Accumulation of metals in the soil of an overland flow wastewater treatment system

Accumulation of Co, Cu, Cr, Mo, Ni, Pb and Zn was evaluated in a soil profile of an overland flow system used for the post-treatment of urban wastewater. A pilot version of the overland flow system received urban wastewater from five up-flow anaerobic filters filled with bamboo (Bambusa tuldoides) rings. The anaerobic effluent was applied as feed over 18 months at rates varying from 7 to 28 L min(-1), to a vegetated slope length covered with Tifton 85 (Cynodon) sp. grass. Soil and plant samples were collected in triplicate from the top to the bottom of the slope. In addition, the soils were sampled at the depths 0-20 and 20-40 cm. The metal concentrations found in the overall system were compared to those obtained in a control area located at the beginning of the slope onto which nothing was applied. A month of monitoring the urban wastewater of Limeira City (S?o Paulo State, Brazil) showed a drastic change in metals concentration due to the irregular discharge of industrial waste. This irregular discharge introduces Cr, Cu, Ni, Pb and Zn into the system used to treat domestic wastewater. The mass balance indicates the accumulation of metals in the soil and the translocation to the plants; also that they could be evapotranspirated, percolated and discharged.     

Preliminary air pollution monitoring in San Miguel, Buenos Aires

Passive diffusion samplers were employed in San Miguel(Buenos Aires Metropolitan Area) for a preliminary airpollution monitoring. The highest loads were observedin downtown, compared with an urban background site.Total suspended particulate matter (TSPM) varied from0.257 to 0.033 mg cm^-2 month^-1; dust was examinedfor particle nature and size distribution. A similartrend was observed for nitrogen dioxide (NO₂) andTSPM spatial distribution, suggesting that traffic isthe major pollution source. Sulphur dioxide (SO₂)values were low and rather homogeneous. Levels for theinvestigated pollutants are below EPA's guide linevalues. Geographic (flat area, near to Rio de LaPlata) and climatologic factors (rainfalls andvariable wind directions) contribute to disperse pollutants.     

Seasonal characteristics of haze observed by continuous visibility monitoring in the urban atmosphere of Kwangju, Korea

Continuous visibility monitoring has been carried out inKwangju, Korea since May 1999. The total light extinctioncoefficient b _ext measured by a transmissometer andreveals seasonal trends in urban visual air quality,especially under hazy conditions with a visual range of lessthan 15 km. Seasonal atmospheric visibility under lowrelative humidity during the winter was observed to be betterthan during any other seasons. Summertime visibility wasseverely degraded due to highly increased light scattering byhygroscopic particles under high humidity atmosphericconditions. Visibility during spring and fall was alsomoderate. However, yellow sand in spring caused the lowestvisibility conditions over the measurement area for a fewdays. With continuous monitoring using the transmissometer,the daily average seasonal visual range was measured to be13.1, 9.2, 11.0, and 13.9 km in spring, summer, falland winter, respectively. Under the atmospheric humiditycondition less than 60%, visual range was observed tobe 16.1, 13.9, 15.1, and 16.6 km in spring, summer,fall, and winter, respectively. The mean light extinctionbudget by sulfate and nitrate aerosols was determined to bethe highest value of 63.71% during the summer and thelowest value of 27.08% during spring. During the `yellow sand dust' period, a mean light extinction budget by soil particles was estimated to be at an unusually high value of 44.22%.     

Application of intrawell testing of RCRA groundwater monitoring data when no upgradient well exists

A statistical quality control approachto detect changes in groundwater quality from aregulated waste unit is described. The approachapplies the combined Shewhart-CUSUM control chartmethodology for intrawell comparison of analyteconcentrations over time and does not require anupgradient well. A case study from the U.S.Department of Energy's Hanford Site is used forillustration purposes. This method is broadlyapplicable in groundwater monitoring programs wherethere is no clearly defined upgradient location, thegroundwater flow rate is exceptionally slow, or wherea high degree of spatial variability exists inparameter concentrations. This study also indicatesthat the use of the Data Quality Objectives (DQO)process can assist in designing an efficient andcost-effective groundwater monitoring plan to achievethe optimum goal of both low false positive and lowfalse negative rates (high power).     

An Evaluation of Selenium Concentrations in Water, Sediment, Invertebrates, and Fish from the Republican River Basin: 1997–1999

The Republican River Basin of Colorado,Nebraska, and Kansas lies in a valley which contains PierreShale as part of its geological substrata. Selenium is anindigenous constituent in the shale and is readily leached intosurrounding groundwater. The Basin is heavily irrigated throughthe pumping of groundwater, some of which is selenium-contaminated, onto fields in agricultural production. Water,sediment, benthic invertebrates, and/or fish were collected from46 sites in the Basin and were analyzed for selenium to determinethe potential for food-chain bioaccumulation, dietary toxicity,and reproductive effects of selenium in biota. Resultingselenium concentrations were compared to published guidelines orbiological effects thresholds. Water from 38% of the sites (n = 18) contained selenium concentrations exceeding 5 g L^-1, which is reported to be a high hazard for selenium accumulation into the planktonic food chain. An additional 12 sites (26% of the sites) contained selenium in water between 3–5 g L^-1, constituting a moderate hazard. Selenium concentrations in sedimentindicated little to no hazard for selenium accumulation fromsediments into the benthic food chain. Ninety-five percent ofbenthic invertebrates collected exhibited selenium concentrationsexceeding 3 g g^-1, a level reported as potentially lethal to fish and birds that consume them. Seventy-five percent of fish collected in 1997, 90% in 1998, and 64% in 1999 exceeded 4 g g^-1selenium, indicating a high potential for toxicity andreproductive effects. However, examination of weight profilesof various species of collected individual fish suggestedsuccessful recruitment in spite of selenium concentrations thatexceeded published biological effects thresholds for health andreproductive success. This finding suggested that universalapplication of published guidelines for selenium may beinappropriate or at least may need refinement for systems similarto the Republican River Basin. Additional research is needed todetermine the true impact of selenium on fish and wildliferesources in the Basin.     

The extraction of aged polycyclic aromatic hydrocarbon (PAH) residues from a clay soil using sonication and a Soxhlet procedure: a comparative study

A sonication method was compared with Soxhlet extraction for recovering polycyclic aromatic hydrocarbons (PAH) from a clay soil that had been contaminated with tar materials for several decades. Using sonication over an 8 h extraction period, maximum extraction of the 16 US EPA priority PAH was obtained with dichloromethane (DCM)-acetone (1 + 1). The same procedure using hexane-acetone (1 + 1) recovered 86% of that obtained using DCM-acetone (1 + 1). PAH recovery was dependent on time of extraction up to a period of 8 h. The sonication procedure showed that individual PAH are extracted at differing rates depending on the number of fused rings in the molecule. Soxhlet extraction [with DCM-acetone (1 + 1)] over an 8 h period recovered 95% of the PAH removed by the sonication procedure using DCM-acetone (1 + 1), indicating that rigorous sonication can achieve PAH recoveries similar to those obtained by Soxhlet extraction. The lower recovery with the Soxhlet extraction was explained by the observed losses of the volatile PAH components after 1-4 h of extraction. The type of solvent used, the length of time of extraction and extraction method influenced the quantification of PAH in the soil. Therefore, the study has implications for PAH analyses in soils and sediments, and particularly for contaminated site assessments where the data from commercial laboratories are being used. The study emphasizes the importance of establishing (and being consistent in the application of) a vigorous extraction, particularly for commercial laboratories that handle samples of soil in batches (at different times) from a single site investigation or remediation process. The strong binding of PAH to soil, forming aged residues, has significant implications for extraction efficiency. This paper illustrates the problem of the underestimation of PAH using the US EPA method 3550, specifically where a surrogate spike is routinely employed and the efficiency of the extraction procedure for aged residues is unknown. The implications of this study for environmental monitoring, particularly where numerous batches of samples from a single site assessment or remediation program are submitted to commercial laboratories, is that it would be advisable for these laboratories to check their existing method's extraction efficiencies by conducting a time course sonication extraction on their particular soil to determine the optimum extraction time.     

Soil Lead and Other Metal Levels in Industrial, Residential and Nature Reserve Areas in Singapore

The use of pressure feedback microwave digestion technique has permitted rapid and efficient digestion of soil and sediment samples. The evaluation of different acid mixtures to digest soil samples were studied by mixed-level orthogonal array design. The selected acid mixture of HCl-HNO3-HF was employed in the survey of Pb, Zn, Cu, Cr and Mn in soil samples. Surface soil samples were collected from industrial, residential and nature reserve areas in Singapore. The five metal concentrations were determined by flame atomic absorption spectrometry and graphite furnace atomic absorption spectrometry. The lead and other metal contents in NBS SRM 1645, NIES CRM No. 2 and NRCC BCSS-1 sediment standard references were determined concurrently with the survey samples. Five measured metal loading on the surface soils was in the order: industrial area > residential area > nature reserve area. The trace metal concentrations in surface soil from areas of heavy traffic are higher than those from residential areas. The main sources of trace metal pollution are vehicular exhaust and industrial activities.     

Study of the relationships between bone lead levels and its variation with time and the cumulative blood lead index, in a repeated bone lead survey

The study aims were to: (i) investigate long term human lead metabolism by measuring the change of lead concentration in the tibia and calcaneus; and (ii) assess whether improved industrial hygiene was resulting in a slow accumulation of lead in an exposed workforce. 109Cd excited K X-ray fluorescence was used to measure tibia lead and calcaneus lead concentrations in 101 workers in a secondary lead smelter. 51 subjects had had similar bone lead measurements 5 years previously. Most of the other subjects had been hired since the first survey. Measurements of whole blood lead were available for the large majority of subjects. Tibia lead concentrations fell significantly (p<0.001) in the 51 subjects with repeated bone lead measurements, from a mean of 39 microg Pb (g bone mineral)(-1) to 33 microg Pb (g bone mineral)(-1). The change correlated negatively with the initial tibia lead concentration, producing an estimate for an overall half-life of 15 years, with a 95% confidence interval of 9 to 55 years. Adding continuing lead exposure and recirculation of bone lead stores to the regression models produced half-life estimates of 12 and 9 years, respectively, for release of lead from the tibia. The repeat subjects showed no net change in calcaneus lead (64 microg Pb (g bone mineral)(-1) initially, 65 microg Pb (g bone mineral)(-1) 5 years later). Subjects not measured previously had average lead concentrations of 15 microg Pb (g bone mincral)(-1) in the tibia and 13 microg Pb (g bone mineral)(-1) in the calcaneus. The rate of clearance of lead from the tibia (9 to 15 years) is towards the more rapid end of previous estimates. The lack of a significant fall in the calcaneus lead was surprising. Attempts should be made to repeat this observation. If confirmed, it would have implications for models of lead metabolism. The relatively low lead concentrations in the non-repeat subjects are reassuring. However, observation after a longer period of employment would be desirable.     

Adsorption characteristics of a phenoxy acetic acid herbicide on activated carbon

The adsorption of 2,4-dichlorophenoxyacetic acid (2,4-D) by two powdered coal activated carbons was studied in aqueous solution. The modelling of the adsorption equilibrium showed that the adsorption of 2,4-D fitted a Langmuir isotherm. Adsorption was influenced by the activated carbon type, adsorbent concentration and solution characteristics. The adsorption was found to decrease with an increase in pH over the range 1.5-9. Maximum adsorption occurred at pH approximately 2.5, which corresponds to the 2,4-D pKa value. The amount of 2,4-D adsorbed was also found to depend on the NaCl concentration.     

Performance evaluation of a sorbent tube sampling method using short path thermal desorption for volatile organic compounds

Air sampling, using sorbents, thermal desorption and gas chromatography, is a versatile method for identifying and quantifying trace levels of volatile organic compounds (VOCs). Thermal desorption can provide high sensitivity, appropropriate choices of sorbents and method parameters can accommodate a wide range of compounds and high humidity, and automated short-path systems can minimize artifacts, losses and carry-over effects. This study evaluates the performance of a short-path thermal desorption method for 77 VOCs using laboratory and field tests and a dual sorbent system (Tenax GR, Carbosieve SIII). Laboratory tests showed that the method requirements for ambient air sampling were easily achieved for most compounds, e.g., using the average and standard deviation across target compounds, blank emissions were < or = 0.3 ng per sorbent tube for all target compounds except benzene, toluene and phenol; the method detection limit was 0.05 +/- 0.08 ppb, reproducibility was 12 +/- 6%, linearity, as the relative standard deviation of relative response factors, was 16 +/- 9%, desorption efficiency was 99 +/- 28%, samples stored for 1-6 weeks had recoveries of 87 +/- 9%, and high humidity samples had recoveries of 102 +/- 12%. Due to sorbent, column and detector characteristics, performance was somewhat poorer for phenol groups, ketones, and nitrogen containing compounds. The laboratory results were confirmed in an analysis of replicate samples collected in two field studies that sampled ambient air along roadways and indoor air in a large office building. Replicates collected under field conditions demonstrated good agreement except for very low concentrations or large (> 41 volume) samples of high humidity air. Overall, the method provides excellent performance and satisfactory throughput for many applications.