A mathematical modeling of sulphur dioxide pollution in Erzurum City

A non-linear simple air-quality model was developed by applying the continuity equation for the air control volume over Erzurum city center and tested using daily average values of SO2 and meteorological data obtained during the winter seasons in Erzurum, Turkey from 1994 to 1998. Model parameters are estimated by non-linear regression analysis. Agreement between model predictions and measured data was found very satisfactory with standard deviations less than 20 microg/m3.     

Lead removal in fixed-bed columns by zeolite and sepiolite

The removal efficiency of zeolite (clinoptilolite) and sepiolite from lead containing aqueous solutions was investigated. A series of experiments were conducted in batch-wise and fixed-bed columns. Synthetic wastewaters containing lead (50 mg l (-1)) and acetic acid (0.001 N) along with untreated and regenerated clinoptilolites and sepiolites were used in the adsorption studies. Batch tests were mainly conducted to isolate the magnitude of lead precipitation from real adsorption. Adsorption isotherms for both abstraction and adsorption were constructed. The removal of lead is found to be a sum of adsorption induced by ion exchange and precipitation of lead hydroxide. The breakthrough curves were obtained under different conditions by plotting the normalized effluent lead concentration (C/C0) versus bed volume (BV). The ion exchange capacity of sepiolite and clinoptilolite for lead removal showed good performance up to approximately 100 and 120 BV where the C/C0 remained below 0.1, respectively. The lead removal capacity of clinoptilolite bed from wastewater containing only lead yielded 45% higher performance compared to that of acetic acid partly due to a decrease in the effluent pH and consequently in precipitation. Also, the presence of acetic acid in the sepiolite column decreased the bed volumes treated by about 40%. Removal efficiency of lead-acetic system both in untreated clinoptilolite and sepiolite columns was found higher than that in regenerated columns.     

Prenatal diagnosis of Joubert syndrome: a case report

Joubert syndrome is a rare, autosomal recessive condition, first described by Joubert in 1969. We present a case of Joubert syndrome from a consanguineous family in which, apart from the cerebellar vermis agenesis, ventriculomegaly, bilateral postaxial polydactyly of hands and right foot and micropenis, episodes of fetal breathing pattern with an increased respiratory rate were also demonstrated by prenatal ultrasound scan. At birth the infant showed an odd face and bilateral fleshy nodules of the tongue. He had an abnormal breathing pattern of alternating tachypnea and apnea. Cranial MRI showed molar tooth sign, hydrocephalus and Dandy–Walker malformation. He had nystagmus, and electroretinography showed retinal dystrophy. Copyright © 2002 John Wiley & Sons, Ltd.     

Growth of the Decision Tree: Advances in Bottom‐Up Climate Change Risk Management

There has recently been a return in climate change risk management practice to bottom‐up, robustness‐based planning paradigms introduced 40 years ago. The World Bank's decision tree framework (DTF) for “confronting climate uncertainty” is one incarnation of those paradigms. In order to better represent the state of the art in climate change risk assessment and evaluation techniques, this paper proposes: (1) an update to the DTF, replacing its “climate change stress test” with a multidimensional stress test; and (2) the addition of a Bayesian network framework that represents joint probabilistic behavior of uncertain parameters as sensitivity factors to aid in the weighting of scenarios of concern (the combination of conditions under which a water system fails to meet its performance targets). Using the updated DTF, water system planners and project managers would be better able to understand the relative magnitudes of the varied risks they face, and target investments in adaptation measures to best reduce their vulnerabilities to change. Next steps for the DTF include enhancements in: modeling of extreme event risks; coupling of human‐hydrologic systems; integration of surface water and groundwater systems; the generation of tradeoffs between economic, social, and ecological factors; incorporation of water quality considerations; and interactive data visualization.     

Determination of Pb(II), Zn(II), Cd(II), and Co(II) ions by flame atomic absorption spectrometry in food and water samples after preconcentration by coprecipitation with Mo(VI)-diethyldithiocarbamate

A new, simple, and rapid separation and preconcentration procedure, for determination of Pb(II), Cd(II), Zn(II), and Co(II) ions in environmental real samples, has been developed. The method is based on the combination of coprecipitation of analyte ions by the aid of the Mo(VI)–diethyldithiocarbamate–(Mo(VI)-DDTC) precipitate and flame atomic absorption spectrometric determinations. The effects of experimental conditions like pH of the aqueous solution, amounts of DDTC and Mo(VI), standing time, centrifugation rate and time, sample volume, etc. and also the influences of some foreign ions were investigated in detail on the quantitative recoveries of the analyte ions. The preconcentration factors were found to be 150 for Pb(II), Zn(II) and Co(II), and 200 for Cd(II) ions. The detection limits were in the range of 0.1–2.2 μg L^?1 while the relative standard deviations were found to be lower than 5 % for the studied analyte ions. The accuracy of the method was checked by spiked/recovery tests and the analysis of certified reference material (CRM TMDW-500 Drinking Water). The procedure was successfully applied to seawater and stream water as liquid samples and baby food and dried eggplant as solid samples in order to determine the levels of Pb(II), Cd(II), Zn(II), and Co(II) ions.     

Effect of high sulfate concentration on the corrosivity: a case study from groundwater in Harran Plain, Turkey

Corrosion, which tends to increase the concentrations of certain metals in tap water, is one of the most important water quality problems as it can affect public health and public acceptance of water supply and the cost of providing safe water. In this context, this study aimed at investigating the scale formation tendency or corrosivity of groundwater in the semi-arid Harran Plain. The degree of scale formation tendency/corrosivity of water was determined considering pHs, Langelier Index, and Ryznar Index of groundwater samples. Except for well no.4, which is close to a local hot spring, all the wells had corrosive characteristics. The amount of CO₂ from the soil zone respiration and high sulfate concentration in the wells are important factors affecting corrosiveness. Results showed that precipitation, excessive irrigation, and change in groundwater level caused seasonal variation in corrosive characteristics.     

Fuzzy multicriteria disposal method and site selection for municipal solid waste

The use of fuzzy multiple criteria analysis (MCA) in solid waste management has the advantage of rendering subjective and implicit decision making more objective and analytical, with its ability to accommodate both quantitative and qualitative data. In this paper a modified fuzzy TOPSIS methodology is proposed for the selection of appropriate disposal method and site for municipal solid waste (MSW). Our method is superior to existing methods since it has capability of representing vague qualitative data and presenting all possible results with different degrees of membership. In the first stage of the proposed methodology, a set of criteria of cost, reliability, feasibility, pollution and emission levels, waste and energy recovery is optimized to determine the best MSW disposal method. Landfilling, composting, conventional incineration, and refuse-derived fuel (RDF) combustion are the alternatives considered. The weights of the selection criteria are determined by fuzzy pairwise comparison matrices of Analytic Hierarchy Process (AHP). It is found that RDF combustion is the best disposal method alternative for Istanbul. In the second stage, the same methodology is used to determine the optimum RDF combustion plant location using adjacent land use, climate, road access and cost as the criteria. The results of this study illustrate the importance of the weights on the various factors in deciding the optimized location, with the best site located in Çatalca. A sensitivity analysis is also conducted to monitor how sensitive our model is to changes in the various criteria weights.     

Removal of AOX, total nitrogen and chlorinated lignin from bleached Kraft mill effluents by UV oxidation in the presence of hydrogen peroxide utilizing TiO2 as photocatalyst

Background, aim, and scope  The pulp and paper industry is the sixth largest polluter discharging a variety of gaseous, liquid, and solid wastes into the environment. Effluents from bleached Kraft mill effluents (BKME) are polluting waters to a great extent These effluents cause considerable damage to the receiving waters if discharged untreated since they have high levels of biological oxygen demand (BOD), chemical oxygen demand (COD), chlorinated compounds (measured as AOX), suspended solids (mainly fibers), fatty acids, tannins, resin acids, lignin and its derivatives, sulfur and sulfur compounds, etc. This study aimed to remove adsorbed organic halogen (AOX), total nitrogen, and lignin-degrading products in the wastewater (4,500 m³/h) from the paper mill in the pulp and paper industry, which is discharged to sea from a plant located in western Turkey. Materials and methods  The photocatalytic degradation of AOX, total nitrogen, and chlorinated lignin in BKME have been investigated in different parameters, such as time, H₂O₂ and TiO₂ concentration. In addition, for investigating the effect of chlorine on the removal of lignin, pure lignin solution was prepared in equal amounts to chlorinated lignin degradation products found in BKME. The same experiments were conducted for this solution. Experiments were carried out in photocatalytic reactor made of Pyrex glass. The mercury lamp was used as a radiation source. All irradiation was carried out under constant stirring. The existence of dissolved O₂ is an important factor which increases the photocatalytic degradation. Hence, we used an air pump for the aeration of the wastewater solutions. The temperature of the wastewater was controlled and adjusted to 25°C by thermostat pump in conjunction with a cooler. At the end of all experiments, AOX, total nitrogen and lignin concentrations were analyzed according to standard methods. All experiments were performed in duplicate and average values were used. Results and discussion  When the effect of H₂O₂ and time were investigated, it was observed that the AOX concentration increased from 3.0 to 11.0 mg/L by only UV. However, when H₂O₂ was added, AOX concentration decreased from approximately 3.0 to 0.0 mg/L. The optimal conditions for the removal of AOX appear to be an initial H₂O₂ concentration of 20.0 mL/L and reaction time of 50 min. In addition, at the same experiment conditions, it was seen that the total nitrogen concentration decreased from 23.0 to 15.0 mg/L by only UV and by increasing H₂O₂ concentration, the concentration of 20.0 mL/L H₂O₂ appears to be optimal (9.0 mg/L). The AOX, total nitrogen and lignin degradation products and pure lignin go through a minimum when the concentration of H₂O₂ and TiO₂ increases at constant pH and UV intensity. The kinetics for the degradation of AOX, total nitrogen and lignin degradation products followed a pseudo-first order law with respect to the products, and the degradation rates (min⁻¹) for the UV/TiO₂/H₂O₂ system were higher than that of the corresponding values for the UV/H₂O₂ system. Conclusions  The AOX, total nitrogen and lignin concentration go through a minimum when the concentration of H₂O₂ and TiO₂ increases at constant pH and UV intensity. It was found that the UV/TiO₂/H₂O₂ system has proved capable of the degradation of total nitrogen as well as chlorinated and degraded lignin in BKME. Recommendations and perspectives  The photocatalytic process can be considered a suitable alternative for the remove of some compounds from the BKME. Nevertheless, further studies should be carried out to confirm the practical feasibility of BKME. Another result obtained from the study is that pre-purification carried out with UV/TiO₂/H₂O₂ photocatalytic process may constitute an important step for further purification processes such as adsorption, membrane processes, etc.     

Drought Resilience of the California Central Valley Surface‐Ground‐Water‐Conveyance System1

Abstract: A series of drought simulations were performed for the California Central Valley using computer applications developed by the California Department of Water Resources and historical datasets representing a range of droughts from mild to severe for time periods lasting up to 60 years. Land use, agricultural cropping patterns, and water demand were held fixed at the 2003 level and water supply was decreased by amounts ranging between 25 and 50%, representing light to severe drought types. Impacts were examined for four hydrologic subbasins, the Sacramento Basin, the San Joaquin Basin, the Tulare Basin, and the Eastside Drainage. Results suggest the greatest impacts are in the San Joaquin and Tulare Basins, regions that are heavily irrigated and are presently overdrafted in most years. Regional surface water diversions decrease by as much as 70%. Stream‐to‐aquifer flows and aquifer storage declines were proportional to drought severity. Most significant was the decline in ground water head for the severe drought cases, where results suggest that under these scenarios the water table is unlikely to recover within the 30‐year model‐simulated future. However, the overall response to such droughts is not as severe as anticipated and the Sacramento Basin may act as ground‐water insurance to sustain California during extended dry periods.     

Removal of methyl parathion from water by electrochemically generated Fenton's reagent

The electro-Fenton process was used to assess the degradation of methyl parathion (MP) in aqueous solutions. This oxidation process allows the production of hydroxyls radicals which react on the organic compounds, leading to their mineralization. Degradation experiments were performed either in perchloric, sulphuric, hydrochloric and nitric acid media under current controlled electrolysis conditions at different pH. The pH effect as well as the nature of the medium (i.e., the nature of the ions present in medium) on the degradation and mineralization efficiency were studied. The mineralization of the initial pollutant was investigated by total organic carbon measurements which show a complete mineralization at pH 3 in perchloric medium. The absolute rate constant of MP hydroxylation reaction was determined as (4.20+/-0.11)x10(9)M(-1)s(-1). Complete degradation of MP and its metabolites occur in less than 45min. Degradation reaction intermediates such as aromatic compounds, carboxylic acids and inorganic ions were identified and a mineralization pathway is proposed.