The Removal of Particulate Matter from Fluid Bed Catalytic Cracking Unit Stack Gases

The application of a high-efficiency centrifugal type of separator to fluid bed catalytic cracking units is described in which most of the catalyst particles often lost to the atmosphere are concentrated into a small part of the stack gas (2%). A further separation can then be made on this small stream by an auxiliary separator which further concentrates the catalyst particle into 0.1% of the initia stream. Performance of the main and auxiliary separators are such as to reduce the loss of catalyst particles in the stack gas from 800 ppm to less than 60 ppm in a typical unit. Large amounts of power can be recovered by application of expander turbines to catalytic cracking plants employing this system of separation.     

On the Relation Between the Indoor and Outdoor Concentrations of Nitrogen Oxides

Simultaneous measurements were made of the concentrations of NO, NO₂, and CO inside and outside of a building. The building is located in the Los Angeles area, which is heavily polluted by photochemical smog, and the experiments were conducted at a time of the year when the pollutants in question tend to be high. The results shows that there is a direct relationship between the inside and outside concentrations, and that the phase lag between the concentrations depends principally on the ratio of the building volume to the ventilation rate. Although the outside concentrations of the pollutants in question did not follow the same pattern every day, peak concentrations seemed to be related to “rush-hour” traffic. By reducing ventilation rates during these periods, it may be possible to reduce the concentration peaks inside of the building. The building involved in the current study was not located in the immediate vicinity of heavy traffic, and the indoor concentrations of NO, NO₂, and CO did not appear to be very severe when compared to those defined by present air quality standards. Finally, the results support the belief that NO and O₃ do not co-exist indoors except in very small quantities.     

A Rating of the Major Air Pollutants and Their Sources by Effect

The available national annual air pollution emissions are based on mass. Different air pollutants have greatly different toxicities per unit mass, hence the emissions should be rated by effect, not by mass, so that more sensible priorities can be set in control research and regulation. Effect factors are derived from the health effect literature indirectly by using the national ambient air quality standards. The resulting analysis by effects shows transportation to be still the largest source as it is in the mass analysis while hydrocarbons become the largest pollutants by effect compared to carbon monoxide being the largest pollutant by mass.     

National Air Quality Standards for Automotive Pollutants – A Critical Review

The recently promulgated national air quality standards for carbon monoxide, nitrogen dioxide, hydrocarbons, and photochemical oxidant are critically reviewed.This review indicates that the standards are more restrictive than can be supported by available data.     

A Portable,Battery-Operated,Immediate-Readout Dust-Particle Analyzer

A portable, battery-operated, electro-optical dust analyzer operating on the principle of light scattering from individual dust particles in air drawn through a high-intensity light field has been developed for monitoring dust levels where external power may be unavailable. The instrument counts and size-discriminates airborne particles over two size ranges upwards of 0.3 microns with immediate readout. A dilution mechanism permits analysis of particulate concentrations as high as 2400 particles/cm³ on each channel. The self-contained Ni-Cd batteries are rechargeable. Total weight, including batteries and all components, is approximately 14 Ib. Total power used, mainly for pumping a filtered air sheath at 300 cm/sec and for the light source, is less than 34 watts. Another unique feature is the flow system designed for turbulence suppression.

Electronic calibration in terms of number of particles/cm³ for each size range is accomplished in the laboratory by means of a pulse generator with respect to which the readout indicator is calibrated for count. The input voltages to the pulse-height discriminators are appropriately attenuated for various pulse amplitudes simulating the output of the light-sensitive pickup, a photomultiplier tube.Pulse height as a function of particle size was measured for polystyrene latex beads ranging from 0.3 to 2 microns in diameter. Good correlation is obtained with results from commercial analyzers.

Field surveys have been undertaken with the CAES prototype analyzer at various sites in central Pennsylvania and at numerous sampling points within the cities of Pittsburgh and Philadelphia. Particulate concentrations as high as 1400 particles/ cm³ have been measured at a coal cleaning plant.     

Roof Monitor Emissions: Test Methodology

Studies of roof monitor emissions are conducted for two reasons: (1) to obtain design data necessary to engineer control systems to meet existing regulations, and (2) to determine projected control costs which can influence present day proposals for process change. Heated wire anemometers and rotating vane anemometers have been selected for velocity measurements, and high-volume air samplers have been selected to collect the particulate sample. Evaluation of other types of velocity sensing devices are described in the paper.

Roof monitor studies must be preceded by a preliminary survey to allow the project engineer to determine the test sampling locations and specific methodology necessary for the given study, and to allow the engineer to determine the type of safety equipment, scaffolds, and power requirements necessary to complete the study.

Field tests are conducted by operating a number of high-volume air samplers simultaneously while at the same time measuring the velocity of the gas through the monitor opening. Curves of particulate concentration and velocity as a function of monitor length are constructed. The concentration and velocity curves are then integrated together and the resultant curve is multiplied by the monitor width to determine a curve of mass emission rate as a function of monitor length. The total mass emission rate is represented by the area under the mass emission rate curve.

Procedures for calibrating the anemometers and correcting for the effect of power fluctuation on the high-volume sampler operation are described. Data evaluation procedures and discussion of test error are also described.

A study can cost between 10 and 20 thousand dollars, including the cost of manpower and the cost of scaffolds, power, cables, etc. It can take four months or more to conduct a study, from the preliminary survey phase through the report phase.     

Honorary Memberships

Honorary Memberships are conferred by the Air Pollution Control Association on persons of widely recognized eminence in some part of the field of air pollution control or who have rendered especially meritorious service to the Association. Honorary Memberships were awarded this year to Dr. Leonard Greenburg and Mr. Milton Reizenstein, both past presidents of APCA.     

Forecasting COH Levels at Six Outlying Sampling Stations in Allegheny County Using Statistical Correlations Derived from the Downtown Station

Verification of forecasts of COH levels at the Downtown Sampling Station using our objective forecast method developed in conjunction with the Allegheny County Bureau of Air Pollution Control gave excellent results. The next step was to expand the area of forecast coverage.

COH data taken from July 1968 through June 1969 from six sampling stations located roughly in a large concentric arc around the Downtown Station were studied. Three of the stations are located in river valleys near large industrial plants and the other three are located on higher terrain in suburban areas.

COH levels of Low, Moderate, High, and Very High (where Low = 0–0.9, Moderate = 1.0–1.9, High = 2.0–3.0, and Very High = >3.0) were used.

The total number of occurrences of High and Very High COHS at the Downtown Station was 10.7% of the total data sample. This was more than twice the frequency of any of the outlying stations.

An evaluation of the statistical frequencies indicate the Downtown Station can safely be used as a “control station” in forecasting Low or Moderate COH levels for the six surrounding stations. However, the occurrence of High or Very High COH levels at the six outlying stations do not occur with a high enough statistical consistency to be predicted by using the forecast value of the Downtown Station.

The valley stations exhibit the characteristics of separate sub air basins particularly during a period in which morning inversions occur for two or more consecutive days and the average daily wind speed does not exceed 4 m/sec.

The results show it is possible to forecast only Low or Moderate COH levels for each of the six outlying stations by using statistical correlations derived from the Downtown Station. Separate objective forecasts which relate the pollution buildup in each valley sub air basin must be used when High or Very High COHS are forecast at the Downtown Station.     

Automotive Exhaust Emission Levels by Geographic Area and Vehicle Make A Nationwide Survey

Gross average automotive exhaust emissions data collected by the Atlantic Richfield Clean Air Caravan during the summer of 1970 showed only slight geographical variations when the specific makes were ignored. When considering specific makes, significant differences were found on an average emissions basis. Vehicle population—emission distributions showed wide variations in the 50% population levels and in the percent of vehicles with emissions greater than specified values. Hydrocarbon (HC) and carbon monoxide (CO) data are given on a gross basis for the 1970, 1968-69, 1966-67, and pre-1966 model year group vehicles. Average HC and CO emissions and vehicle population-Idle emissions distribution curves are included for specific make vehicles in selected areas.