An Inexpensive Dual-Chamber Particle Monitor: Laboratory Characterization

Abstract

In developing countries, high levels of particle pollution from the use of coal and biomass fuels for household cooking and heating are a major cause of ill health and premature mortality. The cost and complexity of existing monitoring equipment, combined with the need to sample many locations, make routine quantification of household particle pollution levels difficult. Recent advances in technology, however, have enabled the development of a small, portable, data-logging particle monitor modified from commercial smoke alarm technology that can meet the needs of surveys in the developing world at reasonable cost. Laboratory comparisons of a prototype particle monitor developed at the University of California at Berkeley (UCB) with gravi-metric filters, a tapered element oscillating microbalance, and a TSI DustTrak to quantify the UCB particle monitor response as a function of both concentration and particle size and to examine sensor response in relation to changes in temperature, relative humidity, and elevation are presented here. UCB particle monitors showed good linearity in response to different concentrations of laboratory-generated oleic acid aerosols with a coarse (mass median diameter, 2.1 µm) and fine (mass median diameter, 0.27–0.42 µm) size distributions (average r² = 0.997 ± 0.005). The photoelectric and ionization chamber showed a wide range of responses based on particle size and, thus, require calibration with the aerosol of interest. The ionization chamber was five times more sensitive to fine rather than coarse particles, whereas the photoelectric chamber was five times more sensitive to coarse than fine. The ratio of the response between the two sensors has the potential for mass calibration of individual data points based on estimated parameters of the size distribution. The results demonstrate the significant potential of this monitor, which will facilitate the evaluation of interventions (improved fuels, stoves, and ventilation) on indoor air pollution levels and research on the impacts of indoor particle levels on health in developing countries.     

Indoor Ozone Exposures

Indoor and outdoor ozone concentrations were measured from late May through October at three office buildings with very different ventilation rates. The indoor values closely tracked the outdoor values, and, depending on the ventilation rate, were 20 to 80 percent of those outdoors. The Indoor/outdoor data are adequately described with a mass balance model. The model can also be coupled with reported air exchange rates to estimate indoor/outdoor ratios for other structures. The results from this and previous studies indicate that Indoor concentrations are frequently a significant fraction of outdoor values. These observations, and the fact that most people spend greater than 90 percent of their time indoors, indicate that indoor ozone exposure (concentration × time) is greater than outdoor exposure for many people. Relatively Inexpensive strategies exist to reduce indoor ozone levels, and these could be implemented to reduce the public’s total ozone exposure.     

A field study on residues of four insecticides used in strawberry protection

Abstract

In 1986 strawberry plots were treated with dimethoate, malathion, permethrin and cypermethrin at 80% bloom of primary flowers. In 1987 the plots were sprayed with dimethoate, malathion and permethrin at 30% bloom. Residue analysis of these insecticides on the flowers were analyzed using solvent extraction and gas liquid chromatography. Residue analysis at 0 to 18 days on flowers and fruit showed an exponential decrease. Organophosphates tended to degrade more quickly than synthetic pyrethroids. The results are discussed in the context of an integrated pest management program.     

Low Concentration Mercury Sorption Mechanisms and Control by Calcium-Based Sorbents: Application in Coal-Fired Processes

ABSTRACT

The capture of elemental mercury (Hg⁰) and mercuric chloride (HgCl₂) by three types of calcium (Ca)-based sor-bents was examined in this bench-scale study under conditions prevalent in coal-fired utilities. Ca-based sorbent performances were compared with that of an activated carbon. Hg⁰ capture of about 40% (nearly half that of the activated carbon) was achieved by two of the Ca-based sorbents. The presence of sulfur dioxide (SO₂) in the simulated coal combustion flue gas enhanced the Hg⁰ capture from about 10 to 40%. Increasing the temperature in the range of 65-100 °C also caused an increase in the Hg⁰ capture by the two Ca-based sorbents. Mercuric chloride (HgCl₂) capture exhibited a totally different pattern. The presence of SO₂ inhibited the HgCl₂ capture by Ca-based sorbents from about 25 to less than 10%. Increasing the temperature in the studied range also caused a decrease in HgCl₂ capture. Upon further pilot-scale confirmations, the results obtained in this bench-scale study can be used to design and manufacture more cost-effective mercury sorbents to replace conventional sorbents already in use in mercury control.     

Comparative Study of Spray Booth Filter System Efficiency

ABSTRACT

During recent years, greater emphasis has been placed on the control of particulate emissions from painting operations. This has gained more importance as more is learned about the potential release of toxic metals to the atmosphere from painting operations. This has led to queries about the efficiency of various painting arrestor systems to reduce particulate discharges to the atmosphere. Even more important is the capability of the arrestor systems to control PM₁₀ emissions.

In 1995, the U.S. Environmental Protection Agency initiated a study to evaluate various dry paint overspray arrestor systems. This study was designed to evaluate not only the total emissions control capability of the arrestor but also the PM₁₀ control capability of the various system designs. Paint overspray arrestor systems using five different filtration concepts or materials were selected. They include systems constructed of fiberglass, paper, Styrofoam, and cardboard materials. These systems used filtration techniques incorporating the following filtration phenomena and designs: cyclone, baffle, bag systems, and mesh systems.

The testing used an optical particle counting procedure to determine the concentration of particles of a given size fraction to penetrate a test arrestor system. The results of the testing indicated that there are significant differences in the efficiency of the tested system designs to capture and retain PM₁₀.

This paper summarizes the results of the research conducted to determine the capability of the arrestor systems to capture particulate of sizes down to approximately 1 μm in surface diameter.     

A Method of Predicting Point and Path- Averaged Ambient Air VOC Concentrations,Using Meteorological Data

A method of predicting point and path-averaged ambient air VOC concentrations is described. This method was developed for the case of a plume generated from a single point source, and is based on the relationship between wind directional frequency and concentration. One-minute means of wind direction and wind speed were used as inputs to a Gaussian dispersion model to develop this relationship.

Both FTIR spectrometry and a whole-air sampling method were used to monitor VOC plumes during simulated field tests. One test set was also conducted using only whole-air samplers deployed in a closely-spaced network, thus providing an evaluation of the prediction technique free of any bias that might exist between the two analytical methods.

Correlations between observed point concentrations and wind directional frequencies were significant at the 0.05 level in most cases. Predicted path-integrated concentrations, based on observed point concentrations and meteorological data, were strongly correlated with observed values. Predicted point concentrations, based on observed path-integrated concentrations and meteorological data, accurately reflected the location and magnitude of the highest concentrations from each test, as well as the shape of the concentration-versus-crosswind distance curve.     

Bryophyte responses to microclimatic edge effects across riparian buffers.

Although riparian buffers are an important aspect of forest management in the boreal forest of Canada, little is known about the habitat conditions within buffers, due in part to complex edge effects in response to both the upland clearcut and the stream. We investigated microclimatic conditions and bryophyte growth and vitality in seven locations between the stream edge and 60 m into the upland undisturbed conifer forests and at the clearcut sites with riparian buffer 30 km northwest of Thunder Bay, Ontario, Canada. We hypothesized that the growth and vitality of a pleurocarpous moss, Hylocomium splendens, and an acrocarpous moss, Polytrichum commune, would be directly related to the microclimatic gradients detected. We further hypothesized that sensitivity of the bryophytes to environmental factors will vary depending on their life form type, i.e., pleurocarpous moss will respond differently than the acrocarpous moss. Both bryophyte species were transplanted in pots and placed at 10-m intervals along 60-m transects perpendicular to the stream across the buffer and undisturbed sites. Bryophyte growth, cover, and vitality, as well as microclimatic parameters and plant cover, were measured over the summer in 2003. The riparian buffers were simultaneously affected by microclimatic gradients extending from both the clearcut edge and the riparian-upland ecotonal edge. Both bryophyte species responded to changes in the microclimatic conditions. However, vapor pressure deficit (VPD) was the most important factor influencing the growth of H. splendens, whereas for P. commune growth soil moisture was most important. Our study confirms earlier findings that interior forest bryophytes such as H. splendens can be used as indicators to monitor edge effects and biodiversity recovery following forest harvesting. We demonstrate that growth and vitality of these bryophytes reflect the prevailing near-ground microclimatic conditions at the forest edges. Abundance estimates of such bryophytes can be used to determine the depth of edge effects across both ecotonal edges (e.g., riparian-upland forest edge) and anthropogenically created edges (e.g., clearcut edge). Forest management practices must consider depth of edge in determining the appropriate width of riparian buffers that would be necessary to sustain biodiversity and associated values at the land/water interface.     

Freshwater lakes--a potential source for aquaculture activities--a model study on Perumal Lake, Cuddalore, Tamil Nadu

The freshwater Perumal lake located at Cuddalore was assessed for its suitability and potential for aquaculture practices. Various hydrobiological parameters determined reveals that the various physicochemical characteristics are with in normal range of values. The DO level, BOD and COD values determined in the lake revealed the consequences of community activities and pollution possibilities. The primary productivity data revealed maximum productivity during March which infer that the lake is unaffected by anthropogenic disturbance and community contamination. The bacterial count remained higher during the monsoon periods, which characterize profuse rainfall and storm water discharge into the lake. The microfauna includes zooplankter such as cladocerans, copepods, rotifers and ostracods. Benthos include carps, catfishes, mullets and prawns. The above study revealed that the various parameters in the lake conform to the levels suited for freshwater fish culture and represents a resource for scientific management.