Human influence over 150 years of coastal evolution in the Volturno delta system (southern Italy)

This paper focused on the past shoreline change rates along the coastal plain of the Volturno River, in southern Italy, western Mediterranean. A wide database comprising historical maps, aerial photographs, topographic sheets, bathymetric data was used to extract the spatial and temporal information of the coastlines at seven time points. Coastline displacement was calculated for two successive time points and relative surface variation (accretion and erosion) was estimated as well as minimum and maximum accretion/erosion linear values and rates. The surface variation analysis has revealed that the studied coast can be considered homogeneous since the 1970s, whereas it exhibits a variety of shoreline evolutionary trends after that time period. Timing and causes of trends and rates of variation were detected. Based on the estimated shoreline change rates, an appropriate morhodynamic one-line model was applied to predict evolutionary scenarios also in presence of port and defence works. The results obtained strongly emphasize that a successful coastal management requires a constant monitoring of the human-induced changes to account for the variability of rates over time.     

Modeling the emissions of a dual fuel engine coupled with a biomass gasifier—supplementing the Wiebe function

There is a growing market demand for small-scale biomass gasifiers that is driven by the economic incentives and the legislative framework. Small-scale gasifiers produce a gaseous fuel, commonly referred to as producer gas, with relatively low heating value. Thus, the most common energy conversion systems that are coupled with small-scale gasifiers are internal combustion engines. In order to increase the electrical efficiency, the operators choose dual fuel engines and mix the producer gas with diesel. The Wiebe function has been a valuable tool for assessing the efficiency of dual fuel internal combustion engines. This study introduces a thermodynamic model that works in parallel with the Wiebe function and calculates the emissions of the engines. This “vis-à-vis” approach takes into consideration the actual conditions inside the cylinders—as they are returned by the Wiebe function—and calculates the final thermodynamic equilibrium of the flue gases mixture. This approach aims to enhance the operation of the dual fuel internal combustion engines by identifying the optimal operating conditions and—at the same time—advance pollution control and minimize the environmental impact.     

A design for EoL approach and metrics to favour closed-loop scenarios for products

Recently, environmentally conscious design and extended producer responsibility have become key aspects for companies that need to develop products that are sustainable along their whole life cycle. Design for End of Life (EoL) is a strategy that aims to reduce landfill waste through the implementation of closed-loop product life cycles. It is important to consider disassembly and EoL scenario management as early as the design phase. For these reasons, this paper presents an approach to help designers in the evaluation and subsequent improvement in product EoL performance. The method is based on four innovative EoL indices that compare different EoL scenarios for each product component. In this way, the designer can modify the product structure or the liaisons to maximise the reuse and remanufacture of components as well as material recycling. The presented case studies confirm the validity of the approach in helping designers during the redesign phase of goods and products to reduce the quantity of materials and industrial wastes sent to landfill.     

Preferential retention of POPs on the northern aspect of mountains

Soils are the main reservoirs of POPs in mountain ecosystems, but the great variability of the concentrations, also at small scale, leaves some uncertainties in the evaluation of environmental burdens and exposure. The role of the aspect of the mountain side and the seasonal variation in the contamination levels was analysed by means of several soil samples taken from central Italian Alps. A greater contamination content was present in northern soils with a mean ratio between the north vs. south normalised concentration of around a factor of 2 (North-South Enrichment Factor). Experimental factors agreed with theoretical calculations based on temperature-specific calculated K_sa values. From May to November consistent differences in normalised concentrations up to 5-fold were observed. A dynamic picture of the POP contamination in high altitudinal soils is derived from the data in this work, with spring-summer half-lives between 60 and 120 days for most of the compounds.     

Visible injury, crown condition, and growth responses of selected Italian forests in relation to ozone exposure

The impact of ozone on forest ecosystems in Italy is monitored within the CONECOFOR programme. Ozone levels are measured in 30 plots using passive samplers. Response parameters used are: crown condition (transparency), BAI (basal area increment), and visible symptoms on spontaneous vegetation. Levels of AOT40 are above the concentration-based critical level of 5 ppmh in all sites, but the evidence of impact on forest vegetation remains limited. Ozone is a predictor of crown transparency residuals in beech sites over two consecutive years, but the variance explained amounts to less than 10%. The relation between BAI reduction and ozone is even less certain. Transparency and BAI are more readily explainable in terms of ecological conditions of the site and climate fluctuations. The interpretation of visible symptoms is doubtful, and is conditioned by the prevailing ecological factors in the areas.     

Corrosion on cultural heritage buildings in Italy: A role for ozone?

Because of climatic reasons and of reduced concentrations of SO₂, ground-level ozone (O₃) is one of the main air pollutants in Southern Europe. Ozone levels are very high both in rural and urban locations. In the cities, O₃ can affect human health and materials. Regarding materials, most relevant is the exposure to pollutants of cultural heritage buildings. In particular, monuments registered on UNESCO's list of the world heritage require special monitoring. In Italy 34% and 97% of the territory is exposed to corrosion risk higher than the tolerable level for limestone and copper, respectively. The tolerable corrosion level for limestone and copper was also exceeded in the central area of Milan. In this area the tolerable O₃ concentration for copper was calculated. These concentrations (ranging between 30 and 40 μg/m³) cannot be exceeded at unchanged concentration of other pollutants to maintain corrosion levels below the tolerable ones.     

Clay-sewage sludge co-pyrolysis. A TG-MS and Py-GC study on potential advantages afforded by the presence of clay in the pyrolysis of wastewater sewage sludge

Wastewater sewage sludge was co-pyrolyzed with a well characterized clay sample, in order to evaluate possible advantages in the thermal disposal process of solid waste. Characterization of the co-pyrolysis process was carried out both by thermogravimetric-mass spectrometric (TG-MS) analysis, and by reactor tests, using a lab-scale batch reactor equipped with a gas chromatograph for analysis of the evolved gas phase (Py-GC).Due to the presence of clay, two main effects were observed in the instrumental characterization of the process. Firstly, the clay surface catalyzed the pyrolysis reaction of the sludge, and secondly, the release of water from the clay, at temperatures of approx. 450-500 °C, enhanced gasification of part of carbon residue of the organic component of sludge following pyrolysis.Moreover, the solid residue remaining after pyrolysis process, composed of the inorganic component of sludge blended with clay, is characterized by good features for possible disposal by vitrification, yielding a vitreous matrix that immobilizes the hazardous heavy metals present in the sludge.     

Preliminary evaluation of insecticide resistance in a strain of Musca domestica (Diptera: Muscidae) from an intensive chicken farm of Northern Italy

The house fly, Musca domestica L., a relevant sanitary pest, is mainly controlled by insecticides. However, an inappropriate use of chemicals may induce resistance, treatment efficacy decline and environmental damages. We evaluated toxicity of some organophosphates, pyrethroids, spinosad and neonicotinoids by topical applications on adults of a M. domestica strain (OcRo) collected from an intensive chicken farm in Northern Italy, in comparison to a susceptible strain (s-DBF). The OcRo strain exhibited higher levels of resistance (RR??) to four pesticides in comparison to s-DBF. Spinosad and imidacloprid had very low RR??, thus were still efficient in OcRo control. We also tested resistance to pesticides in OcRo after topical applications of synergistic compounds. Hydrolases were involved in phosphorganic detoxification and cytochrome P450 monoxygenases in that of pyrethroids. These results indicate that OcRo strain is now multiresistant to organophosphates and pyrethroids, and this should be considered for an environmentally safe pest management.     

Insecticidal activity and fungitoxicity of plant extracts and components of horseradish (Armoracia rusticana) and garlic (Allium sativum)

To avoid environmental pollution and health problems caused by the use of traditional synthetic pesticides, there is a trend to search for naturally occurring toxicants from plants. Among the compounds discussed for anti-fungal and insecticidal activity, the natural extracts from garlic and horseradish have attracted considerable attention. The objective of this study is to determine the insecticidal and anti-fungal activity of Armoracia rusticana and Allium sativum L. extracts against larvae of Aedes albopictus (Skuse) and some pathogenic fungi. For the insecticidal test, horseradish and garlic extracts were prepared from fresh plants (cultivated in Emilia Romagna region) in a solution of ethanol 80 % and the two different solutions were used at different concentrations (for the determination of the lethal dose) against the fourth instar mosquito's larvae. The fungicidal test was carried out by the agar plates technique using garlic and horseradish extracts in a 10 % ethanol solution against the following organisms: Sclerotium rolfsii Sacc., Trichoderma longibrachiatum, Botrytis cinerea Pers., Fusarium oxysporum Schlecht. and Fusarium culmorum (Wm. G. Sm.) Sacc. The first results demonstrated that the horseradish ethanol extracts present only a fungistatic activity against Sclerotium rolfsii Sacc., Fusarium oxysporum Schlecht. and F. culmorum (Wm.G. Sm) Sacc. while garlic extracts at the same concentration provided a good fungicidal activity above all against Botrytis cinerea Pers. and S. rolfsii. A. rusticana and A. sativum preparations showed also an interesting and significant insecticidal activity against larvae of A. albopictus, even if horseradish presented a higher efficacy (LC?? value of 2.34 g/L), approximately two times higher than garlic one (LC?? value of 4.48 g/L).