Design and risk assessment tool for vegetative treatment areas receiving agricultural wastewater: Preliminary results

Vegetative treatment areas (VTAs) are commonly being used as an alternative method of agricultural process wastewater treatment. However, it is also apparent that to completely prevent discharge of pollutants to the surrounding environment, settling of particulates and bound constituents from overland flow through VTAs is not sufficient. For effective remediation of dissolved agricultural pollutants, VTAs must infiltrate incoming wastewater. A simple water balance model for predicting VTA soil saturation and surface discharge in landscapes characterized by sloping terrain and a shallow restrictive layer is presented and discussed. The model accounts for the cumulative effect of successive rainfall events and wastewater input on soil moisture status and depth to water table. Nash–Sutcliffe efficiencies ranged from 0.65 to 0.81 for modeled and observed water table elevations after calibration of saturated hydraulic conductivity. Precipitation data from relatively low, average, and high annual rainfall years were used with soil, site, and contributing area data from an example VTA for simulations and comparisons. Model sensitivity to VTA width and contributing area (i.e. barnyard, feedlot, silage bunker, etc.) curve number was also investigated. Results of this analysis indicate that VTAs should be located on steeper slopes with deeper, more-permeable soils, which effectively lowers the shallow water table. In sloping landscapes (>2%), this model provides practitioners an easy-to-use VTA design and/or risk assessment tool that is more hydrological process-based than current methods.     

Determination of trace metal concentrations in soil profiles of municipal waste dumps in Nigeria

The concentrations of trace metals (Cd, Pb, Cu, Cr, Fe, Ni, Zn and Co) were studied in soil profiles of eight municipal waste dump sites in Warri metropolis. The results indicate that concentrations of trace metals varied widely among the different dumpsites and decreased with depths in a studied soil profile. The accumulation pattern for the heavy metals in the soil profiles follows the order: Fe > Pb > Mn > Co > Cr > Zn > Ni > Cu > Cd. The concentrations of metals found in these sites was below the Canadian remediation criteria for land for agricultural, residential and commercial/industrial purposes except for the cadmium levels in some sites that exceeded criterion values for agricultural and residential. In such sites, remedial actions are required before any form of chosen development can take place. The levels of heavy metals found in these dump sites were higher than that of the control site. The examined metals showed no significant correlation with soil physicochemical properties at the surface horizon, which is suggestive evidence that these metals arise from anthropogenic input.     

Changes in the spatial distribution of spawning activity by north-east Atlantic mackerel in warming seas: 1977–2010

Migratory species with a broad geographic range, such as north-east Atlantic mackerel, may be amongst the fauna most able to respond to warming seas, typically with a poleward shift in range. Habitat heterogeneity could, however, produce more complex patterns than a simple polewards translation in distribution. We tested for changes in the central location and spatial spread of mackerel spawning over a 33-year period. Spatial statistics [centre of gravity (CoG) of egg production, spatial variance, and degree of anisotropy] were used to summarise interannual changes in the spawning locations of the western spawning stock of north-east Atlantic mackerel (NEA-WSC) using data from the ICES triennial egg survey. A northwards shift in CoG of egg production estimates was observed, related to both an expansion in the distribution in survey effort and warming waters of the north-east Atlantic. Sea surface temperature (SST) had a significant positive association with the observed northward movement of NEA-WSC mackerel, equivalent to a displacement of 37.7 km °C^?1 (based on spring mean SST for the region). The spatial distribution of spawning around the CoG also changed significantly with SST, with a less elongated spatial spread in warm years. An increase in the proportion of spawning over the Porcupine Bank demonstrated how habitat interacts with positional shifts to affect how north-east Atlantic mackerel are distributed around the centre of their spawning range.     

Female reproductive qualities affect male painted turtle (Chrysemys picta marginata) reproductive success

Male reproductive success (RS) in polygamous species with minimal social systems is often determined by the number of mates. However, because male RS is translated through females, the number of offspring sired can also be influenced by female qualities. Empirically sufficient data to document how tradeoffs between mate number and quality influence male RS are seldom available for long-lived, iteroparous species. We combined long-term life history data (1983–2006) on the E. S. George Reserve (ESGR, MI, USA) with parentage data from 155 clutches of 59 female painted turtles (Chrysemys picta marginata) of varying reproductive frequencies (2003–2006) to determine the relative contribution of female numbers and qualities on male RS. One previously documented trait of female painted turtles that can have substantial influences on male RS is repeat paternity through the use of stored sperm to fertilize over 95 % of within-year clutches. In addition, our study found that second-clutch producing female painted turtles on the ESGR have higher among-year reproductive frequencies than do first-clutch only females. Multiple paternity was detected in 14.1 % of clutches (min-max?=?6.1–30.0 % annually), and the number of mates of both sexes was low annually (males 1.0; females 1.2) and over 4 years (males 1.1; females 1.7). Among successful males, RS varied substantially (1–32 offspring) and was strongly influenced by the combination of female reproductive frequency and repeat paternity (>38 % among years), but not mate number. Low mate number for both sexes was unexpected in a species without complex mating behaviors or parental care.     

Interactions between Carbon Sequestration and Shade Tree Diversity in a Smallholder Coffee Cooperative in El Salvador

Agroforestry systems have substantial potential to conserve native biodiversity and provide ecosystem services. In particular, agroforestry systems have the potential to conserve native tree diversity and sequester carbon for climate change mitigation. However, little research has been conducted on the temporal stability of species diversity and aboveground carbon stocks in these systems or the relation between species diversity and aboveground carbon sequestration. We measured changes in shade‐tree diversity and shade‐tree carbon stocks in 14 plots of a 35‐ha coffee cooperative over 9 years and analyzed relations between species diversity and carbon sequestration. Carbon sequestration was positively correlated with initial species richness of shade trees. Species diversity of shade trees did not change significantly over the study period, but carbon stocks increased due to tree growth. Our results show a potential for carbon sequestration and long‐term biodiversity conservation in smallholder coffee agroforestry systems and illustrate the opportunity for synergies between biodiversity conservation and climate change mitigation. Interacciones entre el Secuestro de Carbono y la Diversidad de Árboles de Sombra en una Cooperativa de Café de Pequeños Agricultores en El Salvador     

Modal choice for transportation of hazardous materials: the case of land modes of transport of bio-ethanol in Brazil

Performance evaluation is important in managing freight transport. The transport of certain products, especially those that are hazardous, can have significant financial and socio-environmental impacts. This article presents an application of the modal choice method (MCM) to establish an order of priority among the alternatives considered to carry a determined hazardous product. After a research of the literature on the concepts and development of the proposed method, we consulted experts about their experiences and knowledge, to determine a set of relevant attributes for the evaluation process. We then applied this method to the specific case of the Brazilian bio-ethanol industry, to demonstrate the potential of using the MCM as a tool to support make decisions. We can conclude that highway transport, though the most often used, is not the best compared to trains or pipelines (or combinations of any of the three) from a socio-environmental standpoint. Alternatives with longer pipeline segments are the most suitable to replace the current practice in environmental terms.     

Reorienting Systematic Conservation Assessment for Effective Conservation Planning

Abstract: Systematic conservation assessment (an information‐gathering and prioritization process used to select the spatial foci of conservation initiatives) is often considered vital to conservation‐planning efforts, yet published assessments have rarely resulted in conservation action. Conservation assessments may lead more directly to effective conservation action if they are reoriented to inform conservation decisions. Toward this goal, we evaluated the relative priority for conservation of 7 sites proposed for the first forest reserves in the Union of the Comoros, an area with high levels of endemism and rapidly changing land uses in the western Indian Ocean. Through the analysis of 30 indicator variables measured at forest sites and nearby villages, we assessed 3 prioritization criteria at each site: conservation value, threat to loss of biological diversity from human activity, and feasibility of reserve establishment. Our results indicated 2 sites, Yiméré and Hassera‐Ndrengé, were priorities for conservation action. Our approach also informed the development of an implementation strategy and enabled an evaluation of previously unexplored relations among prioritization criteria. Our experience suggests that steps taken to ensure the closer involvement of practitioners, include a broader range of social data, encourage stakeholder participation, and consider the feasibility of conservation action can improve the relevance of assessments for conservation planning, strengthen the scientific basis for conservation decisions, and result in a more realistic evaluation of conservation alternatives.     

CFD Investigation of Particle Deposition in a Horizontal Looped Turbulent Pipe Flow

This paper presents comprehensive 3D numerical investigations on depositions of particles flowing through a horizontal pipe loop consisting of four bends. The multiphase mixture model available in FLUENT 6.2 was used in this study. In this numerical simulation, five different particle sizes have been used as secondary phases to calculate real multiphase effect in which inter-particle interaction has been considered. The deposition of particles along the periphery of the pipe wall was investigated as a function of particle size and fluid velocity. The simulations showed that near the upstream of the bends, maximum particle concentration occurred at the bottom of the pipe. However, downstream the bends, the maximum particle concentration occurred at an angle of 60° from the bottom. The larger particles clearly showed deposition near the bottom wall except downstream. As expected, the smaller particles showed less tendency of deposition and lesser at higher velocity. This numerical investigation showed qualitative agreement with the experiments conducted by Commonwealth Scientific and Industrial Research Organisation, Melbourne team for similar conditions.     

Alternative amendment for soluble phosphorus removal from poultry litter

Background, aim, and scope  

Alum (aluminum sulfate) is the currently preferred chemical amendment for phosphorus (P) treatment in poultry litter (PL). Aluminum-based drinking-water treatment residuals (Al-WTRs) are the waste by-product of the drinking-water treatment process and have been effectively used to remove P from aqueous solutions, but their effectiveness in PL water extracts has not been studied in detail. Elevated cost associated with alum could be minimized by using the equally effective WTRs to remove soluble P from PL, and they can be obtained at a minimal cost from drinking-water treatment plants.     

Characterization of particulate matter concentrations during controlled indoor activities

Indoor sources have been identified as a major contributor to the increase of particle concentration in indoor environments. The work presented here is a study of the characteristics of particulate matter number size distribution and mass concentration under controlled indoor activities in a laboratory room. The objective is to characterize particulate matter concentrations indoors resulted under the influence of specific sources. Measurements were performed in an empty laboratory (period September–October 2006) using a GRIMM SMPS+C system (particle size range between 11.1 and 1083.3 nm), a DustTrak Aerosol Monitor (TSI) and a P-Trak Ultrafine Particle Counter (TSI). The studied indoor activities included candle burning, hot plate heating, water boiling, onion frying, vacuuming, hair drying, hair spraying, smoking and burning of incense stick. The AMANpsd computer algorithm was used to evaluate the modal structure of measured particle number size distribution data. Furthermore, the change of the particle number size distribution shape under the influence of different emission sources was studied versus time. Finally the particle emission rates were computed. High particle number concentrations were observed during smoking, onion frying, candle burning and incense stick burning. The highest particle mass concentrations were measured during smoking and hair spraying. The shift of the particle size distribution to larger diameters suggests the presence of strong coagulation effect during candle burning, incense stick burning, smoking and onion frying. The size distribution was mainly bimodal during onion frying and candle burning, whereas the size distribution remained unimodal during incense stick burning and smoking experiments.