Accelerated soil dissipation of tebuconazole following multiple applications to peanut

Repeated application may increase rates of pesticide dissipation in soil and reduce persistence. The potential for this to occur was investigated for the fungicide, tebuconazole (alpha-[2-(4-chlorophenyl)ethyl]-alpha-(1,1-dimethylethyl)-1H-1,2,4-triazole-1-ethanol), when used for peanut (Arachis hypogaea L.) production. Soil samples were collected from peanut plots after each of four tebuconazole applications at 2-wk intervals. Soil moisture was adjusted to field capacity as necessary and samples were incubated in the laboratory for 63 d at 30 degrees C. Untreated plot samples spiked with the compound served as controls. Results indicated accelerated dissipation in field-treated samples with the time to fifty percent dissipation (DT50) decreasing from 43 to 5 d after three tebuconazole applications. Corresponding increases in rates of accumulation and decay of degradates were also indicated. Best-fit equations (r2 = 0.84-0.98) to dissipation kinetic data combined with estimates of canopy interception rates were used to predict tebuconazole and degradates concentration in soil after each successive application. Predicted concentrations compared with values measured in surface soil samples were from twofold less to twofold greater. Use of kinetic data will likely enhance assessments of treatment efficacy and human and ecological risks from normal agronomic use of tebuconazole on peanut. However, the study indicated that varying soil conditions (in particular, soil temperature and water content) may have an equal or greater impact on field dissipation rate than development of accelerated dissipation. Results emphasize that extension of laboratory-derived kinetic data to field settings should be done with caution.     

Ammonia emission from grassland and livestock production systems in the UK

Emissions of ammonia were measured from livestock excreta and fertilisers applied to grass swards, from grazed paddocks, from decomposing grass herbage and from an animal house containing dairy cows. Emissions from urine, dung, slurry and fertilisers were determined using a system of wind tunnels with each tunnel covering an area of 1 m(2). Emissions from grazed swards were determined using a micrometeorological mass balance method. From the results of these measurements, together with other published information, an inventory for ammonia emissions has been calculated for grassland and livestock production systems over the UK as a whole. It is estimated that emissions from grassland and cattle and sheep production amount to about 230 kt NH(3)-N annually, while emissions from pig and poultry production amount to about 40 kt and 80 kt NH(3)-N, respectively.     

Distribution of fission products in dust samples from the region of Thessaloniki, Greece, after the Chernobyl nuclear accident

The distribution of the fission products (95)Zr, (95)Nb, (103)Ru, (106)Ru (determined through (106)Rh), (125)Sb, (129m)Te, (134)Cs, (137)Cs, (140)Ba, (140)La, (141)Ce and (144)Ce has been determined in dust samples from the region of Thessaloniki, Greece, after the nuclear accident at Chernobyl. The samples studied also included (110m)Ag, not belonging to the products of (235)U fission. Samples showing higher concentrations of radionuclides also show a higher content in clay minerals, whereas samples having low concentrations of radionuclides usually contain large amounts of quartz and feldspars. Desorption and leaching experiments using solutions of chlorides of sodium, potassium, calcium and magnesium (0.5 N), as well as distilled and tap water, were also performed. Sodium and potassium chloride solutions were found to be efficient in desorbing and/or leaching of caesium and ruthenium isotopes to an extent of about 30%.     

铬渣的热解无害化处理

采用热解工艺无害化处理铬渣,探讨了稻秆在铬渣无害化处理中的作用.研究了热解温度、稻秆与铬渣质量比、铬渣粒径及保温时间对铬渣热解无害化处理的影响,并分析了热解前后热解产物中铬元素形态的变化.结果表明,热解工艺能有效地将铬渣中Cr(Ⅵ)还原,稻秆热解过程中产生的气相挥发分对Cr(Ⅵ)的还原起核心作用.较为适宜的热解条件:热解温度为400 ℃,稻秆与铬渣质量比为0.10,铬渣粒径<2 000 μm,保温时间为10 min.在该热解条件处理下,热解产物中的Cr(Ⅵ)质量浓度为121 mg/kg,低于热解前铬渣中的Cr(Ⅵ)(3 400 mg/kg).热解后,可交换态及碳酸盐结合态铬含量降低,大部分铬转化成了稳定的有机结合态和残渣态,极大地降低了铬渣的危害.第一作者:张大磊,男,1982生,博士研究生,研究方向为固体废弃物热处理.     

Influence of ozone stress on growth processes, yields and grain quality characteristics among soybean cultivars

Field studies were conducted at USDA Beltsville Agricultural Research Center, Beltsville, Maryland, in 1984 and 1985 using open-top chambers to acquire information on the responses of 12 soybean (Glycine max L. Merr.) cultivars to O3 stress and to examine the interactions between maturity groups and O3 stress. Cultivars representing Groups III, IV, and V were exposed for approximately 3 months to charcoal-filtered air (CF) and nonfiltered air plus 40 nl litre(-1) O3 (NF + O3). Ozone was added 6 h d(-1), 5 d week(-1) for 13 weeks. The CF effectively reduced the accumulative oxidant exposure (AOX) to less than 1.0 microl litre(-1) h and the NF + O3 treatment approximately doubled the ambient AOX (16.7 microl litre(-1) h) to about 30 microl litre(-1) h. The AOX estimates the total O3 exposure above 30 nl litre(-1) during an entire growing season. Plant growth rates and relative growth rates were reduced by 17.0 and 14.4%, respectively, when averaged over cultivars. Based on growth rates, the Group III cultivars were the most affected by O3 stress. Averaged over cultivars, leaf expansion rates, leaf conductance, and transpiration rates were lower in the NF + O3 treatment compared to the CF control; however, wide variation was found with the stomatal results from field observations. Combined over years and cultivars, grain yield was reduced by an average of 12.5% by O3 stress with 3 of 12 cultivars showing significant reductions. Grain protein content was increased by 0.7% by O3 stress, but cultivar differences were equal to the differences caused by the O3 treatments. Grain oil content was unchanged by the O3 treatments. Group IV cultivars showed the greatest decrease in grain yield due to O3 stress. Multiple regression analyses were calculated using the difference between the CF and NF + O3 treatment as a measure of O3 stress. Significant positive relationships were found among net assimilation rates, plant growth rates, relative growth rates, and leaf expansion rates, which suggest that growth analysis characteristics would be useful in addition to yield in air pollution tolerance improvement studies with soybeans.     

Cadmium contamination in orchard soils and fruit trees and its potential health risk in Guangzhou, China

This study examines cadmium (Cd) contamination in orchard soils and fruit trees in Guangzhou, China, and assesses its potential health risk. Soils and tissues samples of three species of fruit trees were collected from three orchards. The average soil Cd concentration was 1.27, 1.84 and 0.68 mg/kg in orchards I, II, and III, respectively. The carambola (Averrhoa carambola) accumulated exceptionally high concentrations of Cd (7.57, 10.84, 9.01 and 2.15 mg/kg dw in root, twig, leaf and fruit, respectively), being 6.0-24 times and 4.0-10 times the corresponding tissue Cd in the longan (Dimocarpus longan) and wampee (Clausena lansium), respectively. Furthermore, all Cd concentrations (0.04-0.25 mg Cd/kg fw) of the fruits exceeded the tolerance limit of cadmium in foods of PR China (0.03 mg/kg fw). Our results indicate that the carambola tree has high Cd accumulation capacity and might be a Cd accumulator; and its fruit, among the three species of fruits studied, also poses the highest potential health risk to local residents.     

Heavy metal and Pb isotopic compositions of aquatic organisms in the Pearl River Estuary, South China

The accumulation of trace metals in aquatic organisms may lead to serious health problems through the food chain. The present research project aims to study the accumulation and potential sources of trace metals in aquatic organisms of the Pearl River Estuary (PRE). Four groups of aquatic organisms, including fish, crab, shrimp, and shellfish, were collected in the PRE for trace metal and Pb isotopic analyses. The trace metal concentrations in the aquatic organism samples ranged from 0.01 to 2.10 mg/kg Cd, 0.02 to 4.33 mg/kg Co, 0.08 to 4.27 mg/kg Cr, 0.15 to 77.8 mg/kg Cu, 0.17 to 31.0 mg/kg Ni, 0.04 to 30.7 mg/kg Pb, and 8.78 to 86.3 mg/kg Zn (wet weight). High concentrations of Cd were found in crab, shrimp and shellfish samples, while high concentration of Pb was found in fish. In comparison with the baseline reference values in other parts of the world, fish in the PRE had the highest elevated trace metals. The results of Pb isotopic compositions indicated that the bioaccumulation of Pb in fish come from a wide variety of food sources and/or exposure pathways, particularly the anthropogenic inputs.     

Uptake of weakly hydrophobic nitroaromatics from water by semipermeable membrane devices (SPMDs) and by goldfish (Carassius auratus)

Semipermeable membrane devices (SPMDs) filled with triolein, and goldfish (Carassius auratus) were simultaneously exposed to nine weakly hydrophobic nitroaromatics in a laboratory continuous-flow experiment. The results showed that the device concentrated the compounds in most cases to a larger extent than fish and that the overall uptake rate constants (Kmu) and average pollutant sampling rates (R(S)) were similar. We conclude that the SPMDs may be used to determine the levels of weakly hydrophobic nitroaromatics in water. It is obvious, however, that more researches at laboratory in order to establish kinetic database for a wide spectrum of compounds varying in lipophilicity and other properties are needed to elucidate various theoretical and practical aspects of the use of membranes in the environmental research and for related practical applications.     

Higher pH and faster decomposition in biowaste composting by increased aeration

Composting of source separated municipal biowaste has at several plants in Scandinavia been hampered by low pH. In this study the hypothesis that increased aeration would improve the process was tested in full-scale experiments at two large composting plants. The O2 concentrations were high (>15%) even at the low aeration rates, so the prevailing low pH was not due to an anaerobic process environment. In spite of this, increased aeration rates at the start of the process resulted in higher microbial activity, increased pH and a more stable compost product. At one plant the decomposition rate varied in proportion to the aeration rate, to the extent that the temperatures and O2 concentrations were similar during the early processes even though aeration rates varied between 10 and 50 m3/(h, m3 compost). However, increased aeration caused severe drying of the compost, but at one plant the addition of water was adequate to prevent drying. In conclusion, by increasing the aeration rates and adding water to compensate for drying, it was possible to shorten the time needed to produce a stable compost product and thus to increase the efficiency of the composting plants.     

Improvements of nano-SiO2 on sludge/fly ash mortar

Sewage sludge ash has been widely applied to cementitious materials. In this study, in order to determine effects of nano-SiO(2) additives on properties of sludge/fly ash mortar, different amounts of nano-SiO(2) were added to sludge/fly ash mortar specimens to investigate their physical properties and micro-structures. A water-binding ratio of 0.7 was assigned to the mix. Substitution amounts of 0%, 10%, 20%, and 30% of sludge/fly ash (1:1 ratio) were proposed. Moreover, 0%, 1%, 2%, and 3% of nano-SiO(2) was added to the mix. Tests, including SEM and compressive strength, were carried out on mortar specimens cured at 3, 7, and 28 days. Results showed that sludge/fly ash can make the crystals of cement hydration product finer. Moreover, crystals increased after nano-SiO(2) was added. Hence, nano-SiO(2) can improve the effects of sludge/fly ash on the hydration of mortar. Further, due to the low pozzolanic reaction active index of sludge ash, early compressive strengths of sludge/fly ash mortar were decreased. Yet, nano-SiO(2) could help produce hydration crystals, which implies that the addition of nano-SiO(2) to mortar can improve the influence of sludge/fly ash on the development of the early strength of the mortar.