A novel copolymer system has been synthesized using methyl hydroquinone diacetate (MHQDA), 1,4 naphthalene dicarboxylic acid (1,4 NDCA), and polybutylene terephthalate (PBT) using the melt polymerization technique. The optimum kinetic parameters pertinent to this system are reported in this study. A simple second-order reaction sequence summarizes catalyzed and uncatalyzed reactions between MHQDA, 1,4 NDCA, and PBT. The kinetic parameters for the copolymerization reaction were determined using a new second-order model. This technique was used to compute the moles of acetic acid generated in the polymerization process. The model was compared to that of the experimentally determined data. Close comparison (percentage error of less than 5%) was obtained between the experimental and theoretical data. The kinetic data support block copolyester formation. The thermal data also supports formation of block polymers. 相似文献
This study evaluated the microbiocidal efficacy of a cleaning and disinfection (C&D) treatment using stainless-steel coupons applied to three common types of animal mortality transport vehicles when exposed to agricultural conditions. Metal test coupons, inoculated with bacteriophage MS2, were affixed to the undercarriage of three types of animal mortality transport vehicles at various locations. Coupons were grimed by maneuvering the test vehicles down a series of wet dirt roads. Coupons were attached and extracted at various points to evaluate C&D performance with and without grime. C&D efficacy using a water-supplied pressure washing system and a dilute sodium hypochlorite (NaOCl) solution was determined by comparing the difference in recovered viable virus between positive control coupons and test coupons. The results demonstrated a relatively high surface decontamination efficacy, with all but one location showing >5 log reduction of MS2. Coupons located on the roll-off truck's inside-back bumper contained the highest level of grime and resulted in a 4 log reduction of MS2. There was no significant difference in C&D efficacy across vehicle types, but locations impacted by grime and lack of accessibility achieved lower efficacies on average. These findings suggest that common C&D protocols, when applied to farm mortality transport vehicles, are effective. Hard-to-access locations containing high levels of grime may be candidates for additional targeted treatment. 相似文献
The majority of dosimeters currently in use are synthetic and very expensive. Therefore, the study of the dosimetric characteristics of polyphenolic extracts of xerophytes is useful because drought stress causes an increase in the production of these cheap and natural compounds containing benzene rings. Here, the polyphenolic compounds were extracted from Rhamnus lycioides which was collected from Bou-Hedma National Park in Tunisia and identified using liquid chromatography-mass spectrometry (LC-MS). We investigated the impact of cobalt-60 (60Co) irradiation (0–30 kilogray (kGy)) on the color parameters of polyphenolic extracts of R. lycioides using the Konica Minolta CR 300 portable colorimeter and UV–Visible spectroscopy. The structural and morphological characteristics of the irradiated extracts were assessed using Fourier transform infrared (FT-IR) spectroscopy, X-ray diffraction (XRD) technique and scanning electron microscopy (SEM). Overall, our results suggest that exposure to ionizing radiation (IR) of the polyphenolic components of the xerophyte R. lycioides has produced significant dose-dependent changes in their optical and morphological properties. Thus, these extracts can be valorized as biodosimeters in the dose range from 5 to 25 kGy. 相似文献
Environmental Science and Pollution Research - Substantial discharge of hazardous substances, especially dyes and heavy metal ions to the environment, has become a global concern due to... 相似文献
Environmental Science and Pollution Research - This study examines the Environmental Kuznets Curve (EKC) hypothesis in the context of 12 members of the OPEC by utilizing data on both the aggregate... 相似文献
The distribution and composition of hydrocarbons in sediment from the Fladen Ground oilfield in the northern North Sea have been investigated. The total PAH concentrations (2- to 6-ring parent and alkylated PAHs, including the 16 US EPA PAHs) in sediments were relatively low (<100 microg kg(-1) dry weight). The PAH, the Forties crude and diesel oil equivalent concentrations were generally higher in sediment of fine grain size and higher organic carbon concentration. PAH distributions and concentration ratios indicated a predominantly pyrolytic input, being dominated by the heavier, more persistent, 5- and 6-ring compounds, and with a high proportion of parent PAHs. The n-alkane profiles of a number of the sediments contained small, high boiling point, UCMs, indicative of weathered oil arising from a limited petrogenic input. The geochemical biomarker profiles of the sediments that contained UCMs showed a small bisnorhopane peak and a high proportion of norhopane relative to hopane, indicating that there was contamination from both Middle Eastern and North Sea oils. Therefore contamination was not directly as a result of oil exploration activity in the area. The most likely source of petrogenic contamination was from general shipping activity. 相似文献
Environmental Science and Pollution Research - A composite polymer, hydroxyapatite/poly(acrylamide-acrylic acid), was synthesized by gamma-induced polymerization. The factors affecting the sorption... 相似文献
Environmental Science and Pollution Research - The evaluation of the toxicological effects of titanium dioxide nanoparticles (TiO2NPs) is increasingly important due to their growing occupational... 相似文献
Nickel ferrite (NiFe2O4) nanoparticles are prepared through different routes (microwave, co-precipitation, and pyrolysis) and tested for water purification applications through adsorption removal of an acid red dye B as a model organic pollutant. The characterizations of the prepared samples were done using XRD, FT-IR, SEM, TEM, BET, UV-Vis absorbance, Raman spectrum, and vibrating sample magnetometer (VSM). All samples showed an inverse spinel crystal structure. The obtained results pointed out to the effect of the synthetic route on the morphology, particle size, optical, and magnetic properties of the prepared ferrites. Magnetic measurements showed super-paramagnetic behavior for all samples. The magnetic saturation (Ms) of the sample prepared by pyrolysis, was found to possess the highest saturation value, 34.8 emu/g. Adsorption experiments were performed under the change in several parameters, such as pH, adsorbent dosage, and initial dye concentration. A dye removal percentage of 99% was reached under the optimum state. The isothermal adsorption of the acid red dye was investigated using several models, in which the experimental data could be best described by the Freundlich model. Several kinetic and equilibrium models were inspected by linear regression analysis and showed best fitting for the adsorption data through pseudo-second-order model. The calculated thermodynamic parameters indicated that the adsorption of acid red dye onto all the ferrite samples is a spontaneous and endothermic physical adsorption process.
Jordan relies heavily on reservoirs building and development to cope with water supply challenges, where monitoring and assessment of reservoir water quality are critically important for the sustainable use of these water supplies. Mujib Dam is an important water supply source in central western Jordan. Evaluation of water quality parameters and their spatial distributions (vertical and horizontal) showed near-neutral pH values with nearly similar values from surface to bottom. The vertical profile of DO and TDS in the dammed reservoir showed slight decreasing trends with increasing depth. Although Ca, Mg, Na, and K concentrations varied slightly with depths, their variations showed no trends. Similarly, the vertical and horizontal distribution patterns of Cl, SO4, HCO3, NO3, and PO4 in Mujib reservoir water showed insignificant variations in surface water layer and relatively unchanged values or decreasing trends through the water column. Higher values of TN have been observed, especially in the western part, suggesting that agricultural activities and livestock farming in the upstream catchment are impacting water quality. Results revealed that weathering and dissolution of rocks are the major source of water chemistry. The majority of trace metal levels (Cd, Cr, Cu, Fe, Mn, Pb, Zn, Co, Ni, Sr, and B) in water showed relatively similar surface and bottom values. The concentrations of COD and BOD5 in surface water were relatively low with higher concentrations observed in the northwestern corner, coincided with higher levels of chlorophyll a. The average ratio of TN to TP in surface water suggests that phosphorus is the limiting factor for the algal blooms, whereas the average chlorophyll a level in surface water indicates oligo-mesotrophic water. 相似文献