评析中国现行环境保护投资体制

本文通过对我国近15年环保投资相关数据的分析,揭示了现行环保投资体制失灵的一个重要因素是结构上失衡,在环保投资中没有体现环保设施运营费用,直接影响了环保投资的效益,其次,一些指标的设计严重偏离了现实,影响了环保投资的有机构成,也导致环境政策的失效,在此基础上,结合实际,提出初步的改革设想。     

甘氨酸厂废液综合治理的工艺及实验研究

对氯乙酸氨解法生产甘氨酸所排放的工业废水首先运用多效真空蒸发兼热泵技术回收氯化铵,然后对蒸发过程中产生的二次蒸汽冷凝水采用一次吹脱-催化氧化-二次吹脱的工艺进行处理,可使废水中的各种污染物有效去除。通过实验确定了冷凝水处理过程中的吹脱及氧化的最佳工艺参数。     

药厂、啤酒厂等有机废水厌氧处理试验研究

针对几种高浓度有机废水进行厌氧处理试验,取得参数,为生产性试验提供有价值的参数。     

聚异丁烯丁二酰亚胺尾气吸收系统的改进

针对聚异丁烯丁二酰亚胺生产工艺中废气排放量大、尾气吸收得到的盐酸含油量高、难以销售等问题,在分析原因的基础上,对尾气吸收系统进行了技术改进。尾气吸收系统改进后,排放的HCl和Cl2的质量浓度分别由65,42mg／m^3降至为零;产品综合收率由89．5％增加至96．0％;产品成本降低了700元/t。     

Geotechnical and leaching properties of flowable fill incorporating waste foundry sand

Waste foundry sand (WFS) can be converted into flowable fill for geotechnical applications. In this study, WFS samples were obtained from 17 independent metal casting facilities with different casting processes, thus representing a good range of WFS properties. The laboratory studies include physical, geotechnical and leaching properties of flowable fills consisting of WFS, cement, and fly ash mixed to different water contents. The main properties measured include WFS physical properties (density, particle gradation, grain shape, and fine content), WFS flowable fill geotechnical properties (unconfined compressive strength, hydraulic conductivity, setting time, and bleeding), and the fill's leaching properties (heavy metals and organics in the bleed water and the leachate extracted from hardened WFS flowable fills). The test results indicate that in terms of the physical properties, most of the data fall within narrow ranges, although data from the copper/aluminum-based WFS samples might fall beyond the ranges. Geotechnical properties of WFS flowable fills in both fresh and hardened phases were verified conforming to the features of specified flowable fills. Material leaching analyses indicate that the toxicity of WFS flowable fills is below regulated criteria. A mix formulation range originated from this study is proposed for the design of WFS made flowable fill.     

TiO2-PTFE光催化膜的制备及性能

以聚四氟乙烯（PTFE）乳液和纳米TiO2粉末为原料,采用无水乙醇为溶剂,经辊压后与不锈钢网结合,制备了多孔固定化TiO2-PTFE光催化膜。膜性能研究结果表明,m（TiO2）：m（PTFE）=4时,光催化反应处理质量浓度为20mg／L的苯甲酸溶液,2h内TOC去除率高达81．3％。通过扫描电子显微镜观察,TiO2-PTFE光催化膜表面平整,且孔隙分布均匀。TiO2最佳负载量为15mg／cm2。在优化反应条件下同悬浮态TiO2光催化反应体系相比,TiO2-PTFE光催化膜对光源有更高的利用率,表现出更佳的催化活性。     

氯酚与富里酸的缔合作用

本文用超滤膜方法证实氯酚与富里酸之间存在缔合作用,并计算出表观缔合常数在２．７＊１０＾３－－１２１＊１０＾３ｍｌ．ｇ＾－１范围内。实验结果表明”ＰＨ、富里酸含量,氯酚取代氯原子个数都能够影响Ｋ值的大小。     

单甲脒饱和蒸气压的测定和估算

用气体的法测单甲脒在１５,２５,３５和４５℃时的饱和蒸气分别为０．２０２,０．５５４６,１．９５,６．２９Ｐａ;亨利常数计算值分别为６．３０×１０＾－４,１．６７×１０＾－３,５．６８×１０＾０－３和１．７８×１０＆－２,根据Ｃｌａｕｓｉｕｓ Ｃｌａｐｅｙｒｏｎ方程求出单甲脒在常温下气化热为８９．２ｋＪ．ｍｏｌ＾－１。     

Comparison of forest edge effects on throughfall deposition in different forest types

This study examined the influence of distance to the forest edge, forest type, and time on Cl⁻, SO₄²⁻, NO₃⁻, and NH₄⁺ throughfall deposition in forest edges. The forests were dominated by pedunculate oak, silver birch, or Corsican/Austrian pine, and were situated in two regions of Flanders (Belgium). Along transects, throughfall deposition was monitored at distances of 0-128 m from the forest edge. A repeated-measures analysis demonstrated that time, forest type, and distance to the forest edge significantly influenced throughfall deposition of the ions studied. The effect of distance to the forest edge depended significantly on forest type in the deposition of Cl⁻, SO₄²⁻, and NO₃⁻: the edge effect was significantly greater in pine stands than in deciduous birch and oak stands. This finding supports the possibility of converting pine plantations into oak or birch forests in order to mitigate the input of nitrogen and potentially acidifying deposition.