Changes in anoxic denitrification rate resulting from prefermentation of a septic, phosphorus-limited wastewater.

A preliminary bench-scale study of parallel University of Cape Town (UCT) biological nutrient removal systems showed improvement in anoxic denitrification rates resulting from prefermentation of a septic (i.e., high volatile fatty acid [VFA] content), phosphorus-limited (i.e., total chemical oxygen demand/total phosphorus [TP] ratio < 40:1) wastewater. Net phosphorus removals due to enhanced biological phosphorus removal (EBPR) were only improved marginally by prefermentation in spite of significant increases in anaerobic phosphorus release, polyhydroxyalkanoate formation, and higher anoxic and aerobic uptakes. This probably was due to the high VFA/TP ratio in the raw influent relative to the VFA requirements for EBPR because enough VFAs were already present for phosphorus removal prior to prefermentation. An additional assessment of prefermentation using parallel UCT systems with step feed of 50% of the influent to the anoxic zone was completed. This second phase quantified the effect of prefermentation in a step-feed scenario, which prioritized prefermentation use to enhance denitrification rather than EBPR. While specific denitrification rates in the anoxic zone were significantly improved by prefermentation, high denitrification in the clarifiers and aerobic zones (simultaneous denitrification) made definitive conclusions concerning the potential improvements in total system nitrogen removal questionable. The prefermented system always showed superior values of the zone settling velocity and sludge volume index and the improvement became increasingly statistically significant when the prefermenter was performing well.     

Hydrocarbons in Sand Crabs (Emeritaanaloga) from Southern California (U.S.A.)

$\text{Emerita}$$\text{analoga}$ (Crustacea:Hippidae) from three southern California (U.S.A.) beaches contained 0.9 to 24.1 μg/g dry wt saturated hydrocarbons, and 3.6 to 21.4 μg/g dry wt unsaturated hydrocarbons. Major constituents were (in wt. % total): n-alkanes (13.1%), heneicosapentaene plus heneicosahexaene (1.0%), squalene (5.1%), and unidentified polyenes (7.8%). Crabs from beaches exposed to small boat traffic and natural oil seepage were slightly and severely tainted, respectively, with petroleum hydrocarbons. Animals from San Nicolas Island (85 km offshore) contained only biogenic compounds.     

Sources and processes affecting concentrations of PM10 and PM2.5 particulate matter in Birmingham (U.K.)

Hourly average concentrations of PM₁₀ and PM_2.5 have been measured simultaneously at a site within Birmingham U.K. between October 1994 and October 1995. Comparison of PM₁₀ and NO_x data with two other sites in the same city shows comparable summer and winter mean concentrations and highly significant inter-site correlations for both hourly and daily mean data. Over a four-month period samples were also collected for chemical analysis of sulphate, nitrate, chloride, ammonium and elemental and organic carbon. Analysis of the data indicates a marked difference between summer and winter periods. In the winter months PM_2.5 comprises about 80% of PM₁₀ and is strongly correlated with NO_x indicating the importance of road traffic as a source. In the summer months, coarse particles (PM₁₀−PM_2.5) account for almost 50% of PM₁₀ and the influence of resuspended surface dusts and soils and of secondary particulate matter is evident. The chemical analysis data are also consistent with three sources dominating the PM₁₀ composition: vehicle exhaust emissions, secondary ammonium salts and resuspended surface dusts. Coarse particles from resuspension showed a positive dependence on windspeed, whilst elemental carbon derived from road traffic exhibited a negative dependence.     

Concentrations of pesticide residues in grasses and sedges due to point source contamination and the indications for public health risks, Vikuge, Tanzania

The concentrations of organochlorine pesticide residues were determined in roots and leaves of giant sedges (Cyperus exaltatus), fresh leaves and dry hay of guinea grasses (Panicum maximum), and in stems and leaves of elephant grasses (Pennisetum purpureum) in the vicinity of a point source of contamination, an old storage site at Vikuge farm in Tanzania. The GPC-cleaned extracts were analyzed by GC-ECD and GC/MS. The concentrations of total DDT ranged from 83 to 18274 ng/g, 166 to 7922 ng/g, and 68 to 405 ng/g, on fresh weight basis, in C. exaltatus, P. maximum and P. purpureum, respectively. The concentrations of total HCH were up to 74 ng/gfw in leaves of C. exaltatus, 43 ng/gdw in dry hay of P. maximum, and 10 ng/gfw in stems of P. purpureum. Aldrin and dieldrin were only detected in C. exaltatus and their concentrations were up to 11 and 8 ng/gfw, respectively. The strong positive correlations between the concentrations of the detected compounds suggest a common source. The concentrations of total DDT were far above the Australian extraneous maximum residue limit in primary animal feedstuffs. These findings indicate potential risks and concerns for livestock and public health. The concentrations of aldrin, dieldrin and lindane were lower than the Australian limits.     

Effects of reduced return activated sludge flows and volume on anaerobic zone performance for a septic wastewater biological phosphorus removal system.

Enhanced biological phosphorous removal (EBPR) performance was found to be adequate with reduced return-activated sludge (RAS) flows (50% of available RAS) to the anaerobic tank and smaller-than-typical anaerobic zone volume (1.08 hours hydraulic retention time [HRT]). Three identical parallel biological nutrient removal pilot plants were fed with strong, highly fermented (160 mg/L volatile fatty acids [VFAs]), domestic and industrial wastewater from a full-scale wastewater treatment facility. The pilot plants were operated at 100, 50, 40, and 25% RAS (percent of available RAS) flows to the anaerobic tank, with the remaining RAS to the anoxic tank. In addition, varying anaerobic HRT (1.08 and 1.5 hours) and increased hydraulic loading (35% increase) were examined. The study was divided into four phases, and the effect of these process variations on EBPR were studied by having one different variable between two identical systems. The most significant conclusion was that returning part of the RAS to the anaerobic zone did not decrease EBPR performance; instead, it changed the location of phosphorous release and uptake. Bringing less RAS to the anaerobic and more to the anoxic tank decreased anaerobic phosphorus release and increased anoxic phosphorus release (or decreased anoxic phosphorus uptake). Equally important is that, with VFA-rich influent wastewater, excessive anaerobic volume was shown to hurt overall phosphorus removal, even when it resulted in increased anaerobic phosphorus release.     

Evaluation of an explicit NOx chemistry method in AERMOD

An explicit NO_x chemistry method has been implemented in AERMOD version 15181, ADMSM. The scheme has been evaluated by comparison with the methodologies currently recommended by the U.S. EPA for Tier 3 NO₂ calculations, that is, OLM and PVMRM2. Four data sets have been used for NO₂ chemistry method evaluation. Overall, ADMSM-modeled NO₂ concentrations show the most consistency with the AERMOD calculations of NO_x and the highest Index of Agreement; they are also on average lower than those of both OLM and PVMRM2. OLM shows little consistency with modeled NO_x concentrations and markedly overpredicts NO₂. PVMRM2 shows performance closer to that of ADMSM than OLM; however, its behavior is inconsistent with modeled NO_x in some cases and it has less good statistics for NO₂. The trend in model performance can be explained by examining the features particular to each chemistry method: OLM can be considered as a screening model as it calculates the upper bound of conversion from NO to NO₂ possible with the background O₃ concentration; PVMRM2 includes a much-improved estimate of in-plume O₃ but is otherwise similar to OLM, assuming instantaneous reaction of NO with O₃; and ADMSM allows for the rate of this reaction and also the photolysis of NO₂. Evaluation with additional data sets is needed to further clarify the relative performance of ADMSM and PVMRM2.

Implications: Extensive evaluation of the current AERMOD Tier 3 chemistry methods OLM and PVMRM2, alongside a new scheme that explicitly calculates the oxidation of NO by O₃ and the reverse photolytic reaction, shows that OLM consistently overpredicts NO₂ concentrations. PVMRM2 performs well in general, but there are some cases where this method overpredicts NO₂. The new explicit NO_x chemistry scheme, ADMSM, predicts NO₂ concentrations that are more consistent with both the modeled NO_x concentrations and the observations.     

Incubation feeding by helpers influences female nest attendance in the green woodhoopoe,<Emphasis Type="Italic"> Phoeniculus purpureus</Emphasis>

In many bird species, the female alone incubates the eggs, but the male provides her with some food during the incubation period. In cooperatively breeding species, helpers might be expected to assist the breeding male in provisioning the female, but their contribution has been generally ignored. Here, I show that in the green woodhoopoe, Phoeniculus purpureus, the breeding male and helpers of both sexes bring food to the incubating female. The helpers did not increase the overall amount of provisioning the female received: groups of all sizes delivered a similar amount of food per hour. Helpers did, however, reduce the workload of the breeding male. Male and female helpers provisioned incubating females equally, as expected in a species where both sexes are likely to derive equal benefits from their helping behaviours. Female nest attendance was positively related to the level of group provisioning, but only in the short term. Thus, the female-nutrition hypothesis, which suggests that incubation feeding can provide an important source of energy to the breeding female, is supported in the green woodhoopoe.Communicated by I. Hartley     

The Effect of Polymeric Chain Extenders on Physical Properties of Thermoplastic Starch and Polylactic Acid Blends

The effects of a polymeric chain extender on the properties of bioplastic film made from blends of plasticized polylactic acid (p-PLA) and thermoplastic starch (TPS) were studied. Joncryl^? ADR 4370S, a polymeric chain extender, was blended with TPS and p-PLA at a level of 1% (w/w). A co-rotating twin-screw extrusion process was used to prepare films with various ratios of TPS and p-PLA. Mechanical and physical properties of films, including film tensile properties, surface energy, moisture content, hydrophilicity, moisture sorption behaviour and thermal mechanical properties were determined. During extrusion, films enhanced by 1% Joncryl addition demonstrated more desirable and consistent qualities, such as smoother film edge and surface. Addition of Joncryl significantly improved film tensile strength, 0.2% offset yield strength, and elongation, especially evident with the 250% elongation of 70/30 (TPS/p-PLA) film. Total surface energy of films was not significantly influenced by addition of Joncryl. However, the polar contribution to the total surface energy of 70/30 (TPS/p-PLA) film increased after the addition of Joncryl. The study showed that blending TPS with p-PLA transformed TPS film from being highly hydrophilic to highly hydrophobic. On the other hand, addition of Joncryl had limited effects on moisture content, water solubility, glass transition temperature and moisture sorption behaviour of TPS/p-PLA blend films.     

Methods to reduce traffic crashes involving deer: what works and what does not

More than 1.5 million traffic crashes involving deer, producing at least $1.1 billion in vehicle damage and about 150 fatalities, are estimated to occur annually in the United States. Deer-related crashes are increasing as both deer populations and vehicular travel increase. Many methods have been used in attempts to reduce deer crashes, often with little scientific foundation and limited evaluation. This article summarizes the methods and reviews the evidence of their effectiveness and the situations in which each may be useful. The only widely accepted method with solid evidence of effectiveness is well-designed and maintained fencing, combined with underpasses or overpasses as appropriate. Herd reduction is controversial but can be effective. Deer whistles appear useless. Roadside reflectors appear to have little long-term effect, although additional well-designed evaluations are needed before firm conclusions can be drawn. Both temporary passive signs and active signs appear promising in specific situations, but considerable research is required to evaluate long-term driver response and to improve and test deer detection technology for active signs. Other methods using advanced technology require substantial additional research and evaluation.