试验

射流曝气提高了系统的氧利用效率及传质效率.通过逐渐提高进水的容积负荷来考察系统的处理效果, 试验表明, 利用射流曝气MBR处理模拟啤酒废水是可行的, 系统对COD、氨氮、浊度平均去除率为95.74%,97.84%,99.5%.由于系统运行期间不排泥, 因此系统对P O43-的去除效果不佳, 平均去除率为42.9%.膜对...