Mg/Al/Fe型类水滑石焙烧产物吸附去除水中硫酸根离子

通过共沉淀法制备了Mg/AUFe型类水滑石(MgAlFe-HTLCs)并在500℃下焙烧得焙烧产物(HTLCs-500),利用HTLCs-500吸附去除水中的硫酸根离子,并用X射线衍射对MgAlFe-HTLCs及HTLCs-500吸附硫酸根离子前后的结构进行了表征,研究了环境中其他因素对HTLCs-500吸附硫酸根离子的影响.结果表明,实验数据对准二级动力学模型的拟合结果最好;吸附过程符合Langmuir吸附等温模型,通过实验得到HTLCs-500对硫酸根离子的最大吸附量为157.73 mg/g,和Langmuir等温线得到的理论最大吸附量161.29 mg/g相差不大,对硫酸根离子具有良好的吸附性能;硫酸根溶液的初始pH值对HTLCs-500吸附硫酸根离子的性能影响不大,最佳pH值为3;X射线衍射结果表明,HTLCs-500吸附去除硫酸根离子的机理之一为HTLCs-500通过吸附硫酸根离子来恢复层状结构.     

Mn的氧化价态对Mn/γ-Al2O3催化剂催化臭氧氧化气相低浓度甲苯的影响

采用共沉淀法,以Al₂O₃为载体制备Mn/γ-Al₂O₃和Mn-Ce/γ-Al₂O₃催化剂,并分别在N₂气氛和O₂气氛下焙烧。采用固定床连续流动反应器,研究所制备催化剂在室温条件下催化臭氧氧化甲苯的性能。通过XRD、XPS和FTIR等手段对催化剂的结构和组成进行表征。结果表明,Mn/γ-Al₂O₃催化剂具有良好的催化臭氧氧化甲苯和催化臭氧自身分解的性能,共沉淀法制备催化剂的最佳Mn负载量为20%。O₂气氛焙烧和Ce的加入,可以有效提高催化剂的活性和寿命。原因是O₂气氛焙烧和Ce的加入可以提高Mn的氧化价态。催化剂失活的主要原因是有机副产物在催化剂表面吸附堆积,失活催化剂在550℃、空气气氛下焙烧可恢复催化性能。     

Novel pilot-scale washing process and equipment for removing Cr(VI) from contaminated soil

In this study, a novel horizontal rotating soil washing process and equipment were developed and tested for pilot-scale remediation of soils from a site polluted by chromium ore process residue. Operating parameters, including cylinder rotational velocity, cylinder tilt angle, heating temperature and liquid/soil ratio, were investigated. The Taguchi method was used for the experiment design, and the standard L16 orthogonal array with four parameters and four levels was selected for optimising the operating parameters. Optimal removal efficiency was achieved at cylinder rotational velocity of 2.5 rpm, cylinder tilt angle of 2.6°, heating temperature of 200 °C and liquid/soil ratio of 8. The efficiency of citric acid as an extractant in the novel process was compared with that of water. The analysis of the residual Cr(VI) concentration of the soil shows that citric acid could efficiently remove 22.89 % more Cr(VI) than water in one-stage washing. The residual Cr(VI) concentration in the soil after the three-stage washing is as low as 26.16 mg/kg, which meets the screening levels for soil environmental risk assessment of sites in Beijing City (30 mg/kg). Further study is currently underway to optimise the novel process and equipment for commercial-scale use.     

Preparation of regenerated keratin sponge from waste feathers by a simple method and its potential use for oil adsorption

In this work, pigeon feathers, a kind of totally waste by-product from the poultry industry, were utilized to fabricate a highly porous keratin sponge in a very simple way by freeze-drying treatment of the dissolved keratin solution, and applied for the first time as an oil adsorbent. An improved method was proposed to dissolve the feather keratin using the inexpensive sodium disulfite as the reducing reagent for sulfitolysis reaction, with a much lower concentration of all involving reaction regents. Moreover, the regenerated keratin sponges obtained a high oil adsorption capacity of above 30 g/g for both liquid paraffin and soybean oil, as well as a good oil holding ability, suggesting that this keratin sponge might be a potential for use as oil adsorbent.     

Mechanisms of chromium and arsenite adsorption by amino-functionalized SBA-15

The adsorption of Cr(VI) and As(III) by amino-functionalized SBA-15 (NH₂-SBA-15) from single and binary systems were investigated in this work. The effects of pH and temperature on the adsorption of NH₂-SBA-15 were studied. Adsorption kinetics, isotherm model, and thermodynamics were studied to analyze the experimental data. pH 2 was the optimum condition for the adsorption of Cr(VI) and pH 4 for As(III) adsorption. Increasing temperature had a positive effect on the removal of both Cr(VI) and As(III). The Freundlich isotherm model can depict the adsorption process best. The pseudo-second-order kinetic model fitted well with the kinetic data of Cr(VI) and As(III) in the single-component system. In the binary system, the adsorption of As(III) by NH₂-SBA-15 was slightly enhanced with the presence of Cr(VI); however, As(III) had no obvious effect on the removal of Cr(VI). Regeneration experiments indicated that 0.1 mol/L NaHCO₃ was an efficient desorbent for the recovery of Cr(VI) and As(III) from NH₂-SBA-15; the desorption rates for Cr(VI) and As(III) were 91.6 and 33.59 %, respectively. After five recycling cycles, the removal rates were 88 and 7 % for Cr(VI) and As(III) adsorption by NH₂-SBA-15, respectively.     

基于层次分析法的坦塘垃圾填埋场适宜性评价

垃圾填埋场场址的适宜性评价是生活垃圾填埋场建设和运营的前提和基础。以湖南省永州市坦塘垃圾填埋场为例,在分析研究区的地质与水文地质条件的基础上,确定了填埋场适宜性的影响因素为填埋场规模、运输条件、环境条件、建场条件和地质条件,具体包括填埋场面积及容量、综合路况条件、对地表水体污染的可能性、地形平坦程度以及场地是否处在岩溶区等条件,明确了局部地区岩溶发育是制约其适宜性的主要因素。结合垃圾填埋场的建设情况和相关规范、标准,采用层次分析法对坦塘垃圾填埋场进行适宜性评价。评价结果表明,坦塘垃圾填埋场是一个适宜场地,评价结果与实际情况相符。     

Mechanistic and kinetic study on the ozonolysis of n-butyl vinyl ether, i-butyl vinyl ether and t-butyl vinyl ether

Density functional theory (DFT) and ab initio method are employed to elucidate the mechanisms for O(3)-initiated oxidation of n-butyl vinyl ether (n-BVE) and its isomers (i-BVE and t-BVE). For each BVE, the reactions proceed via O(3) cycloaddition resulting in the formation of primary ozonides (POZs) and then two self-decomposition pathways of POZs are followed. Major products are identified to be formaldehyde and butyl formates (CH(3)CH(2)CH(2)CH(2)OCHO for n-BVE, (CH(3))(2)CHCH(2)OCHO for i-BVE and (CH(3))(3)COCHO for t-BVE). The total and individual rate constants for main product channels have been calculated using the modified multichannel Rice-Ramsperger-Kassel-Marcus (RRKM) approach. At 298 K and 101 kPa, the calculated total rate constants are 2.50×10(-16), 3.41×10(-16) and 4.17×10(-16) cm(3) molecule(-1) s(-1) for n-BVE+O(3), i-BVE+O(3) and t-BVE+O(3), respectively, which are in perfect agreement with experimental results. The total rate coefficients are almost pressure independent in the range of 0.001-101 kPa but obviously positive temperature dependent over the whole study temperature range (200-400 K). Also, the favorable reaction pathways have been determined through the estimation of branching ratios. Moreover, the influence of alkoxy group structure on the reactivity of vinyl ethers was examined.     

Effects of phosphorus amendments and plant growth on the mobility of Pb, Cu, and Zn in a multi-metal-contaminated soil

Purpose

Phosphorus amendments have been widely and successfully used in immobilization of one single metal (e.g., Pb) in contaminated soils. However, application of P amendments in the immobilization of multiple metals and particularly investigations about the effects of planting on the stability of the initially P-induced immobilized metals in the contaminated soils are far limited.

Methods

This study was conducted to determine the effects of phosphate rock tailing (PR), triple superphosphate fertilizer (TSP), and their combination (P+T) on mobility of Pb, Cu, and Zn in a multimetal-contaminated soil. Chinese cabbage (Brassica rapa subsp. chinensis) (metal-sensitive) and Chinese kale (Brassica alboglabra Bailey) (metal-resistant) were introduced to examine the effects of planting on leaching of Pb, Cu, and Zn in the P-amended soils.

Results

All three P treatments greatly reduced CaCl₂-extractable Pb and Zn by 55.2?C73.1% and 14.3?C33.6%, respectively. The PR treatment decreased CaCl₂-extractable Cu by 27.8%, while the TSP and P+T treatments increased it by 47.2% and 44.4%, respectively. All three P treatments were effective in reducing simulated rainwater leachable Pb, with dissolved and total leachable Pb decrease by 15.6?C81.9% and 16.3?C64.5%, respectively. The PR treatment reduced the total leachable Zn by 16.8%, while TSP and P+T treatments increased Zn leaching by 92.7% and 78.9%, respectively. However, total Cu leaching were elevated by 17.8?C178% in all P treatments. Planting promoted the leaching of Pb and Cu by 98.7?C127% and 23.5?C170%, respectively, especially in the colloid fraction, whereas the leachable Zn was reduced by 95.3?C96.5% due to planting. The P treatments reduced the uptake of Pb, Cu, and Zn in the aboveground parts of Chinese cabbage by up to 65.1%, 34.3%, and 9.59%, respectively. Though P treatments were effective in reducing Zn concentrations in the aboveground parts of the metal-resistant Chinese kale by 22.4?C28.9%, they had little effect on Pb and Cu uptake.

Conclusions

The results indicated that all P treatments were effective in immobilizing Pb. The effect on the immobilization of Cu and Zn varied with the different P treatments and evaluation methods. Metal-sensitive plants are more responsive to the P treatments than metal-resistant plants. Planting affects leaching of metals in the P-amended soils, specially leaching of colloid fraction. The conventional assessment on leaching risks of heavy metals by determining dissolved metals (filtered through 0.45-??m pore size membrane) in leachates could be underestimated since colloid fraction may also contribute to the leaching.     

基于工作过程的高职“教学做一体化”课程探究

“教学做一体化”课程有利于理论教学与实践教学相结合,有利于高职学校长期健康的发展。“教学做一体化”教学模式是基于实际工作过程导向,以工作中典型项目任务引领,激发学生兴趣,以满足培养高等技能型人才的迫切需要。一体化课程的构建应通过项目设立、建立小组、实施、反馈等环节完成。